Giant coronary aneurysms: three-dimensional reconstruction.
Ontology highlight
ABSTRACT:
SUBMITTER: van Beek LM
PROVIDER: S-EPMC3247630 | biostudies-literature | 2012 Jan
REPOSITORIES: biostudies-literature
Publications
Giant coronary aneurysms: three-dimensional reconstruction.
Netherlands heart journal : monthly journal of the Netherlands Society of Cardiology and the Netherlands Heart Foundation 20120101 1
A 31 year old man was referred for the evaluation of chest pain. Cardiac CT reconstruction revealed multiple calcified giant coronary aneurysms. Most likely this patient suffered from subclinical Kawasaki's disease in his childhood. ...[more]
Similar Datasets
Project description:Coronary artery aneurysm is defined as any coronary artery dilation exceeding the diameter of normal adjacent segments or the diameter of the largest coronary artery by 1.5 times. Giant coronary aneurysm refers to an aneurysm with a diameter larger than 20 mm. Giant coronary artery aneurysms have an incidence of 0.02%-2%. Here we describe a patient who had giant coronary aneurysms involving all three coronary arteries. He was managed conservatively with no cardiac events on a follow up of 1 year.
| S-EPMC4310952 | biostudies-literature
Project description:Coronary artery aneurysms larger than 5 cm are exceedingly rare, and a standard treatment for them is lacking. We report two cases of giant right coronary artery aneurysms successfully treated by off-pump resection of the aneurysm and bypass grafting. The controversy surrounding the proper management of such cases is discussed.
| S-EPMC4822193 | biostudies-literature
Project description:All giant Kawasaki aneurysms may not regress fully; some may eventually calcify, undergo thrombosis, and get detected in asymptomatic adults at later age. Tomisaku Kawasaki initially described this illness as mucocutaneous lymph node syndrome in childhood in 1967 and coronary arteritis was recognized later. We present a 58-year-old male, possibly one of the oldest surviving patients with giant coronary aneurysms who presented with large secundum atrial septal defect (ASD) with heart failure. This indicates that the disease was perhaps prevalent outside Japan even before the first Kawasaki's description.
| S-EPMC4070209 | biostudies-literature
Project description:PurposeThe purpose of this study was to introduce a method of using three-dimensional (3D) curved-multiplanar reconstruction (MPR) images for sylvian dissection during microsurgical treatment of middle cerebral artery (MCA) aneurysms.Materials and methodsForty-nine patients who had undergone surgery for MCA aneurysms were enrolled. We obtained the 3D curved-MPR images along the sphenoid ridge using OsiriX MD™ imaging software, compared sylvian dissection time according to several 3D MPR image factors, and investigated the correlations between these images and intraoperative findings.ResultsUtilizing preoperative information of the sylvian fissure (SF) and peri-aneurysmal space on 3D curved-MPR images, we could predict the feasibility of sylvian dissection for a safe surgery. 3D curved-MPR images showed several features: first, perpendicular images to the sylvian surface in the same orientation as the surgeon's view; second, simultaneous visualization of the brain cortex, vessels, and cisternal space; and third, more accurate measurement of various parameters, such as depth of the MCA from the sylvian surface and the location and width of the SFs.ConclusionIn addition to conventional image studies, 3D curved-MPR images seem to provide useful information for Sylvian dissection in the microsurgical treatment of MCA aneurysms.
| S-EPMC5122643 | biostudies-literature
Project description:The aim of this study was to investigate the multiscale surface roughness characteristics of coronary arteries, to aid in the development of novel biomaterials and bioinspired medical devices. Porcine left anterior descending coronary arteries were dissected ex vivo, and specimens were chemically fixed and dehydrated for testing. Surface roughness was calculated from three-dimensional reconstructed surface images obtained by optical, scanning electron and atomic force microscopy, ranging in magnification from 10× to 5500×. Circumferential surface roughness decreased with magnification, and microscopy type was found to influence surface roughness values. Longitudinal surface roughness was not affected by magnification or microscopy types within the parameters of this study. This study found that coronary arteries exhibit multiscale characteristics. It also highlights the importance of ensuring consistent microscopy parameters to provide comparable surface roughness values.
| S-EPMC6774942 | biostudies-literature
Project description:The field of three-dimensional electron microscopy began more than 45years ago with a reconstruction of a helical phage tail, and helical polymers continue to be important objects for three-dimensional reconstruction due to the centrality of helical protein and nucleoprotein polymers in all aspects of biology. We are now witnessing a fundamental revolution in this area, made possible by direct electron detectors, which has led to near-atomic resolution for a number of important helical structures. Most importantly, the possibility of achieving such resolution routinely for a vast number of helical samples is within our reach. One of the main problems in helical reconstruction, ambiguities in assigning the helical symmetry, is overcome when one reaches a resolution where secondary structure is clearly visible. However, obstacles still exist due to the intrinsic variability within many helical filaments.
| S-EPMC4543434 | biostudies-literature
Project description:ObjectivePrecise morphologic evaluation is important for intracranial aneurysm (IA) management. At present, clinicians manually measure the IA size and neck diameter on 2-dimensional (2D) digital subtraction angiographic (DSA) images and categorize the IA shape as regular or irregular on 3-dimensional (3D)-DSA images, which could result in inconsistency and bias. We investigated whether a computer-assisted 3D analytical approach could improve IA morphology assessment.MethodsFive neurointerventionists evaluated the size, neck diameter, and shape of 39 IAs using current and computer-assisted 3D approaches. In the computer-assisted 3D approach, the size, neck diameter, and undulation index (UI, a shape irregularity metric) were extracted using semiautomated reconstruction of aneurysm geometry using 3D-DSA, followed by IA neck identification and computerized geometry assessment.ResultsThe size and neck diameter measured using the manual 2D approach were smaller than computer-assisted 3D measurements by 2.01 mm (P < 0.001) and 1.85 mm (P < 0.001), respectively. Applying the definitions of small IAs (<7 mm) and narrow-necked IAs (<4 mm) from the reported data, interrater variation in manual 2D measurements resulted in inconsistent classification of the size of 14 IAs and the necks of 19 IAs. Visual inspection resulted in an inconsistent shape classification for 23 IAs among the raters. Greater consistency was achieved using the computer-assisted 3D approach for size (intraclass correlation coefficient [ICC], 1.00), neck measurements (ICC, 0.96), and shape quantification (UI; ICC, 0.94).ConclusionsComputer-assisted 3D morphology analysis can improve accuracy and consistency in measurements compared with manual 2D measurements. It can also more reliably quantify shape irregularity using the UI. Future application of computer-assisted analysis tools could help clinicians standardize morphology evaluations, leading to more consistent IA evaluations.
| S-EPMC6383522 | biostudies-literature
Project description:IntroductionCoronary artery aneurysm (CAA) is defined as coronary dilatation which exceeds the diameter of the normal adjacent artery segments or the diameter of the patient's largest coronary artery by 1.5 times. The incidence of giant CAA is difficult to be determined, since only few reports have been described in the literature.Methods and resultsA 65-year-old man was referred to our hospital because of a "mass" in the right heart detected on echocardiography at a regular medical health examination, while he experienced no any symptoms. Coronary angiography showed the severe stenosis of the left anterior descending artery (LAD) and the left circumflex artery (LCX) and the diffusely ectatic change of the right coronary artery (RCA), but no mass was found in any of these arteries. Coronary computed tomography angiography (CTA) confirmed that the "mass" was the giant aneurysms of RCA with thrombus. He received coronary artery bypass graft (CABG) with thrombectomy. The histopathology showed the deposits of lipid and hyalin in the tunica intima, the focal calcifications, the very thin tunica media, and the disappearance of the part of the tunica media in the RCA.ConclusionsCoronary artery aneurysm which may contain thrombus can complicate a diagnostic coronary angiography due to the risk of distal embolization and may lead to myocardial infarction. This case report demonstrates 2 RCA aneurysms with a thrombus presenting as a giant "mass" which was successfully treated by CABG with thrombectomy.
| S-EPMC5044915 | biostudies-literature
Project description:BACKGROUND:The combination of multiple giant coronary artery aneurysms (CAAs) and right coronary artery (RCA) to pulmonary artery (PA) fistula is extremely rare and the patients with CAAs may suffer from several fatal complications. We herein describe a 60-year-old female with hemodynamic instability who was diagnosed with multiple giant CAAs combined with RCA-PA fistula. CASE PRESENTATION:The patient, a 60-year-old female, presented to the emergency room because of progressive exertional chest distress and fatigue. The transthoracic echocardiography (TTE), coronary computed tomography angiography (CTA) and invasive coronary angiography confirmed the existence of multiple giant CAAs and RCA-PA fistula. Laboratory examinations for systemic vasculitis and infectious diseases demonstrated no abnormalities and work-up for childhood and family history were negative. We have performed a successful surgical treatment for this patient. The patient's restrictive cardiac dysfunction was improved after debriding the advanced thrombi in aneurysm sac and ligating the fistulous vessel between the native RCA and PA. The postoperative pathologic examination of the aneurysmal wall revealed loss of smooth muscle cells in the media with local mucoid degeneration, no chronic inflammation, sclerosis and IgG4 were observed. CONCLUSIONS:The treatment decision-making process should depend upon the patients' specific situations. Our case suggests the surgical intervention should be accepted as the preferred treatment for giant CAAs with restrictive cardiac dysfunction.
| S-EPMC6612139 | biostudies-literature
Project description:The structural morphology of coronary stents (e.g. stent expansion, lumen scaffolding, strut apposition, tissue protrusion, side branch jailing, strut fracture), and the local hemodynamic environment after stent deployment are key determinants of procedural success and subsequent clinical outcomes. High-resolution intracoronary imaging has the potential to enable the geometrically accurate three-dimensional (3D) reconstruction of coronary stents. The aim of this work was to present a novel algorithm for 3D stent reconstruction of coronary artery stents based on optical coherence tomography (OCT) and angiography, and test experimentally its accuracy, reproducibility, clinical feasibility, and ability to perform computational fluid dynamics (CFD) studies. Our method has the following steps: 3D lumen reconstruction based on OCT and angiography, stent strut segmentation in OCT images, packaging, rotation and straightening of the segmented struts, planar unrolling of the segmented struts, planar stent wireframe reconstruction, rolling back of the planar stent wireframe to the 3D reconstructed lumen, and final stent volume reconstruction. We tested the accuracy and reproducibility of our method in stented patient-specific silicone models using micro-computed tomography (μCT) and stereoscopy as references. The clinical feasibility and CFD studies were performed in clinically stented coronary bifurcations. The experimental and clinical studies showed that our algorithm (1) can reproduce the complex spatial stent configuration with high precision and reproducibility, (2) is feasible in 3D reconstructing stents deployed in bifurcations, and (3) enables CFD studies to assess the local hemodynamic environment within the stent. Notably, the high accuracy of our algorithm was consistent across different stent designs and diameters. Our method coupled with patient-specific CFD studies can lay the ground for optimization of stenting procedures, patient-specific computational stenting simulations, and research and development of new stent scaffolds and stenting techniques.
| S-EPMC8192920 | biostudies-literature