Porous Clay Heterostructure with Alginate Encapsulation for Toluene Removal.
Ontology highlight
ABSTRACT: A volatile organic compound adsorbent based on a porous clay heterostructure (PCH) with alginate biopolymer was successfully prepared. From N2 adsorption-desorption analysis, the specific surface area, pore volume, and pore size of bentonite were dramatically increased after introducing the porous structure. Following complexation with alginate (Alg-PCH), the pore volume and pore size were not significantly affected by pore structure. The thermal stability of Alg-PCH shows enhanced thermal stability compared to alginate and alginate beads. The morphology layered structure of Alg-PCH was carried out by transmission electron microscopy (TEM), suggesting the disorder and re-order of the c-axis layer stacking by porous structure and complexation with alginate, respectively, which was well-matched with X-ray diffraction results. To optimize the preparation of Alg-PCH, various reaction conditions (alginate, CaCl2 concentration, bead size, and weight ratio between alginate and PCH) were utilized. According to the toluene adsorption-desorption experiments, the preparation conditions for Alg-PCH were selected as a 2 mm extrusion tip, 0.5% of alginate, and 2% of CaCl2 solution with a 1:50 alginate:PCH weight ratio. Additionally, it shows 61.63 mg/g adsorption capacity with around 49% desorption efficacy under atmospheric temperature and pressure.
Project description:Here we characterize the impact of cell confinement on the pancreatic islet signature during the guided differentiation of alginate encapsulated human induced pluripotent stem cells.
Project description:Nanocomposite polymer electrolytes (NPEs) were synthesized using sodium alginate (Alg) and either sodium (SCa-3-Na+)- or lithium (SCa-3-Li+)-modified montmorillonite clays. The samples were characterized by structural, optical, and electrical properties. SCa-3-Na+ and SCa-3-Li+ clays' X-ray structural analyses revealed peaks at 2θ = 7.2° and 6.7° that corresponded to the interlamellar distances of 12.3 and 12.8 Å, respectively. Alg-based NPEs X-ray diffractograms showed exfoliated structures for samples with low clay percentages. The increase of clay content promoted the formation of intercalated structures. Electrochemical Impedance Spectroscopy revealed that Alg-based NPEs with 5 wt% of SCa-3-Na+ clay presented the highest conductivity of 1.96 × 10-2 S/cm2, and Alg with 10 wt% of SCa-3-Li+ showed conductivity of 1.30 × 10-2 S/cm2, both measured at 70 °C. From UV-Vis spectroscopy, it was possible to infer that increasing concentration of clay promoted a decrease of the samples' transmittance and, consequently, an increase of their reflectance.
Project description:Porous materials with well-defined porosity have advantages in a wide range of applications, including filtration media, catalysis, and electrodes. The bottom-up fabrication of inverse opals have promised to provide those nanostructures, but fabrication of these materials is often plagued with large numbers of defects and macro-scale cracks. Here, we present a method for making nanostructured porous clay films with well defined pore size that are crack free over a large area (multiple cm2).
Project description:Leaching of the internal apolar phase from the biopolymeric microparticles during storage is a great concern as it undoes the beneficial effects of encapsulation. In this paper, a novel formulation was prepared by encapsulating the sunflower oil-based organogels in alginate microparticles. Salicylic acid and metronidazole were used as the model drugs. The microparticles were prepared by double emulsion methodology. Physico-chemical characterization of the microparticles was done by microscopy, FTIR, XRD, and DSC studies. Oil leaching studies, biocompatibility, mucoadhesivity, in vitro drug release, and the antimicrobial efficiency of the microparticles were also performed. The microparticles were found to be spherical in shape. Gelation of the sunflower oil prevented leaching of the internal phase from the microparticles. Release of drugs from the microparticles followed Fickian kinetics and non-Fickian kinetics in gastric and intestinal environments, respectively. Microparticles showed good antimicrobial activity against both Gram-positive (Bacillus subtilis) and Gram-negative (Escherichia coli) bacteria. The results suggested that the developed formulations hold promise to carry oils without leakage of the internal phase. Encapsulation of organogels within the microparticles has improved the drug entrapment efficiency and improved characteristics for controlled delivery applications.
Project description:Probiotic functionalization of non-dairy beverages has been garnering interest to provide dairy-sensitive populations with greater probiotic product varieties. The addition of probiotics into popularly consumed beverages-carbonated sodas and beers, presents an interesting challenge as the presence of acidic pH, hops-derived compounds, and ethanol have highly deleterious effects. Herein, alginate encapsulation was proposed to improve probiotics viability within sodas and beers. Three probiotics, namely Lacticaseibacillus rhamnosus GG, Escherichia coli Nissle 1917, and Bifidobacterium longum were encapsulated in alginate spheres and exposed to Coca-Cola, 7-Up, Tiger Beer, and Guinness under refrigerated, room temperature and simulated gastric fluid conditions. Results demonstrate that alginate encapsulation significantly improved the viabilities of all three probiotics in various beverages and conditions. Refrigerated storage better preserved probiotic viabilities and reduced the formation of the probiotic metabolic by-product, L-lactate, than at room temperature storage. Findings here could provide beverage manufacturers with a novel way to develop probiotic-sodas and probiotic-beers through encapsulation.
Project description:Topical imageplication of epidermal growth fctor (EGF) has been used to accelerate diabetic foot ulcers but with limited efficacy. In this study, we selected a complex coacervate (EGF-Coa) composed of the low molecular weight gelatin type A and sodium alginate as a novel delivery system for EGF, based on encapsulation efficiency and protection of EGF from protease. EGF-Coa enhanced in vitro migration of keratinocytes and accelerated wound healing in streptozotocin-induced diabetic mice with increased granulation and re-epithelialization. While diabetic wound sites without treatment showed downward growth of hyperproliferative epidermis along the wound edges with poor matrix formation, EGF-Coa treatment recovered horizontal migration of epidermis over the newly deposited dermal matrix. EGF-Coa treatment also resulted in reduced levels of proinflammatory cytokines IL-1, IL-6, and THF-?. Freeze-dried coacervates packaged in aluminum pouches were stable for up to 4 months at 4 and 25 °C in terms of appearance, purity by RP-HPLC, and in vitro release profiles. There were significant physical and chemical changes in relative humidity above 33% or at 37 °C, suggesting the requirement for moisture-proof packaging and cold chain storage for long term stability. We propose low molecular weight gelatin type A and sodium alginate (LWGA-SA) coacervates as a novel EGF delivery system with enhanced efficacy for chronic wounds.
Project description:Quorum sensing, in which bacteria communities use signaling molecules for inter- and intracellular communication, has been intensively studied in recent decades. In order to fabricate highly sensitive easy-to-handle point of care biosensors that detect quorum sensing molecules, we have developed, as is reported here, reporter bacteria loaded alginate-methacrylate (alginate-MA) hydrogel beads. The alginate-MA beads, which were obtained by electrostatic extrusion, were reinforced by photo-cross-linking to increase stability and thereby to reduce bacteria leaching. In these beads the genetically engineered fluorescent reporter bacterium Escherichia coli pTetR-LasR-pLuxR-GFP (E. coli pLuxR-GFP) was encapsulated, which responds to the autoinducer N-(3-oxododecanoyl)homoserine lactone secreted by Pseudomonas aeruginosa. After encapsulation in alginate-MA hydrogel beads with diameters in the range of 100-300 μm that were produced by an electrostatic extrusion method and rapid photo-cross-linking, the E. coli pLuxR-GFP were found to possess a high degree of viability and sensing activity. The encapsulated bacteria could proliferate inside the hydrogel beads, when exposed to bacteria culture medium. In media containing the autoinducer N-(3-oxododecanoyl)homoserine lactone, the encapsulated reporter bacteria responded with a strong fluorescence signal due to an increased green fluorescent protein (GFP) expression. A prototype dipstick type sensor developed here underlines the potential of encapsulation of viable and functional reporter bacteria inside reinforced alginate-methacrylate hydrogel beads for whole cell sensors for bacteria detection.
Project description:Advancements in polymer science and nanotechnology hold significant potential for addressing the increasing demands of food security, by enhancing the shelf life, barrier properties, and nutritional quality of harvested fruits and vegetables. In this context, biopolymer-based delivery systems present themselves as a promising strategy for encapsulating bioactive compounds, improving their absorption, stability, and functionality. This study provides an exploration of the synthesis, characterization, and postharvest protection applications of nanocarriers formed through the complexation of chitosan oligomers, carboxymethylcellulose, and alginate in a 2:2:1 molar ratio. This complexation process was facilitated by methacrylic anhydride and sodium tripolyphosphate as cross-linking agents. Characterization techniques employed include transmission electron microscopy, energy-dispersive X-ray spectroscopy, infrared spectroscopy, thermal analysis, and X-ray powder diffraction. The resulting hollow nanospheres, characterized by a monodisperse distribution and a mean diameter of 114 nm, exhibited efficient encapsulation of carvacrol, with a loading capacity of approximately 20%. Their suitability for phytopathogen control was assessed in vitro against three phytopathogens-Botrytis cinerea, Penicillium expansum, and Colletotrichum coccodes-revealing minimum inhibitory concentrations ranging from 23.3 to 31.3 μg·mL-1. This indicates a higher activity compared to non-encapsulated conventional fungicides. In ex situ tests for tomato (cv. 'Daniela') protection, higher doses (50-100 μg·mL-1, depending on the pathogen) were necessary to achieve high protection. Nevertheless, these doses remained practical for real-world applicability. The advantages of safety, coupled with the potential for a multi-target mode of action, further enhance the appeal of these nanocarriers.
Project description:Citral is a typical UV-irritation and acid-sensitive active and here we develop a mild method for the encapsulation of citral in calcium alginate microcapsules, in which UV irritation or acetic acid is avoided. Monodispersed oil-in-water-in-oil (O/W/O) emulsions are generated in a capillary microfluidic device as precursors. The middle aqueous phase of O/W/O emulsions contains sodium alginate, calcium-ethylenediaminetetraacetic acid (EDTA-Ca) complex as the calcium source, and D-(+)-Gluconic acid δ-lactone (GDL) as the acidifier. Hydrolysis of GDL will decrease the pH value of the middle aqueous solution, which will trigger the calcium ions released from the EDTA-Ca complex to cross-link with alginate molecules. After the gelling process, the O/W/O emulsions will convert to alginate microcapsules with a uniform structure and monodispersed size. The preparation conditions for alginate microcapsules are optimized, including the constituent concentration in the middle aqueous phase of O/W/O emulsions and the mixing manner of GDL with the alginate-contained aqueous solution. Citral-containing alginate microcapsules are successfully prepared by this mild method and the sustained-release characteristic of citral from alginate microcapsules is analyzed. Furthermore, a typical application of citral-containing alginate microcapsules to delay the oxidation of oil is also demonstrated. The mild gelling method provides us a chance to encapsulate sensitive hydrophobic actives with alginate, which takes many potential applications in pharmaceutical, food, and cosmetic areas.