Dataset Information

Electrostatic Origins of CO2-Increased Hydrophilicity in Carbonate Reservoirs.

ABSTRACT: Injecting CO2 into oil reservoirs appears to be cost-effective and environmentally friendly due to decreasing the use of chemicals and cutting back on the greenhouse gas emission released. However, there is a pressing need for new algorithms to characterize oil/brine/rock system wettability, thus better predict and manage CO2 geological storage and enhanced oil recovery in oil reservoirs. We coupled surface complexation/CO2 and calcite dissolution model, and accurately predicted measured oil-on-calcite contact angles in NaCl and CaCl2 solutions with and without CO2. Contact angles decreased in carbonated water indicating increased hydrophilicity under carbonation. Lowered salinity increased hydrophilicity as did Ca2+. Hydrophilicity correlates with independently calculated oil-calcite electrostatic bridging. The link between the two may be used to better implement CO2 EOR in fields.

SUBMITTER: Chen Y

PROVIDER: S-EPMC6283841 | biostudies-literature | 2018 Dec

REPOSITORIES: biostudies-literature

ACCESS DATA

Publications

Electrostatic Origins of CO2-Increased Hydrophilicity in Carbonate Reservoirs.

Chen Yongqiang Y Sari Ahmad A Xie Quan Q Brady Patrick V PV Hossain Md Mofazzal MM Saeedi Ali A

Scientific reports 20181206 1

Injecting CO2 into oil reservoirs appears to be cost-effective and environmentally friendly due to decreasing the use of chemicals and cutting back on the greenhouse gas emission released. However, there is a pressing need for new algorithms to characterize oil/brine/rock system wettability, thus better predict and manage CO2 geological storage and enhanced oil recovery in oil reservoirs. We coupled surface complexation/CO2 and calcite dissolution model, and accu ...[more]

PMID: 30523289

Similar Datasets

Project description:Simple plugging of the high-permeability "thief zones" of oil reservoirs is the most plausible and also the most straightforwardly achievable approach to enhance sweep efficiency and oil recovery. Sporosarcina pasteurii is a representative microorganism with the ability to precipitate calcium carbonate (CaCO3) via enzymatic hydrolysis of urea in the presence of calcium ions. Microbially induced calcium carbonate precipitation (MICP) can cement and seal the granular and fractured media and thus can be used as a potential microbial plugging agent for the high-permeability zones of oil reservoirs. The following investigated the microscopic characteristics of MICP plugging and its efficacy in permeability reduction. The columns of near-spherical silica sand and angular silica sand with three separate granularities (40/60, 60/80, and 80/120 mesh) were used as artificial rock cores representing distinct pore sizes and pore characteristics to investigate the efficacy and microprocess of MICP plugging with different biotreatment periods. The results indicated that permeability is reduced significantly after only short periods of biotreatment. After eight cycles of MICP treatments, the permeability for each type of cores dropped by 54-90% of individual initial permeabilities. The measured CaCO3 content indicated that the decreasing rate in permeability with the increasing CaCO3 content experiences three contrasting stages, namely, slow decline, speedy decline, and plateauing. X-ray diffraction indicated that most of the generated CaCO3 crystals occur as vaterite with only a small amount of calcite. Imaging by scanning electron microscopy further revealed the microprocess of MICP plugging. Microorganisms first concentrate on the pore wall to secrete CaCO3, forming a thin and large uniform layer of CaCO3. Then, some nucleation sites of CaCO3 crystals will experience further preferential growth, resulting in large, dominant crystals that act as a plugging agent within the pore space. Compared to extracellular polymeric substances, which are currently the primary microbial plugging agent used to enhance sweep efficiency of oil reservoirs, bio-CaCO3 appears more effective in plugging in terms of its morphology, size, and growth characteristics.

Project description:Carbon dioxide/epoxide copolymerization is an efficient way to add value to waste CO2 and to reduce pollution in polymer manufacturing. Using this process to make low molar mass polycarbonate polyols is a commercially relevant route to new thermosets and polyurethanes. In contrast, high molar mass polycarbonates, produced from CO2, generally under-deliver in terms of properties, and one of the most widely investigated, poly(cyclohexene carbonate), is limited by its low elongation at break and high brittleness. Here, a new catalytic polymerization process is reported that selectively and efficiently yields degradable ABA-block polymers, incorporating 6-23 wt % CO2. The polymers are synthesized using a new, highly active organometallic heterodinuclear Zn(II)/Mg(II) catalyst applied in a one-pot procedure together with biobased ?-decalactone, cyclohexene oxide, and carbon dioxide to make a series of poly(cyclohexene carbonate-b-decalactone-b-cyclohexene carbonate) [PCHC-PDL-PCHC]. The process is highly selective (CO2 selectivity >99% of theoretical value), allows for high monomer conversions (>90%), and yields polymers with predictable compositions, molar mass (from 38-71 kg mol-1), and forms dihydroxyl telechelic chains. These new materials improve upon the properties of poly(cyclohexene carbonate) and, specifically, they show good thermal stability (Td,5 ? 280 °C), high toughness (112 MJ m-3), and very high elongation at break (>900%). Materials properties are improved by precisely controlling both the quantity and location of carbon dioxide in the polymer chain. Preliminary studies show that polymers are stable in aqueous environments at room temperature over months, but they are rapidly degraded upon gentle heating in an acidic environment (60 °C, toluene, p-toluene sulfonic acid). The process is likely generally applicable to many other lactones, lactides, anhydrides, epoxides, and heterocumulenes and sets the scene for a host of new applications for CO2-derived polymers.

Dataset Information

Electrostatic Origins of CO2-Increased Hydrophilicity in Carbonate Reservoirs.

Publications

Electrostatic Origins of CO<sub>2</sub>-Increased Hydrophilicity in Carbonate Reservoirs.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets