Drug encapsulation within self-assembled microglobules formed by thermoresponsive supramolecules.
Ontology highlight
ABSTRACT:
SUBMITTER: Betancourt JE
PROVIDER: S-EPMC3021979 | biostudies-literature | 2010 Dec
REPOSITORIES: biostudies-literature
Publications
Drug encapsulation within self-assembled microglobules formed by thermoresponsive supramolecules.
Betancourt José E JE Subramani Chandramouleeswaran C Serrano-Velez José L JL Rosa-Molinar Eduardo E Rotello Vincent M VM Rivera José M JM
Chemical communications (Cambridge, England) 20101025 45
An 8-(phenyl)-2'-deoxyguanosine derivative self-assembles in aqueous media into discrete hexadecamers that further self-assemble above 32 °C into microglobules that encapsulate the drug doxorubicin. ...[more]
Similar Datasets
Project description:Rifampicin (RIF) is a benchmark drug for treatment of tuberculosis, but poor bioavailability, prolonged treatment, and pill burden have been linked to therapeutic failure and the development of multidrug resistant strains. To overcome these limitations, this study investigated a method of rifampicin nanoencapsulation and aerosol delivery using a commercial, hand-held nebulizer modified with a nitrogen stream.
| S-EPMC4792303 | biostudies-literature
Project description:Self-assembled foam-like graphene (SFG) structures were formed using a simple nucleate boiling method, which is governed by the dynamics of bubble generation and departure in the graphene colloid solution. The conductivity and sheet resistance of the calcined (400°C) SFG film were 11.8?S·cm(-1) and 91.2 ??(-1), respectively, and were comparable to those of graphene obtained by chemical vapor deposition (CVD) (~10?S·cm(-1)). The SFG structures can be directly formed on any substrate, including transparent conductive oxide (TCO) glasses, metals, bare glasses, and flexible polymers. As a potential application, SFG formed on fluorine-doped tin oxide (FTO) exhibited a slightly better overall efficiency (3.6%) than a conventional gold electrode (3.4%) as a cathode of quantum dot sensitized solar cells (QDSSCs).
| S-EPMC3590561 | biostudies-literature
Project description:Dinuclear gold complexes have the ability to interact with one or more substrates in a dual-activation mode, leading to different reactivity and selectivity than their mononuclear relatives. In this contribution, this difference was used to control the catalytic properties of a gold-based catalytic system by site-isolation of mononuclear gold complexes by selective encapsulation. The typical dual-activation mode is prohibited by this catalyst encapsulation, leading to typical behavior as a result of mononuclear activation. This strategy can be used as a switch (on/off) for a catalytic reaction and also permits reversible control over the product distribution during the course of a reaction.
| S-EPMC5053284 | biostudies-literature
Project description:The synthesis and spectroscopic characterization of self-assembled dimeric resorcinarenes 1a-d containing four 2-benzimidazolone (cyclic urea) bridges are reported. The nanometer-size capsules are held together by a cyclic array of complementary hydrogen bonds. Unlike the related imide-bridged resorcinarenes reported by Rebek and coworkers [Heinz, T., Rudkevich, D. M. & Rebek, J., Jr. (1998) Nature (London) 394, 764-766], these strongly bound dimers aggregate in chloroform solutions yielding different self-organized structures, depending on the nature and length of the four carbon chains attached at the bottom of each resorcinarene platform, as revealed by transmission electron microscopy. Thus, phenethyl groups (dimer 1c x 1c) produce long fibers, probably arising from tail to tail contacts and subsequent threading of the resulting linear self-assembled polymers, whereas long alkyl chains (dimers 1a x 1a and 1b x 1b) induce formation of large reverse vesicles of 0.8-2.2 microm diameter through side to side extensive stacking. Presumably, the rigidity of the dimer precludes folding of the aggregate into smaller vesicles. On the contrary, dimer 1d. 1d, containing four nine-carbon chains and a cis-double bond, does not substantially aggregate and gives rise to reasonably resolved (1)H NMR spectra. The compound was shown to be dimeric either by matrix-assisted laser desorption ionization-time-of-flight and vapor pressure osmometry. Encapsulation studies were followed by NMR. Propionic or pivalic acid was included in the capsules, probably as head to head hydrogen-bonded dimers in mesitylene-d(12), a solvent too big to be a guest by its own. Longer dimeric carboxylic acids or larger substrates, like 2-adamantyl azide or cyclohexylcarbodiimide, do not encapsulate, but mixtures of a long and a short carboxylic acid (i.e., propionic-adamantyl or propionic-cyclohexyl) yield pairwise complexes.
| S-EPMC122703 | biostudies-literature
Project description:A hyaluronic acid-grafted poly(N-isopropylacrylamide) (HA-pNIPAM) was synthesized as a polymeric nanogel platform for encapsulation and delivery of hydrophobic bioactive compounds using curcumin as a model drug. As demonstrated by transmission electron microscopy and dynamic light scattering techniques, the HA-pNIPAM was simply assembled into spherical nano-sized particles with the thermoresponsive behavior. The success of curcumin aqueous solubilization was confirmed by fluorescent spectroscopy. The resulting nanogel formulation enhanced the aqueous solubility and uptake into NIH-3T3 cells of curcumin. This nanogel formulation also demonstrates cytocompatibility against NIH-3T3 cells, which deems it safe as a delivery vehicle. Moreover, the formulation has a slight skin-protection effect using an artificial skin equivalence model. The curcumin-loaded HA-pNIPAM nanogel showed an anti-proliferative activity against MDA-MB-231, Caco-2, HepG2, HT-29, and TNF-?-induced hyperproliferation of keratinocyte (HaCaT) cells. The thermoresponsive HA-pNIPAM nanogel reported here could be further optimized as a platform for controlled-release systems to encapsulate pharmaceuticals for therapeutic applications.
| S-EPMC7825653 | biostudies-literature
Project description:Herein, studies on the surface activities of newly synthesized l-Asp-based gemini surfactants, both nonionic and anionic, are presented. Conductometry, tensiometry, and the Langmuir-Blodgett (LB) film technique were applied for this purpose. π-A isotherms were obtained with a Langmuir trough and Wilhelmy balance. The structures of the monolayers assembled at the air/water interface and those deposited as LB films were studied via Brewster angle microscopy (BAM) and atomic force microscopy (AFM). The 2D films formed by the anion-active compounds show a well-known pattern of a monolayer film, whereas the nonionogenic amphiphiles have been found to be 1D structures with nano-widths and micro-lengths that align with each other during the process of compression; this is the first study where the organization of 1D fibrils in 2D films during compression is reported. The scanning electron microscopy (SEM) study reveals that 1D nanostructure formation is an intrinsic tendency of these molecules as not only nonionogenic surfactants, but also the anion active representatives have been constructed in the solid state by fibrillary structures.
| S-EPMC9073239 | biostudies-literature
Project description:Self-assembly nanofabrication is increasingly appealing in complex nanostructures, as it requires fewer materials and has potential to reduce feature sizes. The use of DNA to control nanoscale and microscale features is promising but not fully developed. In this work, we study self-assembled DNA nanotubes to fabricate gold nanowires for use as interconnects in future nanoelectronic devices. We evaluate two approaches for seeding, gold and palladium, both using gold electroless plating to connect the seeds. These gold nanowires are characterized electrically utilizing electron beam induced deposition of tungsten and four-point probe techniques. Measured resistivity values for 15 successfully studied wires are between 9.3 × 10-6 and 1.2 × 10-3 Ωm. Our work yields new insights into reproducible formation and characterization of metal nanowires on DNA nanotubes, making them promising templates for future nanowires in complex electronic circuitry.
| S-EPMC7587963 | biostudies-literature
Project description:Controlling the chemistry of the electrode-solution interface is critically important for applications in sensing, energy storage, corrosion prevention, molecular electronics, and surface patterning. While numerous methods of chemically modifying electrodes exist, self-assembled monolayers (SAMs) containing redox-active moieties are particularly important because they are easy to prepare, have well-defined interfaces, and can exhibit textbook photoelectrochemistry. Here, we investigate the photoelectrochemistry of redox-active SAMs on semiconductor/metal interfaces, where the SAM is attached to the metal site instead of the semiconductor. n-Si/Au photoelectrodes were fabricated using a benchtop electrodeposition procedure and subsequently modified by immersion in aqueous solutions of (ferrocenyl)hexanethiol and mercaptohexanol. We explored the relevant preparation conditions, finding that after optimization, we were able to obtain canonical cyclic voltammetry for a surface-bound redox molecule that could be turned on and off using light. We then characterized the optimized electrodes under varying illumination intensities, finding that the heterogeneous electron transfer kinetics improved under higher illumination intensities. These results lay the foundation for future studies of semiconductor/metal/molecule interfaces relevant to sensing and electrocatalysis.
| S-EPMC11340028 | biostudies-literature
Project description:Two-dimensional (2D) materials are a key target for many applications in the modern day. Self-assembly is one approach that can bring us closer to this goal, which usually relies upon strong, directional interactions instead of covalent bonds. Control over less directional forces is more challenging and usually does not result in as well-defined materials. Explicitly incorporating topography into the design as a guiding effect to enhance the interacting forces can help to form highly ordered structures. Herein, we show the process of shape-assisted self-assembly to be consistent across a range of derivatives that highlights the restriction of rotational motion and is verified using a diverse combination of solid state analyses. A molecular curvature governed angle distribution nurtures monomers into loose columns that then arrange to form 2D structures with long-range order observed in both crystalline and soft materials. These features strengthen the idea that shape becomes an important design principle leading towards precise molecular self-assembly and the inception of new materials.
| S-EPMC10406840 | biostudies-literature
Project description:Chemically self-assembled antibody nanorings (CSANs) displaying multiple copies of single-chain variable fragments can be prepared from dihydrofolate reductase (DHFR) fusion proteins and bis-methotrexate (bisMTX). We have designed and synthesized a bisMTX chemical dimerizer (bisMTX-NH(2)) that contains a third linker arm that can be conjugated to fluorophores, radiolabels, and drugs. Monovalent, divalent, and higher-order AntiCD3 CSANs were assembled with a fluorescein isothiocyanate (FITC)-labeled bis-methotrexate ligand (bisMTX-FITC) and found to undergo rapid internalization and trafficking by HPB-MLT, a CD3+ T-leukemia cell line, to the early and late endosome and lysosome. Because the fluorescence of bisMTX-FITC when incorporated into CSANs was found to be significantly greater than that of the free ligand, the stability of the endocytosed AntiCD3 CSANs could be monitored. The internalized CSANs were found to be stable for several hours, while treatment with the nontoxic DHFR inhibitor trimethoprim resulted in a rapid loss (>80%) of cellular fluorescence within minutes, consistent with efficient intracellular disassembly of the nanorings. Over longer time periods (24 h), cellular fluorescence decreased by 75-90%, regardless of whether cells had been treated with DMSO or trimethoprim. Although bisMTX is a potent inhibitor of DHFR, it was found to be nontoxic (GI(50) > 20 ?M) to HPB-MLT cells. In contrast, AntiCD3 CSANs prepared with bisMTX were found to be at least 13-fold more cytotoxic (GI(50) = 0.5-1.5 ?M) than bisMTX at 72 h. Consistent with our findings from CSAN stability studies, no increase in cytotoxicity was observed upon treatment with trimethoprim. Taken together, our results suggest that cell receptor targeting CSANs prepared with trifunctional bisMTX could be used as potential tissue selective drug carriers.
| S-EPMC3549309 | biostudies-literature