Dataset Information

Analysis of whole human blood for Pb, Cd, Hg, Se, and Mn by ICP-DRC-MS for biomonitoring and acute exposures.

ABSTRACT: We improved our inductively coupled plasma mass spectrometry (ICP-MS) whole blood method [1] for determination of lead (Pb), cadmium (Cd), and mercury (Hg) by including manganese (Mn) and selenium (Se), and expanding the calibration range of all analytes. The method is validated on a PerkinElmer (PE) ELAN® DRC II ICP-MS (ICP-DRC-MS) and uses the Dynamic Reaction Cell (DRC) technology to attenuate interfering background ion signals via ion-molecule reactions. Methane gas (CH4) eliminates background signal from 40Ar2+ to permit determination of 80Se+, and oxygen gas (O2) eliminates several polyatomic interferences (e.g. 40Ar15N+, 54Fe1H+) on 55Mn+. Hg sensitivity in DRC mode is a factor of two higher than vented mode when measured under the same DRC conditions as Mn due to collisional focusing of the ion beam. To compensate for the expanded method's longer analysis time (due to DRC mode pause delays), we implemented an SC4-FAST autosampler (ESI Scientific, Omaha, NE), which vacuum loads the sample onto a loop, to keep the sample-to-sample measurement time to less than 5min, allowing for preparation and analysis of 60 samples in an 8-h work shift. The longer analysis time also resulted in faster breakdown of the hydrocarbon oil in the interface roughing pump. The replacement of the standard roughing pump with a pump using a fluorinated lubricant, Fomblin®, extended the time between pump maintenance. We optimized the diluent and rinse solution components to reduce carryover from high concentration samples and prevent the formation of precipitates. We performed a robust calculation to determine the following limits of detection (LOD) in whole blood: 0.07µgdL-1 for Pb, 0.10µgL-1 for Cd, 0.28?gL-1 for Hg, 0.99µgL-1 for Mn, and 24.5µgL-1 for Se.

SUBMITTER: Jones DR

PROVIDER: S-EPMC5123815 | biostudies-literature | 2017 Jan

REPOSITORIES: biostudies-literature

ACCESS DATA

Publications

Analysis of whole human blood for Pb, Cd, Hg, Se, and Mn by ICP-DRC-MS for biomonitoring and acute exposures.

Jones Deanna R DR Jarrett Jeffery M JM Tevis Denise S DS Franklin Melanie M Mullinix Neva J NJ Wallon Kristen L KL Derrick Quarles C C Caldwell Kathleen L KL Jones Robert L RL

Talanta 20160928

We improved our inductively coupled plasma mass spectrometry (ICP-MS) whole blood method [1] for determination of lead (Pb), cadmium (Cd), and mercury (Hg) by including manganese (Mn) and selenium (Se), and expanding the calibration range of all analytes. The method is validated on a PerkinElmer (PE) ELAN® DRC II ICP-MS (ICP-DRC-MS) and uses the Dynamic Reaction Cell (DRC) technology to attenuate interfering background ion signals via ion-molecule reactions. Methane gas (CH<sub>4</sub>) eliminat ...[more]

PMID: 27837806

Similar Datasets

Project description:BackgroundComprehensive information on the effect of time and temperature storage on the measurement of elements in human, whole blood (WB) by inductively coupled plasma-dynamic reaction cell-mass spectrometry (ICP-DRC-MS) is lacking, particularly for Mn and Se.MethodsHuman WB was spiked at 3 concentration levels, dispensed, and then stored at 5 different temperatures: -70 °C, -20 °C, 4 °C, 23 °C, and 37 °C. At 3 and 5 weeks, and at 2, 4, 6, 8, 10, 12, 36 months, samples were analyzed for Pb, Cd, Mn, Se and total Hg, using ICP-DRC-MS. We used a multiple linear regression model including time and temperature as covariates to fit the data with the measurement value as the outcome. We used an equivalence test using ratios to determine if results from the test storage conditions, warmer temperature and longer time, were comparable to the reference storage condition of 3 weeks storage time at -70 °C.ResultsModel estimates for all elements in human WB samples stored in polypropylene cryovials at -70 °C were equivalent to estimates from samples stored at 37 °C for up to 2 months, 23 °C up to 10 months, and -20 °C and 4 °C for up to 36 months. Model estimates for samples stored for 3 weeks at -70 °C were equivalent to estimates from samples stored for 2 months at -20 °C, 4 °C, 23 °C and 37 °C; 10 months at -20 °C, 4 °C, and 23 °C; and 36 months at -20 °C and 4 °C. This equivalence was true for all elements and pools except for the low concentration blood pool for Cd.ConclusionsStorage temperatures of -20 °C and 4 °C are equivalent to -70 °C for stability of Cd, Mn, Pb, Se, and Hg in human whole blood for at least 36 months when blood is stored in sealed polypropylene vials. Increasing the sample storage temperature from -70 °C to -20 °C or 4 °C can lead to large energy savings. The best analytical results are obtained when storage time at higher temperature conditions (e.g. 23 °C and 37 °C) is minimized because recovery of Se and Hg is reduced. Blood samples stored in polypropylene cryovials also lose volume over time and develop clots at higher temperature conditions (e.g., 23 °C and 37 °C), making them unacceptable for elemental testing after 10 months and 2 months, respectively.

Project description:Environmental chemicals and contaminants coming from multiple external sources enter the human body, determining a potential risk for human health. Human biomonitoring (HBM), measuring the concentrations of biomarkers in human specimens, has become an emerging approach for assessing population-wide exposure to hazardous chemicals and health risk through large-scale studies in many countries. However, systematic mapping of HBM studies, including their characteristics, targeted hazardous pollutants, analytical techniques, and sample population (general population and occupationally exposed workers), has not been done so far. We conducted a systematic review of the literature related to airborne hazardous pollutants in biofluids to answer the following questions: Which main chemicals have been included in the literature, which bodily fluids have been used, and what are the main findings? Following PRISMA protocol, we summarized the publications published up to 4 February 2021 of studies based on two methods: gas-chromatography/mass spectrometry (GC/MS) and electronic noses (e-noses). We screened 2606 records and 117 publications were included in the analysis, the most based on GC/MS analysis. The selected HBM studies include measurements of biomarkers in different bodily fluids, such as blood, urine, breast milk, and human semen as well as exhaled air. The papers cover numerous airborne hazardous pollutants that we grouped in chemical classes; a lot of hazardous and noxious compounds, mainly persistent organic pollutants (POPs) and volatile organic compounds (VOCs), have been detected in biological fluids at alarming levels. The scenario that emerged from this survey demonstrates the importance of HBM in human exposure to hazardous pollutants and the need to use it as valid tool in health surveillance. This systematic review represents a starting point for researchers who focus on the world of pollutant biomonitoring in the human body and gives them important insights into how to improve the methods based on GC/MS. Moreover, it makes a first overview of the use of gas sensor array and e-noses in HBM studies.

Dataset Information

Analysis of whole human blood for Pb, Cd, Hg, Se, and Mn by ICP-DRC-MS for biomonitoring and acute exposures.

Publications

Analysis of whole human blood for Pb, Cd, Hg, Se, and Mn by ICP-DRC-MS for biomonitoring and acute exposures.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets