Dataset Information

Development of a new cucumber reference material for pesticide residue analysis: feasibility study for material processing, homogeneity and stability assessment.

ABSTRACT: The feasibility of the production of a reference material for pesticide residue analysis in a cucumber matrix was investigated. Cucumber was spiked at 0.075 mg/kg with each of the 15 selected pesticides (acetamiprid, azoxystrobin, carbendazim, chlorpyrifos, cypermethrin, diazinon, (α + β)-endosulfan, fenitrothion, imazalil, imidacloprid, iprodione, malathion, methomyl, tebuconazole and thiabendazole) respectively. Three different strategies were considered for processing the material, based on the physicochemical properties of the vegetable and the target pesticides. As a result, a frozen spiked slurry of fresh cucumber, a spiked freeze-dried cucumber powder and a freeze-dried cucumber powder spiked by spraying the powder were studied. The effects of processing and aspects related to the reconstitution of the material were evaluated by monitoring the pesticide levels in the three materials. Two separate analytical methods based on LC-MS/MS and GC-MS/MS were developed and validated in-house. The spiked freeze-dried cucumber powder was selected as the most feasible material and more exhaustive studies on homogeneity and stability of the pesticide residues in the matrix were carried out. The results suggested that the between-unit homogeneity was satisfactory with a sample intake of dried material as low as 0.1 g. A 9-week isochronous stability study was undertaken at -20 °C, 4 °C and 18 °C, with -70 °C designated as the reference temperature. The pesticides tested exhibited adequate stability at -20 °C during the 9-week period as well as at -70 °C for a period of 18 months. These results constitute a good basis for the development of a new candidate reference material for selected pesticides in a cucumber matrix.

SUBMITTER: Grimalt S

PROVIDER: S-EPMC4383829 | biostudies-literature |

REPOSITORIES: biostudies-literature

ACCESS DATA

Similar Datasets

Project description:Validation of analytical methods for measurements of microplastics (MP) is severely hampered because of a general lack of reference materials, RM. There is a great need to develop such reference materials. This study presents a concept of three-component kit with immobilised MP in solid NaCl, a surfactant and clean water that can be applied for the production of many types of MP RMs. As proof of concept, an RM for polyethylene terephthalate (PET) particles in water was prepared and evaluated for its homogeneity. The particles ranged from 30 μm (Feretmin) to about 200 μm adapted by wet sieving. A specific number of PET particles were immobilized in about 0.29 g of solid NaCl by freeze-drying 1 mL of a NaCl suspension. By using manual and automated counting, twenty reconstituted 1-L water samples were evaluated for homogeneity with respect to number of PET particles from 30 μm to > 200 μm/L of water. The number of particles was 730 ± 120 (mean ± one standard deviation (SD); n = 10) and 865 ± 155 particles (n = 10) obtained by optical microscopy in two independent laboratories. This corresponded to relative SDs of 16.4 and 17.9% and a mean of 797 ± 151 particles (18.9% RSD, for n = 20). Homogeneity studies of the NaCl carrier without reconstitution resulted in 794 ± 60 particles (7.5% RSD). The homogeneity of PET in the salt carrier was also evaluated directly with respect to mass of PET per vial using an ultra-micro balance. An average mass of 293 ± 41 μg of PET was obtained (14, % RSD for n = 14). Micrographs were recorded to demonstrate the absence of major sources of contamination of the RM components. Information about the particle size distribution and particle shapes was obtained by laser diffraction (LD) and dynamic image analysis (DIA). In addition, the identity of the PET polymer was confirmed by Raman and FT-IR spectroscopy. The RM was developed for a large-scale inter-laboratory comparison of PET particles in water (ILC). Based on the homogeneity results, the material was found to be sufficiently homogeneous to be of meaningful use in the ILC. In a 3-day process, more than 500 samples of PET particles in the NaCl carrier were prepared with good potential for further upscaling with respect to the number of vials or with other kinds of polymers. The stability of PET was not evaluated but it was deemed to be stable for the duration of the ILC.

Project description:Recent advances in mass spectrometric (MS) instruments resulting in high mass resolution and high duty cycles have allowed of very deep coverage of proteomes. However, even with state of the art, high duty cycle instruments, the number of proteins identified with a conventional single liquid chromatography-tandem MS (LC/MS/MS) analysis is typically limited and fractionating protein samples prior to LC/MS/MS analysis is crucial for increasing both the analytical dynamic range and proteome coverage. In order to achieve near comprehensive identification of proteomes two-dimensional (2D) chromatography has been an invaluable tool. This first dimension is typically performed with µL/min flow and relatively large column inner diameters, which allow efficient pre-fractionation but typically require peptide amounts in the milligram range while the second dimension is typically performed with nL/min flow rates and capillary columns with small inner diameters. Typically, reverse phase liquid chromatography (RPLC) provides high peak resolution of peptides and achieves higher peak capacities than strong cation exchange chromatography (SCX) due to the faster chromatographic partitioning. Another advantage of RPLC is that the mobile phases used generate much cleaner samples for downstream analyses, while the incorporation of a desalting step for SCX in order to eliminated the high salt concentrations that can significantly decrease the analytical sensitivity of the MS analysis due to ionization problems. When operated at widely different pH values (e.g., 1st dimension pH 10 and 2nd dimension pH 3) 2D RPLC-RPLC provides separation orthogonality comparable to that of the combination of SCX-RPLC. The difference of separation selectivity between the low and high pH (HpH) RPLC comes from the changes in the charge distribution within peptide chains upon altering pH of the eluent. Herein we describe a method in which tryptic peptides are separated in the first dimension by HpH-RPLC and fractions are collected every 90 s over an 80 min gradient. For the second dimension, each of these fractions is individually run by the standard low pH RPLC method. The implementation of the HpH pre-fractionation allows for short second dimension gradients for bottom up LC/MS/MS and yields very deep (e.g. thousands of identifications) protein coverage at reasonable measurement time.

Dataset Information

Development of a new cucumber reference material for pesticide residue analysis: feasibility study for material processing, homogeneity and stability assessment.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets