Synthesis of nanogate structure in GO-ZnS sandwich material.
Ontology highlight
ABSTRACT:
SUBMITTER: Kumar P
PROVIDER: S-EPMC6353954 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:A novel carbon nanotubes (CNTs) and reduced holey graphene oxide film (RHGOF) sandwich structure has been fabricated to enhance its electrochemical properties. CNTs are grown by a catalyst assisted chemical vapor deposition technique, interpenetrated between the RHGOF layers. A RHGOF/CNTs hybrid film is used as a binder-free supercapacitor electrode. The grown CNTs in the graphene layers structure act as spacers and bridges to increase the counductivity of RHGOF, while the grown CNTs on the surfaces of the graphene contribute to increase the specific surface area of RHGOF. The results demonstrate that the synthesized porous, flexible and binder free hybrid electrode has advantages of higher ion diffusion rate, longer diffusion length and larger ion accessible surface area as compared to the pristine graphene which results in an extra ordinary galvanostatic charge-discharge specific capacitance of 557 F/g at a current density of 0.5 A/g, with excellent rate capabilities and superior cyclic stabilities.
| S-EPMC7012873 | biostudies-literature
Project description:In order to study the interfacial adhesive material simulation method of a sandwich structure with aluminum alloy panels and a low-density foam core under edgewise compression condition, two finite element models were defined using material model no. 185 (MAT 185) adhesive element and tiebreak contact, respectively, by LS-DYNA. Under the conditions of different loading rates, and element sizes, the effects of peak load, energy absorption, failure mode of adhesive layer and the influence degree of the changing condition on the calculated results were compared between the two models, and then compared with the experiment results and theoretical results. The higher the loading rate was, or the smaller the element size was, the higher the peak load was. The simulation results obtained using MAT 185 were closer to the experimental results under the edgewise compression condition.
| S-EPMC7142941 | biostudies-literature
Project description:In this work, Mn doped AIZS/ZnS (Mn:AIZS/ZnS) nanocrystals (NCs) have been synthesized in an approach using heat-up and drop-wise addition of precursors. On the basis of the characterization of these doped NCs on their optical properties and materials, it is found that: (1) as more Mn atoms are doped into NCs, the doped NCs present photoluminescence (PL) red-shift and quantum yield quenching; (2) the doped NCs possess a short PL lifetime in tens of microseconds and a long PL lifetime in hundreds of microseconds, and the short lived PL is more dominant than the long lived one; and (3) the doped NCs present a reversible PL thermal quenching in a range from room temperature to 170°C. Possible PL mechanisms of these NCs were discussed by analyzing their time-resolved PL spectra and thermal stability.
| S-EPMC5724564 | biostudies-literature
Project description:Solvothermal synthesis was used to create a low-dimensional iron(II) chloride formate compound, NH4FeCl2(HCOO), that exhibits interesting magnetic properties. NH4FeCl2(HCOO) crystallizes in the monoclinic space group C2/c (No. 15) with a = 7.888(1) Å, b = 11.156(2) Å, c = 6.920(2) Å, and ? = 108.066(2)°. The crystal structure consists of infinite zigzag chains of distorted Fe(2+)-centered octahedra linked by ?2-Cl and syn-syn formate bridges, with interchain hydrogen bonding through NH4(+) cations holding the chains together. The unique Fe(2+) site is coordinated by four equatorial chlorides at a distance of 2.50 Å and two axial oxygens at a distance of 2.08 Å. Magnetic measurements performed on powder and oriented single-crystal samples show complex anisotropic magnetic behavior dominated by antiferromagnetic interactions (TN = 6 K) with a small ferromagnetic component in the direction of chain propagation. An anisotropic metamagnetic transition was observed in the ordered state at 2 K in an applied magnetic field of 0.85-3 T. (57)Fe Mössbauer spectroscopy reveals mixed hyperfine interactions below the ordering temperature, with strong electric field gradients and complex noncollinear arrangement of the magnetic moments.
| S-EPMC3989075 | biostudies-literature
Project description:Nanotechnology is a growing industry with wide ranging applications in consumer product and technology development. In the biomedical field, nanoparticles are finding increasing use as imaging agents for biomolecular labeling and tumor targeting. The nanoparticle physiochemical properties must be tailored for the specific application. For example, nanoparticle chemical and physical stability in the biological milieu (no oxidation, aggregation, agglomeration or toxicity) are often required. Nanoparticles used for biomolecular fluorescent imaging should also have high quantum yield (QY). The aim of this paper is to examine the QY, stability, and cell toxicity of a series of positive, negative and neutral surface charge quantum dot (QD) nanoparticles. Simple protocols are described to prepare water soluble QDs by modifying the surface with thiol containing antioxidant ligands and polymers keeping the QD core/shell composition constant. The ligands used to produce negatively charged QDs include glutathione (GSH), N-acetyl-L-cysteine (NAC), dihydrolipoic acid (DHLA), tiopronin (TP), bucilliamine (BUC), and mercaptosuccinic acid (MSA). Ligands used to produce positively charged QDs include cysteamine (CYS) and polyethylenimine (PEI). Dithiothreitol (DTT) was used to produce neutral charged QDs. Commercially available nonaqueous octadecylamine (ODA) capped QDs served as the starting material. Our results suggest that QD uptake and cytotoxicity are both dependent on surface ligand coating composition. The negative charged GSH coated QDs show superior performance exhibiting low cytotoxicity, high stability, high QY and therefore are best suited for bioimaging applications. PEI coated QD also show superior performance exhibiting high QY and stability. However, they are considerably more cytotoxic due to their high positive charge which is an advantageous property that can be exploited for gene transfection and/or tumor targeting applications. The synthetic procedures described are straightforward and can be easily adapted in most laboratory settings.
| S-EPMC4749031 | biostudies-literature
Project description:Pure and Eu3+-doped zinc sulfide (ZnS) crystallites were synthesized through a hydrothermal method using water and ethanol (W/E) as the solvent. The powder samples have been characterized systematically using a number of characterization techniques such as X-ray diffraction, scanning electron microscopy, energy-dispersive spectroscopy, photoluminescence spectroscopy, and UV-vis absorption spectroscopy. The band gap of ZnS and ZnS/xEu3+ was calculated according to absorption spectroscopy, and an obvious red shift with the increasing molar fraction of Eu3+-doped ions was found. The luminescent mechanism of ZnS was explored by measuring the emission spectra of ZnS with different ratios of Zn and S. The emission spectra of ZnS/xEu3+ included the characteristic emission peak of ZnS and Eu3+ ions. The CIE chromaticity coordinates of the ZnS/xEu3+ sample varied with the molar fraction of Eu3+ ions. The emission intensity and morphology changed with the ratio of W/E in the process of hydrothermal reaction. The results indicate that the luminescence of the ZnS crystallite can be modulated by doping a certain amount of Eu3+ ions, changing the ratio of Zn and S, or adding moderate ethanol as the reaction medium.
| S-EPMC6641465 | biostudies-literature
Project description:Synthesis and full characterization of cationic isostructural "sandwich" diimine-coinage metal ethylene complexes are reported. Ethylene self-exchange kinetics proceeds by an associative exchange mechanism for Cu and Au complexes. The fastest ligand exchange was observed for Ag complex 8a. The upper limit of ?G‡, assuming associative ligand exchange, was found to be ca. 5.0 kcal/mol. Ethylene self-exchange in Cu complex 7b proceeds with ?G298‡ = 12.9 ± 0.1 kcal/mol, while the exchange is the slowest in Au complex 9, with ?G298‡ = 16.7 ± 0.1 kcal/mol. Copper complex 7b is unusually stable and can survive in air for years.
| S-EPMC5019172 | biostudies-literature
Project description:Metal chalcogenides are attractive anode materials for lithium-ion batteries (LIBs) due to their high theoretical capacities. With the advantages of low cost and abundance reserves, ZnS is regarded as the prime candidate anode material for future generations, but its practical application is hindered by the large volume expansion during repeated cycling processes and inherent poor conductivity. Rational design of the microstructure with large pore volume and high specific surface area is of great significance to solve these problems. Here, a carbon-coated ZnS yolk-shell structure (YS-ZnS@C) has been prepared by selective partial oxidation of a core-shell structured ZnS@C precursor in air and subsequent acid etching. Studies show that the carbon wrapping and proper etching to bring cavities can not only improve the material's electrical conductivity, but can also effectively alleviate the volume expansion problem of ZnS during its cycles. As a LIB anode material, the YS-ZnS@C exhibits an obvious superiority in capacity and cycle life compared to ZnS@C. The YS-ZnS@C composite shows a discharge capacity of 910 mA h g-1 at the current density of 100 mA g-1 after 65 cycles, compared to only 604 mA h g-1 for ZnS@C after 65 cycles. Notably, at a large current density of 3000 mA g-1, a capacity of 206 mA h g-1 can still be maintained after 1000 cycles (over three times of the capacity for ZnS@C). It is expected that the synthetic strategy developed here is applicable to designing various high-performance metal chalcogenide-based anode materials for LIBs.
| S-EPMC10004707 | biostudies-literature
Project description:The intentional introduction of transition metal impurities in semiconductor nanocrystals is an attractive approach for tuning quantum dot emission over a wide range of wavelengths. However, the development of effective doping strategies can be challenging, especially if one simultaneously requires a low-toxicity crystalline core, a functional protein shell, and a "green", single-step synthesis process. Here, we describe a simple and environmentally friendly route for the biofabrication of Cu-doped (blue-green) or Mn-doped (yellow-orange) ZnS nanocrystals surrounded by an antibody-binding protein shell. The ZnS:Mn hybrid particles obtained with this method exhibit a 60% enhancement in maximum photoluminescence intensity relative to undoped nanocrystals and have a hydrodynamic diameter inferior to 10 nm. They can be stored for months at 4 °C, are stable over a physiological range of pH and salt concentrations, can be decorated with variable amounts of antibodies by direct mixing, and hold promise for biosensing and imaging applications.
| S-EPMC3204801 | biostudies-literature
Project description:One of the main culprits in modern drug discovery is apparent cardiotoxicity of many lead-candidates via inadvertent pharmacologic blockade of K+, Ca2+ and Na+ currents. Many drugs inadvertently block hERG1 leading to an acquired form of the Long QT syndrome and potentially lethal polymorphic ventricular tachycardia. An emerging strategy is to rely on interventions with a drug that may proactively activate hERG1 channels reducing cardiovascular risks. Small molecules-activators have a great potential for co-therapies where the risk of hERG-related QT prolongation is significant and rehabilitation of the drug is impractical. Although a number of hERG1 activators have been identified in the last decade, their binding sites, functional moieties responsible for channel activation and thus mechanism of action, have yet to be established. Here, we present a proof-of-principle study that combines de-novo drug design, molecular modeling, chemical synthesis with whole cell electrophysiology and Action Potential (AP) recordings in fetal mouse ventricular myocytes to establish basic chemical principles required for efficient activator of hERG1 channel. In order to minimize the likelihood that these molecules would also block the hERG1 channel they were computationally engineered to minimize interactions with known intra-cavitary drug binding sites. The combination of experimental and theoretical studies led to identification of functional elements (functional groups, flexibility) underlying efficiency of hERG1 activators targeting binding pocket located in the S4-S5 linker, as well as identified potential side-effects in this promising line of drugs, which was associated with multi-channel targeting of the developed drugs.
| S-EPMC4156305 | biostudies-literature