Dataset Information

Geochemical and magnetic data on anthropogenic ashes from municipal solid waste incineration (MSWI).

ABSTRACT: This paper reports supplementary information to "Understanding room-temperature magnetic properties of anthropogenic ashes from municipal solid waste incineration to assess potential impacts and resources" [1]. The sample-set is composed of 47 samples of bottom (BA) and fly (FA) ashes from Municipal Solid Waste Incineration (MSWI), including eight magnetic extracts of selected BA and FA materials. The sampling relies on a simple random sampling strategy at four different MSWI sites in Northern Italy [2]. X-Ray Fluorescence (XRF) analysis on pressed powder pellets, microscopic observations on thin sections and stubs, and magnetic analysis were carried out. Various magnetic measurements are presented: the magnetic susceptibility measured at two different frequencies (0.47 and 4.7 kHz); the mass-specific susceptibility of ARM (?_ARM), expressed in m³/kg, calculated after mass-normalization and bias DC field correction; experiments for isothermal remanent magnetization (IRM) experimented were also conducted. The latter measurement allowed the calculation of additional parameters, such as the coercivity of remanence (B_0cr) and the S-ratio [3]. The IRM acquired in a field of 1.0 T was regarded as the saturation IRM (SIRM). Mass-specific magnetic susceptibility (?) was calculated by dividing the volume susceptibility by the sample mass. Finally, hysteresis loops and backfield curves at room temperature were measured on selected samples and are available. Data can be reused as groundwork information in future studies on MSWI residues. It would be essential to produce new data on geochemical and magnetic characteristics of MSWI residues to assure good coverage of data for enhanced sustainability of these heterogeneous streams of anthropogenic materials. This combination of methods will contribute to paving the way for quick and reliable resource assessment as well as to promote environmental sustainability.

SUBMITTER: Funari V

PROVIDER: S-EPMC7298404 | biostudies-literature | 2020 Aug

REPOSITORIES: biostudies-literature

ACCESS DATA

Publications

Geochemical and magnetic data on anthropogenic ashes from municipal solid waste incineration (MSWI).

Funari Valerio V Mantovani Luciana L Vigliotti Luigi L Dinelli Enrico E Tribaudino Mario M

Data in brief 20200521

This paper reports supplementary information to "Understanding room-temperature magnetic properties of anthropogenic ashes from municipal solid waste incineration to assess potential impacts and resources" [1]. The sample-set is composed of 47 samples of bottom (BA) and fly (FA) ashes from Municipal Solid Waste Incineration (MSWI), including eight magnetic extracts of selected BA and FA materials. The sampling relies on a simple random sampling strategy at four different MSWI sites in Northern I ...[more]

PMID: 32566699

Similar Datasets

Project description:Municipal solid waste incineration (MSWI) ash is often managed through co-disposal with unburned wastes in landfills, a practice previously reported to result in enhanced leaching of pollutants (e.g., heavy metals) in landfill leachate. The objective of this study was to evaluate the effect of co-disposed unburned wastes on per- and polyfluoroalkyl substances (PFAS) in MSWI ash landfill leachate. Leachate was collected from four landfills containing MSWI ash, either as a sole waste stream or co-disposed of with sewage sludge and MSW screenings. Samples of ash and unburned materials were collected and assessed separately for leachable PFAS in the laboratory. All samples were analyzed for 26 PFAS. Results showed that greater ash content was associated with lower leachate PFAS concentrations. The pure ash monofill exhibited the lowest PFAS in landfill leachate (290 ng L-1) while the landfill contained a large amount of unburned waste had the highest PFAS (11,000 ng L-1). For laboratory leaching tests, average ∑26PFAS concentration in lab ash leachate (310 ng L-1) was 10 and 24 times lower than observed in lab sewage sludge leachate (3,200 ng L-1) and lab MSW screenings leachate (7,500 ng L-1), respectively. Leachate from the ash-only landfill had ∑26PFAS concentration similar to what was measured in the ash itself. On the contrary, ∑26PFAS concentration in co-disposal landfill leachates were similar to those in PFAS-rich unburned waste itself, regardless of the percentages of landfilled unburned wastes. We hypothesize that leachate generated in co-disposal scenarios preferentially flows through PFAS-rich unburned materials and that biotransformation of precursors enhanced by unburned waste degradation further contributes to higher concentrations of terminal PFAS in ash co-disposal sites. Landfill operators should expect PFAS in leachates to be higher when PFAS-rich unburned wastes are disposed of alongside MSWI ash, even if the unburned fraction is small.

Project description:Incineration has emerged as one of the acceptable ways to treat municipal solid waste (MSW) due to its potential in reducing the mass and volume of the waste. However, it produces two major by-product residues, namely MSW-bottom ash (MSW-BA) and MSW-fly ash (MSW-FA). These residues have gained great attention to their hazardous nature and potential to be reused and recycled. In this paper, the physicochemical characterizations of the MSW-BA and the MSW-FA were performed, followed by a systematic investigation of metals extraction from MSW-BA and MSW-FA. Various extracting agents were used to investigate the possibility to extract 21 metals including cadmium (Cd), vanadium (V), chromium (Cr), and lead (Pb). It was revealed that some metals were present in a high amount in the MSW-BA while other metals were higher in the MSW-FA. Moreover, the energy-dispersive X-ray spectroscopy results revealed that the MSW-BA was dominated by oxygen (O) 55.4 ±0.6 wt%, silicon (Si) 22.5 ±0.3 wt%, and calcium (Ca) 18.5 ±0.2 wt%. On the other hand, the MSW-FA was enriched with Ca 45.2 ±0.5 wt%, and O 40.3 ±0.4 wt%. From the scanning electron microscopy, the MSW-BA was observed as flaky with an irregular surface that consisted of large pores, while, the MSW-FA was present as agglomerated particles and had a bimodal distribution. Moreover, Fourier transform infrared spectroscopy revealed that Al-Fe-OH, Al-Al-OH, Si-O, C-O, and C-H were some of the major functional groups present in the ashes. The F-tests concluded that the metal extraction from the MSW-BA and MSW-FA were significantly affected by the acid type. it is concluded that nitric acid and phosphoric acid were the best-suited acid for the MSW-BA while sulfuric acid and phosphoric acid for the MSW-FA. More than 11 wt% of Cd and 9 wt% of Cu were extracted from MSW-BA while 6 wt% of Pb and 4.5 wt% of V were extracted from the MSW-FA. The present methodology is an interesting development in metal extraction from the MSW-BA and the MSW-FA, which can develop in a cost-effective and sustainable option to utilize MSW.

Dataset Information

Geochemical and magnetic data on anthropogenic ashes from municipal solid waste incineration (MSWI).

Publications

Geochemical and magnetic data on anthropogenic ashes from municipal solid waste incineration (MSWI).

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets