Dataset Information

Induced seismicity response of hydraulic fracturing: results of a multidisciplinary monitoring at the Wysin site, Poland.

ABSTRACT: Shale oil and gas exploitation by hydraulic fracturing experienced a strong development worldwide over the last years, accompanied by a substantial increase of related induced seismicity, either consequence of fracturing or wastewater injection. In Europe, unconventional hydrocarbon resources remain underdeveloped and their exploitation controversial. In UK, fracturing operations were stopped after the Mw 2.3 Blackpool induced earthquake; in Poland, operations were halted in 2017 due to adverse oil market conditions. One of the last operated well at Wysin, Poland, was monitored independently in the framework of the EU project SHEER, through a multidisciplinary system including seismic, water and air quality monitoring. The hybrid seismic network combines surface mini-arrays, broadband and shallow borehole sensors. This paper summarizes the outcomes of the seismological analysis of these data. Shallow artificial seismic noise sources were detected and located at the wellhead active during the fracturing stages. Local microseismicity was also detected, located and characterised, culminating in two events of Mw 1.0 and 0.5, occurring days after the stimulation in the vicinity of the operational well, but at very shallow depths. A sharp methane peak was detected ~19?hours after the Mw 0.5 event. No correlation was observed between injected volumes, seismicity and groundwater parameters.

SUBMITTER: Lopez-Comino JA

PROVIDER: S-EPMC5988740 | biostudies-literature | 2018 Jun

REPOSITORIES: biostudies-literature

ACCESS DATA

Publications

Induced seismicity response of hydraulic fracturing: results of a multidisciplinary monitoring at the Wysin site, Poland.

López-Comino J A JA Cesca S S Jarosławski J J Montcoudiol N N Heimann S S Dahm T T Lasocki S S Gunning A A Capuano P P Ellsworth W L WL

Scientific reports 20180605 1

Shale oil and gas exploitation by hydraulic fracturing experienced a strong development worldwide over the last years, accompanied by a substantial increase of related induced seismicity, either consequence of fracturing or wastewater injection. In Europe, unconventional hydrocarbon resources remain underdeveloped and their exploitation controversial. In UK, fracturing operations were stopped after the M<sub>w</sub> 2.3 Blackpool induced earthquake; in Poland, operations were halted in 2017 due ...[more]

PMID: 29872137

Similar Datasets

Project description:Hydraulic fracturing (HF) is a reservoir stimulation technique that has been widely deployed in recent years to increase the productivity of light oil and/or natural gas from organic-rich, low-permeability formations. Although the process of fracturing a rock typically results in microseismic events of magnitude < 0, many cases of felt seismic events (typically magnitude 3.0 or larger) have also been reported. In the Western Canada Sedimentary Basin (WCSB), where more than 40,000 wells have been drilled and hydraulically fractured in the past two decades, the occurrence of HF-induced events has surged in some areas. Yet, many other areas of the WCSB have not experienced a significant increase in induced seismicity, despite a sharp increase in both the number of HF wells and the volumes of injected fluid. The relationship between injected volume and induced magnitudes can be quantified using the seismic efficiency ratio (SEFF), which describes the ratio between the net seismic moment release and the injected fluid volume. Runaway rupture, in which the fault rupture is dominated by the release of accumulated tectonic stresses, is inferred to be marked by an abrupt increase in SEFF to a value > 0.5. Most previous studies of induced earthquakes have been limited to a single operation and/or seismicity sequence. To better understand the observed variability of the seismic response to HF stimulations at a basin scale, we compiled HF data for all unconventional wells hydraulic fractured in the WCSB between 2000 and 2020, together with the seismicity reported during the same period. We grouped these observations into bins measuring 0.2° in longitude and 0.1° in latitude, or approximately 13 by 11 km. We identified 14 areas where large magnitude events resulted in high SEFF values, implying runaway rupture had taken place. However, we find that in these areas, sustained fluid injection did not lead to persistent high SEFF values. Instead, as injection continued, SEFF values returned to values less than 0.5. This suggests that there is a limited budget of tectonic strain energy available to generate runaway rupture events: once this is released, event magnitudes decrease even if high volume injection persists.

Dataset Information

Induced seismicity response of hydraulic fracturing: results of a multidisciplinary monitoring at the Wysin site, Poland.

Publications

Induced seismicity response of hydraulic fracturing: results of a multidisciplinary monitoring at the Wysin site, Poland.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets