Dataset Information

Towards Miscanthus combustion quality improvement: the role of flowering and senescence.

ABSTRACT: In commercially grown Miscanthus × giganteus, despite imposing a yield penalty, postwinter harvests improve quality criteria for thermal conversion and crop sustainability through remobilization of nutrients to the underground rhizome. We examined 16 Miscanthus genotypes with different flowering and senescence times for variation in N, P, K, moisture, ash, Cl and Si contents, hypothesizing that early flowering and senescence could result in improved biomass quality and/or enable an earlier harvest of biomass (in autumn at peak yield). Ideal crop characteristics at harvest are low N and P to reduce future fertilizer inputs, low K and Cl to reduce corrosion in boilers, low moisture to reduce spoilage and transportation costs, and low Si and ash to reduce slagging and consequent operational downtime. Stems and leaves were harvested during summer, autumn and then the following spring after overwinter ripening. In spring, stem contents of N were 30-60 mg kg^-1, P were 203-1132 mg kg^-1, K were 290-4098 mg kg^-1, Cl were 10-23 mg kg^-1 and moisture were 12-38%. Notably, late senescence resulted in increased N, P, K, Cl, moisture and ash contents, and should therefore be avoided for thermochemical conversion. Flowering and senescence led to overall improved combustion quality, where flowered genotypes tended towards lower P, K, Cl and moisture contents; marginally less, or similar, N, Si and ash contents; and a similar higher heating value, compared to those that had not flowered. Such genotypes could potentially be harvested in the autumn. However, one genotype that did not flower in our trial exhibited sufficiently low N and K content in autumn to meet the EN plus wood pellet standards for those traits, and some of the lowest P, moisture and ash contents in our trial, and is thus a target for future research and breeding.

SUBMITTER: Jensen E

PROVIDER: S-EPMC5412913 | biostudies-literature |

REPOSITORIES: biostudies-literature

ACCESS DATA

Similar Datasets

Project description:A micro-reciprocating piston internal combustion engine with liquid hydrocarbon fuel has the potential to supply ultrahigh density energy to micro electro mechanical system because of its high-density energy, simple structure, and mature energy conversion principle. However, the diagnostic test of the combustion characteristics of the micro reciprocating piston internal combustion engine shows that its combustion characteristics are poor, and the combustion rate was lower with the combustion duration of more than 50 °CA. The mean indicated pressure (Pmi) value was only 0.137 MPa, the combustion stability was very poor, and the cycle variation rate of the Pmi was up to 60%. To improve its combustion performance, the method to enhance combustion in micro-space is explored then. Mechanism studies have shown that the pyrolysis reaction of nitromethane and hydrogen peroxide can produce amounts of free radicals OH, with the possibility of improving the combustion of methanol. Therefore, a method for adjusting the composition of methanol fuel to enhance combustion is proposed, and the method is theoretically confirmed. Finally, based on this method, the test was carried out. The results showed that the combustion rate increased and the combustion duration decreased by 6% after adding nitromethane. The power performance was enhanced, and the Pmi value was increased by 30%. The combustion stability was enhanced, and the cycle variation rate of the Pmi was reduced to 16.9%. Nitromethane has a significant effect on improving the combustion characteristics of methanol, and the enhancement of the latter was mainly reflected in the ignition phase of the combustion process. This study indicates that exploring the fuel additive that can increase the concentration of OH radical in the reaction is an effective method to improve the micro-space combustion, which will facilitate the development of micro-piston internal combustion engine to supply energy to a micro electro mechanical system.

Project description:In Europe, the perennial C4 grass miscanthus is currently mainly cultivated for energy generation via combustion. In recent years, anaerobic digestion has been identified as a promising alternative utilization pathway. Anaerobic digestion produces a higher-value intermediate (biogas), which can be upgraded to biomethane, stored in the existing natural gas infrastructure and further utilized as a transport fuel or in combined heat and power plants. However, the upgrading of the solid biomass into gaseous fuel leads to conversion-related energy losses, the level of which depends on the cultivation parameters genotype, location, and harvest date. Thus, site-specific crop management needs to be adapted to the intended utilization pathway. The objectives of this paper are to quantify (i) the impact of genotype, location and harvest date on energy yields of anaerobic digestion and combustion and (ii) the conversion losses of upgrading solid biomass into biogas. For this purpose, five miscanthus genotypes (OPM 3, 6, 9, 11, 14), three cultivation locations (Adana, Moscow, Stuttgart), and up to six harvest dates (August-March) were assessed. Anaerobic digestion yielded, on average, 35% less energy than combustion. Genotype, location, and harvest date all had significant impacts on the energy yield. For both, this is determined by dry matter yield and ash content and additionally by substrate-specific methane yield for anaerobic digestion and moisture content for combustion. Averaged over all locations and genotypes, an early harvest in August led to 25% and a late harvest to 45% conversion losses. However, each utilization option has its own optimal harvest date, determined by biomass yield, biomass quality, and cutting tolerance. By applying an autumn green harvest for anaerobic digestion and a delayed harvest for combustion, the conversion-related energy loss was reduced to an average of 18%. This clearly shows that the delayed harvest required to maintain biomass quality for combustion is accompanied by high energy losses through yield reduction over winter. The pre-winter harvest applied in the biogas utilization pathway avoids these yield losses and largely compensates for the conversion-related energy losses of anaerobic digestion.

Project description:Miscanthus is a close relative of Saccharum and a potentially valuable genetic resource for improving sugarcane. Differences in flowering time within and between Miscanthus and Saccharum hinders intra- and interspecific hybridizations. A series of greenhouse experiments were conducted over three years to determine how to synchronize flowering time of Saccharum and Miscanthus genotypes. We found that day length was an important factor influencing when Miscanthus and Saccharum flowered. Sugarcane could be induced to flower in a central Illinois greenhouse using supplemental lighting to reduce the rate at which days shortened during the autumn and winter to 1 min d-1, which allowed us to synchronize the flowering of some sugarcane genotypes with Miscanthus genotypes primarily from low latitudes. In a complementary growth chamber experiment, we evaluated 33 Miscanthus genotypes, including 28 M. sinensis, 2 M. floridulus, and 3 M. ×giganteus collected from 20.9° S to 44.9° N for response to three day lengths (10 h, 12.5 h, and 15 h). High latitude-adapted M. sinensis flowered mainly under 15 h days, but unexpectedly, short days resulted in short, stocky plants that did not flower; in some cases, flag leaves developed under short days but heading did not occur. In contrast, for M. sinensis and M. floridulus from low latitudes, shorter day lengths typically resulted in earlier flowering, and for some low latitude genotypes, 15 h days resulted in no flowering. However, the highest ratio of reproductive shoots to total number of culms was typically observed for 12.5 h or 15 h days. Latitude of origin was significantly associated with culm length, and the shorter the days, the stronger the relationship. Nearly all entries achieved maximal culm length under the 15 h treatment, but the nearer to the equator an accession originated, the less of a difference in culm length between the short-day treatments and the 15 h day treatment. Under short days, short culms for high-latitude accessions was achieved by different physiological mechanisms for M. sinensis genetic groups from the mainland in comparison to those from Japan; for mainland accessions, the mechanism was reduced internode length, whereas for Japanese accessions the phyllochron under short days was greater than under long days. Thus, for M. sinensis, short days typically hastened floral induction, consistent with the expectations for a facultative short-day plant. However, for high latitude accessions of M. sinensis, days less than 12.5 h also signaled that plants should prepare for winter by producing many short culms with limited elongation and development; moreover, this response was also epistatic to flowering. Thus, to flower M. sinensis that originates from high latitudes synchronously with sugarcane, the former needs day lengths >12.5 h (perhaps as high as 15 h), whereas that the latter needs day lengths <12.5 h.

Project description:BACKGROUND:Around the world, many healthcare organizations engage patients as a quality improvement strategy. In Canada, the University of Montreal has developed a model which consists in partnering with patient advisors, providers, and managers in quality improvement. This model was introduced through its Partners in Care Programs tested with several quality improvement teams in Quebec, Canada. Partnering with patients in quality improvement brings about new challenges for healthcare managers. This model is recent, and little is known about how managers contribute to implementing and sustaining it using key practices. METHODS:In-depth multi-level case studies were conducted within two healthcare organizations which have implemented a Partners in Care Program in quality improvement. The longitudinal design of this research enabled us to monitor the implementation of patient partnership initiatives from 2015 to 2017. In total, 38 interviews were carried out with managers at different levels (top-level, mid-level, and front-line) involved in the implementation of Partners in Care Programs. Additionally, seven focus groups were conducted with patients and providers. RESULTS:Our findings show that managers are engaged in four main types of practices: 1-designing the patient partnership approach so that it makes sense to the entire organization; 2-structuring patient partnership to support its deployment and sustainability; 3-managing patient advisor integration in quality improvement to avoid tokenistic involvement; 4-evaluating patient advisor integration to support continuous improvement. Designing and structuring patient partnership are based on typical management practices used to implement change initiatives in healthcare organizations, whereas managing and evaluating patient advisor integration require new daily practices from managers. Our results reveal that managers at all levels, from top to front-line, are concerned with the implementation of patient partnership in quality improvement. CONCLUSION:This research adds empirical support to the evidence regarding daily managerial practices used for implementing patient partnership initiatives in quality improvement and contributes to guiding healthcare organizations and managers when integrating such approaches.

Dataset Information

Towards Miscanthus combustion quality improvement: the role of flowering and senescence.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets