Ultrafast-Charging Supercapacitors Based on Corn-Like Titanium Nitride Nanostructures.
Ontology highlight
ABSTRACT:
SUBMITTER: Yang P
PROVIDER: S-EPMC5057334 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Ultrafast-charging energy storage devices are attractive for powering personal electronics and electric vehicles. Most ultrafast-charging devices are made of carbonaceous materials such as chemically converted graphene and carbon nanotubes. Yet, their relatively low electrical conductivity may restrict their performance at ultrahigh charging rate. Here, we report the fabrication of a porous titanium nitride (TiN) paper as an alternative electrode material for ultrafast-charging devices. The TiN paper shows an excellent conductivity of 3.67 × 104 S m-1, which is considerably higher than most carbon-based electrodes. The paper-like structure also contains a combination of large pores between interconnected nanobelts and mesopores within the nanobelts. This unique electrode enables fast charging by simultaneously providing efficient ion diffusion and electron transport. The supercapacitors (SCs) made of TiN paper enable charging/discharging at an ultrahigh scan rate of 100 V s-1 in a wide voltage window of 1.5 V in Na2SO4 neutral electrolyte. It has an outstanding response time with a characteristic time constant of 4 ms. Significantly, the TiN paper-based SCs also show zero capacitance loss after 200,000 cycles, which is much better than the stability performance reported for other metal nitride SCs. Furthermore, the device shows great promise in scalability. The filtration method enables good control of the thickness and mass loading of TiN electrodes and devices.
| S-EPMC7770898 | biostudies-literature
Project description:The electric capacitance of an amorphous TiO2-x surface increases proportionally to the negative sixth power of the convex diameter d. This occurs because of the van der Waals attraction on the amorphous surface of up to 7?mF/cm2, accompanied by extreme enhanced electron trapping resulting from both the quantum-size effect and an offset effect from positive charges at oxygen-vacancy sites. Here we show that a supercapacitor, constructed with a distributed constant-equipment circuit of large resistance and small capacitance on the amorphous TiO2-x surface, illuminated a red LED for 37?ms after it was charged with 1?mA at 10?V. The fabricated device showed no dielectric breakdown up to 1,100?V. Based on this approach, further advances in the development of amorphous titanium-dioxide supercapacitors might be attained by integrating oxide ribbons with a micro-electro mechanical system.
| S-EPMC5073320 | biostudies-literature
Project description:Supercapacitors (or electric double-layer capacitors) are high-power energy storage devices that store charge at the interface between porous carbon electrodes and an electrolyte solution. These devices are already employed in heavy electric vehicles and electronic devices, and can complement batteries in a more sustainable future. Their widespread application could be facilitated by the development of devices that can store more energy, without compromising their fast charging and discharging times. In situ characterization methods and computational modeling techniques have recently been developed to study the molecular mechanisms of charge storage, with the hope that better devices can be rationally designed. In this Perspective, we bring together recent findings from a range of experimental and computational studies to give a detailed picture of the charging mechanisms of supercapacitors. Nuclear magnetic resonance experiments and molecular dynamics simulations have revealed that the electrode pores contain a considerable number of ions in the absence of an applied charging potential. Experiments and computer simulations have shown that different charging mechanisms can then operate when a potential is applied, going beyond the traditional view of charging by counter-ion adsorption. It is shown that charging almost always involves ion exchange (swapping of co-ions for counter-ions), and rarely occurs by counter-ion adsorption alone. We introduce a charging mechanism parameter that quantifies the mechanism and allows comparisons between different systems. The mechanism is found to depend strongly on the polarization of the electrode, and the choice of the electrolyte and electrode materials. In light of these advances we identify new directions for supercapacitor research. Further experimental and computational work is needed to explain the factors that control supercapacitor charging mechanisms, and to establish the links between mechanisms and performance. Increased understanding and control of charging mechanisms should lead to new strategies for developing next-generation supercapacitors with improved performances.
| S-EPMC4865825 | biostudies-other
Project description:Micro-supercapacitors are promising miniaturized energy storage devices that have attracted considerable research interest. However, their widespread use is limited by inefficient microfabrication technologies and their low energy density. Here, a flexible, designable micro-supercapacitor can be fabricated by a single pulse laser photonic-reduction stamping. A thousand spatially shaped laser pulses can be generated in one second, and over 30,000 micro-supercapacitors are produced within 10 minutes. The micro-supercapacitor and narrow gaps were dozens of microns and 500 nm, respectively. With the unique three-dimensional structure of laser-induced graphene based electrode, a single micro-supercapacitor exhibits an ultra-high energy density (0.23 Wh cm-3), an ultra-small time constant (0.01 ms), outstanding specific capacitance (128 mF cm-2 and 426.7 F cm-3) and a long-term cyclability. The unique technique is desirable for a broad range of applications, which surmounts current limitations of high-throughput fabrication and low energy density of micro-supercapacitors.
| S-EPMC7712890 | biostudies-literature
Project description:As a member of the transition metal nitride material family, titanium nitride (TiN) quantum dots (QDs) have attracted great attention in optical and electronic fields because of their excellent optoelectronic properties and favorable stability. Herein, TiN QDs were synthesized and served as a saturable absorber (SA) for an ultrafast fiber laser. Due to the strong nonlinear optical absorption characteristics with a modulation depth of ~33%, the typical fundamental mode-locked pulses and harmonics mode-locked pulses can be easily obtained in an ultrafast erbium-doped fiber laser with a TiN-QD SA. In addition, at the maximum pump power, harmonic mode-locked pulses with a repetition rate of ~1 GHz (164th order) and a pulse duration of ~1.45 ps are achieved. As far as we know, the repetition rate is the highest in the ultrafast fiber laser using TiN QDs as an SA. Thus, these experimental results indicate that TiN QDs can be considered a promising material, showing more potential in the category of ultrafast laser and nonlinear optics.
| S-EPMC9268693 | biostudies-literature
Project description:All-solid-state supercapacitors have gained increasing attention as wearable energy storage devices, partially due to their flexible, safe, and lightweight natures. However, their electrochemical performances are largely hampered by the low flexibility and durability of current polyvinyl alcohol (PVA) based electrolytes. Herein, a novel polyvinyl alcohol-polyethyleneimine (PVA-PEI) based, conductive and elastic hydrogel was devised as an all-in-one electrolyte platform for wearable supercapacitor (WSC). For proof-of-concept, we assembled all-solid-state supercapacitors based on boron nitride nanosheets (BNNS) intercalated graphene electrodes and PVA-PEI based gel electrolyte. Furthermore, by varying the electrolyte ions, we observed synergistic effects between the hydrogel and the electrode materials when KOH was used as electrolyte ions, as the Graphene/BNNS@PVA-PEI-KOH WSCs exhibited a significantly improved areal capacitance of 0.35 F/cm2 and a smaller ESR of 6.02 ohm/cm2. Moreover, due to the high flexibility and durability of the PVA-PEI hydrogel electrolyte, the developed WSCs behave excellent flexibility and cycling stability under different bending states and after 5000 cycles. Therefore, the conductive, yet elastic, PVA-PEI hydrogel represents an attractive electrolyte platform for WSC, and the Graphene/BNNS@PVA-PEI-KOH WSCs shows broad potentials in powering wearable electronic devices.
| S-EPMC8069789 | biostudies-literature
Project description:FeOOH nanosheets on porous diatomite have been successfully prepared by a facile two-step hydrothermal approach for supercapacitors, and then α-Fe2O3 and γ-Fe2O3 nanostructures are obtained via calcination under different atmospheres and temperatures. The morphologies and structures of all the samples are investigated in detail to make the hierarchical architecture clear. Besides, systemic tests are carried out in 1 M Na2SO4 electrolyte to characterize the electrochemical properties of these materials. Among the iron-related composite electrodes, diatomite@FeOOH owns the highest specific capacitance (157.9 F g-1 at a current density of 0.5 A g-1) and best cycling performance (98.95% retention after 1000 cycles), which is considered to be a potential material for high-performance supercapacitors. Furthermore, the synthesizing strategy can be extended to the preparation of other metallic oxide-derived functional materials towards energy storage and conversion.
| S-EPMC6298910 | biostudies-literature
Project description:High-harmonic generation is a cornerstone of nonlinear optics. It has been demonstrated in dielectrics, semiconductors, semi-metals, plasmas, and gases, but, until now, not in metals. Here we report high harmonics of 800-nm-wavelength light irradiating metallic titanium nitride film. Titanium nitride is a refractory metal known for its high melting temperature and large laser damage threshold. We show that it can withstand few-cycle light pulses with peak intensities as high as 13 TW/cm2, enabling high-harmonics generation up to photon energies of 11 eV. We measure the emitted vacuum ultraviolet radiation as a function of the crystal orientation with respect to the laser polarization and show that it is consistent with the anisotropic conduction band structure of titanium nitride. The generation of high harmonics from metals opens a link between solid and plasma harmonics. In addition, titanium nitride is a promising material for refractory plasmonic devices and could enable compact vacuum ultraviolet frequency combs.
| S-EPMC8371016 | biostudies-literature
Project description:Herein, a 3D composite electrode supported by g-C3N4 nanowire framework as scaffold and poly(3,4-ethylenedioxythiophene): poly(4-styrenesulfonate) (PEDOT: PSS) as conducting polymer is reported for flexible solid-state electrochemical capacitors. Compared to pure PEDOT: PSS, the composite electrodes have a greatly increased specific surface and showed good electrochemical performance. A specific capacitance of 202 F g-1 is achieved, and 83.5% of initial capacitance maintained after 5000 cycles. The device based on the 3D g-C3N4/PEDOT: PSS electrode also exhibits good performance in capacitance, flexibility, and cycling stability.
| S-EPMC6419655 | biostudies-literature
Project description:Photoelectrochemical fuel generation is a promising route to sustainable liquid fuels produced from water and captured carbon dioxide with sunlight as the energy input. Development of these technologies requires photoelectrode materials that are both photocatalytically active and operationally stable in harsh oxidative and/or reductive electrochemical environments. Such photocatalysts can be discovered based on co-design principles, wherein design for stability is based on the propensity for the photocatalyst to self-passivate under operating conditions and design for photoactivity is based on the ability to integrate the photocatalyst with established semiconductor substrates. Here, we report on the synthesis and characterization of zinc titanium nitride (ZnTiN2) that follows these design rules by having a wurtzite-derived crystal structure and showing self-passivating surface oxides created by electrochemical polarization. The sputtered ZnTiN2 thin films have optical absorption onsets below 2 eV and n-type electrical conduction of 3 S/cm. The band gap of this material is reduced from the 3.36 eV theoretical value by cation-site disorder, and the impact of cation antisites on the band structure of ZnTiN2 is explored using density functional theory. Under electrochemical polarization, the ZnTiN2 surfaces have TiO2- or ZnO-like character, consistent with Materials Project Pourbaix calculations predicting the formation of stable solid phases under near-neutral pH. These results show that ZnTiN2 is a promising candidate for photoelectrochemical liquid fuel generation and demonstrate a new materials design approach to other photoelectrodes with self-passivating native operational surface chemistry.
| S-EPMC9354241 | biostudies-literature