Dataset Information

Investigation and Source Apportionment of Air Pollutants in a Large Oceangoing Ship during Voyage.

ABSTRACT: The aims of this study were to determine compartmental air pollution during navigation of a large oceangoing ship and to identify preliminarily the major pollution sources. During the voyage of a bulk carrier ship, air samples were collected at 18 selected sites using a stratified sampling method. The concentrations of 15 pollutants were determined using gas chromatography. Results showed the concentrations of these pollutants varied significantly among the sampling sites, indicating major pollution sources at or nearby those locations. Five common factors extracted using factor analysis explained 89.092% of the total variance. Multivariate linear regression analysis showed the contributions to air pollution of these five common factors, i.e., the volatilization of ship paint, volatilization of ship-based oil, cooking activities, high-temperature release of rubber components on the ship and daily use of chemical products, and the application of deodorant and insecticide, were 41.07%, 25.14%, 14.37%, 11.78%, and 7.63%, respectively. Three significant groups were determined using cluster analysis based on their similarity, i.e., high, medium, and low pollution of sampling sites. This study established that the air of the bulk carrier ship was heavily polluted, and that effective identification of pollution sources could provide a scientific basis for its control.

SUBMITTER: Wang Q

PROVIDER: S-EPMC6388280 | biostudies-literature | 2019 Jan

REPOSITORIES: biostudies-literature

ACCESS DATA

Publications

Investigation and Source Apportionment of Air Pollutants in a Large Oceangoing Ship during Voyage.

Wang Qiang Q An Daizhi D Sun Rubao R Su Mingxing M

International journal of environmental research and public health 20190130 3

The aims of this study were to determine compartmental air pollution during navigation of a large oceangoing ship and to identify preliminarily the major pollution sources. During the voyage of a bulk carrier ship, air samples were collected at 18 selected sites using a stratified sampling method. The concentrations of 15 pollutants were determined using gas chromatography. Results showed the concentrations of these pollutants varied significantly among the sampling sites, indicating major pollu ...[more]

PMID: 30704038

Similar Datasets

Project description:Using daily fine particulate matter (PM2.5) composition data from the 2000-2005 U.S. EPA Chemical Speciation Network (CSN) for over 200 sites, we applied multivariate methods to identify and quantify the major fine particulate matter (PM2.5) source components in the U.S. Novel aspects of this work were: (1) the application of factor analysis (FA) to multi-city daily data, drawing upon both spatial and temporal variations of chemical species; and, (2) the exclusion of secondary components (sulfates, nitrates and organic carbon) from the source identification FA to more clearly discern and apportion the PM2.5 mass to primary emission source categories. For the quantification of source-related mass, we considered two approaches based upon the FA results: 1) using single key tracers for sources identified by FA in a mass regression; and, 2) applying Absolute Principal Component Analysis (APCA). In each case, we followed a two-stage mass regression approach, in which secondary components were first apportioned among the identified sources, and then mass was apportioned to the sources and to other secondary mass not explained by the individual sources. The major U.S. PM2.5 source categories identified via FA (and their key elements) were: Metals Industry (Pb, Zn); Crustal/Soil Particles (Ca, Si); Motor Vehicle Traffic (EC, NO2); Steel Industry (Fe, Mn); Coal Combustion (As, Se); Oil Combustion (V, Ni); Salt Particles (Na, Cl) and Biomass Burning (K). Nationwide spatial plots of the source-related PM2.5 impacts were confirmatory of the factor interpretations: ubiquitous sources, such as Traffic and Soil, were found to be spread across the nation, more unique sources (such as Steel and Metals Processing) being highest in select industrialized cities, Biomass Burning was highest in the U.S. Northwest, while Residual Oil combustion was highest in cities in the Northeastern U.S. and in cities with major seaports. The sum of these source contributions and the secondary PM2.5 components agreed well with the U.S. PM2.5 observed during the study period (mean=14.3 ug/m3; R2= 0.91). Apportionment regression analyses using single-element tracers for each source category gave results consistent with the APCA estimates. Comparisons of nearby sites indicated that the PM2.5 mass and the secondary aerosols were most homogenous spatially, while traffic PM2.5 and its tracer, EC, were among the most spatially representative of the source-related components. Comparison of apportionment results to a previous analysis of the 1979-1982 IP Network revealed similar and correlated major U.S. source category factors, albeit at lower levels than in the earlier period, suggesting a consistency in the U.S. spatial patterns of these source-related exposures over time, as well. These results indicate that applying source apportionment methods to the nationwide CSN can be an informative avenue for identifying and quantifying source components for the subsequent estimation of source-specific health effects, potentially contributing to more efficient regulation of PM2.5.

Project description:It is well established that in Europe, high O3 concentrations are most pronounced in southern/Mediterranean countries due to the more favourable climatological conditions for its formation. However, the contribution of the different sources of precursors to O3 formation within each country relative to the imported (regional and hemispheric) O3 is poorly quantified. This lack of quantitative knowledge prevents local authorities from effectively designing plans that reduce the exceedances of the O3 target value set by the European air quality directive. O3 source attribution is a challenge because the concentration at each location and time results not only from local biogenic and anthropogenic precursors, but also from the transport of O3 and precursors from neighbouring regions, O3 regional and hemispheric transport and stratospheric O3 injections. The main goal of this study is to provide a first quantitative estimation of the contribution of the main anthropogenic activity sectors to peak O3 events in Spain relative to the contribution of imported (regional and hemispheric) O3. We also assess the potential of our source apportionment method to improve O3 modelling. Our study applies and thoroughly evaluates a countrywide O3 source apportionment method implemented in the CALIOPE air quality forecast system for Spain at high resolution (4 × 4 km2) over a 10-day period characterized by typical summer conditions in the Iberian Peninsula (IP). The method tags both O3 and its gas precursor emissions from source sectors within one simulation, and each tagged species is subject to the typical physico-chemical processes (advection, vertical mixing, deposition, emission and chemistry) as the actual conditions remain unperturbed. We quantify the individual contributions of the largest NO x local sources to high O3 concentrations compared with the contribution of imported O3. We show, for the first time, that imported O3 is the largest input to the ground-level O3 concentration in the IP, accounting for 46 %-68 % of the daily mean O3 concentration during exceedances of the European target value. The hourly imported O3 increases during typical northwestern advections (70 %-90 %, 60-80 μg m-3), and decreases during typical stagnant conditions (30 %-40 %, 30-60 μg m-3) due to the local NO titration. During stagnant conditions, the local anthropogenic precursors control the O3 peaks in areas downwind of the main urban and industrial regions (up to 40 % in hourly peaks). We also show that ground-level O3 concentrations are strongly affected by vertical mixing of O3-rich layers present in the free troposphere, which result from local/regional layering and accumulation, and continental/hemispheric transport. Indeed, vertical mixing largely explains the presence of imported O3 at ground level in the IP. Our results demonstrate the need for detailed quantification of the local and remote contributions to high O3 concentrations for local O3 management, and show O3 source apportionment to be an essential analysis prior to the design of O3 mitigation plans in any non-attainment area. Achieving the European O3 objectives in southern Europe requires not only ad hoc local actions but also decided national and European-wide strategies.

Dataset Information

Investigation and Source Apportionment of Air Pollutants in a Large Oceangoing Ship during Voyage.

Publications

Investigation and Source Apportionment of Air Pollutants in a Large Oceangoing Ship during Voyage.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets