Data describing characteristics of waste foundry dust (WFD), sorbent obtained before and after batch sorption tests using As(III) and Cr(VI) aqueous solutions.
Ontology highlight
ABSTRACT:
SUBMITTER: Rha S
PROVIDER: S-EPMC7973122 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Pyrrole (Py) is easily agglomerated during the polymerization process, affecting its performance. In this paper, polypyrrole/monodispersed latex sphere (PPy/MLS) composites were prepared using in-situ polymerization for the adsorption of hexavalent chromium (Cr(VI)). The specific surface area of PPy/MLS (39.30 m2/g) was increased relative to that of PPy (24.82 m2/g), thus providing more effective adsorption sites. In addition, the adsorption properties of Cr(VI) under different conditions, including Py content, pH of the aqueous solution, and PPy/MLS dosage, were investigated to reveal the adsorption mechanism. The results showed that PPy/MLS possessed high Cr(VI) adsorption capacities when the Py content was 50 wt %. The maximum adsorption capacity was 343.64 mg/g at pH 2.0 and 25 °C. Remarkably, the adsorbents exhibited an excellent removal rate of Cr(VI) after three cycles of adsorption-desorption (over 99%), suggesting that the adsorbents had exceptional recyclability. Furthermore, the adsorption process followed quasi-second-order kinetics and Langmuir isothermal adsorption model. The high adsorption performance, sustainability, and cost-efficiency make this adsorbent a promising candidate for large-scale Cr(VI) contaminant removal.
| S-EPMC7114732 | biostudies-literature
Project description:Removal of Cr(VI) from the environment represents a stringent issue because of its tremendous effects on living organisms. In this context, design of sorbents with high sorption capacity for Cr(VI) is getting a strong need. For this purpose, poly(vinylbenzyl chloride), impregnated into porous silica (PSi), was cross-linked with either N,N,N',N'-tetramethyl-1,2-ethylenediamine (TEMED) or N,N,N',N'-tetramethyl-1,3-propanediamine, followed by the reaction of the free -CH2Cl groups with N,N-diethyl-2-hydroxyethylamine to generate strong base anion exchangers (ANEX) inside the pores. The PSi/ANEX composite sorbents were deeply characterized by FTIR spectroscopy, SEM-energy dispersive X-ray spectroscopy (EDX), thermogravimetric analysis (TGA), and water uptake. The sorption performances of composites against Cr(VI) were investigated as a function of pH, contact time, initial concentration of Cr(VI), and temperature. It was found that the cross-linker structure and the silica morphology are the key factors controlling the sorption capacity. The adsorption process was spontaneous and endothermic and well described by pseudo-second-order kinetic and Sips isotherm models. The maximum sorption capacity of 311.2 mg Cr(VI)/g sorbent was found for the composite prepared with mesoporous silica using TEMED as cross-linker. The PSi/ANEX composite sorbents represent an excellent alternative for the removal of Cr(VI) oxyanions, being endowed with fast kinetics, equilibrium in about 60 min, and a high level of reusability in successive sorption/desorption cycles.
| S-EPMC7179461 | biostudies-literature
Project description:Bioremediation of Cr(VI) and nitrate is considered as a promising and cost-effective alternative to chemical and physical methods. However, organo-Cr(III) complexes in effluent generally causes environmental concerns due to second-pollution. Here, Cr(VI) reduction and immobilization efficiencies of anaerobic activated sludge were investigated. Anaerobic activated sludge showed strong reduction ability of Cr(VI) and possessed a great potential of Cr(III) immobilization. Almost 100.0 mg l-1 Cr(VI) could be completely reduced and immobilized by anaerobic activated sludge in a sequencing batch reactor in 24 h. And most generated Cr(III) was accumulated outside of sludge cells. Extracellular polymeric substances (EPS) could bind to Cr(VI) and form EPS-Cr(VI) interaction to reduce the toxic effect of Cr(VI) and promote the Cr(VI) reduction. Protein-like and humic-like substances were responsible for binding with Cr(VI), meanwhile the process was a thermodynamically favorable binding reaction. Then Cr(VI) was reduced to Cr(III) by membrane-associated chromate reductase of sludge. Eventually, the generated Cr(III) might exist as poly-nuclear Cr(III) complexes adhered to sludge surfaces.
| S-EPMC5431812 | biostudies-literature
Project description:Chromate, Cr(VI), contamination in soil and groundwater poses serious threat to living organisms and environmental health worldwide. Sulphate green rust (GRSO4), a naturally occurring mixed-valent iron layered double hydroxide has shown to be highly effective in the reduction of Cr(VI) to poorly soluble Cr(III), giving promise for its use as reactant for in situ remedial applications. However, little is known about its immobilization efficiency inside porous geological media, such as soils and sediments, where this reactant would ultimately be applied. In this study, we tested the removal of Cr(VI) by GRSO4 in quartz sand fixed-bed column systems (diameter?×?length?=?1.4 cm?×?11 cm), under anoxic conditions. Cr(VI) removal efficiency (relative to the available reducing equivalents in the added GRSO4) was determined by evaluating breakthrough curves performed at different inlet Cr(VI) concentrations (0.125-1 mM) which are representative of Cr(VI) concentrations found at contaminated sites, different flow rates (0.25-3 ml/min) and solution pH (4.5, 7 and 9.5). Results showed that (i) increasing Cr(VI) inlet concentration substantially decreased Cr(VI) removal efficiency of GRSO4, (ii) flow rates had a lower impact on removal efficiencies, although values tended to be lower at higher flow rates, and (iii) Cr(VI) removal was enhanced at acidic pH conditions compared to neutral and alkaline conditions. For comparison, Cr(VI) removal by sulphidized nanoscale zerovalent iron (S-nZVI) in identical column experiments was substantially lower, indicating that S-nZVI reactivity with Cr(VI) is much slower compared to GRSO4. Overall, GRSO4 performed reasonably well, even at the highest tested flow rate, showing its versatility and suitability for Cr(VI) remediation applications in high flow environments.
| S-EPMC7429723 | biostudies-literature
Project description:Cr(VI) is a common bioavailable toxic metal that can cause oxidative stress, DNA adducts, and perturb normal gene expression. Changes in gene expression are useful biomarkers of toxicant exposure that provide information about the health of an organism, its ability to adapt to its environment, and indicate potential toxicant-specific effects. Therefore, we developed a toxicology array to the estuarine sentinel species Fundulus heteroclitus, or mummichog. Juvenile mummichog were exposed to potassium dichromate for thirty days at concentrations from 0 to 24 mg/L of Cr(VI), and growth was measured to determine the NOEC (1.5 mg/L or 0.0288 mM) and LOEC (3 mg/L or 0.0577 mM). Body burdens from Cr(VI) exposed fish demonstrated a dose dependent increase and were inversely correlated to body weight. Cr(VI)-exposed juvenile mummichog differentially expressed greater than 20 genes in a dose-dependent manner, including hepatic glucose transporter 2, liver fatty acid binding protein, ATPase synthase 8, type II keratin, TBT binding protein, and complement component C3-2. Many of these genes are involved in energy metabolism or growth, which is consistent with the reduced growth caused by Cr(VI). Keywords: dose response
2006-03-31 | GSE3481 | GEO
Project description:As part of the ENCODE consortium the GENCODE project is producing a reference gene set through manual and automated gene prediction. Selected transcript models are verified experimentally by RT-PCR amplification followed by sequencing. This is batch VI, which targets annotations from Gencode 6 (November 2010) as well as transcript models predicted by the Ensembl Genebuild group based on the Illumina Human BodyMap 2.0 data.
2011-11-25 | E-MTAB-831 | biostudies-arrayexpress
Project description:Urethane copolymer sorbent materials that incorporate β-cyclodextrin (CD) have been prepared and their sorption properties with chlorinated aromatic compounds (i.e., pentachlorophenol, 2,4-dichlorophenol and 2,4-dichlorophenoxy acetic acid) have been evaluated. The sorption properties of granular activated carbon (GAC) were similarly compared in aqueous solution at variable pH conditions. The sorbents displayed variable BET surface areas as follows: MDI-X copolymers (< 10¹ m²/g), CDI-X copolymers (< 10¹ m²/g), and granular activated carbon (GAC ~10³ m²/g). The sorption capacities for the copolymers sorbents are listed in descending order, as follows: GAC > CDI-3 copolymer ≈ MDI-3 copolymer. The sorption capacity for the aromatic adsorbates with each sorbent are listed in descending order, as follows: 2,4-dichlorophenol > 2,4-dichlorophenoxy acetic acid > pentachlorophenol. In general, the differences in the sorption properties of the copolymer sorbents with the chlorinated organics were related to the following factors: (i) surface area of the sorbent; (ii) CD content and accessibility; and (iii) and the chemical nature of the sorbent material.
| S-EPMC5448859 | biostudies-other
Project description:The study assesses the contamination, classification and phytotoxicity of foundry waste. The presented results are a part of the research on the agrotechnical use of foundry waste. Landfilled foundry waste (LFW) and dust samples were taken from one of the Polish foundries. An analysis of the waste and its leachate composition was conducted. Phytotoxicity tests were carried out using Lepidium sativum. The aim of the phytotoxicity study was to evaluate germination and root growth after 72 h and the accumulation of heavy metals after 7 days. LFW was least contaminated with heavy metals and metalloids compared to dust. The composition of the foundry dusts depended on the unit of the foundry, from which it was collected. It was found that electric arc furnace dust (EAFD) was the most polluted by heavy metals among the dust samples. According to the requirements of Polish regulations most of tested waste were classified as non-hazardous, and EAFD as hazardous waste due to high Pb concentration in leachate. Phytotoxicity tests have shown a low phytotoxicity of the leachate from most of the tested waste. The results of the accumulation test showed that an excess of metal and metalloids in leachate was not directly related to its accumulation in plants. A negative correlation between EC, Cu, Co, Fe, Pb, Cr, K, Na, sulfate, fluoride, ammonia, phenol and formaldehyde concentration in leachate and GI was found. It was stated that the Fe, Mn, As and Se in plants was significantly correlated with concentrations in leachate.
| S-EPMC7182548 | biostudies-literature
Project description:This article concerns the effect of the chemical modification of short flax fiber on its sorption properties for heavy metal ions. The main purpose of the modification was to achieve the oxidation of flax cellulose with sodium metaperiodate to form dialdehyde cellulose. Additionally, the research shows the subsequent interaction of dialdehyde cellulose with 1-amino-8-hydroxynaphthalene-3,6-disulfonic acid and its transformation into a derivative capable of forming chelate complexes with heavy metal ions. Additionally, this article presents the results of equilibrium and kinetics studies of the sorption of Cu(II), Cd(II), and Fe(II) ions from aqueous solutions by primary and modified cellulose sorbents. SEM spectra indicate changes in the surface structure of the modified sorbents compared to the original one. IR spectra show the appearance of amino- and sulfogroups in short flax fibers in the process of their modification. The research revealed the efficiency of the method and the possibility of its use for the purification of aqueous solutions from heavy metal ions in industrial processes.
| S-EPMC10649064 | biostudies-literature
Project description:Cr(VI) is a common bioavailable toxic metal that can cause oxidative stress, DNA adducts, and perturb normal gene expression. Changes in gene expression are useful biomarkers of toxicant exposure that provide information about the health of an organism, its ability to adapt to its environment, and indicate potential toxicant-specific effects. Therefore, we developed a toxicology array to the estuarine sentinel species Fundulus heteroclitus, or mummichog. Adults males were exposed to Cr(VI) for 7-days at 0, 1.5 (NOEC), or 3 mg/L (LOEC). Livers were excised and RNA isolated. Adults are used in the laboratory experiments so that we can compare laboratory studies to fish caught at chromium-contaminated field sites. Cr(VI) altered the expression of 12 genes in adult liver, including hepatic growth factor activator, heart fatty acid binding protein, and complement component C3-2. Keywords: dose response
2006-03-31 | GSE3480 | GEO