Project description:The popularity of adding pulse flours to baked goods is growing rapidly due to their recognised health benefits. In this study, increasing amounts (3, 7, 10, and 15%) of white lupin flour (Lupinus albus L.) and of protein concentrate from narrow-leaved lupin (Lupinus angustifolius L.) were used as replacements for durum wheat semolina to prepare bread, and their effects on the physicochemical properties of the flour blends, as well as the technological and sensory qualities of bread, were evaluated. The addition of protein concentrate from narrow-leaved lupin and white lupin flour increased the water binding capacity and the leavening rate compared to pure semolina. A farinograph test indicated that the dough development time had a slight but significant tendency to increase with the addition of lupin flour and protein concentrate of narrow-leaved lupin, while had a negative effect on the stability of dough. The alveograph strength decreased (225, 108, and 76 × 10-4 J for dough made with semolina, 15% of protein concentrate from narrow-leaved lupin, and 15% of white lupin flour, respectively), whereas there was an upward trend in the P/L ratio. Compared to re-milled semolina, the samples with lupin flour and protein concentrate from narrow-leaved lupin had low amylase activity, with falling number values ranging from 439 s to 566 s. The addition of the two different lupin flours lowered the specific volumes of the breads (2.85, 2.39, and 1.93 cm3/g for bread made from semolina, from 15% of protein concentrate from narrow-leaved lupin, and from 15% of white lupin flour, respectively) and increased their hardness values (up to 21.34 N in the bread with 15% of protein concentrate from narrow-leaved lupin). The porosity of the loaves was diminished with the addition of the two lupin flours (range of 5-8). The sensory analysis showed that the addition of white lupin flour or protein concentrate from narrow-leaved lupin did not impart any unpleasant flavours or odours to the bread. To conclude, the use of lupin in breadmaking requires adjustments to strengthen the gluten network but does not require a deflavouring process.
Project description:Preharvest sprouting (PHS) of durum wheat (Triticum turgidum ssp. durum (Desf.) Husn.) is an important problem in Japan, where the rainy season overlaps with the harvest season. Since there are few PHS-resistant genetic resources in durum wheat, we introduced an R-gene for red seeds, the MFT gene, and the QPhs-5AL QTL, all of which are associated with PHS resistance, into durum wheat from a PHS-resistant bread wheat (T. aestivum L.) cultivar, 'Zenkoujikomugi' (Zen), by backcross breeding. Developed near isogenic lines (NILs) with red seeds had a lower percentage germination (PG) and germination index (GI) than the recurrent parent, and seed color had the greatest effect. A NIL combining all three sequences had the lowest GI and PG, with a similar GI to that of 'Shiroganekomugi' bread wheat. Among NILs with white seeds, a NIL combining MFT and QPhs-5AL had the lowest GI and PG. As the combination of all three sequences from Zen conferred PHS resistance on durum wheat, PHS-resistant genetic resources in bread wheat can be used in breeding durum wheat.
Project description:Dietary guidelines recommend the consumption of unprocessed, or minimally processed, wheat foods because they are richer in health-promoting components (i.e., minerals, vitamins, lignans, phytoestrogens, and phenolic compounds) compared to traditionally refined products. The design and implementation of technological solutions applied to the milling process are becoming a key requirement to obtain less refined mill products characterized by healthier nutritional profiles. This study presents the development of an upgraded micronization plant and of a modified air-classification plant to produce several novel types of durum wheat milling fractions, each enriched in bran particles of different sizes (from 425 µm > Ø to Ø < 180 µm) and percentage ratios. A preliminary quality assessment of the milling fractions was carried out by measuring yield percentages and ash content, the latter being related to detect the presence of bran particles. A wide array of milling fractions with different original particle size compositions was provided through the study of the process. Results indicate the ability of the novel pilot plants to produce several types of less refined milling fractions of potential interest for manufacturing durum wheat end-products beneficial for human health.
Project description:The aim of this study was to assess respondents' opinions on the choice of edible insects as a food, and to evaluate the influence of cricket flour (ECF) (10, 20, 30%) on the quality of wheat bread (WB). Whereas ECF is an additional source of acrylamide precursors, in order to reduce acrylamide formation in WB, fermentation of ECF with Lactiplantibacillus plantarum-No.122 was applied. It was established that 70.7% of the respondents had never eaten insects and more than 30% would not choose them. However, ECF was suitable substrate for fermentation (lactobacilli count 8.24 log10CFU/g, pH-4.26). In addition, fermentation reduced the total biogenic amines content in ECF (by 13.1%). The highest specific volume showed WB, prepared with fermented ECF (10, 20, 30%). All the tested WB showed similar overall acceptability (on average, 7.9 points). However, the highest intensity of emotion "happy" was induced by the WB, prepared with fermented ECF. Most of the WB with non-treated and fermented ECF showed higher acrylamide concentration (except WB with 10% of fermented ECF), in comparison with the control. Finally, fermentation is recommended for ECF inclusion in the main WB formula because fermentation improves not only quality but also reduces acrylamide concentration in WB.
Project description:Durum wheat milling is a key process step to improve the quality and safety of final products. The aim of this study was to characterize three bran-enriched milling fractions (i.e., F250, G230 and G250), obtained from three durum wheat grain samples, by using an innovative micronization and air-classification technology. Milling fractions were characterized for main standard quality parameters and for alveographic properties, starch composition and content, phenolic acids, antioxidant activity and ATIs. Results showed that yield recovery, ash content and particle size distributions were influenced either by the operating conditions (230 or 250) or by the grain samples. While total starch content was lower in the micronized sample and air-classified fractions, the P/L ratio increased in air-classified fractions as compared to semolina. Six main individual phenolic acids were identified through HPLC-DAD analysis (i.e., ferulic acid, vanillic acid, p-coumaric acid, sinapic acid, syringic and p-hydroxybenzoic acids). Compared to semolina, higher contents of all individual phenolic components were found in all bran-enriched fractions. The highest rise of TPAs occurred in the F250 fraction, which was maintained in the derived pasta. Moreover, bran-enriched fractions showed significant reductions of ATIs content versus semolina. Overall, our data suggest the potential health benefits of F250, G230 and G250 and support their use to make durum-based foods.
Project description:Phospholipases A2 (PLA2s) are known to mediate signaling cascades during plant growth and development, as well as biotic and abiotic stress responses. In this context, the present study provides extensive characterization of specific PLA2s in durum wheat, and assesses their involvement in durum wheat response to drought stress. In durum wheat leaves, four full-length expressed sequences encoding putative PLA2s were isolated and characterized as belonging to the class of secretory PLA2s (sPLA2s): TdsPLA2I, TdsPLA2II, TdsPLA2III and TdsPLA2IV. PLA2 activity was also detected, the characteristics of which resemble those of previously characterized plant sPLA2s: strong preference for phospholipids; requirement for millimolar Ca2+ concentrations; optimal activity at basic pH; heat stability; and inhibition by the reducing agent dithiothreitol. With drought stress imposed at both the vegetative and reproductive stages, accumulation of TdsPLA2I and TdsPLA2III transcripts, and to a lesser extent of TdsPLA2IV transcript, paralleled increased PLA2 activity; both transcript levels and enzymatic activity decreased as a consequence of stress recovery. Consistently, free fatty acid analysis of drought-stressed leaves revealed increased linoleate, linolenate and palmitate contents, which were reversed by plant re-watering. Overall, these findings strongly suggest that there are inducible sPLA2 isoforms in durum wheat that have roles in orchestrating the plant response to drought stress.
Project description:In the current study, partially defatted coconut flour (PDCF) was prepared using deoiled cake obtained after virgin coconut oil processing. The proximate analysis of PDCF revealed the presence of 5.21% moisture, 14.03% fat, 21.34% protein, 46.39% fiber and 3.27% ash, along with prominent functional properties. Herein, muffins were prepared by incorporation of PDCF as a replacement of refined wheat flour (RWF) at 0, 25, 50, 75 and 100% flour blend. Significant changes in batter rheology were observed after 25 to 100% replacement of RWF with PDCF, which indicated a decrease in peak viscosity and final viscosity by 65.05 to 83.59% and 61.57 to 85.17% respectively, an increase in specific gravity of batter by 0.857-0.929 g/L. The prepared muffins had significant variations in colour of crust and crumb regions as represented by changes in L*a*b*, Hue angle (h°) and Chroma (C) and textural properties such as hardness, springiness, guminess, cohesiveness, chewiness, and resilience. Incorporation of 50% PDCF significantly (P < 0.05) increased the overall acceptability of the muffins (with a maximum score of 8.5), with a fiber content of 5.53 ± 0.23% and protein content of 7.57 ± 0.30%. Storage stability studies performed at 25 ± 2 °C for seven days revealed an increase in microbial count, and reduction in textural properties but both to be in acceptable regime.Supplementary informationThe online version contains supplementary material available at 10.1007/s13197-023-05857-2.
Project description:For characterizing the predominant transcriptional profiles associated with spike development progression, and to identify core regulatory candidate genes.
Project description:Key messageLack of function of a D-genome adult plant resistance gene upon introgression into durum wheat. The wheat Lr34/Yr18/Sr57/Pm38/Ltn1 adult plant resistance gene (Lr34), located on chromosome arm 7DS, provides broad spectrum, partial, adult plant resistance to leaf rust, stripe rust, stem rust and powdery mildew. It has been used extensively in hexaploid bread wheat (AABBDD) and conferred durable resistance for many decades. These same diseases also occur on cultivated tetraploid durum wheat and emmer wheat but transfer of D genome sequences to those subspecies is restricted due to very limited intergenomic recombination. Herein we have introgressed the Lr34 gene into chromosome 7A of durum wheat. Durum chromosome substitution line Langdon 7D(7A) was crossed to Cappelli ph1c, a mutant derivative of durum cultivar Cappelli homozygous for a deletion of the chromosome pairing locus Ph1. Screening of BC1F2 plants and their progeny by KASP and PCR markers, 90 K SNP genotyping and cytology identified 7A chromosomes containing small chromosome 7D fragments encoding Lr34. However, in contrast to previous transgenesis experiments in durum wheat, resistance to wheat stripe rust was not observed in either Cappelli/Langdon 7D(7A) or Bansi durum plants carrying this Lr34 encoding segment due to low levels of Lr34 gene expression.Key message
Project description:Our study proposed date seeds flour (DSF) as an innovative ingredient for sourdough bread production through sustainable bio-recycling. We isolated autochthonous lactic acid bacteria and yeasts from DSF and DSF-derived doughs to build up a reservoir of strains from which to select starters ensuring rapid adaptation and high ecological fitness. The screening based on pro-technological criteria led to the formulation of a mixed starter consisting of Leuconostoc mesenteroides, Lactiplantibacillus plantarum, and Saccharomyces cerevisiae strains, which allowed obtaining a mature type I sourdough after consecutive refreshments, in which an aliquot of the durum wheat flour (DWF) was replaced by DSF. The resulting DSF sourdough and bread underwent an integrated characterization. Sourdough biotechnology was confirmed as a suitable procedure to improve some functional and sensory properties of DWF/DSF mixture formulation. The radical scavenging activity increased due to the consistent release of free phenolics. Perceived bitterness and astringency were considerably diminished, likely because of tannin degradation.