Cotton Fibre/Non Fibre
Ontology highlight
ABSTRACT:
ORGANISM(S): Gossypium hirsutum
SUBMITTER: Gavin Kennedy
PROVIDER: E-GEOD-5133 | biostudies-arrayexpress |
REPOSITORIES: biostudies-arrayexpress
Similar Datasets
Project description:A gene expression profiling study on two major cotton species that are cultivated for fibre, Gossypium hirsutum (L.) and Gossypium barbadense (L.), at different stages during fibre development using a printed cDNA microarray was undertaken to identify potential candidate genes for manipulation to improve fibre quality. Keywords: Species comparison, development Three-condition experiment: 7, 11 and 21 day post anthesis. Biological replicates: 3, Two species compared at each condition: Gossypium.hirsutum and Gossypium.barbadense. One replicate per array, dye swap, one rep per array.
2010-05-16 | E-GEOD-10363 | biostudies-arrayexpress
Project description:Himalaya v 292 Four biological replicates were used for the comparison and the dyes were swapped among the test and control samples for labeling two of the replicates. For each replicate, 50 ?g of total RNA was used for both the Cy3 and Cy5 dyes (Amersham Pharmacia, UK), following the two-step labeling method of Schenk et al. (2000). The control plant, 'Himalaya' was labeled with Cy3 in the un-swapped replicates. The dyes were reversed among the replicate experiments to minimize any bias in cDNA incorporation and photo-bleaching of the fluorescent dyes. The pre-hybridization of the microarray slides, hybridization of samples and subsequent washing of the slides to remove unbound target was performed as per the supplied protocol for the CMT-GAPSTM coated microscope slides (Corning USA). The slides were scanned with a GenePix 4000A microarray scanner (Axon Instruments, Union, CA, USA). The features were analyzed using the GenePix Pro 4 software and unsatisfactorily segmented features were either manually adjusted or discarded to ensure the integrity of the data obtained.
2006-07-24 | E-GEOD-5368 | biostudies-arrayexpress
Project description:0dpa Fibre vs epidermal laser capture microdisection comparison Keywords: Development
2006-06-27 | GSE5133 | GEO
Project description:DP16 ovules of -4, -2, 2 dpa compared to 0 dpa Keywords: Time Course 4 timepoints at -4 dpa, -2 dpa, 0 dpa and +2 dpa. -4, -2 and +2 dpa have 4 slides each, 2 Biological replicates, each biological replicate having 2 technical replicates. Dyes were swapped between technical replicates. 0 dpa has 3 slides , 3 Biological replicates,no technical replicates and no dye swapping.
2005-11-03 | E-GEOD-3545 | biostudies-arrayexpress
Project description:Cycloheximide treatment of cotton ovules Keywords: Antibiotic Treatment Single timepoint, 6 slides, 3 Biological replicates, each biological replicate having 2 technical replicates. Dyes were swapped between technical replicates.
2005-11-03 | E-GEOD-3543 | biostudies-arrayexpress
Project description:Genomic approaches to the discovery of promoters for sustained expression in cotton (Gossypium hirsutum L.) under field conditions: expression analysis in transgenic cotton and Arabidopsis of a Rubisco small subunit promoter identified using EST sequence analysis and cDNA microarrays. RNAs from 8-week old plants were compared to RNAs from 10-, 14-, 20- and 22-week old plants on separate arrays each with a dye swap. The 20 and 22 weeks hybridisations each had a biological replicate (each with a dye swap) as well as a second independent hybridisation (with dye swap) with one of the 22 week RNAs. One of the 22-week slides was of low quality and had to be discarded.
2006-05-31 | E-GEOD-4939 | biostudies-arrayexpress
Project description:Cotton ovule development, mutant vs wild type, Comparisons of DP16 0 dpa ovule Keywords: WildType vs Mutant 7 comparisons and one 0 dpa control. The 1A/DP16 & 4A/DP16 comparisons have 8 slides each, 4 Biological replicates, each biological replicate having 2 technical replicates. Dyes were swapped between technical replicates. The SL1-7-1/DP16 comparison has 6 slides, 3 Biological replicates, each biological replicate having 2 technical replicates. Dyes were swapped between technical replicates. The 5B/DP16, fl/Xu-142, OI/II+N & 53/DP16 comparisons have 4 slides each, 2 Biological replicates, each biological replicate having 2 technical replicates. Dyes were swapped between technical replicates. The 0 dpa control experiment has 3 slides , 3 Biological replicates, no technical replicates and no dye swapping.
2005-11-03 | E-GEOD-3546 | biostudies-arrayexpress
Project description:A microarray analysis of wheat grain hardness For both the Heron and Falcon NIL, whole wheat heads were harvested at 6, 15 and 25 days post anthesis (DPA) from glass house grown material and stored at -80 OC. For the other wheat cultivars analysed, heads at approximately 9-10 DPA were used. Eight to ten developing caryopses at the same age and morphological stage of development were selected from a head to represent a sample. Seed collected from a different head represented a replicate sample. Total RNA was isolated from the whole seed following the method of Higgins et al. (1976) with the following modification to remove starch. After the lithium chloride precipitation, the RNA pellet was resuspended in 250 ?l water. Then 3.5 ?l of 3 M sodium acetate (pH 5.3) and 125 ?l ethanol were added and the sample was centrifuged for 10 minutes at 4 OC. The supernatant was transferred to a fresh tube and the RNA was ethanol-precipitated by the addition of 21.5 ?l of 3 M sodium acetate (pH 5.3) and 375 ?l ethanol. The recovery of RNA varied from 0.06-0.5 ?g RNA per mg of tissue and this was dependent on the developmental stage of the seeds used for extraction of the RNA. For the labelling procedure, 50 ?g of total RNA was used for both the Cy3 and Cy5 dyes (Amersham Pharmacia, UK), following the two-step labelling method of Schenk et al. (2000). The Cy3 control (hard wheat) and Cy5 sample (soft wheat) were swapped among the replicate experiments to minimise any bias in cDNA incorporation and photo-bleaching of the fluorescent dyes. The pre-hybridisation of the microarray slides, hybridisation of the target cDNA and subsequent washing of the slides to remove unbound target was performed as per the supplied protocol for the CMT-GAPSTM coated microscope slides (Corning USA). The slides were scanned with a GenePix 4000A microarray scanner (Axon Instruments, Union, CA, USA). The features were analysed using the GenePix Pro 4 software and unsatisfactorily segmented features were either manually adjusted or discarded to ensure the integrity of the data obtained.
2006-07-24 | E-GEOD-5369 | biostudies-arrayexpress
Project description:GLB1, a class 1 haemoglobin gene from Arabidopsis thaliana (GLB1) is essential for plant survival following hypoxic stress. Keywords = haemoglobin, hypoxic stress, stress
2010-06-10 | E-GEOD-2670 | biostudies-arrayexpress
Project description:* In response to gravitational stresses, angiosperm trees form tension wood in the upper sides of branches and leaning stems in which cellulose content is higher, microfibrils are typically aligned closely with the fibre axis and the fibres often have a thick inner gelatinous cell wall layer (G-layer). * Gene expression was studied in Eucalyptus nitens branches oriented at 45° using microarrays containing 4 900 xylem cDNAs, and wood fibre characteristics revealed by X-ray diffraction, chemical and histochemical methods. * Xylem fibres in tension wood (upper branch) had a low microfibril angle, contained few fibres with G-layers and had higher cellulose and decreased Klason lignin compared to lower branch wood. Expression of two closely related fasciclin-like arabinogalactan proteins and a B-tubulin was inversely correlated with microfibril angle in upper and lower xylem from branches. * Structural and chemical modifications throughout the secondary cell walls of fibres sufficient to resist tension forces in branches can occur in the absence of G-layer enriched fibres and some important genes involved in responses to gravitational stress in eucalypt xylem are identified. Keywords: tissue comparison Two nine-year-old Eucalyptus nitens trees were used as a source of biological material. RNA was isolated from xylem from the vertical main stem and from the upper and lower quarter of branches oriented at approximately 45° from vertical. For each tree, slides were hybridized with probes synthesized from vertical xylem and one or other of upper or lower branch xylem.
2011-05-19 | E-GEOD-8816 | biostudies-arrayexpress