Layered gadolinium hydroxides for low-temperature magnetic cooling.
Ontology highlight
ABSTRACT:
SUBMITTER: Abellan G
PROVIDER: S-EPMC4720933 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:This paper describes the wet-chemistry synthesis of highly crystalline hexagonal flakes of Ni-Fe layered double hydroxide (LDH) produced at temperature as low as 100 °C. The flakes with diameter in the range of 0.5-1.5 μm and the thickness between 15 and 20 nm were obtained by homogeneous precipitation method with the use of triethanolamine (TEA) and urea. By analyzing the intermediate products, it is suggested that, differently from previous reports, a thermodynamically metastable iron oxyhydroxide and Ni-TEA complex are firstly formed at room temperature. Subsequently, when the mixture is heated to 100 °C and the pH increases due to the thermal decomposition of urea, Ni2+ and Fe3+ are slowly released and then recombine, thus leading to formation of pure, highly-crystalline Ni-Fe LDH flakes. This material showed promising results as an electrocatalyst in oxygen evolution reaction (OER) providing an overpotential value of 0.36 V.
| S-EPMC5843585 | biostudies-literature
Project description:A hybrid magnetic multilayer material of micrometric size, with highly crystalline hexagonal crystals consisting of CoAl-LDH ferromagnetic layers intercalated with thermoresponsive 4-(4-anilinophenylazo)benzenesulfonate (AO5) molecules diluted (ratio 9 : 1) with a flexible sodium dodecylsulphate (SDS) surfactant has been obtained. The resulting material exhibits thermochromism attributable to the isomerization between the azo (prevalent at room temperature) and the hydrazone (favoured at higher temperatures) tautomers, leading to a thermomechanical response. In fact, these crystals exhibited thermally induced motion triggering remarkable changes in the crystal morphology and volume. In situ variable temperature XRD of these thin hybrids shows that the reversible change into the two tautomers is reflected in a shift of the position of the diffraction peaks at high temperatures towards lower interlayer spacing for the hydrazone form, as well as a broadening of the peaks reflecting lower crystallinity and ordering due to non-uniform spacing between the layers. These structural variations between room temperature (basal spacing (BS) = 25.91 Å) and 100 °C (BS = 25.05 Å) are also reflected in the magnetic properties of the layered double hydroxide (LDH) due to the variation of the magnetic coupling between the layers. Overall, our study constitutes one of the few examples showing fully reversible thermo-responsive breathing in a 2D hybrid material. In addition, the magnetic response of the hybrid can be modulated due to the thermotropism of the organic component that, by influencing the distance and in-plane correlation of the inorganic LDH, modulates the magnetism of the CoAl-LDH sheets in a certain range.
| S-EPMC5495995 | biostudies-literature
Project description:Gadolinium based contrast agents (GBCAs) were found to play a role in nephrogenic systemic fibrosis in patients with and without renal impairment. Therefore, preserving the structural stability of GBCAs to reduce their propensity to liberate Gd3+ is of utmost importance. This study evaluates the effect of gadolinium concentration of GBCAs on solution temperature under magnetic fields. It is hypothesized that presence of gadolinium will lead to temperature changes of its solutions under magnetic field, and this change will depend on concentration. In this study, GBCAs were diluted to concentrations of 0.6, 1.2, 1.8, 2.4 mMol/L. A 10mL preparation in pure water, simulated body fluid (SBF), and plasma was scanned at 3T following a soft tissue neck protocol, and their temperatures were measured. Findings revealed that concentration of GBCA had significant effect on temperature change in all dilution media. Type of commercially available GBCA had an effect only in SFB and plasma. Evaluation of correlation between conditional stability constant (Kcond) and temperature difference (ΔT) revealed that in water and SBF there exists a positive correlation between Kcond and temperature variation. Collectively, GBCAs can cause local temperature variations when administered into patients, and can affect dissociation of gadolinium from its chelates, which should be investigated in a further study.
| S-EPMC6449068 | biostudies-literature
Project description:We report a general method for the synthesis of core-shell hybrid materials containing a microporous zeolite core with an aqueous miscible organic-layered double hydroxide (AMO-LDH) shell using a simple in situ coprecipitation method. For example, zeolite-HY@AMO-Mg2Al-CO3-LDH contains a 150 nm hierarchical AMO-Mg2Al-CO3-LDH surface coating on zeolite-HY. It exhibits a similar BET surface area (698 m2 g-1) as the parent zeolite-HY but this surface area has been re-allocated between microspores and mesopores. We believe that surface aluminium sites act as nucleation sites for the formation of the LDH coating and so robustly links it into the zeolite lattice. We expect that this new hybrid structure with micropores dominating in the core and mesopores populating the shell will provide a desirable new hybrid structure type for adsorption or catalysis.
| S-EPMC5975924 | biostudies-literature
Project description:Layered double hydroxides (LDHs) constitute a unique group of 2D materials that can deliver exceptional catalytic, optical, and electronic performance. However, they usually suffer from low stability compared to their oxide counterparts. Using density functional calculations, we quantitatively demonstrate the crucial impact of the intercalants (i.e., water, lactate, and carbonate) on the stability of a series of common LDHs based on Mn, Fe, and Co. We found that intercalation with the singly charged lactate results in higher stability in all these LDH compounds, compared to neutral water and doubly charged carbonate. Furthermore, we show that the dispersion effect aids the stability of these LDH compounds. This investigation reveals that certain intercalants enhance LDH stability and alter the bandgap favourably.
| S-EPMC9029406 | biostudies-literature
Project description:In this work, potassium fluoride-doped Ca-Mg-Al layered double hydroxides (CaMgAl-LDHs) were synthesized by a coprecipitation method, after which they were further used as strong adsorbents for HCl gas adsorption in a quartz reactor at high temperature. The physiochemical properties of the as-prepared KF/CaMgAl-LDHs and CaMgAl-LDHs were investigated by X-ray diffraction, thermogravimetric, scanning electron microscopy, energy-dispersive system, and Brunauer-Emmett-Teller. The HCl adsorption test showed that 25 wt % KF loading of the KF/CaMgAl-LDOs was the optimal adsorbent for HCl removal. The highest adsorption capacity of the KF/CaMgAl-LDH adsorbent was achieved with 0.2968 g at 600 °C, 500 ppm HCl concentration, and 0.5 g adsorbent. Furthermore, the microstructure of the adsorbents after the reaction revealed that the adsorbents were encapsulated by dense chloride. The adsorption process was mainly dominated by chemical adsorption, strong acid-base properties, specific surface area, and mesopore number.
| S-EPMC6844095 | biostudies-literature
Project description:Energy transfer between rare earths in layered rare-earth hydroxides (LRHs) is worth the intensive study because the hydroxyls that act as the bridge connecting the neighbouring rare earths would generate non-radiative transitions. This study focuses on the energy transfer in the intralayer and the adjacent layers of LRHs. A series of LEu x Tb1-x Hs (x = 0, 0.05, 0.2, 0.5, 0.8, and 0.95) was synthesized, the basal spacing (d basal) was adjusted from 8.3 to 46 Å through ion-exchange process, and unilamellar nanosheets were prepared through a delamination process. The luminescence behaviours of the samples demonstrated the following: (1) for the delaminated nanosheets, the quenching effect of both Eu3+ and Tb3+ was hardly observed. This implies that in the intralayer, the efficiency of energy transfer is extremely low, so that highly-concentrated co-doping does not influence the luminescence and by controlling the Eu/Tb molar ratio, white light can be obtained. (2) For small d basal, e.g., 27 Å, the fluorescence quenching of Tb3+ and Eu3+ was remarkable, while for large d basal, e.g., 46 Å, the emission of Tb3+ emerged and the self-quenching between Eu3+ ions weakened. (3) The energy transfer efficiency deceased with an increase in the distance between adjacent layers. In other words, either the energy transfer between Eu3+ and Tb3+ or the energy migration between Eu3+ ions was more efficient when they were located in adjacent layers than in intralayers even when they were the nearest neighbours.
| S-EPMC9077665 | biostudies-literature
Project description:High-entropy materials are compositionally complex materials which often contain five or more elements. The most commonly studied materials in this field are alloys and oxides, where their composition allows for tunable materials properties. High-entropy layered double hydroxides have been recently touted as the next focus for the field of high-entropy materials to expand into. However, most previous work on multi-cationic layered double hydroxides has focused on syntheses with 5 or less cations in the structure. To bridge this gap into high-entropy materials, this work explores the range and extent of different compositional combinations for high-entropy double layered hydroxides. Specifically, pure layered double hydroxides were synthesized with different combinations of 7 cations (Mg, Co, Cu, Zn, Ni, Al, Fe, Cr) as well as one combination of 8 cations by utilizing a hydrothermal synthesis method. Furthermore, magnetic properties of the 8-cation LDH were investigated.
| S-EPMC9475562 | biostudies-literature
Project description: Not available
| S-EPMC10509544 | biostudies-literature
Project description:This work presents the development of multifunctional therapeutic membranes based on a high-performance block copolymer scaffold formed by polyether (PE) and polyamide (PA) units (known as PEBA) and layered double hydroxide (LDH) biomaterials, with the aim to study their uses as wound dressings. Two LDH layer compositions were employed containing Mg2+ or Zn2+, Fe3+ and Al3+ cations, intercalated with chloride anions, abbreviated as Mg-Cl or Zn-Cl, or intercalated with naproxenate (NAP) anions, abbreviated as Mg-NAP or Zn-NAP. Membranes were structurally and physically characterized, and the in vitro drug release kinetics and cytotoxicity assessed. PEBA-loading NaNAP salt particles were also prepared for comparison. Intercalated NAP anions improved LDH-polymer interaction, resulting in membranes with greater mechanical performance compared to the polymer only or to the membranes containing the Cl-LDHs. Drug release (in saline solution) was sustained for at least 8 h for all samples and release kinetics could be modulated: a slower, an intermediate and a faster NAP release were observed from membranes containing Zn-NAP, NaNAP and Mg-NAP particles, respectively. In general, cell viability was higher in the presence of Mg-LDH and the membranes presented improved performance in comparison with the powdered samples. PEBA containing Mg-NAP sample stood out among all membranes in all the evaluated aspects, thus being considered a great candidate for application as multifunctional therapeutic dressings.
| S-EPMC7700130 | biostudies-literature