Dataset Information

Environmental Risk Assessment for the Active Pharmaceutical Ingredient Mycophenolic Acid in European Surface Waters.

ABSTRACT: An environmental risk assessment is presented for mycophenolic acid (MPA), an immunosuppressive pharmaceutical used for prevention of organ rejection, and its prodrug mycophenolate mofetil (MPM). Mycophenolic acid will not significantly adsorb to activated sludge. In activated sludge, 14 C-MPA attained >80% degradation, supporting an older environmental fate test with the same compound. Based on n-octanol/water distribution coefficient (log DOW ) values of 2.28, 0.48, and ?-1.54 at pH 5, 7, and 9, respectively, MPA is not expected to bioaccumulate. Sales amounts of MPA+MPM in Europe were used to derive predicted environmental concentrations (PECs) in surface waters; PECs were refined by including expected biodegradation in sewage treatment, average drinking water use, and average dilution of the effluents in the receiving waters per country. In addition, the exposure to pharmaceuticals in the environment (ePiE) model was run for 4 European catchments. The PECs were complemented with 110 measured environmental concentrations (MECs), ranging from below the limit of quantitation (<0.001 µg/L) to 0.656 µg/L. Predicted no-effect concentrations (PNECs) were derived from chronic tests with cyanobacteria, green algae, daphnids, and fish. The comparison of PECs and MECs with the PNECs resulted in a differentiated environmental risk assessment in which the risk ratio of PEC/PNEC or MEC/PNEC was <1 in most cases (mostly >90%), meaning no significant risk, but a potential risk to aquatic organisms in generally <10% of instances. Because this assessment reveals a partial risk, the following questions must be asked: How much risk is acceptable? and Through which measures can this risk be reduced? These questions are all the more important in view of limited alternatives for MPM and MPA and the serious consequences of not using them. Environ Toxicol Chem 2019;38:2259-2278. © 2019 The Authors. Environmental Toxicology and Chemistry published by Wiley Periodicals, Inc. on behalf of SETAC.

SUBMITTER: Straub JO

PROVIDER: S-EPMC6856805 | biostudies-literature | 2019 Oct

REPOSITORIES: biostudies-literature

ACCESS DATA

Publications

Environmental Risk Assessment for the Active Pharmaceutical Ingredient Mycophenolic Acid in European Surface Waters.

Straub Jürg Oliver JO Oldenkamp Rik R Pfister Thomas T Häner Andreas A

Environmental toxicology and chemistry 20190919 10

An environmental risk assessment is presented for mycophenolic acid (MPA), an immunosuppressive pharmaceutical used for prevention of organ rejection, and its prodrug mycophenolate mofetil (MPM). Mycophenolic acid will not significantly adsorb to activated sludge. In activated sludge, <sup>14</sup> C-MPA attained >80% degradation, supporting an older environmental fate test with the same compound. Based on n-octanol/water distribution coefficient (log D<sub>OW</sub> ) values of 2.28, 0.48, and ≤ ...[more]

PMID: 31225916

Similar Datasets

Project description:Washing is a key step in pharmaceutical isolation to remove the unwanted crystallization solvent (mother liquor) from the active pharmaceutical ingredient (API) filter cake. This study looks at strategies for optimal wash solvent selection, which minimizes the dissolution of API product crystals while preventing the precipitation of product or impurities. Selection of wash solvents to avoid both these phenomena can be challenging but is essential to maintain the yield, purity, and particle characteristics throughout the isolation process. An anti-solvent screening methodology has been developed to quantitatively evaluate the propensity for precipitation of APIs and their impurities of synthesis during washing. This is illustrated using paracetamol (PCM) and two typical impurities of synthesis during the washing process. The solubility of PCM in different binary wash solutions was measured to provide a basis for wash solvent selection. A map of wash solution composition boundaries for precipitation for the systems investigated was developed to depict where anti-solvent phenomena will take place. For some crystallization and wash solvent combinations investigated, as much as 90% of the dissolved PCM and over 10% of impurities present in the PCM saturated mother liquor were found to precipitate out. Such levels of uncontrolled crystallization during washing in a pharmaceutical isolation process can have a drastic effect on the final product purity. Precipitation of both the product and impurities from the mother liquor can be avoided by using a solvent in which the API has a solubility similar to that in the mother liquor; for example, the use of acetonitrile as a wash solvent does not result in precipitation of either the PCM API or its impurities. However, the high solubility of PCM in acetonitrile would result in noticeable dissolution of API during washing and would lead to agglomeration during the subsequent drying step. Contrarily, the use of n-heptane as a wash solvent for a PCM crystal slurry resulted in the highest amount of precipitation among the solvent pairs evaluated. This can be mitigated by designing a multi-stage washing strategy where wash solutions of differing wash solvent concentrations are used to minimize step changes in solubility when the mother liquor and the wash solvent come into contact.

Project description:The enhancement of the properties (i.e., poor solubility and low bioavailability) of currently available active pharmaceutical ingredients (APIs) is one of the major goals of modern pharmaceutical sciences. Among different strategies, a novel and innovative route to reach this milestone seems to be the application of nanotechnology, especially the incorporation of APIs into porous membranes composed of pores of nanometric size and made of nontoxic materials. Therefore, in this work, taking the antipsychotic API aripiprazole (APZ) infiltrated into various types of mesoporous matrices (anodic aluminum oxide, native, and silanized silica) characterized by similar pore diameters (d = 8-10 nm) as an example, we showed the advantage of incorporated systems in comparison to the bulk substance considering the crystallization kinetics, molecular dynamics, and physical stability. Calorimetric investigations supported by the temperature-dependent X-ray diffraction measurements revealed that in the bulk system the recrystallization of polymorph III, which next is converted to the mixture of forms IV and I, is visible, while in the case of confined samples polymorphic forms I and III of APZ are produced upon heating of the molten API with different rates. Importantly, the two-step crystallization observed in thermograms obtained for the API infiltrated into native silica templates may suggest crystal formation by the interfacial and core molecules. Furthermore, dielectric studies enabled us to conclude that there is no trace of crystallization of spatially restricted API during one month of storage at T = 298 K. Finally, we found that in contrast to the crystalline and amorphous bulk samples, all examined confined systems show a logarithmic increase in API dissolution over time (very close to a prolonged release effect) without any sign of precipitation. Our data demonstrated that mesoporous matrices appear to be interesting candidates as carriers for unstable amorphous APIs, like APZ. In addition to protecting them against crystallization, they can provide the desired prolonged release effect, which may increase the drug concentration in the blood (resulting in higher bioavailability). We believe that the "nanostructirization" in terms of the application of porous membranes as a novel generation of drug carriers might open unique perspectives in the further development of drugs characterized by prolonged release.

Dataset Information

Environmental Risk Assessment for the Active Pharmaceutical Ingredient Mycophenolic Acid in European Surface Waters.

Publications

Environmental Risk Assessment for the Active Pharmaceutical Ingredient Mycophenolic Acid in European Surface Waters.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets