Dataset Information

Swing-like pool boiling on nano-textured surfaces for microgravity applications related to cooling of high-power microelectronics.

ABSTRACT: Here, we demonstrate that heat removed in pool boiling from a heater mimicking high-power microelectronics could be used to facilitate a swing-like motion of the heater before being finally dissipated. This swing-like motion could be beneficial for shedding a large vapor bubble that encapsulates high-power heaters in microgravity where buoyancy force is unavailable for vapor bubble removal. The swing-like motion is propelled by vapor bubble recoil, the force which exists irrespective of gravity and buoyancy. We also demonstrate that this force could be significantly enhanced by depositing on the heater surface supersonically blown polymer nanofibers with cross-sectional diameters below 100?nm. These nanofibers provide additional nucleation sites, resulting in much more frequent bubble nucleation and departure, and thus a higher overall vapor recoil force propelling the heater motion. Such nanofibers strongly adhere to the heater surface and withstand prolonged harsh pool boiling. The measured velocity of the model swing-like heater in Novec 7300 fluid is about 1?cm/s.

SUBMITTER: Sinha-Ray S

PROVIDER: S-EPMC5460202 | biostudies-literature | 2017

REPOSITORIES: biostudies-literature

ACCESS DATA

Publications

Swing-like pool boiling on nano-textured surfaces for microgravity applications related to cooling of high-power microelectronics.

Sinha-Ray Sumit S Zhang Wenshuo W Stoltz Barak B Sahu Rakesh P RP Sinha-Ray Suman S Yarin Alexander L AL

NPJ microgravity 20170305

Here, we demonstrate that heat removed in pool boiling from a heater mimicking high-power microelectronics could be used to facilitate a swing-like motion of the heater before being finally dissipated. This swing-like motion could be beneficial for shedding a large vapor bubble that encapsulates high-power heaters in microgravity where buoyancy force is unavailable for vapor bubble removal. The swing-like motion is propelled by vapor bubble recoil, the force which exists irrespective of gravity ...[more]

PMID: 28649631

Similar Datasets

Project description:This study addresses the combination of customized surface modification with the use of nanofluids, to infer on its potential to enhance pool-boiling heat transfer. Hydrophilic surfaces patterned with superhydrophobic regions were developed and used as surface interfaces with different nanofluids (water with gold, silver, aluminum and alumina nanoparticles), in order to evaluate the effect of the nature and concentration of the nanoparticles in bubble dynamics and consequently in heat transfer processes. The main qualitative and quantitative analysis was based on extensive post-processing of synchronized high-speed and thermographic images. To study the nucleation of a single bubble in pool boiling condition, a numerical model was also implemented. The results show an evident benefit of using biphilic patterns with well-established distances between the superhydrophobic regions. This can be observed in the resulting plot of the dissipated heat flux for a biphilic pattern with seven superhydrophobic spots, δ = 1/d and an imposed heat flux of 2132 w/m2. In this case, the dissipated heat flux is almost constant (except in the instant t* ≈ 0.9 when it reaches a peak of 2400 W/m2), whilst when using only a single superhydrophobic spot, where the heat flux dissipation reaches the maximum shortly after the detachment of the bubble, dropping continuously until a new necking phase starts. The biphilic patterns also allow a controlled bubble coalescence, which promotes fluid convection at the hydrophilic spacing between the superhydrophobic regions, which clearly contributes to cool down the surface. This effect is noticeable in the case of employing the Ag 1 wt% nanofluid, with an imposed heat flux of 2132 W/m2, where the coalescence of the drops promotes a surface cooling, identified by a temperature drop of 0.7 °C in the hydrophilic areas. Those areas have an average temperature of 101.8 °C, whilst the average temperature of the superhydrophobic spots at coalescence time is of 102.9 °C. For low concentrations as the ones used in this work, the effect of the nanofluids was observed to play a minor role. This can be observed on the slight discrepancy of the heat dissipation decay that occurred in the necking stage of the bubbles for nanofluids with the same kind of nanoparticles and different concentration. For the Au 0.1 wt% nanofluid, a heat dissipation decay of 350 W/m2 was reported, whilst for the Au 0.5 wt% nanofluid, the same decay was only of 280 W/m2. The results of the numerical model concerning velocity fields indicated a sudden acceleration at the bubble detachment, as can be qualitatively analyzed in the thermographic images obtained in this work. Additionally, the temperature fields of the analyzed region present the same tendency as the experimental results.

Dataset Information

Swing-like pool boiling on nano-textured surfaces for microgravity applications related to cooling of high-power microelectronics.

Publications

Swing-like pool boiling on nano-textured surfaces for microgravity applications related to cooling of high-power microelectronics.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets