Improving energy efficiency of electrochemical blackwater disinfection through sequential reduction of suspended solids and chemical oxygen demand.
Ontology highlight
ABSTRACT:
SUBMITTER: Hawkins BT
PROVIDER: S-EPMC6350407 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Decentralized, energy-efficient waste water treatment technologies enabling water reuse are needed to sustainably address sanitation needs in water- and energy-scarce environments. Here, we describe the effects of repeated recycling of disinfected blackwater (as flush liquid) on the energy required to achieve full disinfection with an electrochemical process in a prototype toilet system. The recycled liquid rapidly reached a steady state with total solids reliably ranging between 0.50 and 0.65% and conductivity between 20 and 23 mS/cm through many flush cycles over 15 weeks. The increase in accumulated solids was associated with increased energy demand and wide variation in the free chlorine contact time required to achieve complete disinfection. Further studies on the system at steady state revealed that running at higher voltage modestly improves energy efficiency, and established running parameters that reliably achieve disinfection at fixed run times. These results will guide prototype testing in the field.
| S-EPMC5724497 | biostudies-literature
Project description:Electrochemical disinfection (ECD) has become an important blackwater disinfection technology. ECD is a promising solution for the 2 billion people without access to conventional sanitation practices and in areas deficient in basic utilities (e.g., sewers, electricity, waste treatment). Here, we report on the disinfection of blackwater using potential cycling compared to potentiostatic treatment methods in chloride-containing and chloride-free solutions of blackwater (i.e., untreated wastewater containing feces, urine, and flushwater from a toilet). Potentiodynamic treatment is demonstrated to improve disinfection energy efficiency of blackwater by 24% and 124% compared to static oxidation and reduction methods, respectively. The result is shown to be caused by electrochemical advanced oxidation processes (EAOP) and regeneration of sp2-surface-bonded carbon functional groups that serve the dual purpose of catalysts and adsorption sites of oxidant intermediates. Following 24 h electrolysis in blackwater, electrode fouling is shown to be minimized by the potential cycling method when compared to equivalent potentiostatic methods. The potential cycling current density is 40% higher than both the static oxidative and reductive methods. This work enhances the understanding of oxygen reduction catalysts using functionalized carbon materials and electrochemical disinfection anodes, both of which have the potential to bring a cost-effective, energy efficient, and practical solution to the problem of disinfecting blackwater.
| S-EPMC5995412 | biostudies-literature
Project description:Electrolysis of blackwater for disinfection and nutrient removal is a portable and scalable technology that can lessen the need for cities to construct large-scale wastewater treatment infrastructure and enable the safe onsite reuse of blackwater. Several systems for treating wastewater from single toilets are described in the literature, but there are few examples of systems designed to use electrolysis to treat blackwater from nearby toilets, which is a situation more common in densely packed urban living environments. In order to scale a single toilet electrolysis system to one that could service multiple toilets, computational fluid dynamic analysis was used to optimize the electrochemical reactor design, and laboratory and field-testing were used to confirm results. Design efforts included optimization of the reactor shape and mixing to improve treatment efficiency, as well as automated cleaning and salt injection to reduce maintenance and service requirements. PRACTITIONER POINTS: Design of a reverse polarity mechanism to enable in situ electrode cleaning and improve long-term electrode performance. Optimization of a hopper design and drainpipe location to collect and remove flaking precipitates and mitigate maintenance issues. Design of an automated salt injection system to guarantee sufficient chloride levels for producing adequate chlorine residuals for consistent disinfection.
| S-EPMC7818490 | biostudies-literature
Project description:Measurement of total suspended solids (TSS) and total dissolved solids (TDS) loadings in streams is often used to assess potential impacts from mining on surface water quality within a drainage basin. It has been suggested that TSS could be used as an indicator to estimate TDS loading through the use of a TDS/TSS ratio. The reliability of this approach was tested by examining empirical linear relationships between TSS and TDS loads at three locations within a mining-influenced watershed in Colorado. Predictive accuracy of the relationships was assessed using an independent source of data for the same locations, with comparisons between estimated and observed TDS loads for periods within and outside the years used to develop relationships. Evaluations were conducted over the entire flow regime and for separate periods of low- and high-flow. Improved representation of the data was achieved by incorporation of a regressed average baseflow contribution, indicating the relationship between TDS and TSS loads is not accurately represented by a simple ratio. High variability in data between locations prevents application of a basin scale relationship to all locations within that basin. Local-scale relationships developed under specific flow regimes resulted in more accurate predictions, but results suggest that factors additional to flow may need to be considered to improve predictability. Usefulness of linear empirical relationships to predict TDS load from TSS load will depend on the magnitude of uncertainty that is tolerable for a given situation.
| S-EPMC6020674 | biostudies-literature
Project description:In situ generation of reagents and their subsequent use downstream presents new opportunities to amplify the utility of nanofluidic devices by exploiting the confined geometry to address mass transport limitations on reaction kinetics and efficiency. Oxygen, an inherently valuable reactant, can be produced from electrolysis of water, a process that can be conveniently integrated within a nanofluidic system. Here, we construct and characterize a nanofluidic device consisting of a planar microband electrode embedded within a nanochannel for in situ electrochemical generation and optical monitoring of O2. Fluorescein, a dye with a pH-sensitive emission intensity, was used to monitor the spatiotemporal characteristics of the oxidation of H2O, using the co-produced H+. Application of anodic potentials at the nanochannel-embedded electrode results in a decrease in fluorescence intensity, which reflects the decreasing solution pH. A combination of fluorescence intensity and chronoamperometric response was used to quantitatively determine proton generation, and the H+/O2 stoichiometry was then used to determine the concentration of the O2 in the channel. Comparison of the experimental results to finite element simulations validates the use of fluorescein emission intensity to spectroscopically determine the local oxygen concentration in the nanochannel. By varying the applied potential, spatially averaged O2 concentrations ranging from 0.13 to 0.41 mM were generated. The results demonstrate a convenient route to in situ modulation of the dissolved O2 level in a nanofluidic device and the use of an optical probe to monitor its spatial and temporal distribution under flow conditions.
| S-EPMC6178959 | biostudies-literature
Project description:This study surveys the possibility to optimally produce active chlorine from synthetic saline solutions using electrolysis by Response Surface Methodology (RSM). Various operating parameters, such as sodium chloride concentration, electrical potential and electrolysis time were evaluated. Central composite design (CCD) was applied to determine the optimal experimental factors for chlorine production. The experimental design, statistical analysis of the data and optimization were performed using R 3.5.3 software. The results showed that the optimum value of electrical efficiency (42 mg Cl2/kj) was obtained at the electrical voltage of 15.73 V during 15.63 min in the presence of 63.42 g/l of sodium chloride. The optimum point for current efficiency was 38.40%, which was obtained at the electrical voltage of 10.76 V during 6.70 min in the presence of 34.65 g/l of sodium chloride. Moreover, generated active chlorine was optimized based on energy consumption, which was 77 mg/l for the energy consumption of 0.2 kWh/l at a current density of 2000 mA/cm2. The electrochemical production of the chlorine gas from saline or brine water can be extensively used for water disinfection.
| S-EPMC7721780 | biostudies-literature
Project description:Analyses of natural waters frequently show elevated levels of total aluminum (Al) attributable to acid extraction of Al from the total suspended solids (TSS) minerals. Hence, there is a need for an analytical method that measures only bioavailable Al. Natural waters high in TSS were collected to study the chronic effects of Al on Ceriodaphnia dubia. In the collected waters TSS ranged from 30 to 411 mg/L; total Al concentrations ranged from 2.0 to 44.8 mg/L. The TSS in natural waters inhibited reproduction of C. dubia up to 40% in comparison to the same filtered waters. This inhibition did not correlate with the concentration of TSS or total Al; it was attributed to nutritional deficiency and was prevented by increasing the food supply. To demonstrate that toxicity can be measured in natural waters, samples with elevated TSS were spiked with soluble Al, and survival and reproduction were measured in chronic studies performed at pH 6.3 and 8.0. To properly characterize the Al concentrations in the toxicity studies, a method was needed that could discriminate bioavailable Al from mineral forms of Al. An extraction method at pH 4 for bioavailable Al was developed and evaluated using C. dubia chronic toxicity studies in the presence of TSS. It is concluded that the proposed method is better able to discriminate chronic toxicity effects attributable to bioavailable Al from mineralized nontoxic forms of Al compared with existing methods using total or total recoverable Al (i.e., extraction at pH ≤ 1.5). We propose that this new method be used when assessing the potential for Al in natural surface waters to cause toxicity. Environ Toxicol Chem 2019;38:1668-1681. © 2019 The Authors. Environmental Toxicology and Chemistry published by Wiley Periodicals, Inc. on behalf of SETAC.
| S-EPMC6852577 | biostudies-literature
Project description:Suspended particles in rivers can act as carriers of potentially bioavailable metal species and are thus an emerging area of interest in river system monitoring. The delineation of bulk metals concentrations in river water into dissolved and particulate components is also important for risk assessment. Linear relationships between bulk metal concentrations in water (CW,tot) and total suspended solids (TSS) in water can be used to easily evaluate dissolved (CW, intercept) and particle-bound metal fluxes (CSUS, slope) in streams (CW,tot = CW + CSUS TSS). In this study, we apply this principle to catchments in Iran (Haraz) and Germany (Ammer, Goldersbach, and Steinlach) that show differences in geology, geochemistry, land use and hydrological characteristics. For each catchment, particle-bound and dissolved concentrations for a suite of metals in water were calculated based on linear regressions of total suspended solids and total metal concentrations. Results were replicable across sampling campaigns in different years and seasons (between 2013 and 2016) and could be reproduced in a laboratory sedimentation experiment. CSUS values generally showed little variability in different catchments and agree well with soil background values for some metals (e.g. lead and nickel) while other metals (e.g. copper) indicate anthropogenic influences. CW was elevated in the Haraz (Iran) catchment, indicating higher bioavailability and potential human and ecological health concerns (where higher values of CSUS/CW are considered as a risk indicator).
| S-EPMC5771599 | biostudies-literature
Project description:Total Suspended Solids (TSS) and chlorophyll-a concentration are two critical parameters to monitor water quality. Since directly collecting samples for laboratory analysis can be expensive, this paper presents a methodology to estimate this information through remote sensing and Machine Learning (ML) techniques. TSS and chlorophyll-a are optically active components, therefore enabling measurement by remote sensing. Two study cases in distinct water bodies are performed, and those cases use different spatial resolution data from Sentinel-2 spectral images and unmanned aerial vehicles together with laboratory analysis data. In consonance with the methodology, supervised ML algorithms are trained to predict the concentration of TSS and chlorophyll-a. The predictions are evaluated separately in both study areas, where both TSS and chlorophyll-a models achieved R-squared values above 0.8.
| S-EPMC7181123 | biostudies-literature
Project description:Tumor hypoxia presents a unique therapeutic challenge in the treatment of solid malignancies. Its presence has been established to be a poor prognostic factor in multiple cancer types, and past hypoxia-directed approaches have yielded generally disappointing results. Previous approaches have centered on either increasing oxygen delivery or administering agents that preferentially radiosensitize or kill hypoxic cells. However, a novel and potentially more effective method may be to increase therapeutic benefit by decreasing tumor oxygen consumption via agents such as metformin or nelfinavir in a patient population that is enriched for tumor hypoxia. This promising approach is currently being investigated in clinical trials and the subject of this article.
| S-EPMC4418024 | biostudies-literature