Dataset Information

Software-based noise reduction in cranial magnetic resonance imaging: Influence on image quality.

ABSTRACT:

Objectives

To investigate acoustic noise reduction, image quality and white matter lesion detection rates of cranial magnetic resonance imaging (MRI) scans acquired with and without sequence-based acoustic noise reduction software.

Material and methods

Thirty-one patients, including 18 men and 13 women, with a mean age of 58.3±14.5 years underwent cranial MRI. A fluid-attenuated inversion recovery (FLAIR) sequence was acquired with and without acoustic noise reduction using the Quiet Suite (QS) software (Siemens Healthcare). During data acquisition, peak sound pressure levels were measured with a sound level meter (Testo, Typ 815). In addition, two observers assessed subjective image quality for both sequences using a five-point scale (1 very good-5 inadequate). Signal-to-noise ratio (SNR) was measured for both sequences in the following regions: white matter, gray matter, and cerebrospinal fluid. Furthermore, lesion detection rates in white matter pathologies were evaluated by two observers for both sequences. Acoustic noise, image quality including SNR and white matter lesion detection rates were compared using the Mann-Whitney-U-test.

Results

Peak sound pressure levels were slightly but significantly reduced using QS, P?0.017. Effective sound pressure, measured in Pascal, was decreased by 19.7%. There was no significant difference in subjective image quality between FLAIR sequences acquired without/with QS: observer 1: 2.03/2.07, P = 0.730; observer 2: 1.98/2.10, P = 0.362. In addition, SNR was significantly increased in white matter, P?0.001, and gray matter, P = 0.006, using QS. The lesion detection rates did not decline utilizing QS: observer 1: P = 0.944 observer 2: P = 0.952.

Conclusions

Sequence-based noise reduction software such as QS can significantly reduce peak sound pressure levels, without a loss of subjective image quality and increase SNR at constant lesion detection rates.

SUBMITTER: Fuelkell P

PROVIDER: S-EPMC6211671 | biostudies-literature | 2018

REPOSITORIES: biostudies-literature

ACCESS DATA

Publications

Software-based noise reduction in cranial magnetic resonance imaging: Influence on image quality.

Fuelkell Philipp P Langner Soenke S Friedrich Nele N Kromrey Marie-Luise ML Radosa Christoph G CG Platzek Ivan I Mensel Birger B Kühn Jens-Peter JP

PloS one 20181101 11

<h4>Objectives</h4>To investigate acoustic noise reduction, image quality and white matter lesion detection rates of cranial magnetic resonance imaging (MRI) scans acquired with and without sequence-based acoustic noise reduction software.<h4>Material and methods</h4>Thirty-one patients, including 18 men and 13 women, with a mean age of 58.3±14.5 years underwent cranial MRI. A fluid-attenuated inversion recovery (FLAIR) sequence was acquired with and without acoustic noise reduction using the Qu ...[more]

PMID: 30383774

Similar Datasets

Project description:Intraoperative magnetic resonance imaging (iMRI) is a tool now commonly used in neurosurgery. Safe and reliable patient care in this (or any other) operating room setting depends on an environment, where electrical noise (EN) does not interfere with the operation of the electronic monitoring or imaging equipment. In this investigation, we evaluated the EN generated by the iMRI system and the anesthesia patient monitor used at this institution that impacts the performance of these two devices.We measured the EN generated by our iMRI-compatible anesthesia patient monitor as detected by the EN analysis algorithm in our iMRI system. We measured the EN generated by our iMRI system during scanning as detected in the electrocardiogram (ECG) waveform of our patient monitor. We analyzed the effects on EN reduction and signal quality of the ECG noise filters provided in our iMRI-compatible anesthesia patient monitor.Our patient monitor generated EN that was detectable by the iMRI EN analysis algorithm; however, this interference was within the iMRI manufacturer's acceptable limits for an iMRI scan (<10% more than background system-level noise). In the clinical case analyzed, the iMRI generated a narrow-band low-frequency (20 Hz) relatively high-energy EN that interfered with the ECG signal of our patient monitor during an iMRI scan. This EN was correlated with the acoustic noise from the iMRI system during the scan and was associated with the radio frequency (RF) and magnetic gradient pulsations of the iMRI system. The integrity of the ECG waveform was nearly entirely lost during a scan. The filters of the ECG monitor diminished but did not entirely eliminate this 20 Hz interference. We found that the filters alter the morphology of the ECG signal, which may make it difficult to identify clinically relevant ECG changes.The EN generated by our anesthesia patient monitor is within acceptable limits for the iMRI system. The iMRI generates EN which renders the ECG unreadable in the most commonly used filter mode. The monitor's filters diminish this noise but also alter the morphology of the ECG waveform. The anesthesiologist must be cognizant of these technical compromises and recognize that adjusting the ECG filters on the monitor is required to obtain a useful ECG signal for patient monitoring during the iMRI scan but that the diagnostic value of the ECG will be reduced.

Project description:The goal of this work is to develop software that enables the rapid implementation of custom MRI spectrometers using commercially-available software defined radios (SDRs). The developed gr-MRI software package comprises a set of Python scripts, flowgraphs, and signal generation and recording blocks for GNU Radio, an open-source SDR software package that is widely used in communications research. gr-MRI implements basic event sequencing functionality, and tools for system calibrations, multi-radio synchronization, and MR signal processing and image reconstruction. It includes four pulse sequences: a single-pulse sequence to record free induction signals, a gradient-recalled echo imaging sequence, a spin echo imaging sequence, and an inversion recovery spin echo imaging sequence. The sequences were used to perform phantom imaging scans with a 0.5Tesla tabletop MRI scanner and two commercially-available SDRs. One SDR was used for RF excitation and reception, and the other for gradient pulse generation. The total SDR hardware cost was approximately $2000. The frequency of radio desynchronization events and the frequency with which the software recovered from those events was also measured, and the SDR's ability to generate frequency-swept RF waveforms was validated and compared to the scanner's commercial spectrometer. The spin echo images geometrically matched those acquired using the commercial spectrometer, with no unexpected distortions. Desynchronization events were more likely to occur at the very beginning of an imaging scan, but were nearly eliminated if the user invoked the sequence for a short period before beginning data recording. The SDR produced a 500kHz bandwidth frequency-swept pulse with high fidelity, while the commercial spectrometer produced a waveform with large frequency spike errors. In conclusion, the developed gr-MRI software can be used to develop high-fidelity, low-cost custom MRI spectrometers using commercially-available SDRs.

Dataset Information

Software-based noise reduction in cranial magnetic resonance imaging: Influence on image quality.

Objectives

Material and methods

Results

Conclusions

Publications

Software-based noise reduction in cranial magnetic resonance imaging: Influence on image quality.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets