Browse
Submit Data
Databases
API
Help

Dataset Information

14 Views

0 Connections

0 Citations

0 Reanalyses

0 Downloads

Omics score: 0

Dynamic control of nanoprecipitation in a nanopipette.

ABSTRACT: Studying the earliest stages of precipitation at the nanoscale is technically challenging but quite valuable as such phenomena reflect important processes such as crystallization and biomineralization. Using a quartz nanopipette as a nanoreactor, we induced precipitation of an insoluble salt to generate oscillating current blockades. The reversible process can be used to measure both kinetics of precipitation and relative size of the resulting nanoparticles. Counter ions for the highly water-insoluble salt zinc phosphate were separated by the pore of a nanopipette and a potential applied to cause ion migration to the interface. By analyzing the kinetics of pore blockage, two distinct mechanisms were identified: a slower process due to precipitation from solution, and a faster process attributed to voltage-driven migration of a trapped precipitate. We discuss the potential of these techniques in studying precipitation dynamics, trapping particles within a nanoreactor, and electrical sensors based on nanoprecipitation.

SUBMITTER: Vilozny B

PROVIDER: S-EPMC3082981 | biostudies-literature |

REPOSITORIES: biostudies-literature

ACCESS DATA

Json Xml

Similar Datasets

Dynamic single-cell intracellular pH sensing using a SERS-active nanopipette.

Project description:Glass nanopipettes have shown promise for applications in single-cell manipulation, analysis, and imaging. In recent years, plasmonic nanopipettes have been developed to enable surface-enhanced Raman spectroscopy (SERS) measurements for single-cell analysis. In this work, we developed a SERS-active nanopipette that can be used to perform long-term and reliable intracellular analysis of single living cells with minimal damage, which is achieved by optimizing the nanopipette geometry and the surface density of the gold nanoparticle (AuNP) layer at the nanopipette tip. To demonstrate its ability in single-cell analysis, we used the nanopipette for intracellular pH sensing. Intracellular pH (pHi) is vital to cells as it influences cell function and behavior and pathological conditions. The pH sensitivity was realized by simply modifying the AuNP layer with the pH reporter molecule 4-mercaptobenzoic acid. With a response time of less than 5 seconds, the pH sensing range is from 6.0 to 8.0 and the maximum sensitivity is 0.2 pH units. We monitored the pHi change of individual HeLa and fibroblast cells, triggered by the extracellular pH (pHe) change. The HeLa cancer cells can better resist pHe change and adapt to the weak acidic environment. Plasmonic nanopipettes can be further developed to monitor other intracellular biomarkers.

| S-EPMC7425357 | biostudies-literature

Diversity of dynamic voltage patterns in neuronal dendrites revealed by nanopipette electrophysiology.

Project description:Dendrites and dendritic spines are the essential cellular compartments in neuronal communication, conveying information through transient voltage signals. Our understanding of these compartmentalized voltage dynamics in fine, distal neuronal dendrites remains poor due to the difficulties inherent to accessing and stably recording from such small, nanoscale cellular compartments for a sustained time. To overcome these challenges, we use nanopipettes that permit long and stable recordings directly from fine neuronal dendrites. We reveal a diversity of voltage dynamics present locally in dendrites, such as spontaneous voltage transients, bursting events and oscillating periods of silence and firing activity, all of which we characterized using segmentation analysis. Remarkably, we find that neuronal dendrites can display spontaneous hyperpolarisation events, and sustain transient hyperpolarised states. The voltage patterns were activity-dependent, with a stronger dependency on synaptic activity than on action potentials. Long-time recordings of fine dendritic protrusions show complex voltage dynamics that may represent a previously unexplored contribution to dendritic computations.

| S-EPMC10373629 | biostudies-literature

Mixing and flow-induced nanoprecipitation for morphology control of silk fibroin self-assembly.

Project description:Tuning silk fibroin nanoparticle morphology using nanoprecipitation for bottom-up manufacture is an unexplored field that has the potential to improve particle performance characteristics. The aim of this work was to use both semi-batch bulk mixing and micro-mixing to modulate silk nanoparticle morphology by controlling the supersaturation and shear rate during nanoprecipitation. At flow rates where the shear rate was below the critical shear rate for silk, increasing the concentration of silk in both bulk and micro-mixing processes resulted in particle populations of increased sphericity, lower size, and lower polydispersity index. At high flow rates, where the critical shear rate was exceeded, the increased supersaturation with increasing concentration was counteracted by increased rates of shear-induced assembly. The morphology could be tuned from rod-like to spherical assemblies by increasing supersaturation of the high-shear micro-mixing process, thereby supporting a role for fast mixing in the production of narrow-polydispersity silk nanoparticles. This work provides new insight into the effects of shear during nanoprecipitation and provides a framework for scalable manufacture of spherical and rod-like silk nanoparticles.

| S-EPMC8982335 | biostudies-literature

Design of Insulin-Loaded Nanoparticles Enabled by Multistep Control of Nanoprecipitation and Zinc Chelation.

Project description:Nanoparticle (NP) carriers provide new opportunities for controlled delivery of drugs, and have potential to address challenges such as effective oral delivery of insulin. However, due to the difficulty of efficiently loading insulin and other proteins inside polymeric NPs, their use has been mostly restricted to the encapsulation of small molecules. To better understand the processes involved in encapsulation of proteins in NPs, we study how buffer conditions, ionic chelation, and preparation methods influence insulin loading in poly(lactic-co-glycolic acid)-b-poly(ethylene glycol) (PLGA-PEG) NPs. We report that, although insulin is weakly bound and easily released from the NPs in the presence of buffer ions, insulin loading can be increased by over 10-fold with the use of chelating zinc ions and by the optimization of the pH during nanoprecipitation. We further provide ways of changing synthesis parameters to control NP size while maintaining high insulin loading. These results provide a simple method to enhance insulin loading of PLGA-PEG NPs and provide insights that may extend to other protein drug delivery systems that are subject to limited loading.

| S-EPMC5557377 | biostudies-literature

Cavity Carbon-Nanopipette Electrodes for Dopamine Detection.

Project description:Microelectrodes are typically used for neurotransmitter detection, but nanoelectrodes are not because there is a trade-off between spatial resolution and sensitivity that is dependent on surface area. Cavity carbon-nanopipette electrodes (CNPEs), with tip diameters of a few hundred nanometers, have been developed for nanoscale electrochemistry. Here, we characterize the electrochemical performance of CNPEs with fast-scan cyclic voltammetry (FSCV) for the first time. Dopamine detection using cavity CNPEs, with a depth equivalent to a few radii, is compared with that using open-tube CNPEs, an essentially infinite geometry. Open-tube CNPEs have very slow temporal responses that change over time as the liquid rises in the CNPE. However, a cavity CNPE has a fast temporal response to a bolus of dopamine that is not different from that of a traditional carbon-fiber microelectrode. Cavity CNPEs, with tip diameters of 200-400 nm, have high currents because the small cavity traps and increases the local dopamine concentration. The trapping also leads to an FSCV frequency-independent response and the appearance of cyclization peaks that are normally observed only with large concentrations of dopamine. CNPEs have high dopamine selectivity over ascorbic acid (AA) because of the repulsion of AA by the negative electric field at the holding potential and the irreversible redox reaction. In mouse-brain slices, cavity CNPEs detected exogenously applied dopamine, showing they do not clog in tissue. Thus, cavity CNPEs are promising neurochemical sensors that provide spatial resolution on the scale of hundreds of nanometers, which is useful for small model organisms or for locations near specific cells.

| S-EPMC6526101 | biostudies-literature

Label-free biosensing with functionalized nanopipette probes.

Project description:Nanopipette technology can uniquely identify biomolecules such as proteins based on differences in size, shape, and electrical charge. These differences are determined by the detection of changes in ionic current as the proteins interact with the nanopipette tip coated with probe molecules. Here we show that electrostatic, biotin-streptavidin, and antibody-antigen interactions on the nanopipette tip surface affect ionic current flowing through a 50-nm pore. Highly charged polymers interacting with the glass surface modulated the rectification property of the nanopipette electrode. Affinity-based binding between the probes tethered to the surface and their target proteins caused a change in the ionic current due to a partial blockade or an altered surface charge. These findings suggest that nanopipettes functionalized with appropriate molecular recognition elements can be used as nanosensors in biomedical and biological research.

| S-EPMC2651834 | biostudies-literature

Copper Sensing with a Prion Protein Modified Nanopipette.

Project description:Protein-metal interactions determine and regulate many biological functions. Nanopipettes functionalized with peptide moieties can be used as sensors for metal ions in solution.

| S-EPMC3519431 | biostudies-literature

Reversible cation response with a protein-modified nanopipette.

Project description:The calcium ion response of a quartz nanopipette was enhanced by immobilization of calmodulin to the nanopore surface. Binding to the analyte is rapidly reversible in neutral buffer and requires no change in media or conditions to regenerate the receptor. The signal remained reproducible over numerous measurements. The modified nanopipette was used to measure binding affinity to calcium ions, with a K(d) of 6.3 ± 0.8 × 10(-5) M. This affinity is in good agreement with reported values of the solution-state protein. The behavior of such reversible nanopore-based sensors can be used to study proteins in a confined environment and may lead to new devices for continuous monitoring.

| S-EPMC3155644 | biostudies-literature

FIB-Milled Quartz Nanopores in a Sealed Nanopipette.

Project description:We report the use of laser-pulled quartz nanopipettes as a new platform for microfabricated nanopores. A quartz nanopipette is prepared on a laser puller and sealed closed prior to focused-ion beam (FIB) milling. A quartz nanopore can then be FIB-milled into the side walls of the sealed pipette and used to analyze single nanoparticles. This method is fast, reproducible and creates nearly cylindrical nanopores in ultrathin quartz walls with controllable diameter down to 66 nm. Both pore size and wall thickness can be readily controlled in the FIB milling process by adjusting milling parameters and milling at different locations along the pipette walls. FIB-milled quartz nanopores combine the advantages of the pipette pores and silicon chip-based membrane pores into one device while avoiding many of the challenges of two popular nanopore devices. First, they can be used as a handheld probe device like a quartz pipette. Second, the use of an ultrathin quartz membrane gives them superior electric property enabling low noise recording at a higher bandwidth and a highly focused sensing zone located at a farther distance away from the highly restricted tip region. The inner and outer diameters of the resulting pore can be precisely measured using scanning electron microscopy (SEM). As an application, FIB-milled side nanopores are used to study translocation of polystyrene nanoparticles. In addition to studying the dependence of translocation time on the pore length, we demonstrate detection of nanoparticles in parallel nanopores of different lengths and use finite-element simulation to confirm the identity of the two resulting populations. Our results show that FIB-milled side nanopores are a useful platform for future analytical applications like studying nanoparticle translocation dynamics.

| S-EPMC6707750 | biostudies-literature

Control and Preparation of Quaternized Chitosan and Carboxymethyl Chitosan Nanoscale Polyelectrolyte Complexes Based on Reactive Flash Nanoprecipitation.

Project description:Nanoscale polyelectrolyte complex materials have been extensively investigated for their promising application in protocell, drug carriers, imaging, and catalysis. However, the conventional preparation approach involving positive and negative polyelectrolytes leads to large size, wide size distribution, instability, and aggregation due to the nonhomogeneous mixing process. Herein, we employ reactive flash nanoprecipitation (RFNP) to control the mixing and preparation of the nanoscale polyelectrolyte complex. With RFNP, homogeneous mixing complexation between oppositely charged chitosan derivatives could be achieved, resulting in stable nanoscale complexes (NCs) with controllable size and narrow size distribution. The smallest size of NCs is found at specific pH due to the maximum attraction of positive and negative molecules of chitosan. The size can be modulated by altering the volumetric flow rates of inlet streams, concentration, and charge molar ratio of two oppositely charged chitosan derivatives. The charge molar ratio is also tuned to create NCs with positive and negative shells. There is no significant variation in the size of NCs produced at different intervals of time. This method allows continuous and tunable NC production and could have the potential for fast, practical translation.

| S-EPMC8482477 | biostudies-literature

OmicsDI is part of the ELIXIR infrastructure

OmicsDI is an Elixir interoperability service. Learn more ›

Tweets

OmicsDI Databases

PRIDE
PeptideAtlas
MassIVE
JPOST Repository
Physiome Model Repository

EGA
EVA
ENA
LINCS
PAXDB
Cell Collective

MetaboLights
Metabolomics Workbench
MetabolomeExpress
GNPS
BioModels
FAIRDOMHub

ArrayExpress
dbGaP
ExpressionAtlas
GEO
NODE

Information

Databases
Help
API
Contact us
Code on GitHub
Terms of use
Submit Data