Dataset Information

Development and Initial Validation of Calculated Tumor Area as a Prognostic Tool in Cutaneous Malignant Melanoma.

ABSTRACT:

Importance

Breslow thickness is a 1-dimensional surrogate prognostic feature for tumor size, yet tissue sections have 2 dimensions. Therefore, a 2-dimensional feature, calculated tumor area (CTA), was devised.

Objective

To determine CTA precision and prognostic value.

Design, setting, and participants

This retrospective cohort of patients with cutaneous melanoma presented to the Leicester and Nottingham National Health Service hospital trusts in the United Kingdom. Eligible patients in the Leicester development sample had available primary tumor tissue; a diagnosis from January 1, 2004, through December 31, 2011; invasive disease; and Leicestershire residency. Patients in the Nottingham validation sample had an anonymized spreadsheet with primary melanoma diagnosed from January 1, 2003, through December 31, 2005, or from January 1, 2008, through December 31, 2010. From a starting population of 1463 patients in both data sets, a total of 224 (15.3%) were excluded to yield a study population of 1239. Data were analyzed from April 30, 2018, through January 10, 2019.

Intervention

An observational analysis of the prognostic value of CTA in patients with cutaneous melanoma.

Main outcomes and measures

Independent association of CTA with melanoma-specific survival and confounding effect of CTA on Breslow thickness in survival analysis.

Results

A total of 1239 patients with melanoma were assessed, including 649 (52.4%) women, with a median age of 60 years (interquartile range, 47-71 years). An intraclass correlation coefficient for CTA on 13 cases was 0.99. In 918 patients in the Leicester cohort, CTA was an independent prognostic factor in Cox proportional hazards regression models after adjusting for Breslow thickness, age, sex, ulcer, mitotic rate, and microsatellites (hazard ratio [HR], 1.87; 95% CI, 1.49-2.34; P < .001). Validation in 321 patients in the Nottingham cohort showed an HR of 1.55 (95% CI, 1.15-2.09; P = .005) and in the combined 1239 cases, an HR of 1.70 (95% CI, 1.43-2.03; P < .001). Breslow thickness was significant in multivariable analysis only when CTA was not in the model. The relative importance of CTA was shown by its retention in all 100 bootstrap multivariable models with backward selection, whereas Breslow thickness was retained in only 53. Melanomas stratified by CTA showed wider separation of survival curves than those stratified by Breslow thickness using the American Joint Committee on Cancer Staging Manual, 8th Edition (HRs, 1.00 to 41.46 vs 1.00 to 36.95, respectively), and the model with CTA categories had a Bayesian information criterion difference of 13.9 compared with T category, indicating substantially better fit. This model had a Harrell C index of 83.7%, and bootstrap analysis showed little evidence of model optimism, with a corrected calibration slope of 0.99.

Conclusions and relevance

This study provides a novel microscopic feature, CTA, with evidence of its independent prognostic value. This evidence suggests that CTA should be a priority for further study.

SUBMITTER: Saldanha G

PROVIDER: S-EPMC6596334 | biostudies-literature |

REPOSITORIES: biostudies-literature

ACCESS DATA

Similar Datasets

Project description:Perturbations in microRNA (miRNA) expression profiles has been reported for cutaneous malignant melanoma (CMM). With regards to a rapidly growing number of newly discovered miRNA sequences, the availability of up-to-date miRNA expression profiles for primary cutaneous malignant melanoma (PCMM), cutaneous malignant melanoma metastases (CMMM) and benign melanocytic naevi (BMN) is limited. Patients with PCMM (n=9), CMMM (n=4) and BMN (n=8) were included in the study. Specimens were obtained during surgery from the center of the tumors (lesional). An exploratory microarray analysis was performed by miRNA expression profiling based on miRBase V.16. Additionally, the expression levels of selected miRNA candidates were confirmed by TaqMan real-time quantitative polymerase chain reaction (RT-PCR). New miRNA candidates previously not described to be associated with CMM were found to be potentially dysregulated in CMM. Nine patients with PCMM (PCMM1-PCMM9), four patients with CMMM (CMMM1-CMMM4) and eight patients with BMN (BMN1-BMN8) were enrolled in the present study. All cutaneous specimens were harvested in the operating room, immediately stored in RNAlater (Quiagen, Hilden, Germany) and kept at - 80 °C until RNA isolation. Total RNA including miRNAs was isolated using the miRNeasy Mini Kit (Quiagen, Hilden, Germany) according to the manufacturer’s protocol. RNA concentration and purity was determined by NanoDrop ND-1000 spectral photometer (Peqlab, Erlangen, Germany). RNA integrity control (RIN) was determined by means of capillary electrophoresis with the 2100 Bioanalyzer and the RNA 6000 NanoLabCHip Kits (both Agilent Technologies, Santa Clara, USA). To be further considered for Microarray analysis a RIN ≥ 7.0 indicating medium to good RNA quality was defined as inclusion criteria. For assessment of labeling and hybridization efficiencies total RNA samples were spiked with in-vitro synthesized oligonucleotides by using the MicroRNA Spike-In Kit (Agilent Technologies, Santa Clara, USA). A total of 100 ng total RNA per sample were introduced into a labeling reaction. The spiked total RNA was treated with alkaline calf intestine phosphatase (CIP). The dephosphorylated RNA was labeled with the miRNA Complete Labeling and Hyb Kit (Agilent Technologies, Santa Clara, USA) according to the manufacturer´s instructions using T4 RNA ligase, incorporating Cyanine 3-Cytidine biphosphate (pCp). The Cyanine-3-labeled miRNA samples were prepared for One-Color based hybridization with Complete miRNA Labeling and Hyb Kit (Agilent Technologies, Santa Clara, USA) according to the manufacturer´s instructions. Labeled miRNA samples were hybridized at 55°C for 20 hrs on separate Human miRNA Microarrays Release 16.0 (8x60K format, (Agilent Technologies, Santa Clara, USA). Afterwards, microarrays were washed with increasing stringency using Gene Expression Wash Buffers (Agilent Technologies, Santa Clara, USA) followed by drying with acetonitrile (Sigma-Aldich, St.Louis, USA). Fluorescent signal intensities were detected with Scan Control A.8.4.1 Software (Agilent Technologies, Santa Clara, USA) on the Agilent DNA Microarray Scanner and extracted from the images using Feature Extraction 10.7.3.1 Software (Agilent Technologies, Santa Clara, USA). All the steps described were carried out according to the manufacturer´s instructions.