Acute uterine inversion: a simple modification of hydrostatic method of treatment.
Ontology highlight
ABSTRACT: Background
Hydrostatic method for reducing acute uterine inversion is simple method, if advocated properly.Aim
The aim of this study is to reduce the failures in technique in O'Sullivan's method in acute puerperal uterine inversion hence reducing maternal mortality and morbidity.Subjects and methods
This study was conducted over a f 6 year period s from 2007 to 2013. Women with acute uterine inversion immediately after delivered were included in the study. Repositioning of acute uterine inversion in six patients in emergency was done using trans-urethral resection of prostate set (TURP set), used in endoscopic resection of prostate, and two 3 L saline bags.Results
The repositioning was successful in all requiring no anesthesia.Conclusions
This technique modification is improvisation of hydrostatic pressure with a trans-urethral resection of prostate set (TURP set) and 3 L saline bags and it is simple and effective and will definitely save women's lives; thus, reducing maternal morbidity and mortality.
SUBMITTER: Gupta P
PROVIDER: S-EPMC3991952 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:A facile method for the introduction of various substituents at the C-6 position of guanosine and 2'-deoxyguanosine is reported. In a simple, 1-step transformation, tert-butyldimethylsilyl protected guanosine and 2'-deoxyguanosine were converted to the O(6)-(benzotriazol-1-yl) derivatives via reaction with 1H-benzotriazol-1-yloxy-tris(dimethylamino)phosphonium hexafluorophosphate (BOP) and 1,8-diazabicyclo[5.4.0]undec-7ene (DBU). The easily isolated, stable and storable, O(6)-(benzotriazol-1-yl) guanosine derivatives upon exposure to a range of nucleophiles, under appropriate conditions, led to the C-6 modified 2-amino purine nucleoside analogues in good yields.
| S-EPMC2997774 | biostudies-literature
Project description:A highly stable and magnetized citric acid (CA)-functionalized iron oxide aqueous colloidal solution (Fe3O4@CA) was synthesized by using a simple and rapid method of one-step co-participation via a chemical reaction between Fe3+ and Fe2+ in a NaOH solution at 65 °C, followed by CA addition to functionalize the Fe3O4 surface in 25 min. The NPs were synthesized at lower temperatures and shortened time compared with conventional methods. Surface functionalization is highly suggested because bare Fe3O4 nanoparticles (Fe3O4 NPs) are frequently deficient due to their low stability and hydrophilicity. Hence, 19 nm-sized Fe3O4 NPs coated with CA (Fe3O4@CA) were synthesized, and their microstructure, morphology, and magnetic properties were characterized using X-ray diffraction, transmission electron microscopy, Zeta potential, Fourier transform infrared spectroscopy, and vibrating sample magnetometer. CA successfully modified the Fe3O4 surface to obtain a stabilized (homogeneous and well dispersed) aqueous colloidal solution. The Zeta potential value of the as-prepared Fe3O4@CA increases from - 31 to - 45 mV. These CA-functionalized NPs with high magnetic saturation (54.8 emu/g) show promising biomedical applications.
| S-EPMC7330025 | biostudies-literature
Project description:Introduction:Nonpuerperal uterine inversion (NPUI) is a rare clinical problem with diagnostic and surgical challenges. The objective of our study was to review the literature on NPUI and describe causative pathologies, diagnosis, and different surgical options available for treatment. Materials and Methods:A comprehensive literature review was carried out on MEDLINE and Google Scholar databases to look for NPUI using the term "non-puerperal uterine inversion," and further went through the cross-references of the published articles. Data are published case reports from 1911 to September 2018. Of the 153 published cases, 133 reports had adequate details of surgery for analysis. These reports were analyzed, concerning the clinical presentation, methods of diagnosis, and surgical treatment. Results:Mean age of the women was 46.3 years (standard deviation: 18, N?=?153). Leiomyoma remained the commonest (56.2%) aetiology. While malignancies contributed to 32.02% of cases, 9.2% were idiopathic. High degree of clinical suspicion and identification of unique features on ultrasonography and magnetic resonance imaging enable prompt diagnosis. In cases of uncertainty, laparoscopy or biopsy of the mass was used to confirm the diagnosis. Hysterectomy or repositioning and repair of the uterus are the only treatment options available. The surgical methods implemented were analyzed in three aspects: route of surgical access, method of repositioning, and final surgical procedure undertaken. The majority (48.8%) had only abdominal access, while 27.1% had both abdominal and vaginal access. Haultain procedure was the most useful procedure for reposition (18.0%) of the uterus. The majority (39.7%) required abdominal hysterectomy with or without debulking of the tumour abdominally, while 15.0% had uterine repair after repositioning. We reviewed the different surgical techniques and described and proposed a treatment algorithm. Conclusions:Fibroids were the commonest cause for NPUI. Malignancies accounted for one-third of cases. A combined abdominal and vaginal approach, followed by hysterectomy or repair after repositioning, seems to be better for nonmalignant cases.
| S-EPMC7285247 | biostudies-literature
Project description:Proteins are sensitive to oxidation, and oxidized proteins are excellent substrates for degradation by proteolytic enzymes such as the proteasome and the mitochondrial Lon protease. Protein labeling is required for studies of protein turnover. Unfortunately, most labeling techniques involve (3)H or (14)C methylation, which is expensive, exposes researchers to radioactivity, generates large amounts of radioactive waste, and allows only single-point assays because samples require acid precipitation. Alternative labeling methods have largely proven unsuitable, either because the probe itself is modified by the oxidant(s) being studied or because the alternative labeling techniques are too complex or too costly for routine use. What is needed is a simple, quick, and cheap labeling technique that uses a non-radioactive marker, binds strongly to proteins, is resistant to oxidative modification, and emits a strong signal. We have devised a new reductive method for labeling free carboxyl groups of proteins with the small fluorophore 7-amino-4-methycoumarin (AMC). When bound to target proteins, AMC fluoresces very weakly but when AMC is released by proteinases, proteases, or peptidases, it fluoresces strongly. Thus, without acid precipitation, the proteolysis of any target protein can be studied continuously, in multiwell plates. In direct comparisons, (3)H-labeled proteins and AMC-labeled proteins exhibited essentially identical degradation patterns during incubation with trypsin, cell extracts, and purified proteasome. AMC-labeled proteins are well suited to studying increased proteolytic susceptibility after protein modification, because the AMC-protein bond is resistant to oxidizing agents such as hydrogen peroxide and peroxynitrite and is stable over time and to extremes of pH, temperature (even boiling), freeze-thaw, mercaptoethanol, and methanol.
| S-EPMC4212338 | biostudies-literature
Project description:In this paper, we report a one-step method to obtain conductive polypyrrole thin films on flexible substrates. To do this, substrates were modified through allylamine plasma grafting to create a high amount of reactive amine groups on PDMS surface. These groups are used during polypyrrole particle synthesis as anchoring points to immobilize the polymeric chains on the substrate during polymerization. Surface morphology of polypyrrole thin films are modified, tailoring the polyelectrolyte used in the polypyrrole synthesis obtaining different shapes of nanoparticles that conform to the film. Depending on the polyelectrolyte molecular weight, the shape of polypyrrole particles go from globular (500 nm diameter) to a more constructed and elongated shape. The films obtained with this methodology reflected great stability under simple bending as well as good conductivity values (between 2.2 ± 0.7 S/m to 5.6 ± 0.2 S/cm).
| S-EPMC6960888 | biostudies-literature
Project description:Despite being rich in starch, over half of acorn production is undervalued. High hydrostatic pressure was used to modify the properties of Q. pyrenaica (0.1 and 460 MPa for 20 min) and Q. robur (0.1 and 333 MPa for 17.4 min) acorn starches to obtain high-valued ingredients. Pressure significantly altered the span distribution and heterogeneity of the acorn starch granules depending on the species, but their morphology was unaffected. Pressurization increased the amylose/amylopectin ratio and damaged starch contents, but the effect was more prominent in Q. pyrenaica than in Q. robur. However, the polymorphism, relative crystallinity, gelatinization temperatures, and enthalpies were preserved. The pressure effect on the starch properties depended on the property and species. The solubility, swelling power, and acorn gels' resistance towards deformation for both species decreased after pressurization. For Q. pyrenaica starch, the in vitro digestibility increased, but the pseudoplastic behavior decreased after pressurization. No differences were seen for Q. robur. Regarding the commercial starch, acorn starches had lower gelatinization temperatures and enthalpies, lower in vitro digestibility, lower resistance towards deformation, superior pseudoplastic behavior, and overall higher solubility and swelling power until 80 °C. This encourages the usage of acorn starches as a new food ingredient.
| S-EPMC10529620 | biostudies-literature
Project description:Oxygenic photogranules (OPGs) are dense, three-dimensional aggregates containing a syntrophic, light-driven microbial community. Their temporal and spatial development interests microbial ecologists working at the bioprocess engineering interface, as this knowledge can be used to optimize biotechnological applications, such as wastewater treatment and biomass valorization. The method presented here enables the high-throughput quantification of photogranulation. OPGs are produced from a loose sludge-like microbial matrix in hydrostatic batch cultures exposed to light. This matrix transforms into a consolidated, roughly spherical aggregate over time. Photogranulation is quantified by time-lapse imaging coupled to automated image analysis. This allows studying the development of many OPGs simultaneously and in a fully automated way to systematically test what factors drive photogranulation. The protocol can also be used to quantify other types of (a)biotic aggregation.
| S-EPMC7842665 | biostudies-literature
Project description:Uterine regeneration using decellularization scaffolds provides a novel treatment for uterine factor infertility. Decellularized scaffolds require maximal removal of cellular components and minimal damage to the extracellular matrix (ECM). Among many decellularization methods, the hydrostatic pressure (HP) method stands out due to its low cytotoxicity and superior ECM preservation compared to the traditional detergent methods. Conventionally, 980 MPa was utilized in HP decellularization, including the first successful implementation of uterine decellularization previously reported by our team. However, structural protein denaturation caused by exceeding pressure led to a limited regeneration outcome in our previous research. This factor urged the study on the effects of pressure conditions in HP methods on decellularized scaffolds. The authors, therefore, fabricated a decellularized uterine scaffold at varying pressure conditions and evaluated the scaffold qualities from the perspective of cell removal and ECM preservation. The results show that by using lower decellularization pressure conditions of 250 MPa, uterine tissue can be decellularized with more preserved structural protein and mechanical properties, which is considered to be promising for decellularized uterine scaffold fabrication applications.
| S-EPMC10376797 | biostudies-literature
Project description:Polydimethylsiloxane (PDMS) is a dominant material in the fabrication of microfluidic devices to generate water-in-oil droplets, particularly lipid-stabilized droplets, because of its highly hydrophobic nature. However, its key property of hydrophobicity has hindered its use in the microfluidic generation of oil-in-water droplets, which requires channels to have hydrophilic surface properties. In this article, we developed, optimized, and characterized a method to produce PDMS with a hydrophilic surface via the deposition of polyvinyl alcohol following plasma treatment and demonstrated its suitability for droplet generation. The proposed method is simple, quick, effective, and low cost and is versatile with respect to surfactants, with droplets being successfully generated using both anionic surfactants and more biologically relevant phospholipids. This method also allows the device to be selectively patterned with both hydrophilic and hydrophobic regions, leading to the generation of double emulsions and inverted double emulsions.
| S-EPMC6444978 | biostudies-literature
Project description:BACKGROUND:The presence of urinary fistula after ileal conduit urinary diversion is a challenging complication, and this study investigated the role of the intra-conduit negative pressure system (NPS) in the presence of urinary fistula following ileal conduit (IC) urinary diversion as a conservative treatment. METHODS:Using the intra-conduit NPS, a minor drainage tube was placed within a silicon tube to suck urine from the conduit with consistent negative pressure. Patients with urinary fistula following IC from August 2012 to July 2017 were recorded, and the clinical characteristics and outcome were retrospectively analyzed. RESULTS:The intra-conduit NPS was used as a primarily conservative treatment for 13 patients who suffered from urinary fistula and presented with a large amount of abdominal/pelvic drainage without other significant morbidities. The median age was 60?years old (42-74?years), and 7patients were male. The median duration between the IC operation and the presence of urinary fistula was 15?days (2-28?days), and elevated creatinine levels were detected in the abdominal/pelvic drainage with a median level of 2114??mol/L (636-388??mol/L). A significant decrease in abdominal/pelvic drainage was identified in 12 patients. The median time that the NPS was used was 9?days (7-11?days). The other patient did not show any improvements after 2?days of observation and then underwent open surgery. With ureteral stenting, 2 abdominal drainage tubes and the intra-conduit NPS were placed during operation, no urine leakage was observed in the abdominal/pelvic field, and the patient was cured in 9?days. With a median follow-up of 22?months, no fistula recurrence or hydronephrosis was detected. CONCLUSION:The intra-conduit negative pressure system is a feasible and promising way to cure urinary fistula following ileal conduit urinary diversion. Because this procedure is a mini-invasive and simple approach, it might represent an alternative in selected patients.
| S-EPMC6905099 | biostudies-literature