Contact angle changes induced by immunocomplex formation.
Ontology highlight
ABSTRACT:
SUBMITTER: Kim JH
PROVIDER: S-EPMC3977604 | biostudies-literature | 2014 Mar
REPOSITORIES: biostudies-literature
Publications
Contact angle changes induced by immunocomplex formation.
Kim Jong-Hoon JH Shen Amy Q AQ Lee Kyong-Hoon KH Cangelosi Gerard A GA Chung Jae-Hyun JH
The Analyst 20140301 6
Immunoassays analyzing interactions between antigens and antibodies can be affected by capillary action together with binding affinity. This paper studies contact-angle changes of bacterial suspensions on antibody immobilized surfaces. The capillary action and the dried pattern of the bacterial suspensions are analyzed and correlated with specific- and nonspecific bindings between bacteria and antibodies. ...[more]
Similar Datasets
Project description:UnlabelledRapid HIV-1 spread between CD4 T lymphocytes occurs at retrovirus-induced immune cell contacts called virological synapses (VS). VS are associated with striking T cell polarization and localized virus budding at the site of contact that facilitates cell-cell spread. In addition to this, spatial clustering of organelles, including mitochondria, to the contact zone has been previously shown. However, whether cell-cell contact specifically induces dynamic T cell remodeling during VS formation and what regulates this process remain unclear. Here, we report that contact between an HIV-1-infected T cell and an uninfected target T cell specifically triggers polarization of mitochondria concomitant with recruitment of the major HIV-1 structural protein Gag to the site of cell-cell contact. Using fixed and live-cell imaging, we show that mitochondrial and Gag polarization in HIV-1-infected T cells occurs within minutes of contact with target T cells, requires the formation of stable cell-cell contacts, and is an active, calcium-dependent process. We also find that perturbation of mitochondrial polarization impairs cell-cell spread of HIV-1 at the VS. Taken together, these data suggest that HIV-1-infected T cells are able to sense and respond to contact with susceptible target cells and undergo dynamic cytoplasmic remodeling to create a synaptic environment that supports efficient HIV-1 VS formation between CD4 T lymphocytes.ImportanceHIV-1 remains one of the major global health challenges of modern times. The capacity of HIV-1 to cause disease depends on the virus's ability to spread between immune cells, most notably CD4 T lymphocytes. Cell-cell transmission is the most efficient way of HIV-1 spread and occurs at the virological synapse (VS). The VS forms at the site of contact between an infected cell and an uninfected cell and is characterized by polarized assembly and budding of virions and clustering of cellular organelles, including mitochondria. Here, we show that cell-cell contact induces rapid recruitment of mitochondria to the contact site and that this supports efficient VS formation and consequently cell-cell spread. Additionally, we observed that cell-cell contact induces a mitochondrion-dependent increase in intracellular calcium, indicative of cellular signaling. Taken together, our data suggest that VS formation is a regulated process and thus a potential target to block HIV-1 cell-cell spread.
| S-EPMC4301097 | biostudies-literature
Project description:Static contact angle measurements are one of the most popular methods to analyze the wetting behavior of materials of any kind. Although this method is readily applicable without the need of sophisticated machinery, the results obtained for the very same material may vary strongly. The sensitivity of the measurement against environmental conditions, sample preparation and measurement conduction is a main factor for inconsistent results. Since often no detailed measurement protocols exist alongside published data, contact angle values as well as elaborated wetting studies do not allow for any comparison. This paper therefore aims to discuss possible influences on static contact angle measurements and to experimentally demonstrate the extent of these effects. Sample storage conditions, cleaning procedures, droplet volume, water grade and droplet application as well as the influence of evaporation on the static contact angle are investigated in detail. Especially sample storage led to differences in the contact angle up to 60%. Depending on the wetting state, evaporation can reduce the contact angle by 30-50% within 10 min in dry atmospheres. Therefore, this paper reviews an existing approach for a climate chamber and introduces a new measuring setup based on these results. It allows for the observation of the wetting behavior for several minutes by successfully suppressing evaporation without negatively affecting the surface prior to measurement by exposure to high humidity environments.
| S-EPMC9653445 | biostudies-literature
Project description:Biophysical mechanisms underlying collective cell migration of eukaryotic cells have been studied extensively in recent years. One mechanism that induces cells to correlate their motions is contact inhibition of locomotion, by which cells migrating away from the contact site. Here, we report that tail-following behavior at the contact site, termed contact following locomotion (CFL), can induce a non-trivial collective behavior in migrating cells. We show the emergence of a traveling band showing polar order in a mutant Dictyostelium cell that lacks chemotactic activity. We find that CFL is the cell-cell interaction underlying this phenomenon, enabling a theoretical description of how this traveling band forms. We further show that the polar order phase consists of subpopulations that exhibit characteristic transversal motions with respect to the direction of band propagation. These findings describe a novel mechanism of collective cell migration involving cell-cell interactions capable of inducing traveling band with polar order.
| S-EPMC7213982 | biostudies-literature
Project description:In this work, we investigate the change of contact angle (CA) of a water droplet during evaporation on a Teflon AF1600 surface in the temperature range between 20 and 80 °C under standard laboratory conditions. An almost constant initial CA and a significant increase of the stabilized CA have been observed. The results reveal a temperature-dependent CA change, mainly due to water adsorption on the solid surface. Soaking experiments indicate that besides adsorption, a temperature-independent friction-like force contributes to the pinning of triple-line and therefore to the CA change. We propose an adsorption coverage parameter and a friction-like force to describe the CA change. Furthermore, we describe a reproducible process to produce smooth and homogeneous Teflon AF1600 thin films, minimizing the influence of roughness and local heterogeneity on the CA.
| S-EPMC8812120 | biostudies-literature
Project description:Purpose. We aimed to determine the effect of speed-induced changes in foot contact patterns on the vertical instantaneous loading rate (VILR). We hypothesized that transition runners, i.e. runners that shift towards a mid- (MF) or forefoot contact pattern (FF) when running speed increases, show smaller increases in VILR than non-transition runners, i.e. runners that remain with a rearfoot contact pattern (RF). Methods. Fifty-two male and female runners ran overground at 3.2, 4.1, 5.1 and 6.2 m s-1. Ground reaction forces, lower limb sagittal plane knee and ankle kinematics and plantar pressures were recorded. Multi-level linear regression models were used to assess differences between transition and non-transition runners. Results. Non-transition runners experienced larger speed-induced increases in VILR (48.6 ± 2.6 BW s-1 per m s-1) than transition runners (-1.4 ± 7.6 BW s-1 per m s-1). Transition runners showed higher VILRs and a more flat foot touch down at the same pre-transition speed than non-transition runners. Conclusion. When running speed increases, some runners transition towards more anterior foot contact patterns. This reduces or even eliminates the speed-induced increase in VILR. This result is especially the case for those RF runners who already have relatively high VILRs and flat foot positioning at slower running speeds.
| S-EPMC9524621 | biostudies-literature
Project description:PurposeTo report air pressure-induced corneal deformation and iridocornea contact in eyes with primary angle closure (PAC) during intraocular pressure (IOP) measurement performed using a novel noncontact tonometer.MethodsA single case report.ResultsWe report a patient with bilateral angle closure. One eye had acute PAC and the other had PAC. The latter was evaluated by the movements of the cornea and iris during IOP measurement using a noncontact tonometer. During the examination, the corneal endothelium and the iris came into contact at the mid-peripheral pupillary area in the left eye with PAC during the corneal reaction to an air puff. In contrast, the corneal endothelium in the pupillary area did not come into contact with the iris.ConclusionsAlthough we observed only 1 case and there could be limitations in its interpretation, IOP measurements using a noncontact tonometer may create mechanical stress on the corneal endothelium in eyes with PAC with a very shallow anterior chamber.
| S-EPMC4450920 | biostudies-literature
Project description:Silicon is a widely applied material and the wetting of silicon surface is an important phenomenon. However, contradictions in the literature appear considering the value of the water contact angle (WCA). The purpose of this study is to present a holistic experimental and theoretical approach to the WCA determination. To do this, we checked the chemical composition of the silicon (1,0,0) surface by using the X-ray photoelectron spectroscopy (XPS) method, and next this surface was purified using different cleaning methods. As it was proved that airborne hydrocarbons change a solid wetting properties the WCA values were measured in hydrocarbons atmosphere. Next, molecular dynamics (MD) simulations were performed to determine the mechanism of wetting in this atmosphere and to propose the force field parameters for silica wetting simulation. It is concluded that the best method of surface cleaning is the solvent-reinforced de Gennes method, and the WCA value of silicon covered by SiO2 layer is equal to 20.7° (at room temperature). MD simulation results show that the mechanism of pure silicon wetting is similar to that reported for graphene, and the mechanism of silicon covered by SiO2 layer wetting is similar to this observed recently for a MOF.
| S-EPMC7177545 | biostudies-literature
Project description:The electrostatically assisted wettability enhancement of dielectric solid surfaces, commonly termed as electrowetting-on-dielectric (EWOD), facilitates many microfluidic applications due to simplicity and energy efficiency. The application of a voltage difference between a conductive droplet and an insulated electrode substrate, where the droplet sits, is enough for realizing a considerable contact angle change. The contact angle modification is fast and almost reversible; however it is limited by the well-known saturation phenomenon which sets in at sufficiently high voltages. In this work, we experimentally show and computationally support the effect of elasticity and thickness of the dielectric on the onset of contact angle saturation. We found that the effect of elasticity is important especially for dielectric thickness smaller than 10 μm and becomes negligible for thickness above 20 μm. We attribute our findings on the effect of the dielectric thickness on the electric field, as well as on the induced electric stresses distribution, in the vicinity of the three phase contact line. Electric field and electric stresses distribution are numerically computed and support our findings which are of significant importance for the design of soft materials based microfluidic devices.
| S-EPMC8110038 | biostudies-literature
Project description:Risk assessment of microplastic (MP) pollution requires understanding biodegradation processes and related changes in polymer properties. In the environment, there are two-way interactions between the MP properties and biofilm communities: (i) microorganisms may prefer some surfaces, and (ii) MP surface properties change during the colonization and weathering. In a 2-week experiment, we studied these interactions using three model plastic beads (polyethylene [PE], polypropylene [PP], and polystyrene [PS]) exposed to ambient bacterioplankton assemblage from the Baltic Sea; the control beads were exposed to bacteria-free water. For each polymer, the physicochemical properties (compression, crystallinity, surface chemistry, hydrophobicity, and surface topography) were compared before and after exposure under controlled laboratory conditions. Furthermore, we characterized the bacterial communities on the MP surfaces using 16S rRNA gene sequencing and correlated community diversity to the physicochemical properties of the MP. Significant changes in PE crystallinity, PP stiffness, and PS maximum compression were observed as a result of exposure to bacteria. Moreover, there were significant correlations between bacterial diversity and some physicochemical characteristics (crystallinity, stiffness, and surface roughness). These changes coincided with variation in the relative abundance of unique OTUs, mostly related to the PE samples having significantly higher contribution of Sphingobium, Novosphingobium, and uncultured Planctomycetaceae compared to the other test materials, whereas PP and PS samples had significantly higher abundance of Sphingobacteriales and Alphaproteobacteria, indicating possible involvement of these taxa in the initial biodegradation steps. Our findings demonstrate measurable signs of MP weathering under short-term exposure to environmentally relevant microbial communities at conditions resembling those in the water column. A systematic approach for the characterization of the biodegrading capacity in different systems will improve the risk assessment of plastic litter in aquatic environments.
| S-EPMC7103643 | biostudies-literature
Project description:DNase I footprints of intermolecular DNA triplexes are often accompanied by enhanced cleavage at the 3'-end of the target site at the triplex-duplex junction. We have systematically studied the sequence dependence of this effect by examining oligonucleotide binding to sites flanked by each base in turn. For complexes with a terminal T.AT triplet, the greatest enhancement is seen with ApC, followed by ApG and ApT, with the weakest enhancement at ApA. Similar DNase I enhancements were observed for a triplex with a terminal C+.GC triplet, though with little difference between the different GpN sites. Enhanced reactivity to diethylpyrocarbonate was observed at As that flank the triplex-duplex junction at AAA or AAC but not AAG or AAT. Fluorescence melting experiments demonstrated that the flanking base affected the stability with a 4 °C difference in T m between a flanking C and G. Sequences that produced the strongest enhancement correlated with those having the lower thermal stability. These results are interpreted in terms of oligonucleotide-induced changes in DNA structure and/or flexibility.
| S-EPMC6990630 | biostudies-literature