Design of highly emissive polymer dot bioconjugates for in vivo tumor targeting.
Ontology highlight
ABSTRACT:
SUBMITTER: Wu C
PROVIDER: S-EPMC3095208 | biostudies-literature | 2011 Apr
REPOSITORIES: biostudies-literature
Publications
Design of highly emissive polymer dot bioconjugates for in vivo tumor targeting.
Wu Changfeng C Hansen Stacey J SJ Hou Qiong Q Yu Jiangbo J Zeigler Maxwell M Jin Yuhui Y Burnham Daniel R DR McNeill Jason D JD Olson James M JM Chiu Daniel T DT
Angewandte Chemie (International ed. in English) 20110304 15
Similar Datasets
Project description:Semiconducting polymer dot (Pdot) bioconjugates are a new class of ultrabright fluorescent probes. Here, we report a procedure for lyophilizing Pdot bioconjugates so that they successfully retain their optical properties, colloidal stability, and cell-targeting capability during storage. We found that, when Pdot bioconjugates were lyophilized in the presence of 10% sucrose, the rehydrated Pdot bioconjugates did not show any signs of aggregation and exhibited the same hydrodynamic diameters as before lyophilization. The brightness of the lyophilized Pdots was at least as good as before lyophilization, but in some cases, the quantum yield of lyophilized Pdots curiously showed an improvement. Finally, using flow cytometry, we demonstrated that lyophilized Pdot bioconjugates retained their biological targeting properties and were able to effectively label cells; in fact, cells labeled with lyophilized Pdot bioconjugates composed of PFBT, which were stored for 6 months at -80 °C, were ~22% brighter than those labeled with identical but unlyophilized Pdot bioconjugates. These results indicate lyophilization may be a preferred approach for storing and shipping Pdot bioconjugates, which is an important practical consideration for ensuring Pdots are widely adopted in biomedical research.
| S-EPMC3696440 | biostudies-literature
Project description:Early detection and subsequent complete surgical resection are among the most efficient methods for treating cancer. However, low detection sensitivity and incomplete tumor resection are two challenging issues. Nanoparticle-based imaging-guided surgery has proven promising for cancer-targeted imaging and subsequent debulking surgery. Particularly, the use of near infrared (NIR) fluorescent probes such as NIR quantum dots (QDs) allows deep penetration and high sensitivity for tumor detection. In this study, NIR-emitting CdTe QDs (maximum fluorescence emission peak at 728 nm) were synthesized with a high quantum yield (QY) of 38%. The tumor-specific QD bioconjugates were obtained by attaching cyclic Arg-Gly-Asp peptide (cRGD) to the surface of synthesized QDs, and then injected into U87 MG tumor-bearing mice via tail veins for tumor-targeted imaging. The tumor and its margins were visualized and distinguished by NIR QD bioconjugates, and tumor resection was successfully accomplished via NIR guidance using a Fluobeam-700 NIR imaging system. Our work indicates that the synthesized tumor-specific NIR QDs hold great promise as a potential fluorescent indicator for intraoperative tumor imaging.
| S-EPMC3425123 | biostudies-other
Project description:We report the development of a quantum dot (QD)-peptide-fullerene (C60) electron transfer (ET)-based nanobioconjugate for the visualization of membrane potential in living cells. The bioconjugate is composed of (1) a central QD electron donor, (2) a membrane-inserting peptidyl linker, and (3) a C60 electron acceptor. The photoexcited QD donor engages in ET with the C60 acceptor, resulting in quenching of QD photoluminescence (PL) that tracks positively with the number of C60 moieties arrayed around the QD. The nature of the QD-capping ligand also modulates the quenching efficiency; a neutral ligand coating facilitates greater QD quenching than a negatively charged carboxylated ligand. Steady-state photophysical characterization confirms an ET-driven process between the donor-acceptor pair. When introduced to cells, the amphiphilic QD-peptide-C60 bioconjugate labels the plasma membrane by insertion of the peptide-C60 portion into the hydrophobic bilayer, while the hydrophilic QD sits on the exofacial side of the membrane. Depolarization of cellular membrane potential augments the ET process, which is manifested as further quenching of QD PL. We demonstrate in HeLa cells, PC12 cells, and primary cortical neurons significant QD PL quenching (ΔF/F0 of 2-20% depending on the QD-C60 separation distance) in response to membrane depolarization with KCl. Further, we show the ability to use the QD-peptide-C60 probe in combination with conventional voltage-sensitive dyes (VSDs) for simultaneous two-channel imaging of membrane potential. In in vivo imaging of cortical electrical stimulation, the optical response of the optimal QD-peptide-C60 configuration exhibits temporal responsivity to electrical stimulation similar to that of VSDs. Notably, however, the QD-peptide-C60 construct displays 20- to 40-fold greater ΔF/F0 than VSDs. The tractable nature of the QD-peptide-C60 system offers the advantages of ease of assembly, large ΔF/F0, enhanced photostability, and high throughput without the need for complicated organic synthesis or genetic engineering, respectively, that is required of traditional VSDs and fluorescent protein constructs.
| S-EPMC6001310 | biostudies-literature
Project description:Highly fluorescent multiblock conjugated polymer nanoparticles with folic acid surface ligands are highly effective for bioimaging and in vivo tumor targeting. The targeted nanoparticles were preferentially localized in tumor cells in vivo, thereby illustrating their potential for diagnostic and therapeutic applications.
| S-EPMC4001254 | biostudies-literature
Project description:Cancer research has experienced astonishing advances recently, but cancer remains a major threat because it is one of the leading causes of death worldwide. Glioblastoma (GBM) is the most malignant brain tumor, where the early diagnosis is vital for longer survival. Thus, this study reports the synthesis of novel water-dispersible ternary AgInS2 (AIS) and quaternary AgInS2-ZnS (ZAIS) fluorescent quantum dots using carboxymethylcellulose (CMC) as ligand for multiplexed bioimaging of malignant glioma cells (U-87 MG). Firstly, AgInS2 core was prepared using a one-pot aqueous synthesis stabilized by CMC at room temperature and physiological pH. Then, an outer layer of ZnS was grown and thermally annealed to improve their optical properties and split the emission range, leading to core-shell alloyed nanostructures. Their physicochemical and optical properties were characterized, demonstrating that luminescent monodispersed AIS and ZAIS QDs were produced with average sizes of 2.2?nm and 4.3?nm, respectively. Moreover, the results evidenced that they were cytocompatible using in vitro cell viability assays towards human embryonic kidney cell line (HEK 293T) and U-87 MG cells. These AIS and ZAIS successfully behaved as fluorescent nanoprobes (red and green, resp.) allowing multiplexed bioimaging and biolabeling of costained glioma cells using confocal microscopy.
| S-EPMC5702976 | biostudies-literature
Project description:Here we report the construction and characterization of a recoverable, thermoresponsive polymer-endoglucanase bioconjugate that matches the activity of unmodified enzymes on insoluble cellulose substrates. Two copolymers exhibiting a thermoresponsive lower critical solution temperature (LCST) were created through the copolymerization of an aminooxy-bearing methacrylamide with N-isopropylacrylamide (NIPAm) or N-isopropylmethacrylamide (NIPMa). The aminooxy group provided a handle through which the LCST was adjusted through small-molecule quenching. This allowed materials with LCSTs ranging from 20.9 to 60.5 °C to be readily obtained after polymerization. The thermostable endoglucanase EGPh from the hypothermophilic Pyrococcus horikoshii was transaminated with pyridoxal-5'-phosphate to produce a ketone-bearing protein, which was then site-selectively modified through oxime linkage with benzylalkoxyamine or 5 kDa-poly(ethylene glycol)-alkoxyamine. These modified proteins showed activity comparable to the controls when assayed on an insoluble cellulosic substrate. Two polymer bioconjugates were then constructed using transaminated EGPh and the aminooxy-bearing copolymers. After 12 h, both bioconjugates produced an equivalent amount of free reducing sugars as the unmodified control using insoluble cellulose as a substrate. The recycling ability of the NIPAm copolymer-EGPh conjugate was determined through three rounds of activity, maintaining over 60% activity after two cycles of reuse and affording significantly more soluble carbohydrates than unmodified enzyme alone. When assayed on acid-pretreated Miscanthus, this bioconjugate increased the amount of reducing sugars by 2.8-fold over three rounds of activity. The synthetic strategy of this bioconjugate allows the LCST of the material to be changed readily from a common stock of copolymer and the method of attachment is applicable to a variety of proteins, enabling the same approach to be amenable to thermophile-derived cellulases or to the separation of multiple species using polymers with different recovery temperatures.
| S-EPMC3593141 | biostudies-literature
Project description:We report a simple temperature-responsive bioconjugate system comprising superfolder green fluorescent protein (sfGFP) decorated with poly[(oligo ethylene glycol) methyl ether methacrylate] (PEGMA) polymers. We used amber suppression to site-specifically incorporate the non-canonical azide-functional amino acid p-azidophenylalanine (pAzF) into sfGFP at different positions. The azide moiety on modified sfGFP was then coupled using copper-catalyzed "click" chemistry with the alkyne terminus of a PEGMA synthesized by reversible addition-fragmentation chain transfer (RAFT) polymerization. The protein in the resulting bioconjugate was found to remain functionally active (i.e., fluorescent) after conjugation. Turbidity measurements revealed that the point of attachment of the polymer onto the protein scaffold has an impact on the thermoresponsive behavior of the resultant bioconjugate. Furthermore, small-angle X-ray scattering analysis showed the wrapping of the polymer around the protein in a temperature-dependent fashion. Our work demonstrates that standard genetic manipulation combined with an expanded genetic code provides an easy way to construct functional hybrid biomaterials where the location of the conjugation site on the protein plays an important role in determining material properties. We anticipate that our approach could be generalized for the synthesis of complex functional materials with precisely defined domain orientation, connectivity, and composition.
| S-EPMC4577958 | biostudies-literature
Project description:We demonstrate a new compact CN-PPV dot, which emits in the orange wavelength range with high brightness. The small particle size, high brightness, and the ability to highly specifically target subcellular structures make the CN-PPV dots promising probes for biological imaging and bioanalytical applications.
| S-EPMC3669682 | biostudies-literature
Project description:Surgical resection is recognized as a mainstay in the therapy of malignant brain tumors. In clinical practice, however, surgeons face great challenges in identifying the tumor boundaries due to the infiltrating and heterogeneous nature of neoplastic tissues. Contrast-enhanced magnetic resonance imaging (MRI) is extensively used for defining the brain tumor in clinic. Disappointingly, the commercially available (MR) contrast agents show the transient circulation lifetime and poor blood-brain barrier (BBB) permeability, which seriously hamper their abilities in tumor visualization. In this work, red fluorescent carbonized polymer dots (CPDs) were systematically investigated with respect to their BBB-penetration ability. In summary, CPDs possess long excitation/emission wavelengths, low toxicity, high photostability, and excellent biocompatibility. CPDs exhibit high internalization in glioma cells in time- and dose-dependent procedures, and internalized CPDs locate mainly in endolysosomal structures. In vitro and in vivo studies confirmed the BBB permeability of CPDs, contributing to the early stage diagnosis of brain disorders and the noninvasive visualization of the brain tumor without compromised BBB. Furthermore, owing to the high tumor to normal tissue ratio of CPDs under ex vivo conditions, our nanoprobe holds the promise to guide brain-tumor resection by real-time fluorescence imaging during surgery.
| S-EPMC6072250 | biostudies-literature
Project description:The unique properties provided by hybrid semiconductor quantum dot (QD) bioconjugates continue to stimulate interest for many applications ranging from biosensing to energy harvesting. Understanding both the structure and function of these composite materials is an important component in their development. Here, we compare the architecture that results from using two common self-assembly chemistries to attach DNA to QDs. DNA modified to display either a terminal biotin or an oligohistidine peptidyl sequence was assembled to streptavidin/amphiphilic polymer- or PEG-functionalized QDs, respectively. A series of complementary acceptor dye-labeled DNA were hybridized to different positions on the DNA in each QD configuration and the separation distances between the QD donor and each dye-acceptor probed with Fo?rster resonance energy transfer (FRET). The polyhistidine self-assembly yielded QD-DNA bioconjugates where predicted and experimental separation distances matched reasonably well. Although displaying efficient FRET, data from QD-DNA bioconjugates assembled using biotin-streptavidin chemistry did not match any predicted separation distances. Modeling based upon known QD and DNA structures along with the linkage chemistry and FRET-derived distances was used to simulate each QD-DNA structure and provide insight into the underlying architecture. Although displaying some rotational freedom, the DNA modified with the polyhistidine assembles to the QD with its structure extended out from the QD-PEG surface as predicted. In contrast, the random orientation of streptavidin on the QD surface resulted in DNA with a wide variety of possible orientations relative to the QD which cannot be controlled during assembly. These results suggest that if a particular QD biocomposite structure is desired, for example, random versus oriented, the type of bioconjugation chemistry utilized will be a key influencing factor.
| S-EPMC4383186 | biostudies-literature