Production Characteristics of Volatiles from Anthracite Cracking via Microwave-Induced Discharge
Ontology highlight
ABSTRACT:
SUBMITTER: Zhang L
PROVIDER: S-EPMC10905598 | biostudies-literature | 2024 Feb
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Electric discharge phenomena in metal-solvent mixtures are investigated utilizing a high field density, sealed-vessel, single-mode 2.45 GHz microwave reactor with a built-in camera. Particular emphasis is placed on studying the discharges exhibited by different metals (Mg, Zn, Cu, Fe, Ni) of varying particle sizes and morphologies in organic solvents (e.g., benzene) at different electric field strengths. Discharge phenomena for diamagnetic and paramagnetic metals (Mg, Zn, Cu) depend strongly on the size of the used particles. With small particles, short-lived corona discharges are observed that do not lead to a complete breakdown. Under high microwave power conditions or with large particles, however, bright sparks and arcs are experienced, often accompanied by solvent decomposition and formation of considerable amounts of graphitized material. Small ferromagnetic Fe and Ni powders (<40 μm) are heated very rapidly in benzene suspensions and start to glow in the microwave field, whereas larger particles exhibit extremely strong discharges. Electric discharges were also observed when Cu metal or other conductive materials such as silicon carbide were exposed to the microwave field in the absence of a solvent in an argon or nitrogen atmosphere.
| S-EPMC3922439 | biostudies-literature
Project description:The disposable masks generated in the battle against COVID-19 has attracted wide attention in the world. Pyrolysis can convert the masks into useful chemicals and fuels. In this work, the masks are pyrolyzed at temperatures of 400-580 °C and the volatiles generated are cracked without or with catalysts at 440-580 °C. The catalysts used include metal oxides (Al2O3, kaolin, Fe2O3, CeO2, TiO2) and molecular sieves (HZSM5, HY, β(25H), β(60H)). The yields and composition of gas and liquid products are studied in detail where the tetrahydrofuran (THF) soluble compounds are defined as the liquid product and the n-hexane soluble compounds are defined as the oil. The liquid product and the oil were identified by GC-MS and quantified by GC. Results indicate that 440 °C is sufficient for the masks' pyrolysis and the yields of gas, liquid product and oil are 23.4, 74.7 and 42.1 wt%, respectively. About 30% of the liquid product are C6-C35 hydrocarbons while about 70% are C36-C70 hydrocarbons trapped in the GC column (termed as column residue). The gas products are mainly C5, propylene and butene, accounting for 54.8%, 22.8% and 14.5% of the total gas product, respectively. Cracking of volatiles over various catalysts converts the liquid product mainly to propylene, butene and smaller organic gases. TiO2, HY and β(60H) are good catalysts, especially β(60H), which increases the yield of gas product to 86.5 wt% with 73.0% being ethylene, propylene and butene at 580 °C.
| S-EPMC9754623 | biostudies-literature
Project description:Recently, attention has been drawn to microwave-assisted freeze-drying (MFD), as it drastically reduces the typically long drying times of biopharmaceuticals in conventional freeze-drying (CFD). Nevertheless, previously described prototype machines lack important attributes such as in-chamber freezing and stoppering, not allowing for the performance of representative vial freeze-drying processes. In this study, we present a new technical MFD setup, designed with GMP processes in mind. It is based on a standard lyophilizer equipped with flat semiconductor microwave modules. The idea was to enable the retrofitting of standard freeze-dryers with a microwave option, which would reduce the hurdles of implementation. We aimed to collect process data with respect to the speed, settings, and controllability of the MFD processes. Moreover, we studied the performance of six monoclonal antibody (mAb) formulations in terms of quality after drying and stability after storage for 6 months. We found drying processes to be drastically shortened and well controllable and observed no signs of plasma discharge. The characterization of the lyophilizates revealed an elegant cake appearance and remarkably good stability in the mAb after MFD. Furthermore, overall storage stability was good, even when residual moisture was increased due to high concentrations of glass-forming excipients. A direct comparison of stability data following MFD and CFD demonstrated similar stability profiles. We conclude that the new machine design is highly advantageous, enabling the fast-drying of excipient-dominated, low-concentrated mAb formulations in compliance with modern manufacturing technology.
| S-EPMC10223035 | biostudies-literature
Project description:The study of the adsorption characteristics of coal is of great significance to gas prevention and CO2 geological storage. To explore the adsorption mechanism of coal, this study focuses on columnar anthracite. Adsorption tests on coal rock under a range of physical field conditions were conducted using the volumetric method. The adsorption characteristics of anthracite for CO2, CH4, and N2 gases under different conditions were investigated using Grand Canonical Monte Carlo (GCMC) and Molecular Dynamics (MD) methods. The results showed that the adsorption capacities of anthracite for these three gases are in the order of CO2 > CH4 > N2, and that the adsorption capacity increases with increasing gas injection pressure. The CO2/CH4/N2 gas molecule adsorption capacity of the anthracite macromolecular structure model decreases with increasing temperature. The increase in temperature has the greatest influence on the CO2 absorption capacity, followed by the CH4 and N2 adsorption capacities. The research offers a theoretical basis for the control of coal mine gas and the geological storage of CO2.
| S-EPMC11896062 | biostudies-literature
Project description:Ionic surfactants are widely used in coal dust control in mines, and their adsorption characteristics on the coal surface have a great influence on the coal dust control effect. In this investigation, anionic sodium dodecylbenzenesulfonate (SDBS) and cationic octadecyltrimethylammonium chloride (STAC) were selected to explore the adsorption characteristics of ionic surfactants on the surface of anthracite. The experimental results show that the adsorption rate and efficiency of STAC on the surface of anthracite are higher than that of SDBS; STAC can form a denser surfactant layer on the surface of anthracite, with a larger adsorption capacity and higher strength. Molecular dynamics simulations show that the adsorption between STAC and the surface of anthracite is tighter, and the distribution at the coal-water interface is more uniform; the surface of anthracite modified by STAC has a stronger binding ability to water molecules.
| S-EPMC9416174 | biostudies-literature
Project description:Glucosinolates (GSLs) in Brassica oleracea L. convar. acephala var. viridis (collard) flower, leaf, stem, and root were analyzed qualitatively and quantitatively via their desulfo-counterparts using UHPLC-DAD-MS/MS. Twelve GSLs were identified, including Met-derived GSLs (sinigrin, glucoibervirin, glucoerucin, glucoiberin, glucoraphanin, progoitrin), Trp-derived GSLs (4-hydroxyglucobrassicin, glucobrassicin, 4-methoxyglucobrassicin, and neoglucobrassicin), and Phe-derived GSLs (glucotropaeolin and gluconasturtiin). Total GSL content was highest in the root, having 63.40 μmol/g dried weight (DW), with gluconasturtiin (34.02 μmol/g DW) as the major GSL, followed by sinigrin and glucoibervirin (12.43 and 7.65 μmol/g DW, respectively). Total GSL contents in the flower, leaf, and stem were lower than in root, having 6.27, 2.64, and 1.84 μmol/g DW, respectively, with Trp and/or Met-derived GSLs as the predominant ones. GSL breakdown products were obtained via microwave hydrodiffusion and gravity (MHG) and volatile breakdown products were analyzed using GC-MS techniques. Volatile isolates were tested for their cytotoxic activity using MTT assay. MHG volatile extract from the root demonstrated the best cytotoxic activity against human bladder cancer cell line T24 and breast cancer cell line MDA-MB-231 during an incubation time of 72 h (IC50 21.58, and 11.62 μg/mL, respectively). The activity of the root extract can be attributed to its major volatile, 2-phenylethyl isothiocyanate (gluconasturtiin breakdown product).
| S-EPMC9965355 | biostudies-literature
Project description:Rain cracking compromises quality and quantity of sweet cherries worldwide. Cracking susceptibility differs among genotypes. The objective was to (1) phenotype the progeny of a cross between a tolerant and a susceptible sweet cherry cultivar for cuticle mass per unit area, strain release on cuticle isolation, cuticular microcracking and calcium/dry mass ratio and (2) relate these characteristics to cracking susceptibilities evaluated in laboratory immersion assays and published multiyear field observations. Mass of the dewaxed cuticle per unit area and strain release upon cuticle isolation were significantly related to cracking susceptibility in lab or field. Cuticular microcracking in the stylar end region as indexed by infiltration with acridine orange was more severe in susceptible than in tolerant genotypes and significantly correlated with susceptibility to cracking in lab and field. The Ca/dry mass ratio was lower (-8%) for susceptible than for tolerant genotypes. Fruit that cracked early had less Ca than those that cracked later. Only the Ca/dry mass ratio of the stylar end region was significantly correlated with cracking susceptibility in the field. Based on stepwise regression analyses microcracking of the cuticle accounted for most of the cracking susceptibilities in field and lab (partial r2 = 0.331 to 0.338 for field vs. r2 = 0.326 to 0.453 for lab). The variability in cracking susceptibility accounted for increased to a r2 = 0.571 (lab) when adding mass of dewaxed cuticle, up to r2 = 0.421 (field) when adding the Ca/dry mass ratio in the stylar end region or up to r2 = 0.478 (field) when entering the strain release on isolation into the model. A protocol for phenotyping is suggested that allows larger progenies to be phenotyped for microcracking, DCM mass and strain release.
| S-EPMC11698392 | biostudies-literature
Project description:A slot structure was combined with a discharge electrode to limit incident high-power microwaves via the integration of plasma discharge. At the target resonating frequency of 9.45 GHz, the surface current was concentrated at an electrode, and the electric field was enhanced by the proposed design to lower the response power level of the incident signal. When a low-power signal is injected, plasma is not generated, and the incident wave travels without insertion loss. Double-stage slot structures were utilized to broaden the band-pass characteristics in the frequency domain, and the demonstrated plasma limiter exhibited an insertion loss of 1.01 dB at 9.45 GHz. The xenon gas pressure was optimized with the shortest distance of 100 µm between the upper and lower electrodes to reduce the discharge power of the plasma. In the case of a high-power signal input, as xenon-gas breakdown occurred, the transmitted signal was close to zero, and most of the high-power signal was reflected with a blocking efficiency of 40.55 dB. The demonstrated result will be useful to protect the receiver of a radio detection and ranging system from the high power microwave.
| S-EPMC10287632 | biostudies-literature
Project description:It is thought that extensional structures (extensional cracks and normal faults) generated during the post-seismic period create fluid pathways that enhance the drainage of the subducting plate interface, thus reducing the pore pressure and increasing fault strength. However, it remains to be elucidated how much pore fluid pressure decreases by the extension crack formation. Here we examined (i) the pore fluid pressure decrease, and (ii) the degree fault strength recovery by the extension crack formation during the post-seismic period by analyzing extension quartz veins exposed around the Nobeoka Thrust, southwestern Japan. The Nobeoka Trust is an on-land analog of the modern splay fault at shallow depths (~ 8 km) in the Nankai Trough. The poro-elastic model of extensional quartz vein formation indicates that the formation of extensional cracks only releases up to ~ 7-8% of the total pore fluid pressure at ~ 8 km depth. The pore pressure around the Nobeoka Thrust was close to lithostatic pressure during the entire seismic cycle. The estimated effective frictional coefficient along the Nobeoka Thrust after this small fluid-loss by the extensional crack formation does not exceed 0.15. Hence, the pore fluid pressure reduction due to the post-seismic extensional cracks contributes little to increase the fault strength of the megasplay fault.
| S-EPMC7398914 | biostudies-literature
Project description:AbstractExtracellular vesicles (EVs) are nano-sized membrane-bound particles containing biologically active cargo molecules. The production and molecular composition of EVs reflect the physiological state of parent cells, and once released into the circulation, they exert pleiotropic functions via transferring cargo contents. Thus, circulating EVs not only serve as biomarkers, but also mediators in disease processes or injury responses. In the present study, we performed a comprehensive analysis of plasma EVs from burn patients and healthy subjects, characterizing their size distribution, concentration, temporal changes, cell origins, and cargo protein contents. Our results indicated that burn injury induced a significant increase in circulating EVs, the response peaked at the time of admission and declined over the course of recovery. Importantly, EV production correlated with injury severity, as indicated by the total body surface area and depth of burn, requirement for critical care/ICU stay, hospitalization length, wound infection, and concurrence of sepsis. Burn patients with inhalation injury showed a higher level of EVs than those without inhalation injury. We also evaluated patient demographics (age and sex) and pre-existing conditions (hypertension, obesity, and smoking) and found no significant correlation between these conditions and overall EV production. At the molecular level, flow cytometric analysis showed that the burn-induced EVs were largely derived from leukocytes and endothelial cells (ECs), which are known to be activated postburn. Additionally, a high level of zona-occludens-1 (ZO-1), a major constituent of tight junctions, was identified in burn EV cargos, indicative of injury in tissues that form barriers via tight junctions. Moreover, when applied to endothelial cell monolayers, burn EVs caused significant barrier dysfunction, characterized by decreased transcellular barrier resistance and disrupted cell-cell junction continuity. Taken together, these data suggest that burn injury promotes the production of EVs containing unique cargo proteins in a time-dependent manner; the response correlates with injury severity and worsened clinical outcomes. Functionally, burn EVs serve as a potent mediator capable of reducing endothelial barrier resistance and impairing junction integrity, a pathophysiological process underlying burn-associated tissue dysfunction. Thus, further in-depth characterization of circulating EVs will contribute to the development of new prognostic tools or therapeutic targets for advanced burn care.
| S-EPMC9246995 | biostudies-literature