Dataset Information

Experimental data for aluminum removal from aqueous solution by raw and iron-modified granular activated carbon.

ABSTRACT: This dataset deals with the modification of granular activated carbon (GAC) with FeCl3 under basic conditions (pH ? 12) for removal of aluminium (Al) from aqueous solution. The structural properties and operational parameters including Al ion concentration (2.15 and 10.3?mg/L), pH solution (2-10), adsorbent dosage (0.1-5?g/L), and contact time (0-10?h) was investigated for raw and modified GAC. This dataset provides information about Al removal by GAC and modified GAC at conditions including: pH = 8, contact time = 6?h, initial Al concentration = 2.15?mg/L. The characterization data of the adsorbents was analysed by Fourier transform infrared (FTIR) spectroscopy, scanning electron microscopy (SEM) and Brunauer, Emmett and Teller (BET) test. The data showed that Freundlich isotherm with and Pseudo second order kinetic model were the best models for describing the Al adsorption reactions. The acquired data indicated that the maximum adsorption capacity of GAC and modified GAC to uptake Al (C0 = 10.3?mg/L) was 3 and 4.37?mg/g respectively.

SUBMITTER: Mahdavi M

PROVIDER: S-EPMC5988382 | biostudies-literature | 2018 Apr

REPOSITORIES: biostudies-literature

ACCESS DATA

Publications

Experimental data for aluminum removal from aqueous solution by raw and iron-modified granular activated carbon.

Mahdavi Mokhtar M Ebrahimi Afshin A Mahvi Amir Hossein AH Fatehizadeh Ali A Karakani Farham F Azarpira Hossein H

Data in brief 20180131

This dataset deals with the modification of granular activated carbon (GAC) with FeCl<sub>3</sub> under basic conditions (pH ≈ 12) for removal of aluminium (Al) from aqueous solution. The structural properties and operational parameters including Al ion concentration (2.15 and 10.3 mg/L), pH solution (2-10), adsorbent dosage (0.1-5 g/L), and contact time (0-10 h) was investigated for raw and modified GAC. This dataset provides information about Al removal by GAC and modified GAC at conditions in ...[more]

PMID: 29876430

Similar Datasets

Project description:Nitrification and distillation of urine allow for the recovery of all nutrients in a highly concentrated fertilizer solution. However, pharmaceuticals excreted with urine are only partially removed during these two process steps. For a sustainable and safe application, more extensive removal of pharmaceuticals is necessary. To enhance the pharmaceutical removal, which is already occurring during urine storage, nitrification and distillation, an adsorption column with granular activated carbon (GAC) can be included in the treatment train. We executed a pilot-scale study to investigate the adsorption of eleven indicator pharmaceuticals on GAC. During 74 days, we treated roughly 1000 L of pre-filtered and nitrified urine spiked with pharmaceuticals in two flow-through GAC columns filled with different grain sizes. We compared the performance of these columns by calculating the number of treated bed volumes until breakthrough and carbon usage rates. The eleven spiked pharmaceuticals were candesartan, carbamazepine, clarithromycin, diclofenac, emtricitabine, hydrochlorothiazide, irbesartan, metoprolol, N4-acetylsulfamethoxazole, sulfamethoxazole and trimethoprim. At the shortest empty bed contact time (EBCT) of 25 min, immediate breakthrough was observed in both columns shortly after the start of the experiments. Strong competition by natural organic material (NOM) could have caused the low pharmaceutical removal at the EBCT of 25 min. At EBCTs of 70, 92 and 115 min, more than 660 bed volumes could be treated until breakthrough in the column with fine GAC. The earliest breakthrough was observed for candesartan and clarithromycin. On coarse GAC, only half the number of bed volumes could be treated until breakthrough compared to fine GAC. The probable reason for the later breakthrough with fine GAC is the smaller intraparticle diffusive path length. DOC and UV absorbance measurements at 265 nm indicated that both parameters can be used as indicators for the breakthrough of pharmaceuticals. In contrast to pharmaceuticals and DOC, the nutrient compounds ammonium, nitrate, phosphate, potassium and sulfate were not removed significantly. A comparison with literature values suggests that the amount of GAC needed to remove pharmaceuticals from human excreta could be reduced by nearly two orders of magnitude, if urine were treated on site instead of being discharged and treated in a centralized wastewater treatment plant.

Project description:Oil palm trunk (OPT) represents one of the five main oil palm biomass wastes with high carbon content that can be economically converted to a large surface area, porous activated carbon (AC) adsorbent to treat palm oil mill effluent wastewater in Indonesia and Malaysia. In the first portion of this work, the design of the experiment was used to determine the optimum set of synthesis parameters required to maximize the iodine number of AC [i.e., Brunauer-Emmett-Teller (BET) specific surface area indicator] prepared from OPT via chemical activation route using H3PO4. The iodine numbers of AC and AC yield were probed as the impregnation ratio, the activation time, and the activation temperature were varied in the range of 0.28-3.47, 5.68-69.32 min, and 379-521 °C, respectively. An impregnation ratio of 2.29, an activation time of 6 min, and an activation temperature of 450 °C were identified as the optimum set of synthesis parameters. In the second portion of the work, the AC synthesized using the optimum parameters were then characterized and tested as an adsorbent for tannin. N2 sorption results revealed that the AC exhibits type IV isotherm, that is, contains micropores and mesopores and displays a relatively high BET specific surface area of 1657 m2 g-1. Adsorption equilibria isotherms for tannin adsorption onto the AC were collected at three different pH of 2, 4, and 6 and were nonlinearly fitted using Langmuir and Freundlich isotherm models, where the Langmuir isotherm gave better fitting than Freundlich. The higher adsorption capacity at lower pH can be explained in terms of the absence of electrostatic repulsion interaction between the AC surface and the tannic acid species as suggested by the point of zero charges (pHpzc) of 4.8 and an increasing ionization of tannic acid with pH rise between 4 and 7. Adsorption kinetics data were also obtained at four different pH of 2, 4, 6, and 8 where the nonlinear pseudo-first-order model best fitted the kinetic at pH of 2 and the nonlinear pseudo-second-order model represented the kinetic best at the remaining higher pH, which suggests that tannin adsorption onto AC occurred by physisorption at pH of 2 and by chemisorption at pH of 4, 6, and 8.

Dataset Information

Experimental data for aluminum removal from aqueous solution by raw and iron-modified granular activated carbon.

Publications

Experimental data for aluminum removal from aqueous solution by raw and iron-modified granular activated carbon.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets