Project description:During the doffing of personal protective equipment (PPE), pathogens can be transferred from the PPE to the bodies of healthcare workers (HCWs), putting HCWs and patients at risk of exposure and infection. PPE doffing practices of HCWs who cared for patients with viral respiratory infections were observed at an acute care hospital from March 2017 to April 2018. A trained observer recorded doffing performance of HCWs inside the patient rooms using a pre-defined checklist based on the Centers for Disease Control and Prevention (CDC) guideline. Doffing practices were observed 162 times during care of 52 patients infected with respiratory viral pathogens. Out of the 52 patients, 30 were in droplet and contact isolation, 21 were in droplet isolation, and 1 was in contact isolation. Overall, 90% of observed doffing was incorrect, with respect to the doffing sequence, doffing technique, or use of appropriate PPE. Common errors were doffing gown from the front, removing face shield of the mask, and touching potentially contaminated surfaces and PPE during doffing. Deviations from the recommended PPE doffing protocol are common and can increase potential for contamination of the HCW's clothing or skin after providing care. There is a clear need to change the approach used to training HCWs in PPE doffing practices.
Project description:ObjectiveWith the epidemic of coronavirus disease 2019 (COVID-19), the healthcare workers (HCWs) require proper respiratory personal protective equipment (rPPE) against viral respiratory infectious diseases (VRIDs). It is necessary to evaluate which type of mask and manner of wearing is the best suitable rPPE for preventing the VRID.Study designA Bayesian network meta-analysis was performed to comprehensively analyze the protective efficacy of various rPPE.MethodsThis network meta-analysis protocol was registered in an international prospective register of systematic reviews (CRD42020179489). Electronic databases were searched for cluster randomized control trials (RCTs) of comparing the effectiveness of rPPE and wearing manner in preventing HCWs from VRID. The primary outcome was the incidence of laboratory-confirmed viral respiratory infection reported as an odds ratio (OR) with the associated 95% credibility interval (CrI). The secondary outcome was the incidence of clinical respiratory illness (CRI) reported as an OR with the associated 95% CrI. Surface under the cumulative ranking curve analysis (SUCRA) provided a ranking of each rPPE according to the primary outcome and the secondary outcome as data supplement.ResultsSix studies encompassing 12,265 HCWs were included. In terms of the incidence of laboratory-confirmed viral respiratory infection, the continuous wearing of N95 respirators (network OR, 0.48; 95% CrI: 0.27 to 0.86; SUCRA score, 85.4) showed more effective than the control group. However, in terms of reducing the incidence of CRI, there was no rPPE showing superior protective effectiveness.ConclusionsThere are significant differences in preventive efficacy among current rPPE. Our result suggests that continuous wearing of N95 respirators on the whole shift can serve as the best preventive rPPE for HCWs from the VRID.
Project description:BackgroundTo mitigate potential exposure of healthcare workers (HCWs) to SARS-CoV-2 via aerosol routes, we have developed a portable hood which not only creates a barrier between HCW and patient, but also utilizes negative pressure with filtration of aerosols by a high-efficiency particulate air filter.Material and methodsThe hood has iris-port openings for access to the patient, and an opening large enough for a patient's head and upper torso. The top of the hood is a high-efficiency particulate air filter connected to a blower to apply negative pressure. We determined the aerosol penetration from outside to inside in laboratory experiments.ResultsThe penetration of particles from within the hood to the breathing zones of HCWs outside the hood was near 10-4 (0.01%) in the 200-400 nm size range, and near 10-3 (0.1%) for smaller particles. Penetration values for particles in the 500 nm-5 μm range were below 10-2 (1%). Fluorometric analysis of deposited fluorescein particles on the personal protective equipment of an HCW revealed that negative pressure reduces particle deposition both outside and inside the hood.ConclusionsWe find that negative pressure hoods can be effective controls to mitigate aerosol exposure to HCWs, while simultaneously allowing access to patients.
Project description:BackgroundPersonal protective equipment (PPE) is essential to protect healthcare workers (HCWs). The practice of reusing PPE poses high levels of risk for accidental contamination by HCWs. Scarce medical literature compares practical means or methods for safe reuse of PPE while actively caring for patients.MethodsIn this study, observations were made of 28 experienced clinical participants performing five donning and doffing encounters while performing simulated full evaluations of patients with coronavirus disease 2019. Participants' N95 respirators were coated with a fluorescent dye to evaluate any accidental fomite transfer that occurred during PPE donning and doffing. Participants were evaluated using blacklight after each doffing encounter to evaluate new contamination sites, and were assessed for the cumulative surface area that occurred due to PPE doffing. Additionally, participants' workstations were evaluated for contamination.ResultsAll participants experienced some contamination on their upper extremities, neck and face. The highest cumulative area of fomite transfer risk was associated with the hook and paper bag storage methods, and the least contamination occurred with the tabletop storage method. Storing a reused N95 respirator on a tabletop was found to be a safer alternative than the current recommendation of the US Centers for Disease Control and Prevention to use a paper bag for storage. All participants donning and doffing PPE were contaminated.ConclusionPPE reusage practices pose an unacceptably high level of risk of accidental cross-infection contamination to healthcare workers. The current design of PPE requires complete redesign with improved engineering and usability to protect healthcare workers.
Project description:Introduction: SARS-CoV-2 infection is a global pandemic. Personal Protective Equipment (PPE) to protect healthcare workers has been a recurrent challenge in terms of global stocks, supply logistics and suitability. In some settings, around 20% of healthcare workers treating COVID-19 cases have become infected, which leads to staff absence at peaks of the pandemic, and in some cases mortality. Methods: To address shortcomings in PPE, we developed a simple powered air purifying respirator, made from inexpensive and widely available components. The prototype was designed to minimize manufacturing complexity so that derivative versions could be developed in low resource settings with minor modification. Results: The "Personal Respirator - Southampton" (PeRSo) delivers High-Efficiency Particulate Air (HEPA) filtered air from a battery powered fan-filter assembly into a lightweight hood with a clear visor that can be comfortably worn for several hours. Validation testing demonstrates that the prototype removes microbes, avoids excessive CO2 build-up in normal use, and passes fit test protocols widely used to evaluate standard N95/FFP2 and N99/FFP3 face masks. Feedback from doctors and nurses indicate the PeRSo prototype was preferred to standard FFP2 and FFP3 masks, being more comfortable and reducing the time and risk of recurrently changing PPE. Patients report better communication and reassurance as the entire face is visible. Conclusion: Rapid upscale of production of cheaply produced powered air purifying respirators, designed to achieve regulatory approval in the country of production, could protect healthcare workers from infection and improve healthcare delivery during the COVID-19 pandemic.
Project description:BackgroundHealthcare workers (HCWs) use personal protective equipment (PPE) in Ebola virus disease (EVD) situations. However, preventing the contamination of HCWs and the environment during PPE removal crucially requires improved strategies. This study aimed to compare the efficacy of three PPE ensembles, namely, Hospital Authority (HA) Standard Ebola PPE set (PPE1), Dupont Tyvek Model, style 1422A (PPE2), and HA isolation gown for routine patient care and performing aerosol-generating procedures (PPE3) to prevent EVD transmission by measuring the degree of contamination of HCWs and the environment.MethodsA total of 59 participants randomly performed PPE donning and doffing. The trial consisted of PPE donning, applying fluorescent solution on the PPE surface, PPE doffing of participants, and estimation of the degree of contamination as indicated by the number of fluorescent stains on the working clothes and environment. Protocol deviations during PPE donning and doffing were monitored.ResultsPPE2 and PPE3 presented higher contamination risks than PPE1. Environmental contaminations such as those originating from rubbish bin covers, chairs, faucets, and sinks were detected. Procedure deviations were observed during PPE donning and doffing, with PPE1 presenting the lowest overall deviation rate (%) among the three PPE ensembles (p < 0.05).ConclusionContamination of the subjects' working clothes and surrounding environment occurred frequently during PPE doffing. Procedure deviations were observed during PPE donning and doffing. Although PPE1 presented a lower contamination risk than PPE2 and PPE3 during doffing and protocol deviations, the design of PPE1 can still be further improved. Future directions should focus on designing a high-coverage-area PPE with simple ergonomic features and on evaluating the doffing procedure to minimise the risk of recontamination. Regular training for users should be emphasised to minimise protocol deviations, and in turn, guarantee the best protection to HCWs.
Project description:Personal protective behaviors of healthcare workers (HCWs) and dynamic changes in them are known to play a major role in the hospital transmission of severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2). In this study, 1,499 HCWs in Chinese hospitals completed an online survey about their knowledge on SARS-CoV-2 transmission and their personal protective behaviors before and after coronavirus disease 2019 (COVID-19) vaccination. Of all the respondents, 89% were vaccinated at the time of the survey and 96% believed that the vaccine was effective or highly effective. Further, 88% of the vaccinated HCWs expressed that they would get revaccinated if the vaccination failed. Compared with HCWs with a lower education level, those with a higher education level had less fear of being infected with SARS-CoV-2 and reported a lower negative impact of the pandemic on how they treated patients. Physicians and nurses were willing to believe that short-range airborne and long-range fomite are possible transmission routes. HCWs with a higher education level had a better knowledge of COVID-19 but worse personal protective behaviors. The fact that HCWs with a longer work experience had worse personal protective behaviors showed that HCWs gradually relax their personal protective behaviors over time. Moreover, vaccination reduced the negative effects of the COVID-19 pandemic on how the HCWs treated patients. Importantly, the survey revealed that after vaccination, HCWs in China did not relax their personal protective behaviors, and it may bring a low potential risk for following waves of variant virus (e.g., delta).
Project description:Healthcare workers (HCW's) are at increased risk of corona virus disease (COVID-19) infection during aerosol generating activities. The aerosol box has been used during intubation and extubation to prevent transmission of infection to HCWs. Isolation room with negative pressure has been advocated for COVID-19 patients. The described containment box has been designed to be useful in COVID intensive care unit (ICU) as a multipurpose box which is a cost effective and readily available resource. This innovation combines the containment box with negative pressure generation using central vacuum.