Project description:Flexible and scalable energy storage solutions are necessary for mitigating fluctuations of renewable energy sources. The main advantage of redox flow batteries is their ability to decouple power and energy. However, they present some limitations including poor performance, short-lifetimes, and expensive ion-selective membranes as well as high price, toxicity, and scarcity of vanadium compounds. We report a membrane-free battery that relies on the immiscibility of redox electrolytes and where vanadium is replaced by organic molecules. We show that the biphasic system formed by one acidic solution and one ionic liquid, both containing quinoyl species, behaves as a reversible battery without any membrane. This proof-of-concept of a membrane-free battery has an open circuit voltage of 1.4?V with a high theoretical energy density of 22.5?Wh?L-1 , and is able to deliver 90?% of its theoretical capacity while showing excellent long-term performance (coulombic efficiency of 100?% and energy efficiency of 70?%).
Project description:This paper contains a vanadium redox flow battery stack with an electrode surface area 40 cm2 test data. The aim of the study was to characterize the performance of the stack of the original design. The dataset include three series of galvanostatic charge-discharge cycling in the potential region 8-16?V with current densities 75, 150 and 200?mA/cm2 for 100 cycles. Coulomb, voltaic, energy efficiencies and capacity utilization coefficient are also provided for all three series.
Project description:Energy storage systems are crucial in the deployment of renewable energies. As one of the most promising solutions, redox flow batteries (RFBs) are still hindered for practical applications by low energy density, high cost, and environmental concerns. To breakthrough the fundamental solubility limit that restricts boosting energy density of the cell, we here demonstrate a new RFB system employing polysulfide and high concentrated ferricyanide (up to 1.6 M) species as reactants. The RFB cell exhibits high cell performances with capacity retention of 96.9% after 1,500 cycles and low reactant cost of $32.47/kWh. Moreover, neutral aqueous electrolytes are environmentally benign and cost-effective. A cell stack is assembled and exhibits low capacity fade rate of 0.021% per cycle over 642 charging-discharging steps (spans 60 days). This neutral polysulfide/ferricyanide RFB technology with high safety, long-duration, low cost, and feasibility of scale-up is an innovative design for storing massive energy.
Project description:Proton exchange membrane is the key factor of vanadium redox flow battery (VRB) as their stability largely determine the lifetime of the VRB. In this study, a SPEEK/MWCNTs-OH composite membrane with ultrahigh stability is constructed by blending sulfonated poly(ether ether ketone) (SPEEK) with multi-walled carbon nanotubes toward VRB application. The carbon nanotubes disperse homogeneously in the SPEEK matrix with the assistance of hydroxyl group. The blended membrane exhibits 94.2 and 73.0% capacity retention after 100 and 500 cycles, respectively in a VRB single cell with coulombic efficiency of over 99.4% at 60 mA cm-2 indicating outstanding capability of reducing the permeability of vanadium ions and enhancing the transport of protons. The ultrahigh stability and low cost of the composite membrane make it a competent candidate for the next generation larger-scale vanadium redox flow battery.
Project description:The versatility in design of redox flow batteries makes them apt to efficiently store energy in large-scale applications at low cost. The discovery of inexpensive organic electroactive materials for use in aqueous flow battery electrolytes is highly attractive, but is thus far limited. Here we report on a flow battery using an aqueous electrolyte based on the sodium salt of flavin mononucleotide. Flavins are highly versatile electroactive molecules, which catalyse a multitude of redox reactions in biological systems. We use nicotinamide (vitamin B3) as a hydrotropic agent to enhance the water solubility of flavin mononucleotide. A redox flow battery using flavin mononucleotide negative and ferrocyanide positive electrolytes in strong base shows stable cycling performance, with over 99% capacity retention over the course of 100 cycles. We hypothesize that this is enabled due to the oxidized and reduced forms of FMN-Na being stabilized by resonance structures.
Project description:A sulfonated polyimide (SPI)/Nafion blend membrane composed of a designed and synthesized SPI polymer and the commercial Nafion polymer is prepared by a facile solution casting method for vanadium redox flow battery (VRFB). Similar molecular structures of both SPI and Nafion provide good compatibility and complementarity of the blend membrane. ATR-FTIR, 1H-NMR, AFM, and SEM are used to gain insights on the chemical structure and morphology of the blend membrane. Fortunately, the chemical stability of the SPI/Nafion blend membrane is effectively improved compared with reported SPI-based membranes for VRFB applications. In cycling charge-discharge tests, the VRFB with the as-prepared SPI/Nafion blend membrane shows excellent battery efficiencies and operational stability. Above results indicate that the SPI/Nafion blend membrane is a promising candidate for VRFB application. This work opens up a new possibility for fabricating high-performance SPI-based blend membrane by introduction of a polymer with a similar molecular structure and special functional groups into the SPI polymer.
Project description:Flexible cross-linked anion exchange membranes (AEMs) based on poly (p-phenylene oxide) grafted with N-spirocyclic quaternary ammonium cations were synthesized via UV-induced free-radical polymerization by using diallylpiperidinium chloride as an ionic monomer. Five membranes with ion exchange capacity (IEC) varying between 1.5 to 2.8 mmol Cl-·g-1 polymer were obtained and the correlation between IEC, water uptake, state of water in the membrane and ionic conductivity was studied. In the second part of this study, the influence of properties of four of these membranes on cell cycling stability and performance was investigated in an aqueous organic redox flow battery (AORFB) employing dimethyl viologen (MV) and N,N,N-2,2,6,6-heptamethylpiperidinyl oxy-4-ammonium chloride (TMA-TEMPO). The influence of membrane properties on cell cycling stability and performance was studied. At low-current density (20 mA·cm-2), the best capacity retention was obtained with lower IEC membranes for which the water uptake, freezable water and TMA-TEMPO and MV crossover are low. However, at a high current density (80 mA·cm-2), membrane resistance plays an important role and a membrane with moderate IEC, more precisely, moderate ion conductivity and water uptake was found to maintain the best overall cell performance. The results in this work contribute to the basic understanding of the relationship between membrane properties and cell performance, providing insights guiding the development of advanced membranes to improve the efficiency and power capability for AORFB systems.
Project description:Alkaline zinc-based flow batteries are regarded to be among the best choices for electric energy storage. Nevertheless, application is challenged by the issue of zinc dendrite/accumulation. Here, we report a negatively charged nanoporous membrane for a dendrite-free alkaline zinc-based flow battery with long cycle life. Free of zinc dendrite/accumulation, stable performance is afforded for ?240 cycles at current densities ranging from 80 to 160?mA?cm-2 using the negatively charged nanoporous membrane. Furthermore, 8?h and 7?h plating/stripping processes at 40?mA?cm-2 yield an average energy efficiency of 91.92% and an areal discharge capacity above 130?mAh?cm-2. A peak power density of 1056?mW?cm-2 is achieved at 1040?mA?cm-2. This study may provide an effective way to address the issue of zinc dendrite/accumulation for zinc-based batteries and accelerate the advancement of these batteries.
Project description:We studied the half-cell performance of a slurry-based vanadium redox flow battery via the polarization and electrochemical impedance spectroscopy methods. First, the conductive static mixers are examined and lower ohmic and diffusion resistances are shown. Further analyses of the slurry electrodes for the catholyte (VO2+-VO2 +) and anolyte (V3+-V2+) are presented for the graphite powder slurry containing up to 15.0?wt.% particle content. Overall, the anolyte persists as the more resistive half-cell, while ohmic and diffusion-related limitations are the dominating resistances for both electrolytes. The battery is further improved by the addition of Ketjen black nanoparticles, which results in lower cell resistances. The best results are achieved when 0.5?wt.% Ketjen black nanoparticles are dispersed with graphite powder since the addition of nanoparticles reduces ohmic, charge transfer and mass diffusion resistances by improving particle-particle dynamics. The results prove the importance of understanding resistances in a slurry electrode system.
Project description:Inspired by the electron transfer properties of quinones in biological systems, we recently showed that quinones are also very promising electroactive materials for stationary energy storage applications. Due to the practically infinite chemical space of organic molecules, the discovery of additional quinones or other redox-active organic molecules for energy storage applications is an open field of inquiry. Here, we introduce a high-throughput computational screening approach that we applied to an accelerated study of a total of 1710 quinone (Q) and hydroquinone (QH2) (i.e., two-electron two-proton) redox couples. We identified the promising candidates for both the negative and positive sides of organic-based aqueous flow batteries, thus enabling an all-quinone battery. To further aid the development of additional interesting electroactive small molecules we also provide emerging quantitative structure-property relationships.