Dataset Information

Novel, Activated Carbon-Based Material for in-Situ Remediation of Contaminated Sediments.

ABSTRACT: Applying activated carbon (AC) to contaminated sediments is an in-situ approach to remediation with great potential. The bioavailability of persistent organic pollutants can be rapidly reduced and kept low over long periods of time. However, there are limitations to the method. The high buoyancy of AC particles makes their application difficult in the field, and AC retention on the amended site can be low in turbulent waters. Furthermore, the fine particles of powdered AC (PAC) can have adverse effects on organisms, but their remediation potential is superior to coarser, granular ACs (GAC). To tackle these shortcomings, a novel sorbent material was developed, consisting of PAC embedded into a stable, granular clay-matrix, significantly reducing buoyancy. These AC-clay granules (ACC-G) were tested for remediation potential (PCB-bioaccumulation reduction) and adverse effects on the benthic invertebrates Chironomus riparius and Lumbriculus variegatus. The novel ACC-G material was compared to GAC of the same particle size, the clay-matrix, and PAC. The findings show that ACC-G has a significantly higher remediation potential than GAC, allowing for reductions in PCB-bioaccumulation of up to 89%. Adverse effects could not be totally eliminated with ACC-G, but they were less severe than with PAC, likely due to the increased particle size.

SUBMITTER: Abel S

PROVIDER: S-EPMC6727589 | biostudies-literature | 2019 Mar

REPOSITORIES: biostudies-literature

ACCESS DATA

Publications

Novel, Activated Carbon-Based Material for in-Situ Remediation of Contaminated Sediments.

Abel Sebastian S Akkanen Jarkko J

Environmental science & technology 20190228 6

Applying activated carbon (AC) to contaminated sediments is an in-situ approach to remediation with great potential. The bioavailability of persistent organic pollutants can be rapidly reduced and kept low over long periods of time. However, there are limitations to the method. The high buoyancy of AC particles makes their application difficult in the field, and AC retention on the amended site can be low in turbulent waters. Furthermore, the fine particles of powdered AC (PAC) can have adverse ...[more]

PMID: 30781950

Similar Datasets

Project description:Low-cost mesoporous silicas of the SBA-15 family were prepared, aimed for removal of a broad spectrum of both cationic and anionic forms of hazardous metal pollutants (Cr(III, VI), Mn(II, VII), Pb(II), Cd(II), and Cu(II)) from environmental water. Series of mono- and bifunctional materials with immobilized ethylenediaminetriacetic acid (EDTA), primary amine (NH2), and quaternary ammonium (QAS) groups were prepared in a cost-efficient one-step synthesis using two silica sources, low-cost sodium metasilicate (Na2SiO3 9H2O) and the conventional source-tetraethylorthosilicate (TEOS). The functionalized SBA-15 samples obtained from both silica sources were highly ordered, as evidenced by TEM and SAXS data. All obtained materials were mesoporous with high surface area values of up to 745 m2/g, pore volumes from 0.99 to 1.44 cm3/g, and narrow pore distributions near 7 nm. The adsorption affinity of the EDTA-functionalized samples followed the common order Pb(II)> Cd(II)> Cu(II)> Cr(III)> Mn(II), which could be explained based on the Pearson theory. The highest adsorption capacities were observed for samples functionalized by EDTA groups using TEOS for synthesis (TEOS/EDTA): 195.6 mg/g for Pb(II), 111.2 mg/g for Cd(II), 58.7 mg/g for Cu(II), 57.7 mg/g for Cr(III), and 49.4 mg/g for Mn(II). Moreover, organic matter (humic acid up to 10 mg/L) and inorganic (Na(I), K(I), Mg(II), Ca(II), etc) macrocomponents present in environmental water had almost negligible effect on the removal of these cations. The NaSi/EDTA/NH2 sample revealed a better selectivity compared to the NaSi/NH2 sample towards such species as Cr(III), Mn(II), Cd(II), and Cu(II). The chromate-ions uptake at pH 7.5 by the TEOS/QAS sample turned practically unaffected by the presence of doubly charged anions (CO3 2-, SO4 2-). The content of functional groups on the surface of MS decreased only slightly (∼1-5%) after several regeneration cycles. The complete desorption of all heavy metal ions can be achieved using 1 mol/L EDTA solution. Reusability tests demonstrated the complete stability of the adsorbent for at least five to six consecutive adsorption/desorption cycles with no decrease in its adsorption characteristics compared to those obtained by 0.05 mol/L HNO3 treatments. The synthesized mesoporous materials were evaluated for removal of the heavy metal ions from drinking and different natural water samples, proving their potential as sustainable, effective, and cost-efficient adsorbents.

Dataset Information

Novel, Activated Carbon-Based Material for in-Situ Remediation of Contaminated Sediments.

Publications

Novel, Activated Carbon-Based Material for in-Situ Remediation of Contaminated Sediments.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets