Dataset Information

Estimation of free-roaming domestic dog population size: Investigation of three methods including an Unmanned Aerial Vehicle (UAV) based approach.

ABSTRACT: Population size estimation is performed for several reasons including disease surveillance and control, for example to design adequate control strategies such as vaccination programs or to estimate a vaccination campaign coverage. In this study, we aimed at investigating the possibility of using Unmanned Aerial Vehicles (UAV) to estimate the size of free-roaming domestic dog (FRDD) populations and compare the results with two regularly used methods for population estimations: foot-patrol transect survey and the human: dog ratio estimation. Three studies sites of one square kilometer were selected in Petén department, Guatemala. A door-to-door survey was conducted in which all available dogs were marked with a collar and owner were interviewed. The day after, UAV flight were performed twice during two consecutive days per study site. The UAV's camera was set to regularly take pictures and cover the entire surface of the selected areas. Simultaneously to the UAV's flight, a foot-patrol transect survey was performed and the number of collared and non-collared dogs were recorded. Data collected during the interviews and the number of dogs counted during the foot-patrol transects informed a capture-recapture (CR) model fit into a Bayesian inferential framework to estimate the dog population size, which was found to be 78, 259, and 413 in the three study sites. The difference of the CR model estimates compared to previously available dog census count (110 and 289) can be explained by the fact that the study population addressed by the different methods differs. The human: dog ratio covered the same study population as the dog census and tended to underestimate the FRDD population size (97 and 161). Under the conditions within this study, the total number of dogs identified on the UAV pictures was 11, 96, and 71 for the three regions (compared to the total number of dogs counted during the foot-patrol transects of 112, 354 and 211). In addition, the quality of the UAV pictures was not sufficient to assess the presence of a mark on the spotted dogs. Therefore, no CR model could be implemented to estimate the size of the FRDD using UAV. We discussed ways for improving the use of UAV for this purpose, such as flying at a lower altitude in study area wisely chosen. We also suggest to investigate the possibility of using infrared camera and automatic detection of the dogs to increase visibility of the dogs in the pictures and limit workload of finding them. Finally, we discuss the need of using models, such as spatial capture-recapture models to obtain reliable estimates of the FRDD population. This publication may provide helpful directions to design dog population size estimation methods using UAV.

SUBMITTER: Warembourg C

PROVIDER: S-EPMC7141685 | biostudies-literature | 2020

REPOSITORIES: biostudies-literature

ACCESS DATA

Publications

Estimation of free-roaming domestic dog population size: Investigation of three methods including an Unmanned Aerial Vehicle (UAV) based approach.

Warembourg Charlotte C Berger-González Monica M Alvarez Danilo D Maximiano Sousa Filipe F López Hernández Alexis A Roquel Pablo P Eyerman Joe J Benner Merlin M Dürr Salome S

PloS one 20200408 4

Population size estimation is performed for several reasons including disease surveillance and control, for example to design adequate control strategies such as vaccination programs or to estimate a vaccination campaign coverage. In this study, we aimed at investigating the possibility of using Unmanned Aerial Vehicles (UAV) to estimate the size of free-roaming domestic dog (FRDD) populations and compare the results with two regularly used methods for population estimations: foot-patrol transec ...[more]

PMID: 32267848

Similar Datasets

Project description:The study of animal locomotion can be logistically challenging, especially in the case of large or unhandleable animals in uncontrolled environments. Here we demonstrate the utility of a low cost unmanned aerial vehicle (UAV) in measuring two-dimensional running kinematics from free-roaming giraffes (Giraffa camelopardalis giraffa) in the Free State Province, South Africa. We collected 120 Hz video of running giraffes, and calibrated each video frame using metatarsal length as a constant object of scale. We tested a number of methods to measure metatarsal length. The method with the least variation used close range photography and a trigonometric equation to spatially calibrate the still image, and derive metatarsal length. In the absence of this option, a spatially calibrated surface model of the study terrain was used to estimate topographical dimensions in video footage of interest. Data for the terrain models were collected using the same equipment, during the same study period. We subsequently validated the accuracy of the UAV method by comparing similar speed measurements of a human subject running on a treadmill, with treadmill speed. At 8 m focal distance we observed an error of 8% between the two measures of speed. This error was greater at a shorter focal distance, and when the subject was not in the central field of view. We recommend that future users maximise the camera focal distance, and keep the subject in the central field of view. The studied giraffes used a grounded rotary gallop with a speed range of 3.4-6.9 ms-1 (never cantering, trotting or pacing), and lower duty factors when compared with other cursorial quadrupeds. As this pattern might result in adverse increases in peak vertical limb forces with speed, it was notable to find that contralateral limbs became more in-phase with speed. Considering the latter pattern and the modest maximal speed of giraffes, we speculate that tissue safety factors are maintained within tolerable bounds this way. Furthermore, the angular kinematics of the neck were frequently isolated from the pitching of the body during running; this may be a result of the large mass of the head and neck. Further field experiments and biomechanical models are needed to robustly test these speculations.

Project description:BackgroundThe technology of cotton defoliation is essential for mechanical cotton harvesting. Agricultural unmanned aerial vehicle (UAV) spraying has the advantages of low cost, high efficiency and no mechanical damage to cotton and has been favored and widely used by cotton planters in China. However, there are also some problems of low cotton defoliation rates and high impurity rates caused by unclear spraying amounts of cotton defoliants. The chemical rate recommendation and application should be based upon crop canopy volume rather than on land area. Plant height and leaf area index (LAI) is directly connected to plant canopy structure. Accurate dynamic monitoring of plant height and LAI provides important information for evaluating cotton growth and production. The traditional method to obtain plant height and LAI was s a time-consuming and labor-intensive task. It is very difficult and unrealistic to use the traditional measurement method to make the temporal and spatial variation map of plant height and LAI of large cotton fields. With the application of UAV in agriculture, remote sensing by UAV is currently regarded as an effective technology for monitoring and estimating plant height and LAI.ResultsIn this paper, we used UAV RGB photos to build dense point clouds to estimate cotton plant height and LAI following cotton defoliant spraying. The results indicate that the proposed method was able to dynamically monitor the changes in the LAI of cotton at different times. At 3 days after defoliant spraying, the correlation between the plant height estimated based on the constructed dense point cloud and the measured plant height was strong, with [Formula: see text] and RMSE values of 0.962 and 0.913, respectively. At 10 days after defoliant spraying, the correlation became weaker over time, with [Formula: see text] and RMSE values of 0.018 and 0.027, respectively. Comparing the actual manually measured LAI with the estimated LAI based on the dense point cloud, the [Formula: see text] and RMSE were 0.872 and 0.814 and 0.132 and 0.173 at 3 and 10 days after defoliant spraying, respectively.ConclusionsDense point cloud construction based on UAV remote sensing is a potential alternative to plant height and LAI estimation. The accuracy of LAI estimation can be improved by considering both plant height and planting density.

Project description:Plant nitrogen concentration (PNC) is a critical indicator of N status for crops, and can be used for N nutrition diagnosis and management. This work aims to explore the potential of multispectral imagery from unmanned aerial vehicle (UAV) for PNC estimation and improve the estimation accuracy with hyperspectral data collected in the field with a hyperspectral radiometer. In this study we combined selected vegetation indices (VIs) and texture information to estimate PNC in rice. The VIs were calculated from ground and aerial platforms and the texture information was obtained from UAV-based multispectral imagery. Two consecutive years (2015 & 2016) of experiments were conducted, involving different N rates, planting densities and rice cultivars. Both UAV flights and ground spectral measurements were taken along with destructive samplings at critical growth stages of rice (Oryza sativa L.). After UAV imagery preprocessing, both VIs and texture measurements were calculated. Then the optimal normalized difference texture index (NDTI) from UAV imagery was determined for separated stage groups and the entire season. Results demonstrated that aerial VIs performed well only for pre-heading stages (R2 = 0.52-0.70), and photochemical reflectance index and blue N index from ground (PRIg and BNIg) performed consistently well across all growth stages (R2 = 0.48-0.65 and 0.39-0.68). Most texture measurements were weakly related to PNC, but the optimal NDTIs could explain 61 and 51% variability of PNC for separated stage groups and entire season, respectively. Moreover, stepwise multiple linear regression (SMLR) models combining aerial VIs and NDTIs did not significantly improve the accuracy of PNC estimation, while models composed of BNIg and optimal NDTIs exhibited significant improvement for PNC estimation across all growth stages. Therefore, the integration of ground-based narrow band spectral indices with UAV-based textural information might be a promising technique in crop growth monitoring.

Project description:Systematic monitoring of pasture quantity and quality is important to match the herd forage demand (pasture removal by grazing or harvest) to the supply of forage with adequate nutritive value. The aim of this research was to monitor, assess and manage changes in pasture growth, morphology and digestibility by integrating information from an Unmanned Aerial Vehicle (UAV) and two process-based models. The first model, Systems Approach to Land Use Sustainability (SALUS), is a process-based crop growth model used to predict pasture regrowth based on soil, climate, and management data. The second model, Morphogenetic and Digestibility of Pasture (MDP), uses paddock-scale values of herbage mass as input to predict leaf morphogenesis and forage nutritive value. Two field experiments were carried out on tall fescue- and ryegrass-based pastures under rotational grazing with lactating dairy cattle. The first experiment was conducted at plot scale and was used to calibrate the UAV and to test models. The second experiment was conducted at field scale and was used to test the UAV's ability to predict pasture biomass under grazing rotation. The Normalized Difference Vegetation Index (NDVI) calculated from the UAV's multispectral reflectance (n = 72) was strongly correlated (p < 0.001) to plot measurements of pasture biomass (R2 = 0.80) within the range of ~226 and 4208 kg DM ha-1. Moreover, there was no difference (root mean square error, RMSE < 500 kg DM ha-1) between biomass estimations by the UAV (1971±350 kg ha-1) and two conventional methods used as control, the C-Dax proximal sensor (2073±636 kg ha-1) and ruler (2017±530 kg ha-1). The UAV approach was capable of mapping at high resolution (6 cm) the spatial variability of pasture (16 ha). The integrated UAV-modeling approach properly predicted spatial and temporal changes in pasture biomass (RMSE = 509 kg DM ha-1, CCC = 0.94), leaf length (RMSE = 6.2 cm, CCC = 0.62), leaf stage (RMSE = 0.7 leaves, CCC = 0.65), neutral detergent fiber (RMSE = 3%, CCC = 0.71), digestibility of neutral detergent fiber (RMSE = 8%, CCC = 0.92) and digestibility of dry matter (RMSE = 5%, CCC = 0.93) with reasonable precision and accuracy. These findings therefore suggest potential for the present UAV-modeling approach for use as decision support tool to allocate animals based on spatially and temporally explicit predictions of pasture biomass and nutritive value.

Project description:Rapid, non-destructive and accurate detection of crop N status is beneficial for optimized fertilizer applications and grain quality prediction in the context of precision crop management. Previous research on the remote estimation of crop N nutrition status was mostly conducted with ground-based spectral data from nadir or oblique angles. Few studies investigated the performance of unmanned aerial vehicle (UAV) based multispectral imagery in regular nadir views for such a purpose, not to mention the feasibility of oblique or multi-angular images for improved estimation. This study employed a UAV-based five-band camera to acquire multispectral images at seven view zenith angles (VZAs) (0°, ± 20°, ± 40° and ±60°) for three critical growth stages of winter wheat. Four representative vegetation indices encompassing the Visible Atmospherically Resistant Index (VARI), Red edge Chlorophyll Index (CIred-edge), Green band Chlorophyll Index (CIgreen), Modified Normalized Difference Vegetation Index with a blue band (mNDblue) were derived from the multi-angular images. They were used to estimate the N nutrition status in leaf nitrogen concentration (LNC), plant nitrogen concentration (PNC), leaf nitrogen accumulation (LNA), and plant nitrogen accumulation (PNA) of wheat canopies for a combination of treatments in N rate, variety and planting density. The results demonstrated that the highest accuracy for single-angle images was obtained with CIgreen for LNC from a VZA of -60° (R2 = 0.71, RMSE = 0.34%) and PNC from a VZA of -40° (R2 = 0.36, RMSE = 0.29%). When combining an off-nadir image (-40°) and the 0° image, the accuracy of PNC estimation was substantially improved (CIred-edge: R2 = 0.52, RMSE = 0.28%). However, the use of dual-angle images did not significantly increase the estimation accuracy for LNA and PNA compared to the use of single-angle images. Our findings suggest that it is important and practical to use oblique images from a UAV-based multispectral camera for better estimation of nitrogen concentration in wheat leaves or plants. The oblique images acquired from additional flights could be used alone or combined with the nadir-view images for improved crop N status monitoring.

Dataset Information

Estimation of free-roaming domestic dog population size: Investigation of three methods including an Unmanned Aerial Vehicle (UAV) based approach.

Publications

Estimation of free-roaming domestic dog population size: Investigation of three methods including an Unmanned Aerial Vehicle (UAV) based approach.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets