Dataset Information

Investigating Adsorbing Viscoelastic Fluids Using the Quartz Crystal Microbalance.

ABSTRACT: There is little research on using the quartz crystal microbalance (QCM) with adsorbing viscoelastic fluids. These fluids are widely encountered but often difficult to study as many are opaque and highly viscous. Since the QCM does not involve any scattering or reflection of input radiation, it has the potential to study these complex fluids to determine the relative viscoelasticity of the bulk fluid and surface adsorption of active species onto different substrates. In the current study, both Newtonian (sucrose) and viscoelastic (sodium polystyrene sulfonate (NaPSS)) fluids were introduced into the QCM, and the sensor responses were compared. QCM responses of Newtonian sucrose solutions matched the Kanazawa and Gordon model (KG model), as expected. The QCM responses with viscoelastic NaPSS solutions were well below those described by the KG model. A viscoelastic model was used to determine the fluid viscosity and shear modulus at a very high frequency. It was found that the viscosity of NaPSS did not change much compared with low-frequency rheometer measurements, but a significant increase in the shear modulus of several orders of magnitude was found at the QCM frequencies. Modifying the KG model frequency shifts by multiplying by the QCM shear wave decay length ratio, X = ?V/?N, we were able to match the measured QCM values in viscoelastic NaPSS solutions. The QCM dissipation values for NaPSS were matched in a similar way by multiplying the KG model by X 1/3. By changing the QCM sensor from silica (no NaPSS adsorption) to alumina (NaPSS adsorption), it was shown that the adsorption isotherm of NaPSS on alumina could be recovered and fitted with a Langmuir isotherm despite the frequency response being only a small fraction of the total measured QCM signal.

SUBMITTER: Hodges CS

PROVIDER: S-EPMC7482089 | biostudies-literature | 2020 Sep

REPOSITORIES: biostudies-literature

ACCESS DATA

Publications

Investigating Adsorbing Viscoelastic Fluids Using the Quartz Crystal Microbalance.

Hodges Chris S CS Harbottle David D Biggs Simon S

ACS omega 20200827 35

There is little research on using the quartz crystal microbalance (QCM) with adsorbing viscoelastic fluids. These fluids are widely encountered but often difficult to study as many are opaque and highly viscous. Since the QCM does not involve any scattering or reflection of input radiation, it has the potential to study these complex fluids to determine the relative viscoelasticity of the bulk fluid and surface adsorption of active species onto different substrates. In the current study, both Ne ...[more]

PMID: 32923766

Similar Datasets

Project description:High percentages of harmful microbes or their secreting toxins bind to specific carbohydrate sequences on human cells at the recognition and attachment sites. A number of studies also show that lectins react with specific structures of bacteria and fungi. In this report, we take advantage of the fact that a high percentage of microorganisms have both carbohydrate and lectin binding pockets at their surface. We demonstrate here for the first time that a carbohydrate nonlabeled mass sensor in combination with lectin-bacterial O-antigen recognition can be used for detection of high molecular weight bacterial targets with remarkably high sensitivity and enhanced specificity. A functional mannose self-assembled monolayer in combination with lectin concanavalin A (Con A) was used as molecular recognition elements for the detection of Escherichia coli W1485 using a quartz crytsal microbalance (QCM) as a transducer. The multivalent binding of Con A to the E. coli surface O-antigen favors the strong adhesion of E. coli to the mannose-modified QCM surface by forming bridges between these two. As a result, the contact area between cell and QCM surface that increases leads to rigid and strong attachment. Therefore, it enhances the binding between E. coli and the mannose. Our results show a significant improvement of the sensitivity and specificity of the carbohydrate QCM biosensor with a experimental detection limit of a few hundred bacterial cells. The linear range is from 7.5 x 10(2) to 7.5 x 10(7) cells/mL, which is four decades wider than the mannose-alone QCM sensor. The change of damping resistances for E. coli adhesion experiments was no more than 1.4%, suggesting that the bacterial attachment was rigid, rather than a viscoelastic behavior. Little nonspecific binding was observed for Staphylococcus aureus and other proteins (fetal bovine serum, Erythrina cristagalli lectin). Our approach not only overcomes the challenges of applying QCM technology for bacterial detection but also increases the binding of bacteria to their carbohydrate receptor through bacterial surface binding lectins that significantly enhanced specificity and sensitivity of QCM biosensors. Combining carbohydrate and lectin recognition events with an appropriate QCM transducer can yield sensor devices highly suitable for the fast, reversible, and straightforward on-line screening and detection of bacteria in food, water, and clinical and biodefense areas.

Dataset Information

Investigating Adsorbing Viscoelastic Fluids Using the Quartz Crystal Microbalance.

Publications

Investigating Adsorbing Viscoelastic Fluids Using the Quartz Crystal Microbalance.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets