Enhanced flight performance in non-uniformly flexible wings
Ontology highlight
ABSTRACT:
SUBMITTER: Vincent L
PROVIDER: S-EPMC7423438 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Aves are an incredibly diverse class of animals, ranging greatly in size and thriving in a wide variety of environments. Here, we explore the scaling trends of bird wings in connection with their flight performance. The tensile strength of avian bone is hypothesized to be a limiting factor in scaling the humerus with mass, which is corroborated by its experimentally determined allometric scaling trend. We provide a mechanics analysis that explains the scaling allometry of the wing humerus length, L H, with body weight W, L H ? W 0.44. Lastly, wing feathers are demonstrated to generally scale isometrically with bird mass, with the exception of the spacing between barbules, which falls within the same range for birds of all masses. Our findings provide insight into the "design" of birds and may be translatable to more efficient bird-inspired aircraft structures.
| S-EPMC6357743 | biostudies-literature
Project description:Classical tissue recombination experiments performed in the chick embryo provide evidence that signals operating during early limb development specify the position and identity of feathers. Here, we show that Sonic hedgehog (Shh) signalling in the embryonic chick wing bud specifies positional information required for the formation of adult flight feathers in a defined spatial and temporal sequence that reflects their different identities. We also reveal that Shh signalling is interpreted into specific patterns of Sim1 and Zic transcription factor expression, providing evidence of a putative gene regulatory network operating in flight feather patterning. Our data suggest that flight feather specification involved the co-option of the pre-existing digit patterning mechanism and therefore uncovers an embryonic process that played a fundamental step in the evolution of avian flight.
| S-EPMC7225127 | biostudies-literature
Project description:Insect wing shapes are remarkably diverse and the combination of shape and kinematics determines both aerial capabilities and power requirements. However, the contribution of any specific morphological feature to performance is not known. Using targeted RNA interference to modify wing shape far beyond the natural variation found within the population of a single species, we show a direct effect on flight performance that can be explained by physical modelling of the novel wing geometry. Our data show that altering the expression of a single gene can significantly enhance aerial agility and that the Drosophila wing shape is not, therefore, optimized for certain flight performance characteristics that are known to be important. Our technique points in a new direction for experiments on the evolution of performance specialities in animals.
| S-EPMC4773512 | biostudies-literature
Project description:A free-wake method is used to simulate the wake from retractable, jointed wings. The method serves to complement existing experimental studies that visualise flying animal wakes. Simulated wakes are shown to be numerically convergent for a case study of the Rock Pigeon in minimum power cruising flight. The free-wake model is robust in simulating wakes for a range of wing geometries and dynamics without requiring changes to the numerical method. The method is found to be useful for providing low order predictions of wake geometries. However, it is not well suited to reconstructing 3d flowfields as solutions are sensitive to the numerical mesh node locations.
| S-EPMC3719125 | biostudies-literature
Project description:Wide range binary and ternary thin film combinatorial libraries mixing Al, Cu, and Ga were screened for identifying alloys with enhanced ability to withstand electromigration. Bidimensional test wires were obtained by lithographically patterning the substrates before simultaneous vacuum co-deposition from independent sources. Current-voltage measurement automation allowed for high throughput experimentation, revealing the maximum current density and voltage at the electrical failure threshold for each alloy. The grain boundary dynamic during electromigration is attributed to the resultant between the force corresponding to the electron flux density and the one corresponding to the atomic concentration gradient perpendicular to the current flow direction. The screening identifies Al-8 at. % Ga and Cu-5 at. % Ga for replacing pure Al or Cu connecting lines in high current/power electronics. Both alloys were deposited on polyethylene naphthalate (PEN) flexible substrates. The film adhesion to PEN is enhanced by alloying Al or Cu with Ga. Electrical testing demonstrated that Al-8 at. % Ga is more suitable for conducting lines in flexible electronics, showing an almost 50% increase in electromigration suppression when compared to pure Al. Moreover, Cu-5 at. % Ga showed superior properties as compared to pure Cu on both SiO2 and PEN substrates, where more than 100% increase in maximum current density was identified.
| S-EPMC7883345 | biostudies-literature
Project description:The wings of many insect species including crane flies and damselflies are petiolate (on stalks), with the wing planform beginning some distance away from the wing hinge, rather than at the hinge. The aerodynamic impact of flapping petiolate wings is relatively unknown, particularly on the formation of the lift-augmenting leading-edge vortex (LEV): a key flow structure exploited by many insects, birds and bats to enhance their lift coefficient. We investigated the aerodynamic implications of petiolation P using particle image velocimetry flow field measurements on an array of rectangular wings of aspect ratio 3 and petiolation values of P = 1-3. The wings were driven using a mechanical device, the 'Flapperatus', to produce highly repeatable insect-like kinematics. The wings maintained a constant Reynolds number of 1400 and dimensionless stroke amplitude Λ* (number of chords traversed by the wingtip) of 6.5 across all test cases. Our results showed that for more petiolate wings the LEV is generally larger, stronger in circulation, and covers a greater area of the wing surface, particularly at the mid-span and inboard locations early in the wing stroke cycle. In each case, the LEV was initially arch-like in form with its outboard end terminating in a focus-sink on the wing surface, before transitioning to become continuous with the tip vortex thereafter. In the second half of the wing stroke, more petiolate wings exhibit a more detached LEV, with detachment initiating at approximately 70% and 50% span for P = 1 and 3, respectively. As a consequence, lift coefficients based on the LEV are higher in the first half of the wing stroke for petiolate wings, but more comparable in the second half. Time-averaged LEV lift coefficients show a general rise with petiolation over the range tested.
| S-EPMC5206603 | biostudies-other
Project description:Implementation of a new algorithm, SMILE, is described for reconstruction of non-uniformly sampled two-, three- and four-dimensional NMR data, which takes advantage of the known phases of the NMR spectrum and the exponential decay of underlying time domain signals. The method is very robust with respect to the chosen sampling protocol and, in its default mode, also extends the truncated time domain signals by a modest amount of non-sampled zeros. SMILE can likewise be used to extend conventional uniformly sampled data, as an effective multidimensional alternative to linear prediction. The program is provided as a plug-in to the widely used NMRPipe software suite, and can be used with default parameters for mainstream application, or with user control over the iterative process to possibly further improve reconstruction quality and to lower the demand on computational resources. For large data sets, the method is robust and demonstrated for sparsities down to ca 1%, and final all-real spectral sizes as large as 300 Gb. Comparison between fully sampled, conventionally processed spectra and randomly selected NUS subsets of this data shows that the reconstruction quality approaches the theoretical limit in terms of peak position fidelity and intensity. SMILE essentially removes the noise-like appearance associated with the point-spread function of signals that are a default of five-fold above the noise level, but impacts the actual thermal noise in the NMR spectra only minimally. Therefore, the appearance and interpretation of SMILE-reconstructed spectra is very similar to that of fully sampled spectra generated by Fourier transformation.
| S-EPMC5438302 | biostudies-literature
Project description:Butterflies look like no other flying animal, with unusually short, broad and large wings relative to their body size. Previous studies have suggested butterflies use several unsteady aerodynamic mechanisms to boost force production with upstroke wing clap being a prominent feature. When the wings clap together at the end of upstroke the air between the wings is pressed out, creating a jet, pushing the animal in the opposite direction. Although viewed, for the last 50 years, as a crucial mechanism in insect flight, quantitative aerodynamic measurements of the clap in freely flying animals are lacking. Using quantitative flow measurements behind freely flying butterflies during take-off and a mechanical clapper, we provide aerodynamic performance estimates for the wing clap. We show that flexible butterfly wings, forming a cupped shape during the upstroke and clap, thrust the butterfly forwards, while the downstroke is used for weight support. We further show that flexible wings dramatically increase the useful impulse (+22%) and efficiency (+28%) of the clap compared to rigid wings. Combined, our results suggest butterflies evolved a highly effective clap, which provides a mechanistic hypothesis for their unique wing morphology. Furthermore, our findings could aid the design of man-made flapping drones, boosting propulsive performance.
| S-EPMC7879755 | biostudies-literature
Project description:Small-winged drones can face highly varied aerodynamic requirements, such as high manoeuvrability for flight among obstacles and high wind resistance for constant ground speed against strong headwinds that cannot all be optimally addressed by a single aerodynamic profile. Several bird species solve this problem by changing the shape of their wings to adapt to the different aerodynamic requirements. Here, we describe a novel morphing wing design composed of artificial feathers that can rapidly modify its geometry to fulfil different aerodynamic requirements. We show that a fully deployed configuration enhances manoeuvrability while a folded configuration offers low drag at high speeds and is beneficial in strong headwinds. We also show that asymmetric folding of the wings can be used for roll control of the drone. The aerodynamic performance of the morphing wing is characterized in simulations, in wind tunnel measurements and validated in outdoor flights with a small drone.
| S-EPMC5206609 | biostudies-literature
Project description:Animal flight performance has been studied using models developed for man-made aircraft. For an aeroplane with fixed wings, the energetic cost as a function of flight speed can be expressed in terms of weight, wing span, wing area and body area, where more details are included in proportionality coefficients. Flying animals flap their wings to produce thrust. Adopting the fixed wing flight model implicitly incorporates the effects of wing flapping in the coefficients. However, in practice, these effects have been ignored. In this paper, the effects of reciprocating wing motion on the coefficients of the fixed wing aerodynamic power model for forward flight are explicitly formulated in terms of thrust requirement, wingbeat frequency and stroke-plane angle, for optimized wingbeat amplitudes. The expressions are obtained by simulating flights over a large parameter range using an optimal vortex wake method combined with a low-level blade element method. The results imply that previously assumed acceptable values for the induced power factor might be strongly underestimated. The results also show the dependence of profile power on wing kinematics. The expressions introduced in this paper can be used to significantly improve animal flight models.
| S-EPMC4985036 | biostudies-literature