Gold nanorods 3D-supercrystals as surface enhanced Raman scattering spectroscopy substrates for the rapid detection of scrambled prions.
Ontology highlight
ABSTRACT:
SUBMITTER: Alvarez-Puebla RA
PROVIDER: S-EPMC3100977 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Graphene is a promising platform for surface-enhanced Raman spectroscopy (SERS)-active substrates, primarily due to the possibility of quenching photoluminescence and fluorescence. Here we study ultrathin gold films near the percolation threshold fabricated by electron-beam deposition on monolayer CVD graphene. The advantages of such hybrid graphene/gold substrates for surface-enhanced Raman spectroscopy are discussed in comparison with conventional substrates without the graphene layer. The percolation threshold is determined by independent measurements of the sheet resistance and effective dielectric constant by spectroscopic ellipsometry. The surface morphology of the ultrathin gold films is analyzed by the use of scanning electron microscopy (SEM) and atomic force microscopy (AFM), and the thicknesses of the films in addition to the quartz-crystal mass-thickness sensor are also measured by AFM. We experimentally demonstrate that the maximum SERS signal is observed near and slightly below the percolation threshold. In this case, the region of maximum enhancement of the SERS signal can be determined using the figure of merit (FOM), which is the ratio of the real and imaginary parts of the effective dielectric permittivity of the films. SERS measurements on hybrid graphene/gold substrates with the dye Crystal Violet show an enhancement factor of ~105 and also demonstrate the ability of graphene to quench photoluminescence by an average of ~60%.
| S-EPMC7022774 | biostudies-literature
Project description:Exosomes are a potential source of cancer biomarkers. Probing tumor-derived exosomes can offer a potential non-invasive way to diagnose cancer, assess cancer progression, and monitor treatment responses. Novel molecular methods would facilitate exosome analysis and accelerate basic and clinical exosome research. Methods: A standard gold-coated glass microscopy slide was used to develop a miniaturized affinity-based device to capture exosomes in a target-specific manner with the assistance of low-cost 3-D printing technology. Gold nanorods coated with QSY21 Raman reporters were used as the label agent to quantitatively detect the target proteins based on surface enhanced Raman scattering spectroscopy. The expressions of several surface protein markers on exosomes from conditioned culture media of breast cancer cells and from HER2-positive breast cancer patients were quantitatively measured. The data was statistically analyzed and compared with healthy controls. Results: A miniaturized 17 × 5 Au array device with 2-mm well size was fabricated to capture exosomes in a target-specific manner and detect the target proteins on exosomes with surface enhanced Raman scattering gold nanorods. This assay can specifically detect exosomes with a limit of detection of 2×106 exosomes/mL and analyze over 80 purified samples on a single device within 2 h. Using the assay, we have showed that exosomes derived from MDA-MB-231, MDA-MB-468, and SKBR3 breast cancer cells give distinct protein profiles compared to exosomes derived from MCF12A normal breast cells. We have also showed that exosomes in the plasma from HER2-positive breast cancer patients exhibit significantly (P ? 0.01) higher level of HER2 and EpCAM than those from healthy donors. Conclusion: We have developed a simple, inexpensive, highly efficient, and portable Raman exosome assay for detection and protein profiling of exosomes. Using the assay and model exosomes from breast cancer cells, we have showed that exosomes exhibit diagnostic surface protein markers, reflecting the protein profile of their donor cells. Through proof-of-concept studies, we have identified HER2 and EpCAM biomarkers on exosomes in plasma from HER2-positive breast cancer patients, suggesting the diagnostic potential of these markers for breast cancer diagnostics. This assay would accelerate exosome research and pave a way to the development of novel cancer liquid biopsy for cancer detection and monitoring.
| S-EPMC5957005 | biostudies-literature
Project description:Surface enhanced Raman scattering (SERS) is a powerful tool for vibrational spectroscopy, providing orders of magnitude increase in chemical sensitivity compared to spontaneous Raman scattering. Yet it remains a challenge to synthesize robust, uniform SERS substrates quickly and easily. Lithographic approaches to produce substrates can achieve high, uniform sensitivity but are expensive and complex, thus difficult to scale. Facile solution-phase chemical approaches often result in unreliable SERS substrates due to heterogeneous arrangement of "hot spots" throughout the material. Here we demonstrate the synthesis and characterization of a homogeneous gold nanofoam (AuNF) substrate produced by a rapid, one-pot, four-ingredient synthetic approach. AuNFs are rapidly nucleated with macroscale porosity and then chemically roughened to produce nanoscale features that confer homogeneous and high signal enhancement (~109) across large areas, a comparable performance to lithographically produced substrates.
| S-EPMC9668102 | biostudies-literature
Project description:We synthesize a high-efficiency substrate for surface-enhanced Raman scattering (SERS) measurements, which is composed of gold nanoparticles (AuNPs) on two-dimensional silicate nanoplatelets acting as an inorganic stabilizer, via the in-situ reduction of hydrogen tetrachloroaurate (III) by sodium citrate in an aqueous solution. Silicate platelets of ~1-nm thickness and various sizes, viz. laponite (50 nm), sodium montmorillonite (Na⁺⁻MMT, 100 nm), and mica (500 nm), are used to stabilize the AuNPs (Au@silicate), which are formed with uniform diameters ranging between 25 and 30 nm as confirmed by transmission electron microscopy (TEM). In particular, the laponite SERS substrate can be used in biological, environmental, and food safety applications to measure small molecules such as DNA (adenine molecule), dye (Direct Blue), and herbicide (paraquat) as it shows high detection sensitivity with a detection limit of 10-9 M for adenine detection. These highly sensitive SERS substrates, with their three-dimensional hot-junctions formed with AuNPs and two-dimensional silicate nanoplatelets, allow the highly efficient detection of organic molecules. Therefore, these Au@silicate nanohybrid substrates have great potential in biosensor technology because of their environmentally-friendly and simple fabrication process, high efficiency, and the possibility of rapid detection.
| S-EPMC6473534 | biostudies-literature
Project description:The [URE3] prion of Saccharomyces cerevisiae is a self-propagating amyloid form of Ure2p. The amino-terminal prion domain of Ure2p is necessary and sufficient for prion formation and has a high glutamine (Q) and asparagine (N) content. Such Q/N-rich domains are found in two other yeast prion proteins, Sup35p and Rnq1p, although none of the many other yeast Q/N-rich domain proteins have yet been found to be prions. To examine the role of amino acid sequence composition in prion formation, we used Ure2p as a model system and generated five Ure2p variants in which the order of the amino acids in the prion domain was randomly shuffled while keeping the amino acid composition and C-terminal domain unchanged. Surprisingly, all five formed prions in vivo, with a range of frequencies and stabilities, and the prion domains of all five readily formed amyloid fibers in vitro. Although it is unclear whether other amyloid-forming proteins would be equally resistant to scrambling, this result demonstrates that [URE3] formation is driven primarily by amino acid composition, largely independent of primary sequence.
| S-EPMC479727 | biostudies-literature
Project description:Mesoporous gold sponges were prepared using 4-dimethylaminopyridine (DMAP)-stabilized Au seeds. This is a general process, which involves a simple template-free method, room temperature reduction of HAuCl4·4H2O with hydroxylamine. The formation process of mesoporous gold sponges could be accounted for the electrostatic interaction (the small Au nanoparticles (~3 nm) and the positively charged DMAP-stabilized Au seeds) and Ostwald ripening process. The mesoporous gold sponges had appeared to undergo electrostatic adsorption initially, sequentially linear aggregation, welding and Ostwald ripening, then, they randomly cross link into self-supporting, three-dimensional networks with time. The mesoporous gold sponges exhibit higher surface area than the literature. In addition, application of the spongelike networks as an active material for surface-enhanced Raman scattering has been investigated by employing 4-aminothiophenol (4-ATP) molecules as a probe.
| S-EPMC4633612 | biostudies-literature
Project description:Recently we have reported electronic pre-resonance stimulated Raman scattering (epr-SRS) microscopy as a powerful technique for super-multiplex imaging ( Wei, L. ; Nature 2017 , 544 , 465 - 470 ). However, under rigorous electronic resonance, background signal, which mainly originates from pump-probe process, overwhelms the desired vibrational signature of the chromophores. Here we demonstrate electronic resonant stimulated Raman scattering (er-SRS) microspectroscopy and imaging through suppression of electronic background and subsequent retrieval of vibrational peaks. We observed a change of the vibrational band shapes from normal Lorentzian, through dispersive shapes, to inverted Lorentzian as the electronic resonance was approached, in agreement with theoretical prediction. In addition, resonant Raman cross sections have been determined after power-dependence study as well as Raman excitation profile calculation. As large as 10-23 cm2 of resonance Raman cross section is estimated in er-SRS, which is about 100 times higher than previously reported in epr-SRS. These results of er-SRS microspectroscopy pave the way for the single-molecule Raman detection and ultrasensitive biological imaging.
| S-EPMC6425473 | biostudies-literature
Project description:A new strategy named integrated plasmon-enhanced Raman scattering (iPERS) spectroscopy that features a configuration of evanescent field excitation and inverted collection is presented, which well unites the local field enhancement and far field emission, couples localized and propagating surface plasmons, integrates the SERS substrates and Raman spectrometers via a self-designed aplanatic solid immersion lens. A metallic nanoparticle-on-a film (NOF) system was adopted in this configuration because it improves the amplification of the incidence light field in near field by 10 orders of magnitude due to the simultaneous excitation of quadrupolar and dipolar resonance modes. This iPERS allows for higher excitation efficiency to probed molecules and full collection of the directional-radiation Raman scattering signal in an inverted way, which exhibits a practical possibility to monitor plasmonic photocatalytic reactions in nanoscale and a bright future on interfacial reaction studies.
| S-EPMC5676962 | biostudies-literature
Project description:Conventional Raman scattering is a workhorse technique for detecting and identifying complex molecular samples. In surface enhanced Raman scattering, a nanorough metallic surface close to the sample enhances the Raman signal enormously. In this work, the surface is on a clear epoxy substrate. The epoxy is cast on a silicon wafer, using 20 nm of gold as a mold release. This single step process already produces useful enhanced Raman signals. However, the Raman signal is further enhanced by (1) depositing additional gold on the epoxy substrate and (2) by using a combination of wet and dry etches to roughen the silicon substrate before casting the epoxy. The advantage of a clear substrate is that the Raman signal may be obtained by passing light through the substrate, with opaque samples simply placed against the surface. Results were obtained with solutions of Rhodamine 6G in deionized water over a range of concentrations from 1 nM to 1 mM. In all cases, the signal to noise ratio was greater than 10:1.
| S-EPMC3829892 | biostudies-other
Project description:Surface-enhanced Raman spectroscopy (SERS) has great potential as an analytical technique for environmental analyses. In this study, we fabricated highly porous gold (Au) supraparticles (i.e., ∼100 μm diameter agglomerates of primary nano-sized particles) and evaluated their applicability as SERS substrates for the sensitive detection of environmental contaminants. Facile supraparticle fabrication was achieved by evaporating a droplet containing an Au and polystyrene (PS) nanoparticle mixture on a superamphiphobic nanofilament substrate. Porous Au supraparticles were obtained through the removal of the PS phase by calcination at 500 °C. The porosity of the Au supraparticles was readily adjusted by varying the volumetric ratios of Au and PS nanoparticles. Six environmental contaminants (malachite green isothiocyanate, rhodamine B, benzenethiol, atrazine, adenine, and gene segment) were successfully adsorbed to the porous Au supraparticles, and their distinct SERS spectra were obtained. The observed linear dependence of the characteristic Raman peak intensity for each environmental contaminant on its aqueous concentration reveals the quantitative SERS detection capability by porous Au supraparticles. The limit of detection (LOD) for the six environmental contaminants ranged from ∼10 nM to ∼10 μM, which depends on analyte affinity to the porous Au supraparticles and analyte intrinsic Raman cross-sections. The porous Au supraparticles enabled multiplex SERS detection and maintained comparable SERS detection sensitivity in wastewater influent. Overall, we envision that the Au supraparticles can potentially serve as practical and sensitive SERS devices for environmental analysis applications.
| S-EPMC9665105 | biostudies-literature