Unknown

Dataset Information

0

Chipping fracture resistance of denture tooth materials.


ABSTRACT: OBJECTIVE:The applicability of the edge chipping method to denture tooth materials was assessed. These are softer materials than those usually tested by edge chipping. The edge chipping fracture resistances of polymethylmethacrylate (PMMA) based and two filled resin composite denture tooth materials were compared. METHODS:An edge chipping machine was used to chip rectangular blocks and flattened anterior denture teeth. Force versus edge distance data were collected over a broad range of forces and distances. Between 20 and 65 chips were made per condition depending upon the material, the scatter, and the indenter type. Different indenter types were used including Rockwell C, sharp conical 120(o), Knoop, and Vickers. The edge toughness, Te, was evaluated for different indenter types. RESULTS:The edge chipping data collected on the blocks matched the data collected from flattened teeth. High scatter, particularly at large distances and loads, meant that many tests (up to 64) were necessary to compare the denture tooth materials and to ascertain the appropriate data trends. A linear force-distance trend analysis was adequate for comparing these materials. A power law trend might be more appropriate, but the large scatter obscured the definitive determination of the precise trend. Different indenters produce different linear trends, with the ranking of: sharp conical 120(o), Rockwell C, and Knoop, from lowest to highest edge toughness. Vickers indenter data were extremely scattered and a sensible trend could not be obtained. Edge toughness was inversely correlated to hardness. SIGNIFICANCE:Edge chipping data collected either from simple laboratory scale test blocks or from actual denture teeth may be used to evaluate denture materials. The edge chipping method's applicability has been extended to another class of restorative materials.

SUBMITTER: Quinn GD 

PROVIDER: S-EPMC4084649 | biostudies-literature | 2014 May

REPOSITORIES: biostudies-literature

altmetric image

Publications

Chipping fracture resistance of denture tooth materials.

Quinn G D GD   Giuseppetti A A AA   Hoffman K H KH  

Dental materials : official publication of the Academy of Dental Materials 20140325 5


<h4>Objective</h4>The applicability of the edge chipping method to denture tooth materials was assessed. These are softer materials than those usually tested by edge chipping. The edge chipping fracture resistances of polymethylmethacrylate (PMMA) based and two filled resin composite denture tooth materials were compared.<h4>Methods</h4>An edge chipping machine was used to chip rectangular blocks and flattened anterior denture teeth. Force versus edge distance data were collected over a broad ra  ...[more]

Similar Datasets

| S-EPMC4100685 | biostudies-literature
| S-EPMC6005551 | biostudies-literature
| S-EPMC5456172 | biostudies-other
| S-EPMC8063872 | biostudies-literature
| S-EPMC6759352 | biostudies-literature
| S-EPMC5397414 | biostudies-literature
| S-EPMC2288763 | biostudies-literature