A Numerical Algorithm to Solve the Two-Phase Flow in Porous Media Including Foam Displacement
Ontology highlight
ABSTRACT:
SUBMITTER: Krzhizhanovskaya V
PROVIDER: S-EPMC7304854 | biostudies-literature | 2020 May
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:We use synchrotron X-ray micro-tomography to investigate the displacement dynamics during three-phase-oil, water and gas-flow in a hydrophobic porous medium. We observe a distinct gas invasion pattern, where gas progresses through the pore space in the form of disconnected clusters mediated by double and multiple displacement events. Gas advances in a process we name three-phase Haines jumps, during which gas re-arranges its configuration in the pore space, retracting from some regions to enable the rapid filling of multiple pores. The gas retraction leads to a permanent disconnection of gas ganglia, which do not reconnect as gas injection proceeds. We observe, in situ, the direct displacement of oil and water by gas as well as gas-oil-water double displacement. The use of local in situ measurements and an energy balance approach to determine fluid-fluid contact angles alongside the quantification of capillary pressures and pore occupancy indicate that the wettability order is oil-gas-water from most to least wetting. Furthermore, quantifying the evolution of Minkowski functionals implied well-connected oil and water, while the gas connectivity decreased as gas was broken up into discrete clusters during injection. This work can be used to design CO2 storage, improved oil recovery and microfluidic devices.
| S-EPMC7776970 | biostudies-literature
Project description:Field trials have demonstrated that foamed gel is a very cost-effective technology for profile modification and water shut-off. However, the mechanisms of profile modification and flow behavior of foamed gel in non-homogeneous porous media are not yet well understood. In order to investigate these mechanisms and the interactions between foamed gel and oil in porous media, coreflooding and pore-scale visualization waterflooding experiments were performed in the laboratory. The results of the coreflooding experiment in non-homogeneous porous media showed that the displacement efficiency improved by approximately 30% after injecting a 0.3 pore volume of foamed gel, and was proportional to the pore volumes of the injected foamed gel. Additionally, the mid-high permeability zone can be selectively plugged by foamed gel, and then oil located in the low permeability zone will be displaced. The visualization images demonstrated that the amoeba effect and Jamin effect are the main mechanisms for enhancing oil recovery by foamed gel. Compared with conventional gel, a unique benefit of foamed gel is that it can pass through micropores by transforming into arbitrary shapes without rupturing, this phenomenon has been named the amoeba effect. Additionally, the stability of foam in the presence of crude oil also was investigated. Image and statistical analysis showed that these foams boast excellent oil resistance and elasticity, which allows them to work deep within formations.
| S-EPMC4451013 | biostudies-other
Project description:We identify a distinct two-phase flow invasion pattern in a mixed-wet porous medium. Time-resolved high-resolution synchrotron X-ray imaging is used to study the invasion of water through a small rock sample filled with oil, characterized by a wide non-uniform distribution of local contact angles both above and below 90°. The water advances in a connected front, but throats are not invaded in decreasing order of size, as predicted by invasion percolation theory for uniformly hydrophobic systems. Instead, we observe pinning of the three-phase contact between the fluids and the solid, manifested as contact angle hysteresis, which prevents snap-off and interface retraction. In the absence of viscous dissipation, we use an energy balance to find an effective, thermodynamic, contact angle for displacement and show that this angle increases during the displacement. Displacement occurs when the local contact angles overcome the advancing contact angles at a pinned interface: it is wettability which controls the filling sequence. The product of the principal interfacial curvatures, the Gaussian curvature, is negative, implying well-connected phases which is consistent with pinning at the contact line while providing a topological explanation for the high displacement efficiencies in mixed-wet media.
| S-EPMC7482207 | biostudies-literature
Project description:We present an experimental and numerical study of immiscible two-phase flow of Newtonian fluids in three-dimensional (3D) porous media to find the relationship between the volumetric flow rate (Q) and the total pressure difference ([Formula: see text]) in the steady state. We show that in the regime where capillary forces compete with the viscous forces, the distribution of capillary barriers at the interfaces effectively creates a yield threshold ([Formula: see text]), making the fluids reminiscent of a Bingham viscoplastic fluid in the porous medium. In this regime, Q depends quadratically on an excess pressure drop ([Formula: see text]). While increasing the flow rate, there is a transition, beyond which the overall flow is Newtonian and the relationship is linear. In our experiments, we build a model porous medium using a column of glass beads transporting two fluids, deionized water and air. For the numerical study, reconstructed 3D pore networks from real core samples are considered and the transport of wetting and non-wetting fluids through the network is modeled by tracking the fluid interfaces with time. We find agreement between our numerical and experimental results. Our results match with the mean-field results reported earlier.
| S-EPMC5522531 | biostudies-literature
Project description:The propagation of foam in an oil reservoir depends on the creation and stability of the foam in the reservoir, specifically the creation and stability of foam films, or lamellae. As the foam propagates far from the injection well, superficial velocity and pressure gradient decrease with distance from the well. Experimental (Friedmann et al. Steam-foam mechanistic field trial in the midway-sunset field. SPERE. 1994, 9 (4), 297-304) and theoretical (Ashoori, et al. Roles of Transient and Local Equilibrium Foam Behaviour in Porous Media: Traveling Wave. Colloids Surf. A 2011, 337 (1-3), 228-242). studies relate concerns about foam propagation at low superficial velocity to the minimum velocity or pressure gradient for foam generation near the well (Gauglitz et al. Foam Generation in Homogeneous Porous Media. Chem. Eng. Sci. 2002, 57, 4037-4052; Rossen et al. Percolation Theory of Creation and Mobilization of Foams in Porous Media. AI Chem Eng. J. 1990, 36, (8)). The objective of this work is to measure the impact of surfactant concentration and gas fractional flow on foam generation. Theory (Kam et al. Model for Foam Generation in Homogeneous Media. SPE J. 2003, 8 (4): 417-42, SPE-87334-PA; Rossen 1990) relates foam generation to gas fractional flow and, indirectly, to the stability of foam films, or lamellae, which in turn depends on surfactant concentration (Apaydin et al. Surfactant Concentration and End Effects on Foam Flow in Porous Media. (Apaydin et al.Transp Porous Media. 2001, 43, 511-536). However, the link between foam generation and surfactant concentration has not been established experimentally. In our experiments, nitrogen foam is generated in a core of Bentheimer sandstone. The foam-generation experiments consist of measuring the minimum velocity for foam generation as a function of gas fractional flow at three surfactant concentrations well above the critical micelle concentration. Experimental results show that the minimum velocity for foam generation decreases with increasing liquid fraction, as shown by previous foam generation studies (Friedmann et al., 1994; Rossen and Gauglitz, 1990). Additionally, our results show that this velocity decreases with increasing surfactant concentration, far above the CMC. We also propose a workflow for screening out the experimental artifacts that can distort the trigger velocity.
| S-EPMC6369666 | biostudies-literature
Project description:Description Microscopy reveals that polymers cause chaotic flow fluctuations in a porous medium, increasing macroscopic flow resistance. Many energy, environmental, industrial, and microfluidic processes rely on the flow of polymer solutions through porous media. Unexpectedly, the macroscopic flow resistance often increases above a threshold flow rate in a porous medium, but not in bulk solution. The reason why has been a puzzle for over half a century. Here, by directly visualizing flow in a transparent 3D porous medium, we demonstrate that this anomalous increase is due to the onset of an elastic instability in which the flow exhibits strong spatiotemporal fluctuations reminiscent of inertial turbulence, despite the small Reynolds number. Our measurements enable us to quantitatively establish that the energy dissipated by pore-scale fluctuations generates the anomalous increase in the overall flow resistance. Because the macroscopic resistance is one of the most fundamental descriptors of fluid flow, our results both help deepen understanding of complex fluid flows and provide guidelines to inform a broad range of applications.
| S-EPMC8570596 | biostudies-literature
Project description:We present a systematic, quantitative assessment of the impact of pore size disorder and its interplay with flow rates and wettability on immiscible displacement of a viscous fluid. Pore-scale simulations and micromodel experiments show that reducing disorder increases the displacement efficiency and compactness, minimizing the fluid-fluid interfacial area, through (i) trapping at low rates and (ii) viscous fingering at high rates. Increasing the wetting angle suppresses both trapping and fingering, hence reducing the sensitivity of the displacement to the underlying disorder. A modified capillary number Ca* that includes the impact of disorder ? on viscous forces (through pore connectivity) is direct related to ?, in par with previous works. Our findings bear important consequences on sweep efficiency and fluid mixing and reactions, which are key in applications such as microfluidics to carbon geosequestration, energy recovery, and soil aeration and remediation.
| S-EPMC5080577 | biostudies-literature
Project description:We examined how bees solve a visual discrimination task with stimuli commonly used in numerical cognition studies. Bees performed well on the task, but additional tests showed that they had learned continuous (non-numerical) cues. A network model using biologically plausible visual feature filtering and a simple associative rule was capable of learning the task using only continuous cues inherent in the training stimuli, with no numerical processing. This model was also able to reproduce behaviours that have been considered in other studies indicative of numerical cognition. Our results support the idea that a sense of magnitude may be more primitive and basic than a sense of number. Our findings highlight how problematic inadvertent continuous cues can be for studies of numerical cognition. This remains a deep issue within the field that requires increased vigilance and cleverness from the experimenter. We suggest ways of better assessing numerical cognition in non-speaking animals, including assessing the use of all alternative cues in one test, using cross-modal cues, analysing behavioural responses to detect underlying strategies, and finding the neural substrate.
| S-EPMC7934903 | biostudies-literature
Project description:This work provides new insights into the dynamics of silica nanoparticle-based removal of organic fluids (here oil) from naturally occurring porous media. We have used 4D (time-resolved 3D) imaging at pore-scale using X-ray computed micro-tomography (μCT) technique. The captured 3D tomographic time-series data reveal the dynamics of immiscible oil displacement from a carbonate rock upon injection of nanoparticle (NP) suspensions (0.06 and 0.12 wt% SiO2 in deionised water). Our analysis shows significant pore-scale remobilisation of initially trapped oil upon injection of the NP suspensions, specifically, at higher concentration. Our data shows that oil clusters become significantly smaller with larger fluid/fluid interface as a result of the higher concentration NP injection. This paper demonstrates that use of 2D radiograms collected during fluid injections allows monitoring flow dynamics at time resolutions down to a few seconds using conventional laboratory-based μCT scanners. Here, as an underlying mechanism for oil remobilisation, we present the first 4D evidence of in-situ formation of an oil in water emulsion induced by nanoparticles.
| S-EPMC6057960 | biostudies-literature
Project description:Microfluidics methods offer possibilities for visual observations of oil recovery processes. Good control over test parameters also provides the opportunity to conduct tests that simulate representative reservoir conditions. This paper presents a setup and procedure development for microfluidic oil recovery tests at elevated temperature and pressure. Oil recovery factors and displacement patterns were determined in single- or two-step recovery tests using two crude oils, high salinity salt solutions and low salinity surfactant solutions. Neither the displacement pattern nor the recovery factor was significantly affected by the pressure range tested here. Increasing temperature affected the recovery factor significantly, but with opposite trends for the two tested crude oils. The difference was justified by changes in wettability alteration, due to variations in the amounts and structure of the acidic and basic oil fractions. Low salinity surfactant solutions enhanced the oil recovery for both oils.
| S-EPMC8514519 | biostudies-literature