Extra-electron induced covalent strengthening and generalization of intrinsic ductile-to-brittle criterion.
Ontology highlight
ABSTRACT:
SUBMITTER: Niu H
PROVIDER: S-EPMC3466921 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Contrasting deformation mechanisms precede volcanic eruptions and control precursory signals. Density increase and high uplifts consistent with magma intrusion and pressurization are in contrast with dilatant responses and reduced surface uplifts observed before eruptions. We investigate the impact that the rheology of rocks constituting the volcanic edifice has on the deformation mechanisms preceding eruptions. We propose a model for the pressure and temperature dependent brittle-ductile transition through which we build a strength profile of the shallow crust in two idealized volcanic settings (igneous and sedimentary basement). We have performed finite element analyses in coupled thermo-hydro-mechanical conditions to investigate the influence of static diking on the local brittle-ductile transition. Our results show that in active volcanoes: (i) dilatancy is an appropriate indicator for the brittle-ductile transition; (ii) the predicted depth of the brittle-ductile transition agrees with the observed attenuated seismicity; (iii) seismicity associated with diking is likely to be affected by ductile deformation mode caused by the local temperature increase; (iv) if failure occurs within the edifice, it is likely to be brittle-dilatant with strength and stiffness reduction that blocks stress transfers within the volcanic edifice, ultimately damping surface uplifts.
| S-EPMC6333802 | biostudies-literature
Project description:Current understanding of the brittleness of glass is limited by our poor understanding and control over the microscopic structure. In this study, we used a pressure quenching route to tune the structure of silica glass in a controllable manner, and observed a systematic increase in ductility in samples quenched under increasingly higher pressure. The brittle to ductile transition in densified silica glass can be attributed to the critical role of 5-fold Si coordination defects (bonded to 5 O neighbors) in facilitating shear deformation and in dissipating energy by converting back to the 4-fold coordination state during deformation. As an archetypal glass former and one of the most abundant minerals in the Earth's crest, a fundamental understanding of the microscopic structure underpinning the ductility of silica glass will not only pave the way toward rational design of strong glasses, but also advance our knowledge of the geological processes in the Earth's interior.
| S-EPMC4030258 | biostudies-literature
Project description:Within a low-grade ductile shear zone, we investigated exceptionally well exposed brittle faults, which accumulated antithetic slip and rotated into the shearing direction. The foliation planes of the mylonitic host rock intersect the faults approximately at their centre and exhibit ductile reverse drag. Three types of brittle faults can be distinguished: (i) Faults developing on pre-existing K-feldspar/mica veins that are oblique to the shear direction. These faults have triclinic flanking structures. (ii) Wing cracks opening as mode I fractures at the tips of the triclinic flanking structures, perpendicular to the shear direction. These cracks are reactivated as faults with antithetic shear, extend from the parent K-feldspar/mica veins and form a complex linked flanking structure system. (iii) Joints forming perpendicular to the shearing direction are deformed to form monoclinic flanking structures. Triclinic and monoclinic flanking structures record elliptical displacement-distance profiles with steep displacement gradients at the fault tips by ductile flow in the host rocks, resulting in reverse drag of the foliation planes. These structures record one of the greatest maximum displacement/length ratios reported from natural fault structures. These exceptionally high ratios can be explained by localized antithetic displacement along brittle slip surfaces, which did not propagate during their rotation during surrounding ductile flow.
| S-EPMC4689182 | biostudies-literature
Project description:Deformation of all materials necessitates the collective propagation of various microscopic defects. On Earth, fracturing gives way to crystal-plastic deformation with increasing depth resulting in a "brittle-to-ductile" transition (BDT) region that is key for estimating the integrated strength of tectonic plates, constraining the earthquake cycle, and utilizing deep geothermal resources. Here, we show that the crossing of a BDT in marble during deformation experiments in the laboratory is accompanied by systematic increase in the frequency of acoustic emissions suggesting a profound change in the mean size and propagation velocity of the active defects. We further identify dominant classes of emitted waveforms using unsupervised learning methods and show that their relative activity systematically changes as the rocks cross the brittle-ductile transition. As pressure increases, long-period signals are suppressed and short-period signals become dominant. At higher pressures, signals frequently come in avalanche-like patterns. We propose that these classes of waveforms correlate with individual dominant defect types. Complex mixed-mode events indicate that interactions between the defects are common over the whole pressure range, in agreement with postmortem microstructural observations. Our measurements provide unique, real-time data of microscale dynamics over a broad range of pressures (10 to 200 MPa) and can inform micromechanical models for semi-brittle deformation.
| S-EPMC10589702 | biostudies-literature
Project description:Brittle fracture of a covalent material is ultimately governed by the strength of the electronic bonds. Recently, attempts have been made to alter the mechanical properties including fracture strength by excess electron/hole doping. However, the underlying mechanics/mechanism of how these doped electrons/holes interact with the bond and changes its strength is yet to be revealed. Here, we perform first-principles density-functional theory calculations to clarify the effect of excess electrons/holes on the bonding strength of covalent Si. We demonstrate that the bond strength of Si decreases or increases monotonically in correspondence with the doping concentration. Surprisingly, change to the extent of 30-40% at the maximum feasible doping concentration could be observed. Furthermore, we demonstrated that the change in the covalent bond strength is determined by the bonding/antibonding state of the doped excess electrons/holes. In summary, this work explains the electronic strengthening mechanism of covalent Si from a quantum mechanical point of view and provides valuable insights into the electronic-level design of strength in covalent materials.
| S-EPMC10545711 | biostudies-literature
Project description:Earthquakes deep in the continental lithosphere are rare and hard to interpret in our current understanding of temperature control on brittle failure. The recent lithospheric mantle earthquake with a moment magnitude of 4.8 at a depth of ~75 km in the Wyoming Craton was exceptionally well recorded and thus enabled us to probe the cause of these unusual earthquakes. On the basis of complete earthquake energy balance estimates using broadband waveforms and temperature estimates using surface heat flow and shear wave velocities, we argue that this earthquake occurred in response to ductile deformation at temperatures above 750°C. The high stress drop, low rupture velocity, and low radiation efficiency are all consistent with a dissipative mechanism. Our results imply that earthquake nucleation in the lithospheric mantle is not exclusively limited to the brittle regime; weakening mechanisms in the ductile regime can allow earthquakes to initiate and propagate. This finding has significant implications for understanding deep earthquake rupture mechanics and rheology of the continental lithosphere.
| S-EPMC5351985 | biostudies-literature
Project description:The permeability of volcanic rock controls the distribution of pore fluids and pore fluid pressure within a volcanic edifice, and is therefore considered to influence eruptive style and volcano deformation. We measured the porosity and permeability of a porous volcanic rock during deformation in the brittle and ductile regimes. In the brittle regime, permeability decreases by a factor of 2-6 up to the peak stress due the closure of narrow pore throats but, following shear fracture formation, remains approximately constant as strain is accommodated by sliding on the fracture. In the ductile regime, permeability continually decreases, by up to an order of magnitude, as a function of strain. Although compaction in the ductile regime is localized, permeability is not reduced substantially due to the tortuous and diffuse nature of the compaction bands, the geometry of which was also influenced by a pore shape preferred orientation. Although the evolution of the permeability of the studied porous volcanic rock in the brittle and ductile regimes is qualitatively similar to that for porous sedimentary rocks, the porosity sensitivity exponent of permeability in the elastic regime is higher than found previously for porous sedimentary rocks. This exponent decreases during shear-enhanced compaction toward a value theoretically derived for granular media, suggesting that the material is effectively granulating. Indeed, cataclastic pore collapse evolves the microstructure to one that is more granular. Understanding how permeability can evolve in a volcanic edifice will improve the accuracy of models designed to assist volcano monitoring and volcanic hazard mitigation.
| S-EPMC9286468 | biostudies-literature
Project description:We combine an analytically solvable mean-field elasto-plastic model with molecular dynamics simulations of a generic glass former to demonstrate that, depending on their preparation protocol, amorphous materials can yield in two qualitatively distinct ways. We show that well-annealed systems yield in a discontinuous brittle way, as metallic and molecular glasses do. Yielding corresponds in this case to a first-order nonequilibrium phase transition. As the degree of annealing decreases, the first-order character becomes weaker and the transition terminates in a second-order critical point in the universality class of an Ising model in a random field. For even more poorly annealed systems, yielding becomes a smooth crossover, representative of the ductile rheological behavior generically observed in foams, emulsions, and colloidal glasses. Our results show that the variety of yielding behaviors found in amorphous materials does not necessarily result from the diversity of particle interactions or microscopic dynamics but is instead unified by carefully considering the role of the initial stability of the system.
| S-EPMC6042060 | biostudies-literature
Project description:Fe-Al compounds are of interest due to their combination of light weight, high strength, and wear and corrosion resistance, but new forms that are also ductile are needed for their widespread use. The challenge in developing Fe-Al compositions that are both lightweight and ductile lies in the intrinsic tradeoff between Al concentration and brittle-to-ductile transition temperature. Here, we show that a room-temperature, ductile-like response can be attained in a FeAl/FeAl2 layered composite. Transmission electron microscopy, nanomechanical testing, and ab initio calculations find a critical layer thickness on the order of 1 μm, below which the FeAl2 layer homogeneously codeforms with the FeAl layer. The FeAl2 layer undergoes a fundamental change from multimodal, contained slip to unimodal slip that is aligned and fully transmitting across the FeAl/FeAl2 interface. Lightweight Fe-Al alloys with room-temperature, ductile-like responses can inspire new applications in reactor systems and other structural applications for extreme environments.
| S-EPMC7531877 | biostudies-literature
Project description:Aftershock occurrence is characterized by scaling behaviors with quite universal exponents. At the same time, deviations from universality have been proposed as a tool to discriminate aftershocks from foreshocks. Here we show that the change in rheological behavior of the crust, from velocity weakening to velocity strengthening, represents a viable mechanism to explain statistical features of both aftershocks and foreshocks. More precisely, we present a model of the seismic fault described as a velocity weakening elastic layer coupled to a velocity strengthening visco-elastic layer. We show that the statistical properties of aftershocks in instrumental catalogs are recovered at a quantitative level, quite independently of the value of model parameters. We also find that large earthquakes are often anticipated by a preparatory phase characterized by the occurrence of foreshocks. Their magnitude distribution is significantly flatter than the aftershock one, in agreement with recent results for forecasting tools based on foreshocks.
| S-EPMC7295783 | biostudies-literature