Slow earthquakes associated with fault healing on a serpentinized plate interface
Ontology highlight
ABSTRACT:
SUBMITTER: Katayama I
PROVIDER: S-EPMC3646269 | biostudies-literature | 2013 Jan
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:The dynamics of continental subduction is largely controlled by the rheological properties of rocks involved along the subduction channel. Serpentinites have low viscosity at geological strain rates. However, compelling geophysical evidence of a serpentinite channel during continental subduction is still lacking. Here we show that anomalously low shear-wave seismic velocities are found beneath the Western Alps, along the plate interface between the European slab and the overlying Adriatic mantle. We propose that these seismic velocities indicate the stacked remnants of a weak fossilised serpentinite channel, which includes both slivers of abyssal serpentinite formed at the ocean floor and mantle-wedge serpentinite formed by fluid release from the subducting slab. Our results suggest that this serpentinized plate interface may have favoured the subduction of continental crust into the upper mantle and the formation/exhumation of ultra-high pressure metamorphic rocks, providing new constraints to develop the conceptual and quantitative understanding of continental-subduction dynamics.
| S-EPMC7195360 | biostudies-literature
Project description:Repeating earthquakes (REs) rupture the same fault patches at different times allowing temporal variations in the mechanical behavior of specific areas of the fault to be interrogated over the earthquake cycle. We study REs that reveal fault weakening after a large megathrust earthquake in Costa Rica, followed by fault recovery. We find shorter RE recurrence intervals and larger slip areas immediately following the mainshock that both gradually return to pre-earthquake values. RE seismic moments remain nearly constant throughout the earthquake cycle. This implies a balance between fault weakening (reducing slip) and transient embrittlement (increasing rupture area by converting regions from aseismic to seismic slip), induced by the increased loading rate following the mainshock. This interpretation is consistent with positive, negative, and constant moment versus RE recurrence interval trends reported in other studies following large earthquakes and with experimental work showing slip amplitudes and stress drop decrease with loading rate.
| S-EPMC7406380 | biostudies-literature
Project description:Slow earthquakes including tremor and slow-slip events are recent additions to the conventional earthquake family and have a close link to megathrust earthquakes. Slow earthquakes along the Cascadia subduction zone display a diverse behavior at different spatiotemporal scales and an intriguing increase of events frequency with depth. However, what causes such variability, especially the depth-dependent behavior is not well understood. Here we build on a heterogeneous asperities-in-matrix fault model that incorporates differential pore pressure in a rate-and-state friction framework to investigate the underlying processes of the observed episodic tremor and slow-slip (ETS) variability. We find that the variations of effective normal stress (pore pressure) is one important factor in controlling ETS behavior. Our model reproduces the full complexity of ETS patterns and the depth-frequency scaling that agree quantitatively well with observations, suggesting that fault zone heterogeneities can be one viable mechanism to explain a broad spectrum of transient fault behaviors.
| S-EPMC8010077 | biostudies-literature
Project description:Slow earthquakes represent an important conundrum in earthquake physics. While regular earthquakes are catastrophic events with rupture velocities governed by elastic wave speed, the processes that underlie slow fault slip phenomena, including recent discoveries of tremor, slow-slip and low-frequency earthquakes, are less understood. Theoretical models and sparse laboratory observations have provided insights, but the physics of slow fault rupture remain enigmatic. Here we report on laboratory observations that illuminate the mechanics of slow-slip phenomena. We show that a spectrum of slow-slip behaviours arises near the threshold between stable and unstable failure, and is governed by frictional dynamics via the interplay of fault frictional properties, effective normal stress and the elastic stiffness of the surrounding material. This generalizable frictional mechanism may act in concert with other hypothesized processes that damp dynamic ruptures, and is consistent with the broad range of geologic environments where slow earthquakes are observed.
| S-EPMC4821871 | biostudies-other
Project description:Earthquakes are dissipation of energy throughout elastic waves. Canonically is the elastic energy accumulated during the interseismic period. However, in crustal extensional settings, gravity is the main energy source for hangingwall fault collapsing. Gravitational potential is about 100 times larger than the observed magnitude, far more than enough to explain the earthquake. Therefore, normal faults have a different mechanism of energy accumulation and dissipation (graviquakes) with respect to other tectonic settings (strike-slip and contractional), where elastic energy allows motion even against gravity. The bigger the involved volume, the larger is their magnitude. The steeper the normal fault, the larger is the vertical displacement and the larger is the seismic energy released. Normal faults activate preferentially at about 60° but they can be shallower in low friction rocks. In low static friction rocks, the fault may partly creep dissipating gravitational energy without releasing great amount of seismic energy. The maximum volume involved by graviquakes is smaller than the other tectonic settings, being the activated fault at most about three times the hypocentre depth, explaining their higher b-value and the lower magnitude of the largest recorded events. Having different phenomenology, graviquakes show peculiar precursors.
| S-EPMC4501010 | biostudies-other
Project description:Earthquakes occur because faults weaken with increasing slip and slip rate. Thermal pressurization (TP) of trapped pore fluids is deemed to be a widespread coseismic fault weakening mechanism. Yet, due to technical challenges, experimental evidence of TP is limited. Here, by exploiting a novel experimental configuration, we simulate seismic slip pulses (slip rate 2.0 m/s) on dolerite-built faults under pore fluid pressures up to 25 MPa. We measure transient sharp weakening, down to almost zero friction and concurrent with a spike in pore fluid pressure, which interrupts the exponential-decay slip weakening. The interpretation of mechanical and microstructural data plus numerical modeling suggests that wear and local melting processes in experimental faults generate ultra-fine materials to seal the pressurized pore water, causing transient TP spikes. Our work suggests that, with wear-induced sealing, TP may also occur in relatively permeable faults and could be quite common in nature.
| S-EPMC9995344 | biostudies-literature
Project description:Slow earthquakes, like regular earthquakes, result from unstable frictional slip. They produce little slip and can therefore repeat frequently. We assess their predictability using the slip history of the Cascadia subduction between 2007 and 2017, during which slow earthquakes have repeatedly ruptured multiple segments. We characterize the system dynamics using embedding theory and extreme value theory. The analysis reveals a low-dimensional (<5) nonlinear chaotic system rather than a stochastic system. We calculate properties of the underlying attractor like its correlation and instantaneous dimension, instantaneous persistence, and metric entropy. We infer that the system has a predictability horizon of the order of days weeks. For the better resolved segments, the onset of large slip events can be correctly forecasted by high values of the instantaneous dimension. Longer-term deterministic prediction seems intrinsically impossible. Regular earthquakes might similarly be predictable but with a limited predictable horizon of the order of their durations.
| S-EPMC7458452 | biostudies-literature
Project description:Slow earthquakes may trigger failure on neighboring locked faults that are stressed sufficiently to break, and slow slip patterns may evolve before a nearby great earthquake. However, even in the clearest cases such as Cascadia, slow earthquakes and associated tremor have only been observed in intermittent and discrete bursts. By training a convolutional neural network to detect known tremor on a single seismic station in Cascadia, we isolate and identify tremor and slip preceding and following known larger slow events. The deep neural network can be used for the detection of quasi-continuous tremor, providing a proxy that quantifies the slow slip rate. Furthermore, the model trained in Cascadia recognizes tremor in other subduction zones and also along the San Andreas Fault at Parkfield, suggesting a universality of waveform characteristics and source processes, as posited from experiments and theory.
| S-EPMC7375133 | biostudies-literature
Project description:The Guerrero seismic gap is presumed to be a major source of seismic and tsunami hazard along the Mexican subduction zone. Until recently, there were limited observations at the shallow portion of the plate interface offshore Guerrero, so we deployed instruments there to better characterize the extent of the seismogenic zone. Here we report the discovery of episodic shallow tremors and potential slow slip events in Guerrero offshore. Their distribution, together with that of repeating earthquakes, seismicity, residual gravity and bathymetry, suggest that a portion of the shallow plate interface in the gap undergoes stable slip. This mechanical condition may not only explain the long return period of large earthquakes inside the gap, but also reveals why the rupture from past M < 8 earthquakes on adjacent megathrust segments did not propagate into the gap to result in much larger events. However, dynamic rupture effects could drive one of these nearby earthquakes to break through the entire Guerrero seismic gap.
| S-EPMC8239025 | biostudies-literature
Project description:It has been shown that large magnitude earthquakes can remotely trigger other large magnitude earthquakes within three days. Such triggering of high magnitude earthquakes is potentially indicative of fault systems at the end of their seismic cycles. Here a method is developed to examine local earthquake history to determine how susceptible a given area is to remote triggering of high magnitude earthquakes. The method is applied to all plate boundaries. Only 14% of global tectonic boundaries are not susceptible to remote triggering, while 86% show susceptibility to varying degrees. The most highly susceptible locations begin triggering at lower magnitudes, dependent on the type of plate boundary. Varying patterns in susceptibility to remote triggering are observed around individual plates. Finite element modeling of the Cocos Plate reveals normal modes which appear consistent with its spatial patterns of high susceptibility. Many of the natural frequencies of the Cocos Plate are closely associated with the frequencies of free oscillations of the earth and could be induced by large earthquakes. Analysis of the stress tensors generated by the normal modes supports a delayed triggering mechanism involving one-sided negative (compressive) stress normal to the plane of the fault.
| S-EPMC8782900 | biostudies-literature