Preferential synthesis of (6,4) single-walled carbon nanotubes by controlling oxidation degree of Co catalyst.
Ontology highlight
ABSTRACT:
SUBMITTER: Xu B
PROVIDER: S-EPMC5593930 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:In this work, we studied enzyme-catalyzed oxidation of single-walled carbon nanotubes (SWCNTs) produced by the high-pressure carbon monoxide (HiPco) method. While oxidation via strong acids introduced defect sites on SWCNTs and suppressed their near-infrared (NIR) fluorescence, our results indicated that the fluorescence of SWCNTs was restored upon enzymatic oxidation, providing new evidence that the reaction catalyzed by horseradish peroxidase (HRP) in the presence of H2O2 is mainly a defect-consuming step. These results were further supported by both UV-vis-NIR and Raman spectroscopy. Therefore, when acid oxidation followed by HRP-catalyzed enzyme oxidation was employed, shortened (<300 nm in length) and NIR-fluorescent SWCNTs were produced. In contrast, upon treatment with myeloperoxidase, H2O2, and NaCl, the oxidized HiPco SWCNTs underwent complete oxidation (i.e., degradation). The shortened, NIR-fluorescent SWCNTs resulting from HRP-catalyzed oxidation of acid-cut HiPco SWCNTs may find applications in cellular NIR imaging and drug delivery systems.
| S-EPMC3773842 | biostudies-literature
Project description:Structural engineering is an effective methodology for the tailoring of the quantities of active sites in nanostructured materials for fuel cell applications. In the present study, Co nanoparticles were incorporated into the network of 3D nitrogen-doped carbon tubes (Co@NCNTs) that were obtained via the molten-salt synthetic approach at 800 °C. Morphological representation reveals that the Co@NCNTs are encompassed with Co nanoparticles on the surface of the mesoporous walls of the carbon nanotubes, which offers a significant active surface area for electrochemical reactions. The CoNPs/NCNTs-1 (treated with CaCl2) nanomaterial was used as a potential candidate for the electro-oxidation of hydrazine, which improved the response of hydrazine (~8.5 mA) in 1.0 M NaOH, as compared with CoNPs/NCNTs-2 (treated without CaCl2), NCNTs, and the unmodified GCE. Furthermore, the integration of Co helps to improve the conductivity and promote the lower onset electro-oxidation potential (-0.58 V) toward the hydrazine electro-oxidation reaction. In particular, the CoNPs/NCNTs-1 catalysts showed significant catalytic activity and stability performances i.e., the i-t curves showed notable stability when compared with their initial current responses, even after 10 days, which indicates the significant durability of the catalyst materials. This work could present a new approach for the design of efficient electrode materials, which can be used as a favorable candidate for the electro-oxidation of liquid fuels in fuel cell applications.
| S-EPMC8619281 | biostudies-literature
Project description:This work is dedicated to the study of the treatment of multi-walled carbon nanotubes (MWCNTs) with dichromic acid. The dichromic acid was formed by dissolving different concentrations of CrO3 in water. The effect of the concentration of dichromic acid on the change in texture characteristics, elemental composition, defectiveness, graphitization degree, and surface chemistry of MWCNTs was investigated using various analytical techniques, such as transmission electron microscopy, energy-dispersive X-ray spectroscopy (EDX), Fourier transform infrared spectroscopy (FTIR), X-ray diffraction, and X-ray photoelectron spectroscopy (XPS). Testing of MWCNTs as electrodes for supercapacitors in 3.5 M H2SO4 solution was carried out using cyclic voltammetry. A decrease in the average diameter of CNTs after treatment was found. The EDX and XPS showed that the oxygen content on the surface of MWCNTs increased after treatment with dichromic acid. The formation of Cr2O3 after treatment with dichromic acid was detected by XPS. High angle annular dark field scanning transmission electron microscopy was used to confirm the intercalation of the chromium-containing compound between graphene layers of MWCNTs after treatment with dichromic acid. It was found that two different types of MWCNTs showed diverse behavior after treatment. The highest specific capacitance of the MWCNTs after treatment was 141 F g-1 (at 2 mV s-1) compared to 0.3 F g-1 for the untreated sample.
| S-EPMC10456443 | biostudies-literature
Project description:We report on a dip-coating method to prepare catalyst particles (mixture of iron and cobalt) with a controlled diameter distribution on silicon wafer substrates by changing the solution's concentration and withdrawal velocity. The size and distribution of the prepared catalyst particles were analyzed by atomic force microscopy. Carbon nanotubes were grown by chemical vapor deposition on the substrates with the prepared catalyst particles. By decreasing the catalyst particle size to below 10 nm, the growth of carbon nanotubes can be tuned from few-walled carbon nanotubes, with homogeneous diameter, to highly pure single-walled carbon nanotubes. Analysis of the Raman radial breathing modes, using three different Raman excitation wavelengths (488, 633, and 785 nm), showed a relatively broad diameter distribution (0.8-1.4 nm) of single-walled carbon nanotubes with different chiralities. However, by changing the composition of the catalyst particles while maintaining the growth parameters, the chiralities of single-walled carbon nanotubes were reduced to mainly four different types, (12, 1), (12, 0), (8, 5), and (7, 5), accounting for about 70% of all nanotubes.
| S-EPMC3381010 | biostudies-literature
Project description:We examined the effect of hydrogen on the growth of single-walled carbon nanotubes in the aerosol (a specific case of the floating catalyst) chemical vapor deposition process using ethylene as a carbon source and ferrocene as a precursor for a Fe-based catalyst. With a comprehensive set of physical methods (UV-vis-NIR and Raman spectroscopies, transmission electron microscopy, scanning electron microscopy, differential mobility analysis, and four-probe sheet resistance measurements), we showed hydrogen to inhibit ethylene pyrolysis extending the window of synthesis parameters. Moreover, the detailed study at different temperatures allowed us to distinguish three different regimes for the hydrogen effect: pyrolysis suppression at low concentrations (I) followed by surface cleaning/activation promotion (II), and surface blockage/nanotube etching (III) at the highest concentrations. We believe that such a detailed study will help to reveal the complex role of hydrogen and contribute toward the synthesis of single-walled carbon nanotubes with detailed characteristics.
| S-EPMC10180455 | biostudies-literature
Project description:In this work, technetium-99 (99mTc) was used as the radiolabeling isotope to study the biodistribution of oxidized multi-walled carbon nanotubes (oMWCNTs) and/or nanodiamonds (NDs) in mice after intravenous administration. The histological impact of non-radiolabeled oMWCNTs or NDs was investigated in comparison to the co-exposure groups. 99mTc-labeled nanomaterials had high stability in vivo and fast clearance from blood. After a single injection of oMWCNTs, the highest distribution was found in the lungs, with lower uptake in the liver/spleen. As for NDs injected alone, high distribution in the liver, spleen, and lungs was observed right after. However, uptake in the lungs was decreased obviously after 24?h, while high accumulation in the liver or spleen continued. After co-injection of oMWCNTs and NDs, oMWCNTs significantly affected the distribution pattern of NDs in vivo. Meanwhile, the increasing dose of oMWCNTs decreased the hepatic and splenic accumulation of NDs and gradually increased lung retention. On the contrary, the NDs had no significant effects on the distribution of oMWCNTs in mice. Histological photographs showed that oMWCNTs were mainly captured by lung macrophages, and NDs were located in the bronchi and alveoli after co-administration. oMWCNTs and NDs had different modes of micro-cells. In conclusion, the behavior and fate of NDs in mice depended strongly on oMWCNTs, but NDs had a small influence on the biodistribution and excretion pattern of oMWCNTs.
| S-EPMC3478214 | biostudies-literature
Project description:Carbon nanotubes (CNTs), owing to their high surface area-to-volume ratio and hollow core, can be employed as hosts for adsorbed and/or encapsulated molecules. At high temperatures, the ends of CNTs close spontaneously, which is relevant for several applications, including catalysis, gas storage, and biomedical imaging and therapy. This study highlights the influence of the annealing temperature in the range between 400 and 1100 °C on the structure and morphology of single-walled CNTs. The nitrogen adsorption and density functional theory calculations indicate that the fraction of end-closed CNTs increases with temperature. Raman spectroscopy reveals that the thermal treatment does not alter the tubular structure. Insight is also provided into the efficacy of CNTs filling from the molten phase, depending on the annealing temperature. The CNTs are filled with europium (III) chloride and analyzed by using electron microscopy (scanning electron microscopy and high-resolution transmission electron microscopy) and energy-dispersive X-ray spectroscopy, confirming the presence of filling and closed ends. The filling yield increases with temperature, as determined by thermogravimetric analysis. The obtained results show that the apparent surface area of CNTs, fraction of closed ends, and amount of encapsulated payload can be tailored via annealing.
| S-EPMC8704686 | biostudies-literature
Project description:The world-wide production of carbon nanotubes (CNTs) has increased substantially in the last decade, leading to occupational exposures. There is a paucity of exposure data of workers involved in the commercial production of CNTs. The goals of this study were to assess personal exposure to multi-walled carbon nanotubes (MWCNTs) during the synthesis and handling of MWCNTs in a commercial production facility and to link these exposure levels to specific activities. Personal full-shift filter-based samples were collected, during commercial production and handling of MWCNTs, R&D activities, and office work. The concentrations of MWCNT were evaluated on the basis of EC concentrations. Associations were studied between observed MWCNT exposure levels and location and activities. SEM analyses showed MWCNTs, present as agglomerates ranging between 200 nm and 100 µm. Exposure levels of MWCNTs observed in the production area during the full scale synthesis of MWCNTs (N = 23) were comparable to levels observed during further handling of MWCNTs (N = 19): (GM (95% lower confidence limit-95% upper confidence limit)) 41 μg m(-3) (20-88) versus 43 μg m(-3) (22-86), respectively. In the R&D area (N = 11) and the office (N = 5), exposure levels of MWCNTs were significantly (P < 0.05) lower: 5 μg m(-3) (2-11) and 7 μg m(-3) (2-28), respectively. Bagging, maintenance of the reactor, and powder conditioning were associated with higher exposure levels in the production area, whereas increased exposure levels in the R&D area were related to handling of MWCNTs powder.
| S-EPMC4834915 | biostudies-literature
Project description:Long carbon nanotubes (CNTs) resemble asbestos fibers due to their high length to diameter ratio and they thus have genotoxic effects. Another parameter that might explain their genotoxic effects is contamination with heavy metal ions. On the other hand, short (1-2 µm) CNTs do not resemble asbestos fibers, and, once purified from contaminations, they might be suitable for medical applications. To identify the role of fiber thickness and surface properties on genotoxicity, well-characterized short pristine and carboxylated single-walled (SCNTs) and multi-walled (MCNTs) CNTs of different diameters were studied for cytotoxicity, the cell's response to oxidative stress (immunoreactivity against hemoxygenase 1 and glutathione levels), and in a hypoxanthine guanine phosphoribosyltransferase (HPRT) assay using V79 chinese hamster fibroblasts and human lung adenocarcinoma A549 cells. DNA repair was demonstrated by measuring immunoreactivity against activated histone H2AX protein. The number of micronuclei as well as the number of multinucleated cells was determined. CNTs acted more cytotoxic in V79 than in A549 cells. Plain and carboxylated thin (<8 nm) SCNTs and MCNTs showed greater cytotoxic potential and carboxylated CNTs showed indication for generating oxidative stress. Multi-walled CNTs did not cause HPRT mutation, micronucleus formation, DNA damage, interference with cell division, and oxidative stress. Carboxylated, but not plain, SCNTs showed indication for in vitro DNA damage according to increase of H2AX-immunoreactive cells and HPRT mutation. Although short CNTs presented a low in vitro genotoxicity, functionalization of short SCNTs can render these particles genotoxic.
| S-EPMC4434219 | biostudies-literature
Project description:While several approaches have been developed for sorting metallic (m) or semiconducting (s) single-walled carbon nanotubes (SWCNTs), the length of SWCNTs is limited within a micrometer, which restricts excellent electrical performances of SWCNTs for macro-scale applications. Here, we demonstrate a simple sorting method of centimetre-long aligned m- and s-SWCNTs. Ni particles were selectively and uniformly coated along the 1-cm-long m-SWCNTs by applying positive gate bias during electrochemical deposition with continuous electrolyte injection. To sort s-SWCNTs, the Ni coating was oxidized to form insulator outer for blocking of current flow through inner m-SWCNTs. Sorting of m-SWCNTs were demonstrated by selective etching of s-SWCNTs via oxygen plasma, while the protected m-SWCNTs by Ni coating remained intact. The series of source-drain pairs were patterned along the 1-cm-long sorted SWCNTs, which confirmed high on/off ratio of 10(4)-10(8) for s-SWCNTs and nearly 1 for m-SWCNTs.
| S-EPMC4967858 | biostudies-literature