Acoustic-Friction Networks and the Evolution of Precursor Rupture Fronts in Laboratory Earthquakes
Ontology highlight
ABSTRACT:
SUBMITTER: Ghaffari H
PROVIDER: S-EPMC3647170 | biostudies-literature | 2013 Jan
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Friction plays a key role in how ruptures unzip faults in the Earth's crust and release waves that cause destructive shaking. Yet dynamic friction evolution is one of the biggest uncertainties in earthquake science. Here we report on novel measurements of evolving local friction during spontaneously developing mini-earthquakes in the laboratory, enabled by our ultrahigh speed full-field imaging technique. The technique captures the evolution of displacements, velocities and stresses of dynamic ruptures, whose rupture speed range from sub-Rayleigh to supershear. The observed friction has complex evolution, featuring initial velocity strengthening followed by substantial velocity weakening. Our measurements are consistent with rate-and-state friction formulations supplemented with flash heating but not with widely used slip-weakening friction laws. This study develops a new approach for measuring local evolution of dynamic friction and has important implications for understanding earthquake hazard since laws governing frictional resistance of faults are vital ingredients in physically-based predictive models of the earthquake source.
| S-EPMC5493769 | biostudies-literature
Project description:The HTML version of this Article incorrectly omits Supplementary Movie 1. Supplementary Movie 1 can be found as Supplementary Information associated with this Correction.
| S-EPMC6365550 | biostudies-literature
Project description:Large, destructive earthquakes often propagate along thrust faults including megathrusts. The asymmetric interaction of thrust earthquake ruptures with the free surface leads to sudden variations in fault-normal stress, which affect fault friction. Here, we present full-field experimental measurements of displacements, particle velocities, and stresses that characterize the rupture interaction with the free surface, including the large normal stress reductions. We take advantage of these measurements to investigate the dependence of dynamic friction on transient changes in normal stress, demonstrate that the shear frictional resistance exhibits a significant lag in response to such normal stress variations, and identify a predictive frictional formulation that captures this effect. Properly accounting for this delay is important for simulations of fault slip, ground motion, and associated tsunami excitation.
| S-EPMC7474586 | biostudies-literature
Project description:Characterizing the interaction between fluids and microscopic defects is one of the long-standing challenges in understanding a broad range of cracking processes, in part because they are so difficult to study experimentally. We address this issue by reexamining records of emitted acoustic phonon events during rock mechanics experiments under wet and dry conditions. The frequency spectrum of these events provides direct information regarding the state of the system. Such events are typically subdivided into high frequency (HF) and low frequency (LF) events, whereas intermediate "Hybrid" events, have HF onsets followed by LF ringing. At a larger scale in volcanic terranes, hybrid events are used empirically to predict eruptions, but their ambiguous physical origin limits their diagnostic use. By studying acoustic phonon emissions from individual microcracking events we show that the onset of a secondary instability-related to the transition from HF to LF-occurs during the fast equilibration phase of the system, leading to sudden increase of fluid pressure in the process zone. As a result of this squeezing process, a secondary instability akin to the LF event occurs. This mechanism is consistent with observations of hybrid earthquakes.
| S-EPMC5225436 | biostudies-literature
Project description:The moment evolution of large earthquakes is a subject of fundamental interest to both basic and applied seismology. Specifically, an open problem is when in the rupture process a large earthquake exhibits features dissimilar from those of a lesser magnitude event. The answer to this question is of importance for rapid, reliable estimation of earthquake magnitude, a major priority of earthquake and tsunami early warning systems. Much effort has been made to test whether earthquakes are deterministic, meaning that observations in the first few seconds of rupture can be used to predict the final rupture extent. However, results have been inconclusive, especially for large earthquakes greater than M w 7. Traditional seismic methods struggle to rapidly distinguish the size of large-magnitude events, in particular near the source, even after rupture completion, making them insufficient to resolve the question of predictive rupture behavior. Displacements derived from Global Navigation Satellite System data can accurately estimate magnitude in real time, even for the largest earthquakes. We employ a combination of seismic and geodetic (Global Navigation Satellite System) data to investigate early rupture metrics, to determine whether observational data support deterministic rupture behavior. We find that while the earliest metrics (~5 s of data) are not enough to infer final earthquake magnitude, accurate estimates are possible within the first tens of seconds, prior to rupture completion, suggesting a weak determinism. We discuss the implications for earthquake source physics and rupture evolution and address recommendations for earthquake and tsunami early warning.
| S-EPMC6360447 | biostudies-literature
Project description:Whether earthquakes of different sizes are distinguishable early in their rupture process is a subject of debate. Studies have shown that the frequency content of radiated seismic energy in the first seconds of earthquakes scales with magnitude, implying determinism. Other studies have shown that recordings of ground displacement from small to moderate-sized earthquakes are indistinguishable, implying a universal early rupture process. Regardless of how earthquakes start, events of different sizes must be distinguishable at some point. If that difference occurs before the rupture duration of the smaller event, this implies some level of determinism. We show through analysis of a database of source time functions and near-source displacement records that, after an initiation phase, ruptures of M7 to M9 earthquakes organize into a slip pulse, the kinematic properties of which scale with magnitude. Hence, early in the rupture process-after about 10 s-large and very large earthquakes can be distinguished.
| S-EPMC6541458 | biostudies-literature
Project description:The rupture fronts that mediate the onset of frictional sliding may propagate at speeds below the Rayleigh wave speed or may surpass the shear wave speed and approach the longitudinal wave speed. While the conditions for the transition from sub-Rayleigh to supershear propagation have been studied extensively, little is known about what dictates supershear rupture speeds and how the interplay between the stresses that drive propagation and interface properties that resist motion affects them. By combining laboratory experiments and numerical simulations that reflect natural earthquakes, we find that supershear rupture propagation speeds can be predicted and described by a fracture mechanics-based equation of motion. This equation of motion quantitatively predicts rupture speeds, with the velocity selection dictated by the interface properties and stress. Our results reveal a critical rupture length, analogous to Griffith's length for sub-Rayleigh cracks, below which supershear propagation is impossible. Above this critical length, supershear ruptures can exist, once excited, even for extremely low preexisting stress levels. These results significantly improve our fundamental understanding of what governs the speed of supershear earthquakes, with direct and important implications for interpreting their unique supershear seismic radiation patterns.
| S-EPMC6051736 | biostudies-literature
Project description:Seismicity induced by geo-engineering operations may be hazardous for people, infrastructure and the environment. The crucial information for assessing induced seismic hazards and related risks is knowledge of the time-dependent strength of rocks and the deformation due to fluid injection. Our studies of seismic and injection data from a geothermal field indicate that pressurized injections lead to rock fracturing at stress levels below the rock toughness, i.e., subcritical fracture growth. We provide a relation between the rate of this subcritical fracture growth and the injection rate. Based on this relation, we estimate the maximum subcritical magnitude. We hypothesize that subcritical fracture growth may be controlled by the amount of stress asymmetry, i.e., the relative values of the principal stresses. We discuss the conditions under which the subcritical fracturing regime can transform to a critical state and critical rupture may occur. We present the possibility of using these results in the operational reservoir to manage seismic hazards.
| S-EPMC7055262 | biostudies-literature
Project description:The sliding of a solid object on a solid substrate requires a shear force that is larger than the maximum static friction force. It is commonly believed that the maximum static friction force is proportional to the loading force and does not depend on the apparent contact area. The ratio of the maximum static friction force to the loading force is called the static friction coefficient µM, which is considered to be a constant. Here, we conduct experiments demonstrating that the static friction force of a slider on a substrate follows a novel friction law under certain conditions. The magnitude of µM decreases as the loading force increases or as the apparent contact area decreases. This behavior is caused by the slip of local precursors before the onset of bulk sliding and is consistent with recent theory. The results of this study will develop novel methods for static friction control.
| S-EPMC4159624 | biostudies-literature
Project description:Earthquakes occur in clusters or sequences that arise from complex triggering mechanisms, but direct measurement of the slow subsurface slip responsible for delayed triggering is rarely possible. We investigate the origins of complexity and its relationship to heterogeneity using an experimental fault with two dominant seismic asperities. The fault is composed of quartz powder, a material common to natural faults, sandwiched between 760 mm long polymer blocks that deform the way 10 meters of rock would behave. We observe periodic repeating earthquakes that transition into aperiodic and complex sequences of fast and slow events. Neighboring earthquakes communicate via migrating slow slip, which resembles creep fronts observed in numerical simulations and on tectonic faults. Utilizing both local stress measurements and numerical simulations, we observe that the speed and strength of creep fronts are highly sensitive to fault stress levels left behind by previous earthquakes, and may serve as on-fault stress meters.
| S-EPMC9652330 | biostudies-literature