Fungus-mediated preferential bioleaching of waste material such as fly - ash as a means of producing extracellular, protein capped, fluorescent and water soluble silica nanoparticles.
Ontology highlight
ABSTRACT:
SUBMITTER: Khan SA
PROVIDER: S-EPMC4171486 | biostudies-literature | 2014
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:This study examines the bioleaching of municipal solid waste incineration fly ash by Aspergillus niger, and its effect on the fungal morphology, the fate of the ash particles, and the precipitation of metallic salt crystals during bioleaching. The fungal morphology was significantly affected during one-step and two-step bioleaching; scanning electron microscopy revealed that bioleaching caused distortion of the fungal hyphae (with up to 10 μm hyphae diameter) and a swollen pellet structure. In the absence of the fly ash, the fungi showed a linear structure (with 2-4 μm hyphae diameter). Energy-dispersive X-ray spectroscopy and X-ray diffraction confirmed the precipitation of calcium oxalate hydrate crystals at the surface of hyphae in both one-step and two-step bioleaching. Calcium oxalate precipitation affects bioleaching via the weakening of the fly ash, thus facilitating the release of other tightly bound metals in the matrix.
| S-EPMC5466095 | biostudies-literature
Project description:In this study, an alkaline activator was synthesized by dissolving waste glass powder (WGP) in NaOH-4M solution to explore its effects on the formation of alkali-activated material (AAM) generated by Class-C fly ash (FA) and ground granulated blast furnace slag (GGBS). The compressive strength, flexure strength, porosity and water absorption were measured, and X-ray diffraction (XRD) and scanning electron microscopy with energy dispersive X-ray (SEM-EDX) were used to study the crystalline phases, hydration mechanism and microstructure of the resulting composites. Results indicated that the composition of alkali solutions and the ratios of FA/GGBS were significant in enhancing the properties of the obtained AAM. As the amount of dissolved WGP increased in alkaline solution, the silicon concentration increased, causing the accelerated reactivity of FA/GGBS to develop Ca-based hydrate gel as the main reaction product in the system, thereby increasing the strength and lowering the porosity. Further increase in WGP dissolution led to strength loss and increased porosity, which were believed to be due to the excessive water demand of FA/GGBS composites to achieve optimum mixing consistency. Increasing the GGBS proportion in a composite appeared to improve the strength and lower the porosity owing to the reactivity of GGBS being higher than that of FA, which contributed to develop C-S-H-type hydration.
| S-EPMC7503637 | biostudies-literature
Project description:Methane is a greenhouse gas and significantly contributes to global warming. Methane biofiltration with immobilized methane-oxidizing bacteria (MOB) is an efficient and eco-friendly approach for methane elimination. To achieve high methane elimination capacity (EC), it is necessary to use an exceptional support material to immobilize MOB. The MOB consortium was inoculated in biofilters to continuusly eliminate 1% (v/v) of methane. Results showed that the immobilized MOB cells outperformed than the suspended MOB cells. The biofilter packed with fly ash ceramsite (FAC) held the highest average methane EC of 4.628 g h-1 m-3, which was 33.4% higher than that of the biofilter with the suspended MOB cells. The qPCR revealed that FAC surface presented the highest pmoA gene abundance, which inferred that FAC surface immobilized the most MOB biomass. The XPS and contact angle measurement indicated that the desirable surface elemental composition and stronger surface hydrophilicity of FAC might favor MOB immobilization and accordingly improve methane elimination.
| S-EPMC7188830 | biostudies-literature
Project description:A highly efficient and low-cost alumina-silica nano-sorbent was fabricated and characterized to understand the key factors responsible for its superiority over the existing adsorbents in treating the industry-discharged wastewater for the removal of dyes and heavy metals. As compared to the properties of raw fly ash, the following fundamental improvements were observed for the alumina-silica nano-sorbent: (a) transformation of throttled mesopores into slit-type pores, (b) increment in the surface area by 65-fold, (c) change in the morphology from spherical particles to a flake-type structure with sharp edges, (d) reduction in the average crystal size from 61.143 to 27.176 nm, and (e) increase in the pore volume from 0.005 to 0.50 cm3 g-1. These desired properties of the nano-sorbent were obtained by blending a waste aluminium foil with fly ash. This process increased the ratio of alumina to silica from 0.59 : 1 to an optimum ratio of 1.9 : 1, beyond which the particles agglomerated and the pore volume reduced. Eventually, the precipitated hydroxides were calcined at 700 °C that favoured the formation of γ-alumina. Moreover, this heat treatment changed its crystallinity and morphology of γ-alumina, which abruptly enhanced its activity towards the pollutants. The obtained product (nano-sorbent) was tested for the removal of lead and malachite green from a model wastewater solution over a wide range of initial pollutant concentrations and adsorbent dosages. After observing almost complete removal capacity and reusability for the pollutants, we propose this synthesized adsorbent as a universal material for treating industrial wastewater.
| S-EPMC9052400 | biostudies-literature
Project description:Silica nanoparticles (SiO2NPs) from renewable sources can be used in very different materials, such as paints, membranes for fuel cells, Li-ion batteries, adsorbents, catalysts, and so on. Brazil is the world's largest producer of sugarcane and generates huge amounts of sugarcane waste ash (SWA), which is a Si-rich source. This study investigates a method to produce highly pure SiO2NPs from SWA. The SiO2NPs were characterized by inductively coupled plasma optical emission spectroscopy, scanning and transmission electron microscopy (TEM), X-ray diffraction analyses, specific surface area and pore distribution, UV and Fourier transform infrared spectroscopy, and thermogravimetric analyses and applied as an adsorbent material in the removal of acid orange 8 (AO8) dye from aqueous solution. The SiO2 content was 88.68 and 99.08 wt % for SWA and SiO2NPs, respectively. TEM images of SWA and SiO2NPs exhibit drastic alterations of the material size ranging from several micrometers to less than 20 nm. The SiO2NPs showed a specific surface area of 131 m2 g-1 and adsorption capacity of around 230 mg g-1 for acid orange 8 dye. Furthermore, the recycling of the SiO2NPs adsorbent after AO8 adsorption was very satisfactory, with reuse for up to five cycles being possible. The results indicate that it was possible to obtain highly pure silica in a nanosize from the waste material and produce an adsorbent with high adsorption capacity and the possibility of reuse.
| S-EPMC6044884 | biostudies-literature
Project description:Securing water in the soil through suitable amendments is one of the methods for drought management in arid regions. In this study, a poor water sorbing fly ash was transformed into a high water-absorbing material for improving soil water retention during the drought period. The fly ash water absorbent (FAWA) exhibited high water-absorbing capacity (WAC) of 310 g/g at par with commercially available superabsorbent hydrogel (SAH). The FAWA showed excellent re-swelling behavior for more than eight alternate wetting-drying cycles. The WAC of FAWA was sensitive to salt type, pH, and ionic strength of the solution. At maximum salinity level permitted for plant growth, the WAC of FAWA was 80 g/g indicating its suitability for drought management. There was only a marginal WAC variation in the range of pH (5.5-7.5) considered most suitable for plant growth. The drying characteristics of FAWA amended soil exhibited an increase in desaturation time by 3.3, 2.2, and 1.5 times for fine sand, silt loam, and clay loam, respectively. The study demonstrates the success of using a low rate of FAWA for drought management with the advantage of offering a non-toxic and eco-friendly solution to mass utilization of industrial solid waste for agricultural applications.
| S-EPMC7596501 | biostudies-literature
Project description:Electrolytic manganese residue (EMR) is a solid waste with a main mineralogical composition of gypsum. It is generated in the production of metal manganese by the electrolysis process. In this research, EMR, fly ash, and clinker were blended to make fly ash-based cementitious material (FAC) to investigate the effect of EMR on strength properties, hydration behavior, microstructure, and environmental performance of FAC. XRD, TG, and SEM studied the hydration behavior of FAC. The pore structure and [SiO4] polymerization degree were characterized by MIP and 29Si NMR, respectively. The experimental results indicate that FAC shows excellent mechanical properties when the EMR dosage is 10%. Moderate content of sulfate provided by EMR can promote hydration reaction of FAC, and it shows a denser pore structure and higher [SiO4] polymerization degree in this case. Heavy metal ions derived from EMR can be adsorbed in the hydration products of FAC to obtain better environmental properties. This paper presents an AFt covering model for the case of excessive EMR in FAC, and it importantly provides theoretical support for the recycling of EMR in cementitious materials.
| S-EPMC8621800 | biostudies-literature
Project description:Municipal solid waste incineration (MSWI) fly ash has a high concentration of heavy metals (HMs) which are hazardous to the environment. Moreover, it has high pH and buffering capacity which hinders the removal of HMs. Another constraining factor is the considerable fraction of HMs which exist in oxidizable and reducible states. The acid pretreatment of MSWI fly ash is a key solution to this problem. Therefore, the current experiment is carried out to evaluate the effect of acid pretreatment of MSWI fly ash and reaction/proposed time on the removal efficiency of HMs through an electrokinetic experiment. The leaching experiment results show that acid pretreatment has increased the desorption/release of heavy metal ions (Pb2+, Cd2+, Cu2+ and Zn2+). It enhances the migration of HM ions in electrolytic cells which get precipitated at the cathode, thereby increasing the removal efficiency of HMs in the electrokinetic experiment. Moreover, it is found that prolonged proposed time (12 d) has significant effect on the removal efficiency of HMs. Finally, it is concluded that acid pretreatment and prolonged proposed time have enhanced the removal electrokinetic remediation of HMs which is carried out via three processes, i.e. desorption (enhanced by acidification), migration and precipitation.
| S-EPMC6124067 | biostudies-literature
Project description:Production of a high value zeolite from fly ash has been shown to be an avenue for the utilization of South African fly ash which presently constitutes a huge disposal problem. The synthesis of zeolites Na-P1 and analcime on a micro-scale has been successful and preliminary investigation shows that scale-up synthesis is promising. However, the post-synthesis supernatant waste generated contains high levels of NaOH that may constitute a secondary disposal problem. A waste minimization protocol was developed to reduce the volume of waste generated with a view to enhancing the feasibility of the scale synthesis. Series of experiments were conducted in 100 mL jacketed batch reactors. Fly ash was reacted with 5 Mol NaOH on a 1:1 mass basis during the aging step, followed by hydrothermal treatment in which ultrapure water was added to the slurry. This study shows that by re-introducing the supernatant waste into the experiments in such a way that it supplies the required reagent (NaOH) for the zeolite synthesis, zeolite Na-P1 and analcime can be synthesized. It also shows that the synthesis process can be altered to allow up to 100% re-use of the supernatant waste to yield high value zeolitic products. This study effectively constructed two protocols for the minimization of waste generated during the synthesis of zeolites from South African coal fly ash. This result could be used to establish a basis for legal and environmental aspects involved in the commission of a full-scale plant synthesizing zeolites NaP1 and analcime.
| S-EPMC5452509 | biostudies-other
Project description:Scaling up the synthesis of fluorescent silica nanoparticles to meet the current demand in diverse applications involves technological limitations. The present study relates to the hydrothermal synthesis of water-soluble, crystalline, blue-emitting amine-functionalized silica nanoparticles from coal fly ash sustainably and economically. This study used tertiary amine (trimethylamine) to prepare amine-functionalized fluorescent silica nanoparticles, enhancing fluorescence quantum yield and nitrogen content for nanofertilizer application. The TEM and FESEM studies show that the silica nanoparticles have a spherical morphology with an average diameter of 4.0 nm. The x-ray photoelectron and Fourier transform infrared spectroscopy studies reveal the presence of the amine group at the surface of silica nanoparticles. The silica nanoparticles exhibit blue fluorescence with an emission maximum of 454 nm at 370 nm excitation and show excitation-dependent emission properties in the aqueous medium. With the perfect spectral overlap between silica nanoparticle emission (donor) and chlorophyll absorption (acceptor), fluorescent silica nanoparticles enhance plant photosynthesis rate by resonance energy transfer. This process accelerates the photosynthesis rate to improve the individual plant's quality and growth. These findings suggested that the fly ash-derived functionalized silica nanoparticles could be employed as nanofertilizers and novel delivery agents.
| S-EPMC10847091 | biostudies-literature