Project description:Hydrophobic deep eutectic solvents (DESs) have recently gained much attention as water-immiscible solvents for a wide range of applications. However, very few studies exist in which the hydrophobicity of these DESs is quantified. In this work, the interfacial properties of hydrophobic DESs with water were computed at various temperatures using molecular dynamics simulations. The considered DESs were tetrabutylammonium chloride-decanoic acid (TBAC-dec) with a molar ratio of 1:2, thymol-decanoic acid (Thy-dec) with a molar ratio of 1:2, and dl-menthol-decanoic acid (Men-dec) with a molar ratio of 2:1. The following properties were investigated in detail: interfacial tensions, water-in-DES solubilities (and salt-in-water solubilities for TBAC-dec/water), density profiles, and the number densities of hydrogen bonds. Different ionic charge scaling factors were used for TBAC-dec. Thy-dec and Men-dec showed a high level of hydrophobicity with negligible computed water-in-DES solubilities. For charge scaling factors of 0.7 and 1 for the thymol and decanoic acid components of Thy-dec, the computed interfacial tensions of the DESs are in the following order: TBAC-dec (ca. 4 mN m-1) < Thy-dec (20 mN m-1) < Men-dec (26 mN m-1). The two sets of charge scaling factors for Thy-dec did not lead to different density profiles but resulted in considerable differences in the DES/water interfacial tensions due to different numbers of decanoic acid-water hydrogen bonds at the interfaces. Large peaks were observed for the density profiles of (the hydroxyl oxygen of) decanoic acid at the interfaces of all DES/water mixtures, indicating a preferential alignment of the oxygen atoms of decanoic acid toward the aqueous phase.
Project description:The solubility of CO2 in hydrophobic deep eutectic solvents (DESs) has been measured for the first time. Six different hydrophobic DESs are studied in the temperature range from 298 to 323 K and at CO2 pressures up to 2 MPa. The results are evaluated by comparing the solubility data with existing hydrophilic DESs and currently applied physical solvents and fluorinated ionic liquids. The DESs are prepared by mixing decanoic acid with a quaternary ammonium salt with different halide anions and alkyl chain lengths. The measured CO2 solubilities are similar to those found in renowned fluorinated ILs, while the heats of CO2 absorption are in the range of nonpolar solvents. The presented DESs show good potential to be used as CO2 capture agents.
Project description:Deep eutectic solvents (DES)/reduced graphene oxide (rGO) composite materials can remove dibenzothiophene (DBT) from fuel oil by adsorption desulfurization. However, the whole synthesis process is complicated, and the DES/rGO is high-cost and not strong enough, which limits its application in industry. Therefore, a one-step method to produce DES/rGO composite materials is proposed. The performance of desulfurization was studied and the feasibility of industrial application was analyzed. First, the proposed method can improve the single extraction efficiency to 94.8% without a complicated process. Secondly, the DES/rGO can also be reused and recycled. Third, the proposed method overcomes the inconvenient storage and transportation of liquid DES. Finally, the proposed method could effectively reduce the cost of desulphurization in the industry.
Project description:Triterpenic acids (TTAs), known for their promising biological properties, can be found in different biomass sources and related by-products, such as Eucalyptus globulus bark, and have been extracted using organic volatile solvents such as dichloromethane. Recently, deep eutectic solvents (DES) have been identified as promising alternatives for the extraction of value-added compounds from biomass. In the present work, several hydrophobic DES were tested for the extraction of TTAs from E. globulus bark. Initial solubility studies revealed that DES based on menthol and thymol as the most promising solvents for these compounds given the highest solubilities obtained for ursolic acid (UA) at temperatures ranging from room temperature up to 90 °C. Accordingly, an eutectic mixture of menthol:thymol (1:2) was confirmed as the best candidate for the TTAs extraction from E. globulus outer bark, leading to extraction yields (weight of TTA per weight of biomass) at room temperature of 1.8 wt% for ursolic acid, 0.84 wt% for oleanolic acid and 0.30 wt% for betulinic acid. These values are significantly higher than those obtained with conventional organic solvents under similar conditions. The results obtained using these DES are promising for the recovery of TTAs for nutraceutical and pharmacological applications, while reinforcing the potential of DES as promising solvents to be applied in biorefinery processes.
Project description:Binary terpenoid-based eutectic systems consisting of the natural substances camphene (CA), fenchol (FE), thymol (TH), menthol (ME), dodecanoic acid (DA), and 1-dodecanol (DO) are synthesized and screened for their Solid-Liquid Equilibrium (SLE) and eutectic compositions. Out of nine eutectic systems, 13 solvent compositions at eutectic points and next to them, in addition to the reference solvent, TH:ME, are synthesized and applied for the solvent extraction of the aromatic aldehydes vanillin (VAN), syringaldehyde (SYR), and p-hydroxybenzaldehyde (HYD) from an acidic aqueous model solution. The extraction efficiency is determined from aldehyde concentrations measured by High-Performance Liquid Chromatography (HPLC), taking into consideration mutual solubility measured by Karl Fischer titration (KF) and a Total Organic Carbon-analysis (TOC). Physicochemical properties, such as the density, viscosity, and stability of the solvents, are evaluated and discussed. Additionally, 1H-NMR measurements are performed to verify hydrogen bonding present in some of the solvents. The results show that all synthesized eutectic systems have a strong hydrophobic character with a maximum water saturation of ≤2.21 vol.% and solvent losses of ≤0.12 vol.% per extraction step. The hydrophobic eutectic solvents based on CA exhibit lower viscosities, lower mutual solubility, and lower extraction efficiency for the aromatic aldehydes when compared with FE-based solvents. The highest extraction efficiencies for VAN (>95%) and for SYR (>93%) at an extraction efficiency of 92.61% for HYD are achieved by the reference solvent TH:ME (50:50 mol.%). With an extraction efficiency of 93.08%, HYD is most preferably extracted by the FE-DO-solvent (80:20 mol.%), where the extraction efficiencies for VAN and SYR reach their maximum at 93.37% and 90.75%, respectively. The drawbacks of the high viscosities of 34.741 mPas of the TH:ME solvent and 31.801 mPas of the FE-DO solvent can be overcome by the CA-TH solvent, which has a viscosity of 3.436 mPas, while exhibiting extraction efficiencies of 71.92% for HYD, >95% for VAN, and >93% for SYR, respectively.
Project description:Redox biocatalysis is an essential pillar of the chemical industry. Yet, the enzymes' nature restricts most reactions to aqueous conditions, where the limited substrate solubility leads to unsustainable diluted biotranformations. Non-aqueous media represent a strategic solution to conduct intensified biocatalytic routes. Deep eutectic solvents (DESs) are designable solvents that can be customized to meet specific application needs. Within the large design space of combining DES components (and ratios), hydrophobic DESs hold the potential to be both enzyme-compatible - keeping the enzymes' hydration -, and solubilizers for hydrophobic reactants. We explored two hydrophobic DESs, lidocaine/oleic acid, and lidocaine/decanoic acid, as reaction media for carbonyl reduction catalyzed by horse liver alcohol dehydrogenase, focusing on the effect of water contents and on maximizing substrate loadings. Enzymes remained highly active and stable in the DESs with 20 wt % buffer, whereas the reaction performance in DESs outperformed the pure buffer system with hydrophobic substrates (e. g., cinnamaldehyde to form the industrially relevant cinnamyl alcohol), with a 3-fold specific activity. Notably, the cinnamaldehyde reduction was for the first time performed at 800 mM (~100 g L-1) with full conversion, which opens up new avenues to industrial applications of hydrophobic DESs for enzyme catalysis.
Project description:The transition to a circular economy vision must handle the increasing request of metals required to satisfy the battery industry; this can be obtained by recycling and feeding back secondary raw materials recovered through proper waste management. Here, a novel and green proof-of-concept was developed, based on deep eutectic solvents (DESs) to fully and easily recover valuable metals from various cathode active materials, including LiMn2 O4 , LiNi0.5 Mn1.5 O4 , and LiNi0.8 Co0.2 O2 . DES composed of choline chloride and lactic acid could leach Li, Mn, Co, and Ni, achieving efficiency of 100 % under much milder conditions with respect to the previous literature. For the first time, to our best knowledge, a two-step approach was reported in the case of LiNi0.8 Co0.2 O2 for selective recovery of Li, Co, and Ni with high yield and purity. Furthermore, other cathode components, namely aluminum current collector and binder, were found to be not dissolved by the proposed DES, thus making a simple separation from the active material possible. Finally, this strategy was designed to easily regenerate and reuse the leaching solvents for more than one extraction, thus further boosting process sustainability.
Project description:The present study proposes a green extraction approach for the recovery of lycopene from tomato fruits. Different hydrophobic natural deep eutectic solvents (HNADESs) based on terpenes (i.e., menthol and thymol) and fatty acids (i.e., decanoic acid and dodecanoic acid) were prepared at different molar ratios, characterised in terms of density, rheological properties, and Fourier transform-infrared (FT-IR) spectroscopy, and were examined for their effectiveness to extract lycopene from tomato. Response surface methodology (RSM) was employed to optimise the extraction parameters, namely duration (min) and solvent:solid ratio (v/w). Spectrophotometry and RP-HPLC-DAD were used in order to monitor the process efficiency. The combination of decanoic acid and dodecanoic acid was found to exhibit comparable extraction capacity to acetone. Taking into account that the HNADESs used in the present study are considered green, biodegradable and of low cost, the obtained carotenoid rich extracts are expected to be of use in industrial food applications.
Project description:Deep eutectic solvents (DESs) are considered as efficient and green solvents for the extraction of bioactive compounds from medicinal plants. In this work, a novel method of DES-based ultrasound-assisted extraction of bioactive compounds from Baphicacanthus cusia leaves (BCL) was established. Systematic screening and the morphology of the original and treated BCL were observed with scanning electron microscopy to determine the extraction efficiency of different solvents. The extraction conditions were optimized by Box-Behnken design (BBD) tests and the optimal extraction conditions were as follows: lactic acid/L-menthol ratio of 5: 2 (mol/mol), solid-liquid ratio of 80.0 mL/g and temperature of 60.5 °C. The extraction yields of tryptanthrin, indigo and indirubin reached 0.356, 1.744 and 0.562 mg/g, respectively. The results of a 2,2-diphenyl-1-picrylhydrazy (DPPH) radical scavenging activity test indicated the feasibility of DESs in the extraction of bioactive compounds. This study indicated that L-menthol/lactic acid was a green and efficient solvent for the extraction of bioactive compounds from BCL, and DES-based ultrasound-assisted extraction could be used as an effective application strategy for the extraction of bioactive compounds from medicinal plants.