Browse
Submit Data
Databases
API
Help

Dataset Information

34 Views

0 Connections

0 Citations

0 Reanalyses

0 Downloads

Omics score: 0

Single-Stage Revision Anterior Cruciate Ligament Reconstruction Using Fast-Setting Bone Graft Substitutes.

ABSTRACT: Revision anterior cruciate ligament reconstructions can be performed using either a single-stage or 2-stage technique. There are several benefits to using a single-stage approach when technically possible. Although not always feasible, eliminating the necessity of a 2-stage approach for certain indications is clearly preferable because it requires fewer operative procedures, leads to a more rapid recovery, and is cost effective. Here, we describe the use of fast-setting bone graft substitutes in the setting of single-stage revision anterior cruciate ligament reconstruction. The authors have found this technique useful in converting what would sometimes otherwise be approached using 2 stages into a single-stage procedure.

SUBMITTER: Serbin PA

PROVIDER: S-EPMC7029178 | biostudies-literature |

REPOSITORIES: biostudies-literature

ACCESS DATA

Json Xml

Similar Datasets

Fatigue Behavior of Nitinol Anterior Cruciate Ligament Graft and Inappropriate Femoral Tunnel Placement: Single-Stage Revision Anterior Cruciate Ligament Reconstruction Surgery.

Project description:Anterior cruciate ligament (ACL) injury is the most common ligament injury in the knee, and progressive instability and disability may develop in a significant number of patients. The incidence of ACL reconstruction is rapidly increasing, as is the number of failures. Although ACL reconstruction is a common procedure, less than satisfactory outcomes have been reported to occur in up to 25% of patients. The reasons for clinical failure after ACL reconstruction are numerous but can be broadly separated into 3 categories: technical, biological, and mechanical failures. It is generally thought that poor tunnel positioning (especially the femoral tunnel) is the most common technical error. Revision ACL reconstruction can be performed in 1 or 2 stages. The decision to perform a multistage approach is based on the position and size of the original tunnels. The varied success rates and associated advantages and disadvantages of each method have resulted in controversy as to the best treatment for revision ACL surgery. We describe our preferred operative technique to remove a fractured nitinol synthetic ACL graft and manage single-stage revision ACL reconstruction without bone grafting.

| S-EPMC5443615 | biostudies-literature

Revision Anterior Cruciate Ligament Reconstruction: Tibial Tunnel-First Graft-Sizing Technique.

Project description:Revision anterior cruciate ligament reconstruction (R-ACLR) has become more common as the number of failed primary ACLRs increase. Although increasingly common, R-ACLR has a greater failure rate than a primary reconstruction. Technical errors, particularly in tunnel placement, account for a large proportion of graft failure in R-ACLR as well as re-revision cases. Tunnel placement and trajectory is particularly important in R-ACLR and becomes more challenging with each additional revision attempt. This is in part because any tunnels created for revision may converge with formerly drilled tunnels or face interference hardware creating, complicating proper graft fixation. While there are many approaches to revision ACL surgery, our technique describes a simple, tibial tunnel-first graft-sizing method initially reaming tunnels with very small diameters and sequentially working your way up to more anatomic diameters.

| S-EPMC8719212 | biostudies-literature

Two-Stage Revision Anterior Cruciate Ligament Reconstruction Using Allograft Bone Dowels.

Project description:Revision anterior cruciate ligament (ACL) reconstruction is substantially more challenging than primary reconstruction. Management of previously malpositioned or widened tunnels often requires innovative approaches for managing bony defects. Massive osteolysis with poor bone stock and convergence or overlapping of revision tunnels into the previously placed tunnels may necessitate a staged revision procedure. In this surgical technique description, we describe a method for the management of bony deficiencies using allograft bone dowels in staged revision ACL reconstruction.

| S-EPMC5622280 | biostudies-literature

Combined Revision Anterior Cruciate Ligament and Anterolateral Ligament Reconstruction.

Project description:There has been a substantial increase in the number of revision anterior cruciate ligament (ACL) reconstructions performed in the past decade. This Technical Note describes combined revision ACL and anterolateral ligament reconstruction using outside-in drilling, which avoids the need for 2-stage revision ACL reconstruction because it allows unconstrained anatomic placement.

| S-EPMC9353271 | biostudies-literature

Arthroscopic Delivery of Injectable Bone Graft for Staged Revision Anterior Cruciate Ligament Reconstruction.

Project description:Bone defects caused by femoral and tibial tunnel enlargement can pose a significant technical challenge when planning to perform revision anterior cruciate ligament reconstruction. A number of options have been described for managing osseous deficiencies, including the use of large autograft or allograft bone dowels to provide sufficient tunnel fill and subsequent structural support for revision surgery. These techniques can be time-consuming and technically demanding to ensure proper tunnel fill and press-fit stability of the bone graft. We describe our preferred technique for arthroscopic bone grafting using a mixture of demineralized cortical bone graft augmented with platelet-rich plasma delivered through a simple delivery system.

| S-EPMC5765773 | biostudies-literature

Two-Stage Revision Anterior Cruciate Ligament Reconstruction Using Silicate-Substituted Calcium Phosphate.

Project description:Revision surgery after failed primary anterior cruciate ligament reconstruction is technically demanding. In cases in which the tunnels of the primary anterior cruciate ligament reconstruction are widened to greater than 10 mm and/or are incorrectly positioned, a 2-stage procedure enables restoration of bone stock and thus free placement of the tunnels during the revision. The gold standard for tunnel augmentation is an autologous iliac crest cancellous bone graft. However, harvesting the graft is associated with high morbidity. This article describes an alternative method for managing bone deficiencies using the synthetic bone graft substitute silicate-substituted calcium phosphate.

| S-EPMC7000346 | biostudies-literature

Two-Stage Anterior Cruciate Ligament Reconstruction Revision Surgery for Severe Bone Defects With Anterolateral Ligament Reconstruction Technique.

Project description:Anterior cruciate ligament revision surgery poses a number of specific difficulties. These include the lack of bone mass to enable effective fixation of the reconstruction, morbidity of the donor area when bone autograft is used to fill the tunnels, and absence of the semitendinosus and gracilis homolateral tendons in cases in which they have already been used in the primary surgical procedure. To address all these problems, we describe a 2-stage revision technique that uses bone allograft for tunnel filling and Achilles allograft for ligament reconstruction. In addition, the intervention includes an extra-articular phase in which the anterolateral ligament is reinforced to increase the rotational stability of the knee, thus improving the prognosis of operation.

| S-EPMC7093708 | biostudies-literature

Bone-Tendon-Autograft Anterior Cruciate Ligament Reconstruction: A New Anterior Cruciate Ligament Graft Option.

Project description:The bone-tendon-bone (BTB) autograft is widely used for anterior cruciate ligament (ACL) reconstruction. However, the primary disadvantages of this technique include postoperative kneeling pain, the risk of perioperative patellar fracture, and graft-tunnel mismatch. Therefore, a single bone plug technique for ACL reconstructions was developed to mitigate the disadvantages of the BTB technique. To differentiate this graft, we have coined the term BTA, for bone-tendon-autograft. The middle third of the patellar tendon is used with a typical width of 10 to 11 mm. A standard tibial tubercle bone plug is harvested. The length of the patellar tendon and graft construct is then measured. If the tendon is >45 mm and the construct at least 70 mm, then we proceed with the BTA technique. At the inferior pole of the patella, electrocautery is used to harvest the tendon from the patella. The advantages of this technique include faster graft harvest and preparation. Obviating the patellar bone plug harvest should eliminate the risk of perioperative patellar fracture and theoretically will mitigate donor site morbidity and kneeling pain, 2 of the most commonly cited complications of the use of BTB autografts for ACL reconstruction. In conclusion, the BTA technique is a reliable technique for ACL reconstruction.

| S-EPMC7587499 | biostudies-literature

"Y" Graft Double Bundle Anterior Cruciate Ligament Reconstruction.

Project description:Single-bundle (SB) anterior cruciate ligament (ACL) reconstruction has been a standard procedure. However, residual rotary instability in approximately 20% of the cases (irrespective of the graft choice and the surgical technique) forces the surgeon to improve the biomechanical quality of the reconstruction. In parallel, adjustable suspensory fixation (ASF) devices have arisen. Biomechanics has defined (both anatomical and functional) the anteromedial (AM) and posterolateral (PL) bundles that work synergistically. In the unsymmetrical "anatomic" SB ACL reconstruction, the distribution of the ACL graft fibers (for AM or PL behavior) is not under the control of the surgeon. Furthermore, different sizes of the original footprints (depending on height) suggest the need to customize the graft footprint. This customization is only possible if distances are measured during surgical procedures. We present an inside-out technique for DB ACL reconstruction ("all-inside" also possible). Semitendinosus is folded to obtain a Y-shaped trifurcate configuration graft, distributing their bundles in two different areas. Used as measuring instruments, we used the "offset" guides as measuring instruments, allowing the surgeon to know the distance between the centers of the AM and PL tunnels. It may be carried out by means of common "offset" guides and any marketed ASF devices, while generating customized footprints.ClassificationI: knee; II: ACL.

| S-EPMC8417341 | biostudies-literature

Hamstring Graft Preparation Techniques for Anterior Cruciate Ligament Reconstruction.

Project description:Anterior cruciate ligament reconstruction is one of the most commonly performed procedures in orthopaedics, with more than 125,000 performed in the United States per year. There are several reconstruction graft choices that can be used to reconstruct the native anterior cruciate ligament, with autograft hamstring tendons being one of the most commonly used. Preparation of a hamstring autograft varies depending on patient characteristics and physician preference. The purpose of this Technical Note is to describe in detail different variants of hamstring graft preparation techniques that are commonly used in practice.

| S-EPMC5766355 | biostudies-literature

OmicsDI is part of the ELIXIR infrastructure

OmicsDI is an Elixir interoperability service. Learn more ›

Tweets

OmicsDI Databases

PRIDE
PeptideAtlas
MassIVE
JPOST Repository
Physiome Model Repository

EGA
EVA
ENA
LINCS
PAXDB
Cell Collective

MetaboLights
Metabolomics Workbench
MetabolomeExpress
GNPS
BioModels
FAIRDOMHub

ArrayExpress
dbGaP
ExpressionAtlas
GEO
NODE

Information

Databases
Help
API
Contact us
Code on GitHub
Terms of use
Submit Data