Photosensitive and Flexible Organic Field-Effect Transistors Based on Interface Trapping Effect and Their Application in 2D Imaging Array.
Ontology highlight
ABSTRACT:
SUBMITTER: Chu Y
PROVIDER: S-EPMC5069582 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Free-standing and flexible field-effect transistors based on 6,13-bis(triisopropylsilylethynyl)-pentacene (TIPS-pentacene)/polystyrene bilayers are obtained by well-controlled phase separation of both components. The phase separation is induced by solvent vapor annealing of initially amorphous blend films, leading to crystallization of TIPS-pentacene as the top layer. The crystallinity and blend morphology strongly depend on the molecular weight of polystyrene, and under optimized conditions, distinct phase separation with a well-defined and trap-free interface between both fractions is achieved. Due to the distinct bilayer morphology, the resulting flexible field-effect transistors reveal similar charge carrier mobilities as rigid devices and additionally pronounced environmental and bias stress stabilities. The performance of the flexible transistors remains stable up to a strain of 1.8%, while above this deformation, a close relation between current and strain is observed that is required for applications in strain sensors.
| S-EPMC8678985 | biostudies-literature
Project description:In this study, a novel approach to the fabrication of a multimodal temperature and force sensor on ultrathin, conformable and flexible substrates is presented. This process involves coupling a charge-modulated organic field-effect transistor (OCMFET) with a pyro/piezoelectric element, namely a commercial film of poly-vinylene difluoride (PVDF). The proposed device is able to respond to both pressure stimuli and temperature variations, demonstrating the feasibility of the approach for the development of low-cost, highly sensitive and conformable multimodal sensors. The overall thickness of the device is 1.2??m, being thus able to conform to any surface (including the human body), while keeping its electrical performance. Furthermore, it is possible to discriminate between simultaneously applied temperature and pressure stimuli by coupling sensing surfaces made of poled and unpoled spin-coated PVDF-trifluoroethylene (PVDF-TrFE, a PVDF copolymer) with OCMFETs. This demonstrates the possibility of creating multimodal sensors that can be employed for applications in several fields, ranging from robotics to wearable electronics.
| S-EPMC5966445 | biostudies-literature
Project description:Radiation therapy is one of the most prevalent procedures for cancer treatment, but the risks of malignancies induced by peripheral beam in healthy tissues surrounding the target is high. Therefore, being able to accurately measure the exposure dose is a critical aspect of patient care. Here a radiation detector based on an organic field-effect transistor (RAD-OFET) is introduced, an in vivo dosimeter that can be placed directly on a patient's skin to validate in real time the dose being delivered and ensure that for nearby regions an acceptable level of low dose is being received. This device reduces the errors faced by current technologies in approximating the dose profile in a patient's body, is sensitive for doses relevant to radiation treatment procedures, and robust when incorporated into conformal large-area electronics. A model is proposed to describe the operation of RAD-OFETs, based on the interplay between charge photogeneration and trapping.
| S-EPMC7509662 | biostudies-literature
Project description:Solution-processed 2D organic semiconductors (OSCs) have drawn considerable attention because of their novel applications from flexible optoelectronics to biosensors. However, obtaining well-oriented sheets of 2D organic materials with low defect density still poses a challenge. Here, a highly crystallized 2,9-didecyldinaphtho[2,3-b:2',3'-f]thieno[3,2-b]thiophene (C10-DNTT) monolayer crystal with large-area uniformity is obtained by an ultraslow shearing (USS) method and its growth pattern shows a kinetic Wulff's construction supported by theoretical calculations of surface energies. The resulting seamless and highly crystalline monolayers are then used as templates for thermally depositing another C10-DNTT ultrathin top-up film. The organic thin films deposited by this hybrid approach show an interesting coherence structure with a copied molecular orientation of the templating crystal. The organic field-effect transistors developed by these hybrid C10-DNTT films exhibit improved carrier mobility of 14.7 cm2 V-1 s-1 as compared with 7.3 cm2 V-1 s-1 achieved by pure thermal evaporation (100% improvement) and 2.8 cm2 V-1 s-1 achieved by solution sheared monolayer C10-DNTT. This work establishes a simple yet effective approach for fabricating high-performance and low-cost electronics on a large scale.
| S-EPMC6774035 | biostudies-literature
Project description:Polymer-ceramic dielectric composites have been of great interest because they combine the processability of polymers with the desired dielectric properties of the ceramics. We fabricated a low voltage-operated flexible organic field-effect transistor (OFET) based on crosslinked poly (4-vinyl phenol) (PVP) polymer blended with novel ceramic calcium titanate nanoparticles (CaTiO3 NPs) as gate dielectric. To reduce interface roughness caused by nanoparticles, it was further coated with a very thin PVP film. The resulting OFET exhibited much lower operated voltage (reducing from -10.5 V to -2.9 V), a relatively steeper threshold slope (~0.8 V/dec) than those containing a pure PVP dielectric. This is ascribed to the high capacitance of the CaTiO3 NP-filled PVP insulator, and its smoother and hydrophobic dielectric surface proved by atomic force microscopy (AFM) and a water contact angle test. We also evaluated the transistor properties in a compressed state. The corresponding device had no significant degradation in performance when bending at various diameters. In particular, it operated well continuously for 120 hours during a constant bending stress. We believe that this technology will be instrumental in the development of future flexible and printed electronic applications.
| S-EPMC7153480 | biostudies-literature
Project description:Two dimensional (2D) molecular crystals have attracted considerable attention because of their promising potential in electrical device applications, such as high-performance field-effect transistors (FETs). However, such devices demand high voltages, thereby considerably increasing power consumption. This study demonstrates the fabrication of organic FETs based on 2D crystalline films as semiconducting channels. The application of high-? oxide dielectrics allows the transistors run under a low operating voltage (-4?V). The devices exhibited a high electrical performance with a carrier mobility up to 9.8?cm2?V-1 s-1. Further results show that the AlOx layer is beneficial to the charge transport at the conducting channels of FETs. Thus, the device strategy presented in this work is favorable for 2D molecular crystal-based transistors that can operate under low voltages.
| S-EPMC5552882 | biostudies-other
Project description:Flexible pressure sensors based on organic field-effect transistors (OFETs) have emerged as promising candidates for electronic-skin applications. However, it remains a challenge to achieve low operating voltages of hysteresis-free flexible pressure sensors. Interface engineering of polymer dielectrics is a feasible strategy toward sensitive pressure sensors based on low-voltage OFETs. Here, a novel type of solution-processed bilayer dielectrics is developed by combining a thick polyelectrolyte layer of polyacrylic acid (PAA) with a thin poly(methyl methacrylate) (PMMA) layer. This bilayer dielectric can provide a vertical phase separation structure from hydrophilic interface to hydrophobic interface which adjoins well to organic semiconductors, leading to improved stability and remarkably reduced leakage currents. Consequently, OFETs using the PMMA/PAA dielectrics reveal greatly suppressed hysteresis and improved mobility compared to those with a pure PAA dielectric. Using the optimized PMMA/PAA dielectric, flexible OFET-based pressure sensors that show a record high sensitivity of 56.15 kPa-1 at a low operating voltage of -5 V, a fast response time of less than 20 ms, and good flexibility are further demonstrated. The salient features of high capacitance, good dielectric performance, and excellent reliability of the bilayer dielectrics promise a bright future of flexible sensors based on low-voltage OFETs for wearable electronic applications.
| S-EPMC6145259 | biostudies-literature
Project description:In this work, a novel thermoresponsive switching transistor is developed through the rational design of active materials based on the typical field-effect transistor (FET) device configuration, where the active material is composed of a blend of a thermal expansion polymer and a polymeric semiconductor. Herein, polyethylene (PE) is employed as the thermal expansion polymer because of its high volume expansion coefficient near its melting point (90-130 °C), which similarly corresponds to the overheating point that would cause damage or cause fire in the devices. It is revealed that owing to the thermistor property of PE, the FET characteristics of the derived device will be largely decreased at high temperatures (100-120 °C). It is because the high volume expansion of PE at such high temperature (near its T m) effectively increases the distance of the crystalline domains of poly(3-hexylthiophene-2,5-diyl) to result in a great inhibition of current. Besides, the performance of this device will recover back to its original value after cooling from 120 to 30 °C owing to the volume contraction of PE. The reversible FET characteristics with temperature manifest the good thermal sensitivity of the PE-based device. Our results demonstrate a facile and promising approach for the development of next-generation overheating shutdown switches for electrical circuits.
| S-EPMC6933784 | biostudies-literature
Project description:Organic light-emitting field-effect transistors (OLEFETs) are regarded as a novel kind of device architecture for fulfilling electrical-pumped organic lasers. However, the realization of OLEFETs with high external quantum efficiency (EQE) and high brightness simultaneously is still a tough task. Moreover, the design of the resonator structure in LED is far from satisfactory. Here, OLEFETs with EQE of 1.5% at the brightness of 2600 cdm(-2), and the corresponding ON/OFF ratio and current efficiency reaches above 10(4) and 3.1 cdA(-1), respectively, were achieved by introducing 1,4,5,8,9,12-hexaazatriphenylene-hexacarbonitrile (HAT-CN) as a charge generation layer. Moreover, a vertical microcavity based on distributed Bragg reflector (DBR) and Ag source/drain electrodes is successfully introduced into the high performance OLEFETs, which results in electroluminescent spectrum linewidth narrowing from 96 nm to 6.9 nm. The results manifest the superiority of the vertical microcavity as an optical resonator in OLEFETs, which sheds some light on achieving the electrically pumped organic lasers.
| S-EPMC4794712 | biostudies-literature
Project description:Organic field-effect transistors (OFETs) are used to directly "touch" the movement and dynamics of polymer chains, and then determine Tg. As a molecular-level probe, the conducting channel of OFETs exhibits several unique advantages: 1) it directly detects the motion and dynamics of polymer chain at Tg; 2) it allows the measurement of size effects in ultrathin polymer films (even down to 6 nm), which bridges the gap in understanding effects between surface and interface. This facile and reliable determination of Tg of polymer films and the understanding of polymer chain dynamics guide a new prospect for OFETs besides their applications in organic electronics and casting new light on the fundamental understanding of the nature of polymer chain dynamics.
| S-EPMC4165941 | biostudies-literature