Passive broadband full Stokes polarimeter using a Fresnel cone.
Ontology highlight
ABSTRACT:
SUBMITTER: Hawley RD
PROVIDER: S-EPMC6389910 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Non-linear effects of the Navier-Stokes equations disappear under the Stokes regime of Newtonian fluid flows disallowing a flow rectification behavior. Here we show that passive flow rectification of Newtonian fluids is obtainable under the Stokes regime of both compressible and incompressible flows by introducing nonlinearity into the otherwise linear Stokes equations. Asymmetric flow resistances arise in shallow nozzle/diffuser microchannels with deformable ceiling, in which the fluid flow is governed by a non-linear coupled fluid-solid mechanics equation. The proposed model captures the unequal deflection profile of the deformable ceiling depending on the flow direction under the identical applied pressure, permitting a larger flow rate in the nozzle configuration. Ultra-low aspect ratio microchannels sealed by a flexible membrane have been fabricated to demonstrate passive flow rectification for low-Reynolds-number flows (0.001 < Re < 10) of common Newtonian fluids such as water, methanol, and isopropyl alcohol. The proposed rectification mechanism is also extended to compressible flows, leading to the first demonstration of rectifying equilibrium gas flows under the Stokes flow regime. While the maximum rectification ratio experimentally obtained in this work is limited to 1.41, a higher value up to 1.76 can be achieved by optimizing the width profile of the asymmetric microchannels.
| S-EPMC8119468 | biostudies-literature
Project description:Metalenses composed of a large number of subwavelength nanostructures provide the possibility for the miniaturization and integration of the optical system. Broadband polarization-insensitive achromatic metalenses in the visible light spectrum have attracted researchers because of their wide applications in optical integrated imaging. This paper proposes a polarization-insensitive achromatic metalens operating over a continuous bandwidth from 470 nm to 700 nm. The silicon nitride nanopillars of 488 nm and 632.8 nm are interleaved by Fresnel zone spatial multiplexing method, and the particle swarm algorithm is used to optimize the phase compensation. The maximum time-bandwidth product in the phase library is 17.63. The designed focal length can be maintained in the visible light range from 470 nm to 700 nm. The average focusing efficiency reaches 31.71%. The metalens can achieve broadband achromatization using only one shape of nanopillar, which is simple in design and easy to fabricate. The proposed metalens is expected to play an important role in microscopic imaging, cameras, and other fields.
| S-EPMC9738994 | biostudies-literature
Project description:Cylindrically polarized (CP) modes are laser beam modes which have rotational symmetry of the polarization distribution around the beam axis. Considerable attention has been paid to CP modes for their various applications. In this paper, by using the extended Stokes parameters and the degree of polarization defined for the spatial distribution (DOP-SD), we fully-quantitatively characterize the spectrally-resolved polarization states of arbitrary CP (axisymmetrically polarized and higher-order cylindrically polarized) broadband pulses generated by coherent beam combining. All the generated pulse states were fully-quantitatively analyzed for the first time and proved to have high symmetry (DOP-SD ≳ 0.95) and low spectral dependence of polarization states. Moreover, we show the DOP-SD, which cannot be defined by the conventional higher-order and hybrid Stokes parameters, enables us to make a quantitative evaluation of small degradation of rotational symmetry of polarization distribution. This quantitative characterization with high precision is significant for applications of precise material processing, quantum information processing, magneto-optical storage and nonlinear spectroscopic polarimetry.
| S-EPMC4674746 | biostudies-literature
Project description:Polarimetric imaging has a wide range of applications for uncovering features invisible to human eyes and conventional imaging sensors. Chip-integrated, fast, cost-effective, and accurate full-Stokes polarimetric imaging sensors are highly desirable in many applications, which, however, remain elusive due to fundamental material limitations. Here we present a chip-integrated Metasurface-based Full-Stokes Polarimetric Imaging sensor (MetaPolarIm) realized by integrating an ultrathin (~600 nm) metasurface polarization filter array (MPFA) onto a visible imaging sensor with CMOS compatible fabrication processes. The MPFA is featured with broadband dielectric-metal hybrid chiral metasurfaces and double-layer nanograting polarizers. This chip-integrated polarimetric imaging sensor enables single-shot full-Stokes imaging (speed limited by the CMOS imager) with the most compact form factor, records high measurement accuracy, dual-color operation (green and red) and a field of view up to 40 degrees. MetaPolarIm holds great promise to enable transformative applications in autonomous vision, industry inspection, space exploration, medical imaging and diagnosis.
| S-EPMC10482842 | biostudies-literature
Project description:On-chip polarimeters are highly desirable for the next-generation ultra-compact optical and optoelectronic systems. Polarization-sensitive photodetectors relying on anisotropic absorption of natural/artificial materials have emerged as a promising candidate for on-chip polarimeters owing to their filterless configurations. However, these photodetectors can only be applied for detection of either linearly or circularly polarized light, not applicable for full-Stokes detection. Here, we propose and demonstrate three-ports polarimeters comprising on-chip chiral plasmonic metamaterial-mediated mid-infrared photodetectors for full-Stokes detection. By manipulating the spatial distribution of chiral metamaterials, we could convert polarization-resolved absorptions to corresponding polarization-resolved photovoltages of three ports through the photothermoelectric effect. We utilize the developed polarimeter in an imaging demonstration showing reliable ability for polarization reconstruction. Our work provides an alternative strategy for developing polarization-resolved photodetectors with a bandgap-independent operation range in the mid-infrared. Mid-infrared polarization-sensitive photodetectors are desired for several applications, such as chemical analysis and biomedical diagnosis. Here, the authors report on-chip polarimeters based on the combination of plasmonic chiral metamaterials and 2D thermoelectric materials, showing tunable full-Stokes detection of linearly and circularly polarized light at room temperature.
| S-EPMC9356042 | biostudies-literature
Project description:Full-field transmission X-ray microscopy is a unique non-destructive technique for three-dimensional imaging of specimens at the nanometer scale. Here, the use of zone-doubled Fresnel zone plates to achieve a spatial resolution better than 20 nm in the hard X-ray regime (8-10 keV) is reported. By obtaining a tomographic reconstruction of a Ni/YSZ solid-oxide fuel cell, the feasibility of performing three-dimensional imaging of scientifically relevant samples using such high-spatial-resolution Fresnel zone plates is demonstrated.
| S-EPMC3579491 | biostudies-literature
Project description:In early 2013, three airborne polarimeters were flown on the high altitude NASA ER-2 aircraft in California for the Polarimeter Definition Experiment (PODEX). PODEX supported the pre-formulation NASA Aerosol-Cloud-Ecosystem (ACE) mission, which calls for an imaging polarimeter in polar orbit (among other instruments) for the remote sensing of aerosols, oceans, and clouds. Several polarimeter concepts exist as airborne prototypes, some of which were deployed during PODEX as a capabilities test. Two of those instruments to date have successfully produced Level 1 (georegistered, calibrated radiance and polarization) data from that campaign: the Airborne Multiangle Spectropolarimetric Imager (AirMSPI) and the Research Scanning Polarimeter (RSP). We compared georegistered observations of a variety of scene types by these instruments to test whether Level 1 products agreed within stated uncertainties. Initial comparisons found radiometric agreement, but polarimetric biases beyond measurement uncertainties. After subsequent updates to calibration, georegistration, and the measurement uncertainty models, observations from the instruments now largely agree within stated uncertainties. However, the 470 nm reflectance channels have a roughly +6% bias of AirMSPI relative to RSP, beyond expected measurement uncertainties. We also find that observations of dark (ocean) scenes, where polarimetric uncertainty is expected to be largest, do not agree within stated polarimetric uncertainties. Otherwise, AirMSPI and RSP observations are consistent within measurement uncertainty expectations, providing credibility for the subsequent creation of Level 2 (geophysical product) data from these instruments, and comparison thereof. The techniques used in this work can also form a methodological basis for other intercomparisons, for example, of the data gathered during the recent Aerosol Characterization from Polarimeter and Lidar (ACEPOL) field campaign, carried out in October and November of 2017 with four polarimeters (including AirMSPI and RSP).
| S-EPMC6996873 | biostudies-literature
Project description:Raman microspectroscopy can provide the chemical contrast needed to characterize the complex intracellular environment and macromolecular organization in cells without exogenous labels. It has shown a remarkable ability to detect chemical changes underlying cell differentiation and pathology-related chemical changes in tissues but has not been widely adopted for imaging, largely due to low signal levels. Broadband coherent anti-Stokes Raman scattering (B-CARS) offers the same inherent chemical contrast as spontaneous Raman but with increased acquisition rates. To date, however, only spectrally resolved signals from the strong CH-related vibrations have been used for CARS imaging. Here, we obtain Raman spectral images of single cells with a spectral range of 600-3200 cm?¹, including signatures from weakly scattering modes as well as CH vibrations. We also show that B-CARS imaging can be used to measure spectral signatures of individual cells at least fivefold faster than spontaneous Raman microspectroscopy and can be used to generate maps of biochemical species in cells. This improved spectral range and signal intensity opens the door for more widespread use of vibrational spectroscopic imaging in biology and clinical diagnostics.
| S-EPMC2955349 | biostudies-other
Project description:Polarization, one of the fundamental properties of light, is critical for certain imaging applications because it captures information from the scene that cannot directly be recorded by traditional intensity cameras. Currently, mainstream approaches for polarization imaging rely on strong dichroism of birefringent crystals or artificially fabricated structures that exhibit a high diattenuation typically exceeding 99%, which corresponds to a polarization extinction ratio (PER) >~100. This not only limits the transmission efficiency of light, but also makes them either offer narrow operational bandwidth or be non-responsive to the circular polarization. Here, we demonstrate a single-shot full-Stokes polarization camera incorporating a disordered metasurface array with weak dichroism. The diattenuation of the metasurface array is ~65%, which corresponds to a PER of ~2. Within the framework of compressed sensing, the proposed disordered metasurface array serves as an efficient sensing matrix. By incorporating a mask-aware reconstruction algorithm, the signal can be accurately recovered with a high probability. In our experiments, the proposed approach exhibits high-accuracy full-Stokes polarimetry and high-resolution real-time polarization imaging. Our demonstration highlights the potential of combining meta-optics with reconstruction algorithms as a promising approach for advanced imaging applications.
| S-EPMC10630513 | biostudies-literature
Project description:A three-dimensional finite element numerical modeling for the scanning microwave microscopy (SMM) setup is applied to study the full-wave quantification of the local material properties of samples. The modeling takes into account the radiation and scattering losses of the nano-sized probe neglected in previous models based on low-frequency assumptions. The scanning techniques of approach curves and constant height are implemented. In addition, we conclude that the SMM has the potential for use as a broadband dielectric spectroscopy operating at higher frequencies up to THz. The results demonstrate the accuracy of previous models. We draw conclusions in light of the experimental results.
| S-EPMC5700110 | biostudies-literature