Dataset Information

Mechanistic Investigation of LSW/Surfactant/Alkali Synergism for Enhanced Oil Recovery: Fluid-Fluid Interactions.

ABSTRACT: The combination of chemical enhanced oil recovery (CEOR) and low salinity water (LSW) flooding is one of the most attractive enhanced oil recovery (EOR) methods. While several studies on CEOR have been performed to date, there still exists a lack of mechanistic understanding on the synergism between surfactant, alkali and LSW. This synergism, in terms of fluid-fluid interactions, is experimentally investigated in this study, and mechanistic understanding is gained through fluid analysis techniques. Two surfactants, one cationic and one anionic, namely an alkyltrimethylammonium bromide (C₁₉TAB) and sodium dodecylbenzenesulfonate (SDBS), were tested, together with NaOH used as the alkali, diluted formation brine used as the LSW, and the crude oil was collected from an Iranian carbonate oil reservoir. Fluids were analyzed using pendant drop method for interfacial tension (IFT) measurement, and Fourier transform infrared spectroscopy for determination of aqueous and oleic phase chemical interaction. The optimum concentration of LSW for IFT reduction was investigated to be 1000 ppm. Additionally, both surfactants reduced IFT significantly, from 28.86 mN/m to well below 0.80 mN/m, but in the presence of optimal alkali concentration the IFT dropped further to below 0.30 mN/m. IFT reduction by alkali was linked to the production of three different types of in situ anionic surfactants, while in the case of anionic and cationic surfactants, saponification reactions and the formation of the C₁₉TAOH alcohol, respectively, were linked to IFT reduction. The critical micelle concentration and optimal alkali concentration when using cationic C₁₉TAB were significantly lower than with the anionic surfactant; respectively: 335 vs 5000 ppm, and 500 vs 5000 ppm. However, it was found that SDBS was more compatible with NaOH than C₁₉TAB, due to occurrence of alkali deposition with the latter beyond the optimal point.

SUBMITTER: Esfandiarian A

PROVIDER: S-EPMC7689896 | biostudies-literature | 2020 Nov

REPOSITORIES: biostudies-literature

ACCESS DATA

Publications

Mechanistic Investigation of LSW/Surfactant/Alkali Synergism for Enhanced Oil Recovery: Fluid-Fluid Interactions.

Esfandiarian Ali A Azdarpour Amin A Santos Rafael M RM Mohammadian Erfan E Hamidi Hossein H Sedaghat Milad M Dehkordi Parham B PB

ACS omega 20201113 46

The combination of chemical enhanced oil recovery (CEOR) and low salinity water (LSW) flooding is one of the most attractive enhanced oil recovery (EOR) methods. While several studies on CEOR have been performed to date, there still exists a lack of mechanistic understanding on the synergism between surfactant, alkali and LSW. This synergism, in terms of fluid-fluid interactions, is experimentally investigated in this study, and mechanistic understanding is gained through fluid analysis techniqu ...[more]

PMID: 33251441

Similar Datasets

Project description:Throughout the application of enhanced oil recovery (EOR), surfactant adsorption is considered the leading constraint on both the successful implementation and economic viability of the process. In this study, a comprehensive investigation on the adsorption behaviour of nonionic and anionic individual surfactants; namely, alkyl polyglucoside (APG) and alkyl ether carboxylate (AEC) was performed using static adsorption experiments, isotherm modelling using (Langmuir, Freundlich, Sips, and Temkin models), adsorption simulation using a state-of-the-art method, binary mixture prediction using the modified extended Langmuir (MEL) model, and artificial neural network (ANN) prediction. Static adsorption experiments revealed higher adsorption capacity of APG as compared to AEC, with sips being the most fitted model with R2 (0.9915 and 0.9926, for APG and AEC respectively). It was indicated that both monolayer and multilayer adsorption took place in a heterogeneous adsorption system with non-uniform surfactant molecules distribution, which was in remarkable agreement with the simulation results. The (APG/AEC) binary mixture prediction depicted contradictory results to the experimental individual behaviour, showing that AEC had more affinity to adsorb in competition with APG for the adsorption sites on the rock surface. The adopted ANN model showed good agreement with the experimental data and the simulated adsorption values for APG and AEC showed a decreasing trend as temperature increases. Simulating the impact of binary surfactant adsorption can provide a tremendous advantage of demonstrating the binary system behaviour with less experimental data. The utilization of ANN for such prediction procedure can minimize the experimental time, operating cost and give feasible predictions compared to other computational methods. The integrated workflow followed in this study is quite innovative as it has not been employed before for surfactant adsorption studies.

Project description:Expanding swept volume technology via continuous-phase polymer solution and dispersed-phase particle gel is an important technique to increase oil production and control water production in mature waterflooding reservoirs. However, problems such as the low viscosity retention rate, deep migration, and weak mobility control of conventional polymers, and the contradiction between migration distance of particle gel and plugging strength, restrict the long-term effectiveness of oil displacement agents and the in-depth sweep efficiency expanding capability in reservoirs. Combined with the technical advantages of polymer and particle gel, a novel controllable phase-transition polymer was developed and systematically studied to gain mechanistic insights into enhanced oil recovery for mature waterflooding reservoirs. To reveal the phase-transition mechanism, the molecular structure, morphology, and rheological properties of the controllable phase-transition polymer were characterized before and after phase transition. The propagation behavior of the controllable phase-transition polymer in porous media was studied by conducting long core flow experiments. Two-dimensional micro visualization and parallel core flooding experiments were performed to investigate the EOR mechanism from porous media to pore level. Results show that the controllable phase-transition polymer could change phase from dispersed-phase particle gel to continuous-phase solution with the prolongation of ageing time. The controllable phase-transition polymer exhibited phase-transition behavior and good propagation capability in porous media. The results of micro visualization flooding experiments showed that the incremental oil recovery of the controllable phase-transition polymer was highest when a particle gel and polymer solution coexisted, followed by a pure continuous-phase polymer solution and pure dispersed-phase particle gel suspension. The recovery rate of the novel controllable phase-transition polymer was 27.2% after waterflooding, which was 8.9% higher than that of conventional polymer, providing a promising candidate for oilfield application.

Project description:The primary objective of this study is to develop a novel experimental nanofluid based on surfactant-nanoparticle-brine tuning, subsequently evaluate its performance in the laboratory under reservoir conditions, then upscale the design for a field trial of the nanotechnology-enhanced surfactant injection process. Two different mixtures of commercial anionic surfactants (SA and SB) were characterized by their critical micelle concentration (CMC), density, and Fourier transform infrared (FTIR) spectra. Two types of commercial nanoparticles (CNA and CNB) were utilized, and they were characterized by SBET, FTIR spectra, hydrodynamic mean sizes (dp50), isoelectric points (pHIEP), and functional groups. The evaluation of both surfactant-nanoparticle systems demonstrated that the best performance was obtained with a total dissolved solid (TDS) of 0.75% with the SA surfactant and the CNA nanoparticles. A nanofluid formulation with 100 mg·L-1 of CNA provided suitable interfacial tension (IFT) values between 0.18 and 0.15 mN·m-1 for a surfactant dosage range of 750-1000 mg·L-1. Results obtained from adsorption tests indicated that the surfactant adsorption on the rock would be reduced by at least 40% under static and dynamic conditions due to nanoparticle addition. Moreover, during core flooding tests, it was observed that the recovery factor was increased by 22% for the nanofluid usage in contrast with a 17% increase with only the use of the surfactant. These results are related to the estimated capillary number of 3 × 10-5, 3 × 10-4, and 5 × 10-4 for the brine, the surfactant, and the nanofluid, respectively, as well as to the reduction in the surfactant adsorption on the rock which enhances the efficiency of the process. The field trial application was performed with the same nanofluid formulation in the two different injection patterns of a Colombian oil field and represented the first application worldwide of nanoparticles/nanofluids in enhanced oil recovery (EOR) processes. The cumulative incremental oil production was nearly 30,035 Bbls for both injection patterns by May 19, 2020. The decline rate was estimated through an exponential model to be -0.104 month-1 before the intervention, to -0.016 month-1 after the nanofluid injection. The pilot was designed based on a production increment of 3.5%, which was successfully surpassed with this field test with an increment of 27.3%. This application is the first, worldwide, to demonstrate surfactant flooding assisted by nanotechnology in a chemical enhanced oil recovery (CEOR) process in a low interfacial tension region.

Dataset Information

Mechanistic Investigation of LSW/Surfactant/Alkali Synergism for Enhanced Oil Recovery: Fluid-Fluid Interactions.

Publications

Mechanistic Investigation of LSW/Surfactant/Alkali Synergism for Enhanced Oil Recovery: Fluid-Fluid Interactions.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets