Molecular dynamics study of fluorosulfonyl ionic liquids as electrolyte for electrical double layer capacitors† † Electronic supplementary information (ESI) available. See DOI: https://doi.org/10.1039/d3ra04798a
Ontology highlight
ABSTRACT:
SUBMITTER: Wang S
PROVIDER: S-EPMC10571016 | biostudies-literature | 2023 Oct
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:The performance of electrochemical devices using ionic liquids (ILs) as electrolytes can be impaired by water uptake. This work investigates the influence of water on the behavior of hydrophilic and hydrophobic ILs─with ethylsulfate and tris(perfluoroalkyl)trifluorophosphate or bis(trifluoromethyl sulfonyl)imide (TFSI) anions, respectively─on electrified graphene, a promising electrode material. The results show that water uptake slightly reduces the IL electrochemical stability and significantly influences graphene's potential of zero charge, which is justified by the extent of anion depletion from the surface. Experiments confirm the dominant contribution of graphene's quantum capacitance (CQ) to the total interfacial capacitance (Cint) near the PZC, as expected from theory. Combining theory and experiments reveals that the hydrophilic IL efficiently screens surface charge and exhibits the largest double layer capacitance (CIL ∼ 80 μF cm-2), so that CQ governs the charge stored. The hydrophobic ILs are less efficient in charge screening and thus exhibit a smaller capacitance (CIL ∼ 6-9 μF cm-2), which governs Cint already at small potentials. An increase in the total interfacial capacitance is observed at positive voltages for humid TFSI-ILs relative to dry ones, consistent with the presence of a satellite peak. Short-range surface forces reveal the change of the interfacial layering with potential and water uptake owing to reorientation of counterions, counterion binding, co-ion repulsion, and water enrichment. These results are consistent with the charge being mainly stored in a ∼2 nm-thick double layer, which implies that ILs behave as highly concentrated electrolytes. This knowledge will advance the design of IL-graphene-based electrochemical devices.
| S-EPMC10210538 | biostudies-literature
Project description:Polymer electrolytes have attracted considerable research interest due to their advantages of shape control, excellent safety, and flexibility. However, the limited use of traditional polymer electrolytes in electric double-layer capacitors due to their unsatisfactory ionic conductivities and poor mechanical properties makes them difficult to operate for long periods of time in large-scale energy storage. Therefore, we fabricated a high-performance microporous electrolyte based on poly(arylene ether ketone) (PAEK)/poly(ethylene glycol)-grafted poly(arylene ether ketone) (PAEK-g-PEG) using a certain amount of carboxylated chitosan with a high electrolyte uptake rate of 322 wt% and a high ionic conductivity of 2 × 10-2 S cm-1 at room temperature. A symmetric solid-state supercapacitor that uses activated carbon as electrodes and a composite microporous polymer film as the electrolyte shows a high specific capacitance of 134.38 F g-1 at a current density of 0.2 A g-1, while liquid electrolytes demonstrate a specific capacitance of 126.92 F g-1. Energy density of the solid-state supercapacitor was 15.82% higher than that of the liquid supercapacitor at a current density of 5 A g-1. In addition, the solid-state supercapacitor exhibited excellent cycling stability of over 5000 charge/discharge cycles at a current density of 1 A g-1. Furthermore, solid-state supercapacitors display lower self-discharge behavior with an open-circuit potential drop of only 36% within 70 000 s, which is significantly better than that of conventional supercapacitors (52% @ 70 000 s), at a charging current density of 1 mA cm-2. The satisfactory results indicated that the PAEK/PAEK-g-PEG composite microporous polymer film demonstrates high potential as an electrolyte material in practical applications of solid-state and portable energy storage devices.
| S-EPMC8698150 | biostudies-literature
Project description:The electrical double layer (EDL) at metal oxide-electrolyte interfaces critically affects fundamental processes in water splitting, batteries, and corrosion. However, limitations in the microscopic-level understanding of the EDL have been a major bottleneck in controlling these interfacial processes. Herein, we use ab initio-based machine learning potential simulations incorporating long-range electrostatics to unravel the molecular-scale picture of the EDL at the prototypical anatase TiO2-electrolyte interface under various pH conditions. Our large-scale simulations, capable of capturing interfacial water dissociation/recombination reactions and electrolytic proton transport, provide unprecedented insights into the detailed structure of the EDL. Moreover, the larger capacitance of the EDL under basic relative to acidic conditions, originating from the higher affinity of the cations for the oxide surface, is found to give rise to distinct charging mechanisms on negative and positive surfaces. Our results are validated by the agreement between the computed EDL capacitance and experimental data.
| S-EPMC11599572 | biostudies-literature
Project description:Nanoscale ionic materials (NIMs) are an emerging class of materials consisting of charged nanoparticles and polymeric canopies attaching to them dynamically by electrostatic interactions. Using molecular simulations, we examine the structure and dynamics of the polymeric canopies in model NIMs in which the canopy thickness is much smaller than the nanoparticle diameter. Without added electrolyte ions, the charged terminal groups of polymers adsorb strongly on charged walls, thereby electrostatically "grafting" polymers to the wall. These polymers are highly stretched. They rarely desorb from the wall, but maintain modest in-plane mobility. When electrolyte ion pairs are introduced, the counterions adsorb on the wall, causing some electrostatically "grafted" polymers to desorb. The desorbed polymers, however, are less than the adsorbed counter-ions, which leads to an overscreening of wall charges. The desorbed polymers' charged terminal groups do not distribute uniformly across the canopy but are depleted in some regions; they adopt conformation similar to those in bulk and exchange with the "grafted" polymers rapidly, hence dilating the canopy and accelerating its dynamics. We understand these results by taking the canopy as an electrical double layer, and highlight the importance of the interplay of electrostatic and entropic effects in determining its structure and dynamics.
| S-EPMC5979949 | biostudies-literature
Project description:Solid polymer electrolyte (SPE) composed of semi-crystalline poly (vinylidene fluoride-hexafluoropropylene) [P(VdF-HFP)] copolymer, 1-ethyl-3-methylimidazolium bis (trifluoromethyl sulphonyl) imide [EMI-BTI] and graphene oxide (GO) was prepared and its performance evaluated. The effects of GO nano-filler were investigated in terms of enhancement in ionic conductivity along with the electrochemical properties of its electrical double layer capacitors (EDLC). The GO-doped SPE shows improvement in ionic conductivity compared to the P(VdF-HFP)-[EMI-BTI] SPE system due to the existence of the abundant oxygen-containing functional group in GO that assists in the improvement of the ion mobility in the polymer matrix. The complexation of the materials in the SPE is confirmed in X-ray diffraction (XRD) and thermogravimetric analysis (TGA) studies. The electrochemical performance of EDLC fabricated with GO-doped SPE is examined using cyclic voltammetry and charge-discharge techniques. The maximum specific capacitance obtained is 29.6 F∙g-1, which is observed at a scan rate of 3 mV/s in 6 wt % GO-doped, SPE-based EDLC. It also has excellent cyclic retention as it is able keep the performance of the EDLC at 94% even after 3000 cycles. These results suggest GO doped SPE plays a significant role in energy storage application.
| S-EPMC5456773 | biostudies-other
Project description:In this work, γ-valerolactone (GVL), a green solvent based on largely available biomass (carbohydrates), highly biodegradable, and with low eco-toxicological profile, was used as electrolyte component in energy storage devices. This solvent allowed the realization of electrolytes with good transport properties and high thermal stability, which could be successfully applied in electrical double layer capacitors (EDLCs). GVL-based EDLCs could operate at 2.7-2.9 V and displayed good performance in term of capacitance, cycling stability, as well as specific energy and power. The results of this study indicate that the use of solvent obtained from largely available natural sources is a feasible strategy for the realization of sustainable and safe electrolytes for EDLCs.
| S-EPMC10099548 | biostudies-literature
Project description:Developing advanced ionic electroactive devices such as ionic actuators and supercapacitors requires the understanding of ionic diffusion and drifting processes, which depend on the distances over which the ions travel, in these systems. The charge dynamics of [C(4)mim][PF(6)] ionic liquid films and Aquivion membranes with 40 wt% [C(2)mim][TfO] were investigated over a broad film thickness (d) range. It was found that the double layer charging time ?(DL) follows the classic model ?(DL) = ?(D)d/(2D) very well, where D is the diffusion coefficient and ?(D) the Debye length. In the longer time regimes (t ? ?(DL)) where diffusion dominates, the charge dynamics become voltage dependent. For low applied voltage, the later stage charge process seems to follow the d(2) dependence. However, at high voltages (> 0.5 V) in which significant device responses occur, the charging process does not show d(2) dependence so that ?(diff) = d(2)/(4D), corresponding to the ion diffusion from the bulk region, was not observed.
| S-EPMC3298447 | biostudies-literature
Project description:We combine direct surface force measurements with thermodynamic arguments to demonstrate that pure ionic liquids are expected to behave as dilute weak electrolyte solutions, with typical effective dissociated ion concentrations of less than 0.1% at room temperature. We performed equilibrium force-distance measurements across the common ionic liquid 1-butyl-3-methylimidazolium bis(trifluoromethanesulfonyl)imide ([C4mim][NTf2]) using a surface forces apparatus with in situ electrochemical control and quantitatively modeled these measurements using the van der Waals and electrostatic double-layer forces of the Derjaguin-Landau-Verwey-Overbeek theory with an additive repulsive steric (entropic) ion-surface binding force. Our results indicate that ionic liquids screen charged surfaces through the formation of both bound (Stern) and diffuse electric double layers, where the diffuse double layer is comprised of effectively dissociated ionic liquid ions. Additionally, we used the energetics of thermally dissociating ions in a dielectric medium to quantitatively predict the equilibrium for the effective dissociation reaction of [C4mim][NTf2] ions, in excellent agreement with the measured Debye length. Our results clearly demonstrate that, outside of the bound double layer, most of the ions in [C4mim][NTf2] are not effectively dissociated and thus do not contribute to electrostatic screening. We also provide a general, molecular-scale framework for designing ionic liquids with significantly increased dissociated charge densities via judiciously balancing ion pair interactions with bulk dielectric properties. Our results clear up several inconsistencies that have hampered scientific progress in this important area and guide the rational design of unique, high-free-ion density ionic liquids and ionic liquid blends.
| S-EPMC3683794 | biostudies-literature
Project description:Electrochemical double layer capacitors (EDLCs) employing ionic liquid electrolytes are the subject of much research as they promise increased operating potentials, and hence energy densities, when compared with currently available devices. Herein we report on the influence of the particle size distribution of activated carbon material on the performance of ionic liquid based EDLCs. Mesoporous activated carbon was ball-milled for increasing durations and the resultant powders characterized physically (using laser diffraction, nitrogen sorption and SEM) and investigated electrochemically in the form of composite EDLC electrodes. A bi-modal particle size distribution was found for all materials demonstrating an increasing fraction of smaller particles with increased milling duration. In general, cell capacitance decreased with increased milling duration over a wide range of rates using CV and galvanostatic cycling. Reduced coulombic efficiency is observed at low rates (<25 mVs(-1)) and the efficiency decreases as the volume fraction of the smaller particles increases. Efficiency loss was attributed to side reactions, particularly electrolyte decomposition, arising from interactions with the smaller particles. The effect of reduced efficiency is confirmed by cycling for over 15,000 cycles, which has the important implication that diminished performance and reduced cycle life is caused by the presence of submicron-sized particles.
| S-EPMC4766507 | biostudies-literature
Project description:We develop a temperature-programmed pretreatment strategy for converting aliphatic-rich petroleum pitch into a mesophase framework, which can then be activated using KOH to produce high-performance carbons for electric double-layer capacitors (EDLCs). In the pretreatment of pitch at an optimal temperature, both the temperature ramp and holding time influence the mesophase structure, which governs the pore structure and crystallinity of the resulting activated carbon. High carbon microporosity is beneficial to capacitance maximization but detrimental to ion transport. To resolve this problem, we develop a multistep ramp incorporating aliphatic species into the aromatic framework during mesophase formation. This incorporation process produces a mesophase framework that can be activated to form carbons with high crystallinity, thereby enhancing electronic conductivity and hierarchical porosity, which improves ionic conductivity. The resulting carbon electrode is used to assemble a symmetric EDLC, which exhibits a capacitance of 160 F g-1 and excellent high-rate retention in a propylene carbonate solution of N,N-diethyl-N-methylethanaminium tetrafluoroborate. The EDLC delivers a superior specific energy of 40 Wh kg-1 (based on the total carbon mass) within a voltage range of 0-2.7 V and sustained a high energy of 24 Wh kg-1 at a high power of 50 kW kg-1. The findings of this study demonstrate that incorporating aliphatic species into aromatic mesophase frameworks plays a crucial role in regulating the crystallinity and pore structure of pitch-derived carbons for charge storage.
| S-EPMC6796889 | biostudies-literature