Phylogenetic comparison of egg transparency in ascidians by hyperspectral imaging.
Ontology highlight
ABSTRACT:
SUBMITTER: Shito TT
PROVIDER: S-EPMC7709464 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Organismal transparency constitutes a significant concern in whole-body live imaging, yet its underlying structural, genetic, and physiological foundations remain inadequately comprehended. Diverse environmental and physiological factors (multimodal factors) are recognized for their influence on organismal transparency. However, a comprehensive and integrated quantitative evaluation system for biological transparency across a broad spectrum of wavelengths is presently lacking. In this study, we have devised an evaluation system to gauge alterations in organismal transparency induced by multimodal factors, encompassing a wide range of transmittance spanning from 380 to 1000 nm, utilizing hyperspectral microscopy. Through experimentation, we have scrutinized the impact of three environmental variables (temperature, salinity, and pH) and the effect of 11 drugs treatment containing inhibitors targeting physiological processes in the ascidian Ascidiella aspersa. This particular species, known for its exceptionally transparent eggs and embryos, serves as an ideal model. We calculated bio-transparency defined as the mean transmittance ratio of visible light within the range of 400-760 nm. Our findings reveal a positive correlation between bio-transparency and temperature, while an inverse relationship is observed with salinity levels. Notably, reduced pH levels and exposure to six drugs have led to significant decreasing in bio-transparency (ranging from 4.2% to 58.6%). Principal component analysis (PCA) on the measured transmittance data classified these factors into distinct groups. This suggest diverse pathways through which opacification occurs across different spectrum regions. The outcome of our quantitative analysis of bio-transparency holds potential applicability to diverse living organisms on multiple scales. This analytical framework also contributes to a holistic comprehension of the mechanisms underlying biological transparency, which is susceptible to many environmental and physiological modalities.
| S-EPMC10566722 | biostudies-literature
Project description:Microscopy and omics are complementary approaches to probe the molecular state of cells in health and disease, combining granularity with scalability. While important advances have been achieved over the last decade in each area, integrating both imaging- and sequencing-based assays on the same cell has proven challenging. In this study, a new approach called HyperSeq that combines hyperspectral autofluorescence imaging with transcriptomics on the same cell is demonstrated. HyperSeq was applied to Michigan Cancer Foundation 7 (MCF-7) breast cancer cells and identified a subpopulation of cells exhibiting bright autofluorescence rings at the plasma membrane in optical channel 13 (ex = 431 nm, em = 594 nm). Correlating the presence of a ring with the gene expression in the same cell indicated that ringed cells are more likely to express hallmark genes of apoptosis and gene silencing and less likely to express genes associated with ATP production. Further, correlation of cell morphology with gene expression suggested that multiple members of the spliceosome were upregulated in larger cells. A number of genes, albeit evenly expressed across cell sizes, exhibited higher usage of specific exons in larger or smaller cells. Finally, correlation between gene expression and fluorescence within the spectral range of Nicotinamide adenine dinucleotide hydrogen (NADH) provided preliminary insight into the metabolic states of cells. These observations provided a link between the cell’s optical spectrum and its internal molecular state, demonstrating the utility of HyperSeq to study cell biology at single cell resolution by integrating spectral, morphological and transcriptomic analyses into a single, streamlined workflow.
2024-02-05 | GSE254034 | GEO
Project description:Hyperspectral cameras onboard unmanned aerial vehicles (UAVs) have recently emerged for monitoring crop traits at the sub-field scale. Different physical, statistical, and hybrid methods for crop trait retrieval have been developed. However, spectra collected from UAVs can be confounded by various issues, including illumination variation throughout the crop growing season, the effect of which on the retrieval performance is not well understood at present. In this study, four retrieval methods are compared, in terms of retrieving the leaf area index (LAI), fractional vegetation cover (fCover), and canopy chlorophyll content (CCC) of potato plants over an agricultural field for six dates during the growing season. We analyzed: (1) The standard look-up table method (LUTstd), (2) an improved (regularized) LUT method that involves variable correlation (LUTreg), (3) hybrid methods, and (4) random forest regression without (RF) and with (RFexp) the exposure time as an additional explanatory variable. The Soil-Leaf-Canopy (SLC) model was used in association with the LUT-based inversion and hybrid methods, while the statistical modelling methods (RF and RFexp) relied entirely on in situ data. The results revealed that RFexp was the best-performing method, yielding the highest accuracies, in terms of the normalized root mean square error (NRMSE), for LAI (5.36%), fCover (5.87%), and CCC (15.01%). RFexp was able to reduce the effects of illumination variability and cloud shadows. LUTreg outperformed the other two retrieval methods (hybrid methods and LUTstd), with an NRMSE of 9.18% for LAI, 10.46% for fCover, and 12.16% for CCC. Conversely, LUTreg led to lower accuracies than those derived from RF for LAI (5.51%) and for fCover (6.23%), but not for CCC (16.21%). Therefore, the machine learning approaches-in particular, RF-appear to be the most promising retrieval methods for application to UAV-based hyperspectral data.
| S-EPMC7613394 | biostudies-literature
Project description:SignificanceHyperspectral reflectance imaging can be used in medicine to identify tissue types, such as tumor tissue. Tissue classification algorithms are developed based on, e.g., machine learning or principle component analysis. For the development of these algorithms, data are generally preprocessed to remove variability in data not related to the tissue itself since this will improve the performance of the classification algorithm. In hyperspectral imaging, the measured spectra are also influenced by reflections from the surface (glare) and height variations within and between tissue samples.AimTo compare the ability of different preprocessing algorithms to decrease variations in spectra induced by glare and height differences while maintaining contrast based on differences in optical properties between tissue types.ApproachWe compare eight preprocessing algorithms commonly used in medical hyperspectral imaging: standard normal variate, multiplicative scatter correction, min-max normalization, mean centering, area under the curve normalization, single wavelength normalization, first derivative, and second derivative. We investigate conservation of contrast stemming from differences in: blood volume fraction, presence of different absorbers, scatter amplitude, and scatter slope-while correcting for glare and height variations. We use a similarity metric, the overlap coefficient, to quantify contrast between spectra. We also investigate the algorithms for clinical datasets from the colon and breast.ConclusionsPreprocessing reduces the overlap due to glare and distance variations. In general, the algorithms standard normal variate, min-max, area under the curve, and single wavelength normalization are the most suitable to preprocess data used to develop a classification algorithm for tissue classification. The type of contrast between tissue types determines which of these four algorithms is most suitable.
| S-EPMC9541333 | biostudies-literature
Project description:This study compared the relative cellular uptake of 80 nm silver nanoparticles (AgNP) with four different coatings including: branched polyethyleneimine (bPEI), citrate (CIT), polyvinylpyrrolidone (PVP), and polyethylene glycol (PEG). A gold nanoparticle PVP was also compared to the silver nanoparticles. Biophysical parameters of cellular uptake and effects included flow cytometry side scatter (SSC) intensity, nuclear light scatter, cell cycle distributions, surface plasmonic resonance (SPR), fluorescence microscopy of mitochondrial gross structure, and darkfield hyperspectral imaging. The AgNP-bPEI were positively charged and entered cells at a higher rate than the negatively or neutrally charged particles. The AgNP-bPEI were toxic to the cells at lower doses than the other coatings which resulted in mitochondria being transformed from a normal string-like appearance to small round beaded structures. Hyperspectral imaging showed that AgNP-bPEI and AgNP-CIT agglomerated in the cells and on the slides, which was evident by longer spectral wavelengths of scattered light compared to AgNP-PEG and AgNP-PVP particles. In unfixed cells, AgNP-CIT and AgNP-bPEI had higher SPR than either AgNP-PEG or AgNP-PVP particles, presumably due to greater intracellular agglomeration. After 24 hr. incubation with AgNP-bPEI, there was a dose-dependent decrease in the G1 phase and an increase in the G2/M and S phases of the cell cycle suggestive of cell cycle inhibition. The nuclei of all the AgNP treated cells showed a dose-dependent increase in nanoparticles following non-ionic detergent treatment in which the nuclei retained extra-nuclear AgNP, suggesting that nanoparticles were attached to the nuclei or cytoplasm and not removed by detergent lysis. In summary, positively charged AgNP-bPEI increased particle cellular uptake. Particles agglomerated in the peri-nuclear region, increased mitochondrial toxicity, disturbed the cell cycle, and caused abnormal adherence of extranuclear material to the nucleus after detergent lysis of cells. These results illustrate the importance of nanoparticle surface coatings and charge in determining potentially toxic cellular interactions.
| S-EPMC6668787 | biostudies-literature
Project description:Biological systems inspire the design of multifunctional materials and devices. However, current synthetic replicas rarely capture the range of structural complexity observed in natural materials. Prior to the definition of a biomimetic design, a dual investigation with a common set of criteria for comparing the biological material and the replica is required. Here, we deal with this issue by addressing the non-trivial case of insect cuticles tessellated with polygonal microcells with iridescent colours due to the twisted cholesteric organization of chitin fibres. By using hyperspectral imaging within a common methodology, we compare, at several length scales, the textural, structural and spectral properties of the microcells found in the two-band cuticle of the scarab beetle Chrysina gloriosa with those of the polygonal texture formed in flat films of cholesteric liquid crystal oligomers. The hyperspectral imaging technique offers a unique opportunity to reveal the common features and differences in the spectral-spatial signatures of biological and synthetic samples at a 6-nm spectral resolution over 400 nm-1000 nm and a spatial resolution of 150 nm. The biomimetic design of chiral tessellations is relevant to the field of non-specular properties such as deflection and lensing in geometric phase planar optics.
| S-EPMC7328402 | biostudies-literature
Project description:Analysis of microplastics (MP) in environmental samples is an emerging field, which is performed with various methods and instruments based either on spectroscopy or thermoanalytical methods. In general, both approaches result in two different types of data sets that are either mass or particle number related. Depending on detection limits of the respective method and instrumentation the derived polymer composition trends may vary. In this study, we compare the results of hyperspectral Fourier-transform infrared (FTIR) imaging analysis and pyrolysis gas chromatography-mass spectrometry (Py-GC/MS) analysis performed on a set of environmental samples that differ in complexity and degree of microplastic contamination. The measurements were conducted consecutively, and on exactly the same sample. First, the samples were investigated with FTIR using aluminum oxide filters; subsequently, these were crushed, transferred to glass fiber filters, in pyrolysis cups, and measured via Py-GC/MS. After a general data harmonization step, the trends in MP contamination were thoroughly investigated with regard to the respective sample set and the derived polymer compositions. While the overall trends in MP contamination were very similar, differences were observed in the polymer compositions. Furthermore, polymer masses were empirically calculated from FTIR data and compared with the Py-GC/MS results. Here, a most plausible shape-related overestimation of the calculated polymer masses was observed in samples with larger particles and increased particle numbers. Taking into account the different measurement principles of both methods, all results were examined and discussed, and future needs for harmonization of intermethodological results were identified and highlighted. Graphical abstract.
| S-EPMC7680748 | biostudies-literature
Project description:Dynamic thin film interferometry is a technique used to non-invasively characterize the thickness of thin liquid films that are evolving in both space and time. Recovering the underlying thickness from the captured interferograms, unconditionally and automatically is still an open problem. Here we report a compact setup employing a snapshot hyperspectral camera and the related algorithms for the automated determination of thickness profiles of dynamic thin liquid films. The proposed technique is shown to recover film thickness profiles to within 100 nm of accuracy as compared to those profiles reconstructed through the manual color matching process. Subsequently, we discuss the characteristics and advantages of hyperspectral interferometry including the increased robustness against imaging noise as well as the ability to perform thickness reconstruction without considering the absolute light intensity information.
| S-EPMC7347853 | biostudies-literature
Project description:Many applications requiring both spectral and spatial information at high resolution benefit from spectral imaging. Although different technical methods have been developed and commercially available, computational spectral cameras represent a compact, lightweight, and inexpensive solution. However, the tradeoff between spatial and spectral resolutions, dominated by the limited data volume and environmental noise, limits the potential of these cameras. In this study, we developed a deeply learned broadband encoding stochastic hyperspectral camera. In particular, using advanced artificial intelligence in filter design and spectrum reconstruction, we achieved 7000-11,000 times faster signal processing and ~10 times improvement regarding noise tolerance. These improvements enabled us to precisely and dynamically reconstruct the spectra of the entire field of view, previously unreachable with compact computational spectral cameras.
| S-EPMC8149860 | biostudies-literature
Project description:Monitoring plant responses to stress is an ongoing challenge for crop breeders, growers, and agronomists. The measurement of below-ground stress is particularly challenging as plants do not always show visible signs of stress in the above-ground organs, particularly at early stages. Hyperspectral imaging is a technique that could be used to overcome this challenge if associations between plant spectral data and specific stresses can be determined. In this study, three genotypes of red raspberry plants grown under controlled conditions in a glasshouse were subjected to below-ground biotic stresses (root pathogen Phytophthora rubi and root herbivore Otiorhynchus sulcatus) or abiotic stress (soil water availability) and regularly imaged using hyperspectral cameras over this period. Significant differences were observed in plant biophysical traits (canopy height and leaf dry mass) and canopy reflectance spectrum between the three genotypes and the imposed stress treatments. The ratio of reflectance at 469 and 523 nm showed a significant genotype-by-treatment interaction driven by differential genotypic responses to the P. rubi treatment. This indicates that spectral imaging can be used to identify variable plant stress responses in raspberry plants.
| S-EPMC10020142 | biostudies-literature