Dataset Information

Electronic Devices That Identify Individuals with Fever in Crowded Places: A Prototype.

ABSTRACT: Most epidemiological surveillance systems for severe infections with epidemic potential are based on accumulated symptomatic cases in defined geographical areas. Eventually, all cases have to be clinically verified to confirm an outbreak. These patients will present high fever at the early stages of the disease. Here, we introduce a non-invasive low-cost electronic device (bracelet) that measures and reports 24/7, year-round information on the temperature, geographical location, and identification of the subject using the device. The data receiver can be installed in a tower (ground) or a drone (air) in densely populated or remote areas. The prototype was made with low-cost electronic components, and it was tested indoors and outdoors. The prototype shows efficient ground and air connectivity. This electronic device will allow health professionals to monitor the prevalence of fever in a geographical area and to reduce the time span between the presentation of the first cases of a potential outbreak and their medical evaluation by giving an early warning. Field tests of the device, programs, and technical diagrams of the prototype are available as ^{Supplementary Materials}.

SUBMITTER: Polanco Gonzalez C

PROVIDER: S-EPMC6189754 | biostudies-literature | 2017 Jun

REPOSITORIES: biostudies-literature

ACCESS DATA

Publications

Electronic Devices That Identify Individuals with Fever in Crowded Places: A Prototype.

Polanco González Carlos C Islas Vazquez Ignacio I Castañón González Jorge Alberto JA Buhse Thomas T Arias-Estrada Miguel M

Micromachines 20170624 7

Most epidemiological surveillance systems for severe infections with epidemic potential are based on accumulated symptomatic cases in defined geographical areas. Eventually, all cases have to be clinically verified to confirm an outbreak. These patients will present high fever at the early stages of the disease. Here, we introduce a non-invasive low-cost electronic device (bracelet) that measures and reports 24/7, year-round information on the temperature, geographical location, and identificati ...[more]

PMID: 30400392

Similar Datasets

Project description:To investigate passive vaping due to sub-ohm electronic cigarettes (e-cigs), aerosol number size distribution measurements (6 nm-10 µm) were performed during volunteer-vaping sessions. E-liquids, with vegetable glycerin (VG) and propylene glycol (PG), with a VG/PG ratio of 50/50 (with nicotine) and 80/20 (without nicotine), were vaped with a double-coil, single aerosol exit hole at 25-80 W electric power, corresponding to 130-365 kW m-2 heat fluxes and with an octa-coil, four aerosol exit holes atomizers, at 50-150 W electric power, corresponding to 133-398 kW m-2 heat fluxes. At the lowest heat flux, lower particle number concentrations (NTot) were observed for the nicotine-liquid than for the nicotine-free liquid, also due to its higher content of PG, more volatile than VG. For the octa-coil atomizer, at 265 and 398 kW m-2, NTot decreased below the first-generation e-cig, whereas volume concentrations greatly increased, due to the formation of super micron droplets. Higher volume concentrations were observed for the 80/20 VG/PG liquid, because of VG vaporization and of its decomposition products, greater than for PG. For the double coil atomizer, increasing the electric power from 40 W (208 kW m-2) to 80 W (365 kW m-2) possibly led to a critical heat flow condition, causing a reduction of the number concentrations for the VG/PG 50/50 liquid, an increase for the 80/20 VG/PG liquid and a decrease of the volume concentrations for both of them. Coherently, the main mode was at about 0.1 µm on both metrics for both liquids. For the other tests, two main modes (1 and 2 µm) were observed in the volume size distributions, the latter becoming wider at 100 and 150 W (265 and 398 kW m-2), suggesting the increased emission of light condensable decomposition products. The lower aerosol emissions observed at 150 W than at 100 W suggest the formation of gas-phase decomposition products. The observation of low-count high-volume aerosols addresses the relevance of the volume metric upon measuring the second-hand concentration of the aerosols released by sub-ohm e-cigarettes.

Dataset Information

Electronic Devices That Identify Individuals with Fever in Crowded Places: A Prototype.

Publications

Electronic Devices That Identify Individuals with Fever in Crowded Places: A Prototype.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets