Stereoselectivity in spontaneous assembly of rolled incommensurate carbon bilayers.
Ontology highlight
ABSTRACT:
SUBMITTER: Matsuno T
PROVIDER: S-EPMC7946902 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Controlling the 3D assembly of individual nanomaterials can be a challenging task. However, it opens up opportunities for the production of increasingly complex nanostructures. Unusual rolled multiwall carbon nanotube structures are synthesized here by simply inducing a change of precursor composition during the growth of multiwall carbon nanotube forests. The multiwall carbon nanotube structures are comprised of nitrogen-doped and undoped sections, and are obtained via a detailed peel off and roll mechanism. These results open new doors for the development of increasingly complex nanostructures.
| S-EPMC7753106 | biostudies-literature
Project description:Developing new techniques to prepare free-standing tubular scaffolds has always been a challenge in the field of regenerative medicine. Here, we report a new and simple way to prepare free-standing collagen constructs with rolled-up architecture by self-assembling nanofibers on porous alumina (Al2O3) textiles modified with different silanes, carbon or gold. Following self-assembly and cross-linking with glutaraldehyde, collagen nanofibers spontaneously rolled up on the modified Al2O3 textiles and detached. The resulting collagen constructs had an inner diameter of approximately 2 to 4 mm in a rolled-up state and could be easily detached from the underlying textiles. Mechanical testing of wet collagen scaffolds following detachment yielded mean values of 3.5 ± 1.9 MPa for the tensile strength, 41.0 ± 20.8 MPa for the Young's modulus and 8.1 ± 3.7% for the elongation at break. No roll-up was observed on Al2O3 textiles without any modification, where collagen did not assemble into fibers, either. Blends of collagen and chitosan were also found to roll into fibrous constructs on silanized Al2O3 textiles, while fibrinogen nanofibers or blends of collagen and elastin did not yield such structures. Based on these differences, we hypothesize that textile surface charge and protein charge, in combination with the porous architecture of protein nanofibers and differences in mechanical strain, are key factors in inducing a scaffold roll-up. Further studies are required to develop the observed roll-up effect into a reproducible biofabrication process that can enable the controlled production of free-standing collagen-based tubes for soft tissue engineering.
| S-EPMC10436369 | biostudies-literature
Project description:Enzymes are characteristic of catalytic efficiency and specificity by maneuvering multiple components in concert at a confined nanoscale space. However, achieving such a configuration in artificial catalysts remains challenging. Herein, we report a microenvironment regulation strategy by modifying carbon paper with hexadecyltrimethylammonium cations, delivering electrochemical carbon-carbon coupling of benzaldehyde with enhanced activity and racemate stereoselectivity. The modified electrode-electrolyte interface creates an optimal microenvironment for electrocatalysis-it engenders dipolar interaction with the reaction intermediate, giving a 2.2-fold higher reaction rate (from 0.13 to 0.28 mmol h-1 cm-2); Moreover, it repels interfacial water and modulates the conformational specificity of reaction intermediate by facilitating intermolecular hydrogen bonding, affording 2.5-fold higher diastereomeric ratio of racemate to mesomer (from 0.73 to 1.82). We expect that the microenvironment regulation strategy will lead to the advanced design of electrode-electrolyte interface for enhanced activity and (stereo)selectivity that mimics enzymes.
| S-EPMC10616095 | biostudies-literature
Project description:The assembly of complex bacterial glycans presenting rare structural motifs and cis-glycosidic linkages is significantly obstructed by the lack of knowledge of the reactivity of the constituting building blocks and the stereoselectivity of the reactions in which they partake. We here report a strategy to map the reactivity of carbohydrate building blocks and apply it to understand the reactivity of the bacterial sugar, caryophyllose, a rare C12-monosaccharide, containing a characteristic tetrasubstituted stereocenter. We mapped reactivity-stereoselectivity relationships for caryophyllose donor and acceptor glycosides by a systematic series of glycosylations in combination with the detection and characterization of different reactive intermediates using experimental and computational techniques. The insights garnered from these studies enabled the rational design of building blocks with the required properties to assemble mycobacterial lipooligosaccharide fragments of M. marinum.
| S-EPMC7821131 | biostudies-literature
Project description:The spontaneous self-assembly of ?-synuclein (?-syn) into aggregates of different morphologies is associated with the development of Parkinson's disease. However, the mechanism behind the spontaneous assembly remains elusive. The current study shows a novel effect of phospholipid bilayers on the assembly of the ?-syn aggregates. Using time-lapse atomic force microscopy, it was discovered that ?-syn assembles into aggregates on bilayer surfaces, even at the nanomolar concentration range. The efficiency of the aggregation process depends on the membrane composition, with the greatest efficiency observed for of 1-palmitoyl-2-oleoyl-sn-glycero-3-phospho-l-serine (POPS). Importantly, assembled aggregates can dissociate from the surface, suggesting that on-surface aggregation is a mechanism by which pathological aggregates may be produced. Computational modeling revealed that dimers of ?-syn assembled rapidly, through the membrane-bound monomer on POPS bilayer, due to an aggregation-prone orientation of ?-syn. Interaction of ?-syn with 1-palmitoyl-2-oleoyl-sn-glycero-3-phosphocholine (POPC) leads to a binding mode that does not induce a fast assembly of the dimer. Based on these findings, we propose a model in which the interaction of ?-syn with membranes plays a critical role initiating the formation of ?-syn aggregates and the overall aggregation process.
| S-EPMC6661114 | biostudies-literature
Project description:We report on the use of supported lipid bilayers to reveal dynamics of actin polymerization from a nonpolymerizing subphase via cationic phospholipids. Using varying fractions of charged lipid, lipid mobility, and buffer conditions, we show that dynamics at the nanoscale can be used to control the self-assembly of these structures. In the case of fluid-phase lipid bilayers, the actin adsorbs to form a uniform two-dimensional layer with complete surface coverage whereas gel-phase bilayers induce a network of randomly oriented actin filaments, of lower coverage. Reducing the pH increased the polymerization rate, the number of nucleation events, and the total coverage of actin. A model of the adsorption/diffusion process is developed to provide a description of the experimental data and shows that, in the case of fluid-phase bilayers, polymerization arises equally due to the adsorption and diffusion of surface-bound monomers and the addition of monomers directly from the solution phase. In contrast, in the case of gel-phase bilayers, polymerization is dominated by the addition of monomers from solution. In both cases, the filaments are stable for long times even when the G-actin is removed from the supernatant-making this a practical approach for creating stable lipid-actin systems via self-assembly.
| S-EPMC3838754 | biostudies-literature
Project description:The use of colloid supported lipid bilayers (CSLBs) has recently been extended to create colloidal joints, that enable the assembly of structures with internal degrees of flexibility, and to study lipid membranes on curved and closed geometries. These novel applications of CSLBs rely on previously unappreciated properties: the simultaneous fluidity of the bilayer, lateral mobility of inserted (linker) molecules and colloidal stability. Here we characterize every step in the manufacturing of CSLBs in view of these requirements using confocal microscopy and fluorescence recovery after photobleaching (FRAP). Specifically, we have studied the influence of different particle properties (roughness, surface charge, chemical composition, polymer coating) on the quality and mobility of the supported bilayer. We find that the insertion of lipopolymers in the bilayer can affect its homogeneity and fluidity. We improve the colloidal stability by inserting lipopolymers or double-stranded inert DNA into the bilayer. We include surface-mobile DNA linkers and use FRAP to characterize their lateral mobility both in their freely diffusive and bonded state. Finally, we demonstrate the self-assembly of flexibly linked structures from the CSLBs modified with surface-mobile DNA linkers. Our work offers a collection of experimental tools for working with CSLBs in applications ranging from controlled bottom-up self-assembly to model membrane studies.
| S-EPMC6371764 | biostudies-literature
Project description:The assembly of nucleic acid nanostructures with controlled size and shape has large impact in the fields of nanotechnology, nanomedicine and synthetic biology. The directed arrangement of nano-structures at interfaces is important for many applications. In spite of this, the use of laterally mobile lipid bilayers to control RNA three-dimensional nanostructure formation on surfaces remains largely unexplored. Here, we direct the self-assembly of RNA building blocks into three-dimensional structures of RNA on fluid lipid bilayers composed of cationic 1,2-dioleoyl-3-trimethylammonium-propane (DOTAP) or mixtures of zwitterionic 1,2-dioleoyl-sn-glycero-3-phosphatidylcholine (DOPC) and cationic sphingosine. We demonstrate the stepwise supramolecular assembly of discrete building blocks through specific and selective RNA-RNA interactions, based on results from quartz crystal microbalance with dissipation (QCM-D), ellipsometry, fluorescence recovery after photobleaching (FRAP) and total internal reflection fluorescence microscopy (TIRF) experiments. The assembly can be controlled to give a densely packed single layer of RNA polyhedrons at the fluid lipid bilayer surface. We show that assembly of the 3D structure can be modulated by sequence specific interactions, surface charge and changes in the salt composition and concentration. In addition, the tertiary structure of the RNA polyhedron can be controllably switched from an extended structure to one that is dense and compact. The versatile approach to building up three-dimensional structures of RNA does not require modification of the surface or the RNA molecules, and can be used as a bottom-up means of nanofabrication of functionalized bio-mimicking surfaces.
| S-EPMC4274363 | biostudies-literature
Project description:DNA-lipid complexes are of biomedical importance as delivery vectors for gene therapy. To gain insight into the interactions of DNA with zwitterionic and cationic (dimyristoyltrimethylammonium propane (DMTAP)) lipids, we have used coarse-grained molecular dynamics simulations to study the self-assembly of DPPC and DPPC/DMTAP lipid bilayers in the presence of a DNA dodecamer. We observed the spontaneous formation of lipid bilayers from initial systems containing randomly placed lipids, water-counterions and DNA. In both the DPPC and DPPC/DMTAP simulations, the DNA molecule is located at the water-lipid headgroup interface, lying approximately parallel to the plane of the bilayer. We have also calculated the potential of mean force for transferring a DNA dodecamer through a DPPC/DMTAP bilayer. A high energetic barrier to DNA insertion into the hydrophobic core of the bilayer is observed. The DNA adopts a transmembrane orientation only in this region. Local bilayer deformation in the vicinity of the DNA molecule is observed, largely as a result of the DNA-DMTAP headgroup attraction.
| S-EPMC2582188 | biostudies-literature
Project description:The high-pressure behavior of layered CrOCl is shown to be governed by non-bonded interactions between chlorine atoms in relation to a rigid framework composed of Cr and O atoms. The competition between optimizing intra- and interlayer Cl-Cl distances and the general trend towards denser packing defines a novel mechanism for high-pressure phase transitions of inorganic materials. CrOCl possesses an incommensurate phase for 16-51 GPa. Single-crystal x-ray diffraction in a diamond anvil cell provides an accurate description of the evolution of the incommensurate wave with pressure. It thus demonstrates a continuous increase of the amplitude up to 30 GPa, followed by a decrease of the wavelength until a lock-in transition occurs at 51 GPa.
| S-EPMC4440982 | biostudies-literature